What is the difference between a positive counter and a  step counter?

1 Answer

Answer :

The load resistor in a positive counter is replaced by a capacitor  in a step counter.

Related questions

Description : How do uhf tubes counter the effects of transit time?

Last Answer : By reducing the spacing between tube elements.

Description : What is the largest count that can be indicated by a four stage counter?

Last Answer : 11112, or 1510.

Description : . What type of counter has clock pulses applied to all FFs?

Last Answer : Synchronous.

Description : An asynchronous counter is also called a ___________ counter.

Last Answer : Ripple

Description : What is the modulus of a five-stage binary counter?

Last Answer : 32.

Description : What is meant by induced emf? By counter emf?

Last Answer : Induced emf is the emf which appears across a conductor when there is relative motion between the conductor and a magnetic field; counter emf is the emf induced in a conductor that opposes the applied voltage.

Description : What motor characteristic is affected by counter emf?

Last Answer : Speed.

Description : What causes counter emf in a dc motor

Last Answer : Generator action.

Description : Why did the Ulema oppose English culture? What step did they take to counter the impact? -SST 10th

Last Answer : The Muslim dynasties had collapsed in India by the end of the 19th century. The Ulema were scared of the impact of colonial culture on Muslims. They were afraid that the British would change ... helped them to fight against English influence. Urdu print helped them to fight these battles in public.

Description : Positive values for the rotation angle θ defines a.Counter clockwise rotations about the end points b.Counter clockwise translation about the pivot point c.Counter clockwise rotations about the pivot point d.Negative direction

Last Answer : c.Counter clockwise rotations about the pivot point

Description : Is contra-counter a positive connotation or negative?

Last Answer : What is the answer ?

Description : Does 1:5 indicate a step-up or step-down transformer?

Last Answer : Step up.

Description : Does 1:5 indicate a step-up or step-down transformer?

Last Answer : Step up

Description : What radar scope uses a range step for range measurement?

Last Answer : The A scope.

Description : If you are required to monitor the speed of a device with a stroboscope over an extended period of time, what step should be taken to prolong the life of the flasher tube?

Last Answer : Monitor a submultiple frequency to prolong the flasher-tube life.

Description : Reduction of Fresnel reflection is possible by reducing the step change in the refractive index at the fiber interface. What material reduces the step change in refractive index at a fiber interface?

Last Answer : Index matching gel.

Description : What are the two basic types of single mode step-index fibers?

Last Answer : Matched-clad and depressed-clad.

Description : Multimode step-index fibers have relatively large core diameters and large numerical apertures. These provide what benefit?

Last Answer : Make it easier to couple light from a light-emitting diode (LED) into the fiber.

Description : In multimode step-index fibers, the majority of light propagates in the fiber core for what reason?

Last Answer : Most modes in multimode step-index fibers propagate far from cutoff.

Description : Multimode step-index fibers have a core and cladding of constant refractive index n1 and n2, respectively. Which refractive index, the core or cladding, is lower?

Last Answer : Cladding.

Description : List the standard core sizes for multimode step-index, multimode graded-index, and single mode fibers

Last Answer : Multimode step-index fibers: 50µm and 100µm. Multimode graded-index fibers: 50µm, 62.5µm, 85µm, and 100µm. Single mode fibers: between 8µm and 10µm.

Description : Multimode optical fibers can have a step-index or graded index refractive index profile. Which fiber, multimode step-index or multimode graded-index fiber, usually performs better?

Last Answer : Multimode graded-index fiber

Description : The refractive index of a fiber core is uniform and undergoes an abrupt change at the corecladding boundary. Is this fiber a step-index or graded-index fiber?

Last Answer : graded-index fiber?

Description : A step transmitter is a modification of what electrical device?

Last Answer : Rotary switch.

Description : Compare the power sources of synchros and step transmission systems.

Last Answer : Synchros use ac; step transmission uses dc.

Description : If a voltage (positive or negative) is measured on the "1" output of a flip-flop, what state is it in?

Last Answer : SET state.

Description : What type of bias (positive or negative) is added to a negative damper for the most positive extremity of the wave shape to be clamped above 0 volts?

Last Answer : Positive bias.

Description : A negative damper with negative bias clamps the most positive extremity of the output wave shape to what polarity (positive or negative)?

Last Answer : Negative potential.

Description : To which polarity does a positive damper with positive bins clamp the most negative extremity of the output waveform (positive or negative)?

Last Answer : Positive potential.

Description : A positive damper clamps which extremity of the output signal to 0 volts?

Last Answer : Most negative.

Description : How can a series-positive limiter be modified to limit unwanted negative portions of the input signal?

Last Answer : Biasing.

Description : Which portion of a sine-wave input is retained in the output of a series-positive limiter?

Last Answer : Negative.

Description : Does a rectifier tube conduct on the positive or negative alternation of the input signal?

Last Answer : Positive.

Description : If the load requirement consists of both positive and negative voltages, what technique is used in the voltage divider to supply the loads from a single voltage source?

Last Answer : The ground (reference point) is placed in the proper point in the voltage divider so that positive and negative voltages are supplied

Description : Which digital data encoding method records a digital one as a positive pulse and a digital (zero) as a negative pulse and returns the tape to neutral between pulses?

Last Answer : Return-to-zero (RZ) encoding.

Description : An electron moves into the electrostatic field between a positive charge and a negative charge. Toward which charge will the electron move?

Last Answer : Toward the positive charge.

Description : How do electrons get from the negative electrode to the positive electrode?

Last Answer : By current flow through the load.

Description : What is another name for the (a) positive electrode, and the (b) negative electrode?

Last Answer : a) The anode, (b) the cathode.

Description : An electron moves into the electrostatic field between a positive charge and a negative charge. Toward which charge will the electron move?

Last Answer : Toward the positive charge.