Description : The asbestos cement pipes are generally laid A. Horizontally B. Vertically C. At an angle of 30° D. At an angle of 60°
Last Answer : ANS: B
Description : Manholes are less common in (A) Cast iron pipes (B) Steel pipes (C) Hume steel pipes (D) R.C.C. pipes
Last Answer : (A) Cast iron pipes
Description : Sewer pipes need be checked for A. Minimum flow B. Maximum flow C. Both A. and B. D. None of these
Last Answer : ANS: C
Description : Aerobic activity is maximum A. In freshly produced sewage B. At sewer pipes C. In sewer treatment plants D. None of these
Last Answer : ANS: A
Description : In R.C. sewer pipes, the percentage longitudinal reinforcement to the cross-sectional area of concrete is kept A. 10.0 B. 5.0 C. 2.0 D. 0.25
Last Answer : ANS: D
Description : Which one of the following tests is used for testing sewer pipes? A. Water test B. Ball test C. Mirror test D. All of these
Description : The porosity of sediments in sewer pipes, is usually taken as A. 0.010 B. 0.011 C. 0.012 D. 0.013
Description : You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at A. Full depth B. Half full C. Two third full D. Three fourth full
Description : An inverted siphon is designed generally for A. One pipe B. Two pipes C. Three pipes D. Four pipes
Description : For sewers, inverted siphon is provided for A. One pipe B. Two pipes C. Three pipes D. Four pipes
Description : Lead caulked joints are used for laying A. Stone ware pipes B. Earthenware pipes C. C.I. pipes D. G.I. pipes
Description : Stone ware pipes are A. Highly resistant to sulphide corrosion B. Highly impervious C. Hydraulically efficient because of their smooth interior surface D. Especially suited to pressure pipes
Description : Pick up the in-correct statement from the following: A. Manholes are provided in sewer pipes at suitable intervals B. Catch basins are generally provided in sewers for carrying drainage discharge C. Inlets are generally provided in all sewers D. None of these
Description : Hydraulic mean radius is A. Mean radius of sewer B. Difference in heads between two points in circular pipes C. Mean of radii in a pipe line of varying cross -sections D. Cross-sectional area/wetted perimeter
Description : ¾th or ¼th extra space is left in sewer pipes at maximum discharge for A. Low estimates of the average and maximum flows B. Large scale infiltration of storm water C. Unexpected increase in population D. All the above
Description : Sewer pipes are designed for maximum discharge with 25% to 33% vacant cross-sectional area for A. Unexpected large scale infiltration of stream water B. Unexpected increase in the population C. Under estimates of maximum and average flows D. All of the above
Description : The sewer pipes A. Carry sewage as gravity conduits B. Are designed for generating self-cleansing velocities at different discharge C. Should resist the wear and tear caused due to abrasion D. All the above
Description : Pick up the correct statement from the following: A. The water supply pipes carry pure water free from solid particles B. The water supply pipes get clogged if flow velocity is less than self ... carried up and down the hills and valleys D. The sewer pipes are generally laid along level hills
Description : For drainage pipes in buildings the test applied before putting them to use, is A. Water test B. Smoke test C. Straightness test D. All the above
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above
Description : Service connections to consumers houses, are generally provided with (A) Copper pipes (B) Hume pipes (C) Galvanised iron pipes (D) P.V.C. pipe
Last Answer : (C) Galvanised iron pipes
Description : The type of pipe commonly used in water supply distribution schemes, is (A) R.C.C. pipes (B) Hume pipes (C) Cast iron pipes (D) G.I. pipes
Last Answer : (C) Cast iron pipes
Description : Pick up the correct statement from the following: (A) Lime mortar with cement in the ratio of in 10 is cheaper and better for outside plaster (B) For very cold or very hot climate, a compact and closed ... (C) On the sea coast, an exposed and open house is generally preferred (D) All the above
Last Answer : Answer: Option D
Description : Q No: 291 The coagulant widely used for sewage treatment, is A. Alum B. Ferric chloride C. Ferric sulphate D. Chlorinated copperas
Description : Q No: 271 Pick up the correct statement from the following: A. Turbidity is more in strong sewage B. The black colour indicates septic sewage C. The sewage omits offensive odours after four hours D. All the above
Description : Q No: 251 In a sludge digestion tank if the moisture content of sludge V1 litres is reduced from p1 % to p2 % the volume V2 is A. [(100 + P1)/(100 – P2)] V1 B. [(100 – P1)/(100 + P2)] V1 C. [(100 – P1)/(100 – P2)] V1 D. [(100 + P2)/(100 – P1)] V1
Description : Q No: 191 Design period of 40 to 50 years is adopted for A. Branch sewers B. Main sewers C. Trunk sewers D. All the above
Description : WASTE WATER ENGINEERING Objective Questions with Answers Q No: 161 The quantity of liquid waste which flows in sewers during the period of rainfall, is known A. Sanitary sewage B. Industrial waste C. Storm sewage D. None of these
Description : WASTE WATER Engineering Objective Questions Pdf :: Q No: 151 The pH value of fresh sewage is usually A. Equal to 7 B. More than 7 C. Less than 7 D. Equal to zero
Description : Q No: 131 The most widely used pump for lifting sewage is A. Centrifugal pump B. Reciprocating pump C. Pneumatic ejector D. Air pressure pump
Description : Q No: 101 are available in size Stoneware sewers A. 10 cm B. 15 cm C. 20 cm D. All the above
Description : The Brake Horse power of the motor (efficiency 60%) required for a pump of capacity 0.075 cumec for a total lift of 12 m, is A. 10 B. 15 C. 20 D. 25 Q No: 44 Aerobic bacterias A. ... presence of free oxygen B. Consume organic matter as their food C. Oxidise organic matter in sewage D. All the above
Description : Which one of the following resists hydrogen sulphide corrosion? A. R.C.C. B. Glazed stone wares C. Asbestos cement D. Glazed ware
Description : 221 For non-scouring velocity 5 m/sec, the type of sewers generally preferred to, is A. Cast iron sewers B. Cement concrete sewers C. Glazed bricks sewers D. Stone ware sewers
Description : In sewers the highest non-scouring velocity is achieved in A. Glazed bricks sewers B. Cast iron sewers C. Cement concrete sewers D. Stone ware sewers
Description : Cement concrete sewers are only suitable if non-scouring velocity is between A. 2.5 to 3.0 m/sec B. 3.0 to 4.0 m/sec C. 3.5 to 4.5 m/sec D. 4.5 to 5.5 m/sec
Description : The asbestos cement sewers are A. Light in weight B. Not structurally strong to bear large compressive stress C. Susceptible to corrosion by sulphuric acid D. All the above
Description : For estimating the peak run off the rational formula Q = 0.0278 KpA was evolved by A. Kinchling B. Lloyd Davis C. Frubling D. All the above
Description : The detention time of a circular tank of diameter d and water depth H, for receiving the sewage Q per hour, is A. d² (0.011d + 0.785H)/Q B. d (0.022d + 0.085H)/Q C. d (0.785d + 0.011H)/Q D. d (0.285d + 0.011H)/Q
Description : In a sedimentation tank (length L, width B, depth D) the settling velocity of a particle for a discharge Q, is A. Q/(B × D) B. Q/(L × D) C. Q/L D. Q/(B × L)
Description : If q is the average sewage flow from a city of population P, the maximum sewage flow A. Q = [(4 + )/(18 + )] q B. Q = [(18 + P)/(4 + )] q C. Q = [(18 + )/(4 + )] q D. Q = [(5 + )/((15 + )] q
Description : Who said that what is needed is an understanding of technology from inside, both as a body of knowledgeand as a social system. Instead, technology is often treated as a ‘‘black box’’ whose contentsand behaviour may be assumed to be common knowledge. a. Layton. b. Rolston III. c. Hume. d. John Locke.
Last Answer : a. Layton.
Description : The mortar in which both cement and lime are used as binding materials, is called (A) Cement mortar (B) Lime mortar (C) Fire resistant mortar (D) Gauged mortar
Description : The pressure exerted by A. The sewage when running full from inside, is called internal pressure B. The internal pressure if any, causes tensile stress in the pipe material C. Pressure sewers are designed to be safe in tension D. All the above
Description : In order to prevent the corrosion of iron pipes they are often coated with a layer of zinc. This process is termed as: A. Electroplating B. Annealing C. Galvanization D. Vulcanization
Last Answer : ANSWER: C
Description : In order to prevent the corrosion of iron pipes, they are often coated with a layer of zinc. This process is termed as (a) electroplating (b) annealing (c) galvanization (d) vulcanization
Last Answer : Ans:(c)
Description : In order to prevent the corrosion of iron pipes they are often coated with a layer of zinc. This process is termed as------? A. Electroplating B. Annealing C. Galvanization (Answer) D. Vulcanization
Last Answer : C. Galvanization (Answer)
Description : Cast iron detachable joint is used in __________ pipes. (A) Steel (B) Cast iron (C) Asbestos cement (D) Reinforced cement concrete
Last Answer : (A) Steel
Description : Lead is poured into the joint between two- __________ pipes. (A) Mild steel (B) Concrete (C) Cast iron (D) Asbestos cement
Last Answer : (C) Cast iron