Description : 47.2 divided by 6.307?
Last Answer : 7.4837
Description : Give the six figure grid reference of : Triangulated height 307. -SST 10th
Last Answer : (a) (i) 859843 (ii) 860788. (b) (i) 8189 (ii) 8188. (c) 8 cm = 4 km. (d) (i) broken ground (ii) perennial stream. (e) (i) Nucleated (ii) There are a number of ... the horizontal distance between two points on the map to the distance of the corresponding points on the ground. (ii) 1 : 50000.
Description : what's 307,495 rounded to the nearest thousand? -General Knowledge
Last Answer : The number 307,495 rounded to the nearest thousand is 307,000.
Description : What is the standard deviation and what is the probability that a student scored higher than 322 if the mean test score is 312 and 16 percent of the scores are under 307?
Last Answer : Assuming a normal distribution:If 16% are less than 307, then 84% are greater than 307.Using single tailed normal tables we want the z value whichgives 84%-50% = 34% = 0.34 to the left of the mean; this is z ≈ ... 1 - 0.977 = 0.023 = 2.3 % are greater than 322→ probability greater than 322 is 2.3%
Description : Which digit is in the hundredths place of 307.28?
Last Answer : 8
Description : What frequency is 10 octaves above 30 Hz? A. 30.72 kHz B. 30 kHz C. 300 Hz D. 307.2 kHz
Last Answer : A. 30.72 kHz
Description : The frame consists of a steel beam welded rigidly to two vertical channels. An eccentric exciter weighing 250 N is attached to the beam, which weighs 10 KN and is used to excite the frame. The unbalance weight of ... ends, magnification factor at resonance is A. 307.5 B. 3.075 C. 30.75 D. 0.3075
Last Answer : C. 30.75
Description : A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is (A) 0.207 (B) 0.307 (C) 0.407 (D) 0.508
Last Answer : (A) 0.207
Description : A beam of length L supported on two intermediate rollers carries a uniformly distributed load on its entire length. If sagging B.M. and hogging B.M. of the beam are equal, the length of each overhang, is (A) 0.107 L (B) 0.207 L (C) 0.307 L(D) 0.407 L
Last Answer : (B) 0.207 L
Description : To ensure that the hogging bending moment at two points of suspension of a pile of length L equals the sagging moment at its centre, the distances of the points of suspension from either end, is (A) 0.107 L (B) 0.207 L (C) 0.307 L (D) 0.407 L
Last Answer : Answer: Option B
Description : 97,122,?,307,503,792 a) 171 b) 158 c) 186 d) 203 e) 178
Last Answer : Answer: c)