1. Get the mobile out of the water as soon as possible. The plastic cover of the mobile is fairly stiff , but it does not take much time for water to enter it , at most 20 seconds. Grab the mobile quickly. Don't forget to turn it on , as it can easily be short-circuited (if it is on , turn it off immediately). One drying is essential in water, whether it works or not. If it is too late to drain the water , remove the battery as soon as possible. This can guarantee that all the power flow in the mobile will be stopped. 2. Keep a cool head. If your phone ruptures quickly , it may not have done much harm. And even if it's late, I don't think you can warm your head and dry the phone. There is much more to do before you give up. 3. Remove the battery of the mobile. This is one of the most important steps. Even if you don't think about the reaction between electricity and water , the two of them can never be together. There are many special parts inside the mobile that you can save from damage if you disconnect its power source (battery). 4. Remove the SIM card. It may contain much needed information. For many, the value of the SIM card information is more than the phone. Although the SIM card is not easily damaged , the next few steps to save the phone may not be helpful for the SIM. Remove and set aside to dry , until your phone is ready to use. 5. Separate other things used in mobile. Such as: cover , holding etc. . Dry the mobile phone well. Even a drop of water can be deadly by entering various important parts of the phone. So you must also quickly and carefully remove the last drop amount of water. Note: Wipe the mobile lightly. Excessive shaking causes water to enter various parts of the interior where water has not yet entered. In this case , the hit will be the opposite. Use tissue paper or cotton cloth. Lightly remove each corner. Use dry tissue on parts of the phone that have holes or holes (such as keypads) . Because , the water of the folded part can go inside. Be sure to remove the battery and wipe the interior. . Use a vacuum cleaner if possible. There is no answer to pulling a tiny drop of water out of different parts of your phone. So , if you have a vacuum cleaner at home, use it. Use it in every possible part of the phone. This will dry out your phone a lot , but it's still not safe to turn it on. So , don't rush. Note: Do not use hair dryer instead of vacuum cleaner (not even Cold Mode ). Many parts of the water can get inside. And if the dryer is too hot , your device may be damaged. So don't forget to use a hair dryer. . Use rice to dry the mobile. Dried rice works very well. Leave your mobile phone for one night. In this , not a single particle of water will be left in the mobile. Note: Turn the phone upside down every hour before you go to sleep. 9. Place the phone in a dry towel after removing the rice. Remember , the purpose of all this is to dry the phone completely. So don't waste all your hard work using wet towels or anything else. 10. It's time to test the phone. If you have completed the above steps by waiting at least 24 hours or more (if possible) , you can now turn on the phone. Thoroughly clean the battery and turn on the phone.