If magnetic tape is stored in areas with temperature and  humidity extremes, what are three types of tape damage that  may occur?

1 Answer

Answer :

Oxide shedding, layer-to-layer sticking, and tape deformation.

Related questions

Description : Environmental damage to magnetic tape can occur when the tape is stored in an area that exceeds what ideal temperature and humidity ranges?

Last Answer : Ideally, use and store tape at 60 to 80º F and at 40 to 60% relative humidity.

Description : Your activity stores its magnetic tape in an area where the temperature is 100º F. What two types of environmental damage could occur that would make these tapes unusable?

Last Answer : Head-to-tape sticking and layer-to-layer adhesion

Description : When the relative humidity is below 10%, what happens to magnetic tape and parts of a tape recorder that could cause environmental damage?

Last Answer : Dirt build-up caused by static electricity.

Description : What six types of environmental damage can occur to tapes in storage when the ideal temperature and humidity ranges are exceeded?

Last Answer : Tape deformation, oxide shedding, head-to-tape sticking, layer to-layer sticking, dirt build-up, and excessive tape and head wear.

Description : After using a tape that was stored in an area where temperatures exceeded 130º F you notice pieces of oxide sticking to the recorder's tape-transport mechanism, to its magnetic heads, and onto the tape. What is the probable cause of these symptoms?

Last Answer : Oxide shedding. At temperatures above 130º F, oxide coating becomes soft and sheds.

Description : You notice steps in the tape pack such as those in figure 2-3. What causes this and how does it damage the magnetic tape?

Last Answer : Pack slip. It's caused by loosely wound tape on a reel that is exposed to excessive vibration or heat. The vibration or heat causes the tape to shift, causing steps in the tape pack. The uneven tape will then rub against the reel's sides and the recorder's tape guides.

Description : List four rules you should follow when storing magnetic tape to protect it from damage.

Last Answer : a. Make sure the tape is wound properly on the reel hub, b. store tapes vertically, c. keep storage area at right temperature and humidity, d. store away from equipment that generates stray magnetic fields.

Description : hard disks should be stored in an environment that stays within what relative humidity and temperature range?

Last Answer : electronics onto the disk. 30-60 percent relative humidity. b. 70-80 degrees Fahrenheit.

Description : In digital magnetic tape recording, the series of recorded digital pulses can represent what three types of data?

Last Answer : a. Data used by digital computers. b. Pulsed squarewave signals. c. Digitized analog waveforms.

Description : How does relative humidity over 95% cause excessive tape and head wear?

Last Answer : High humidity causes increased friction as the tape passes over the heads.

Description : What two types of record and reproduce electronics are used by magnetic tape recorders?

Last Answer : . a. Direct record (AM). b. Frequency modulation (FM).

Description : What are four types of tape errors that can degrade a magnetic recording system’s performance?

Last Answer : Signal dropout, noise, skew, and level. Dropout is the most common.

Description : Which of the two types of magnetic tape is used to record audio and instrumentation type signals in the VLF to 2.5MHz frequency range?

Last Answer : Analog magnetic tape.

Description : Magnetic tape recorders can have up to three different heads installed. What are the three functions performed by a recorder's heads?

Last Answer : Record, reproduce, and erase.

Description : Magnetic tape is made of what three basic materials?

Last Answer : a. Base material. b. Coating of magnetic oxide particles. c. Glue that bonds the particles to the base.

Description : Digital magnetic tape recorders used to store and retrieve digital data fall into what three categories?

Last Answer : a. Computer-compatible digital tape recorders. b. Telemetry digital tape recorders. c. Instrumentation digital tape recorders

Description : What three formats are used for digital magnetic tape recording?

Last Answer : 1) Serial, (2) parallel, and (3) serial-parallel.

Description : The amount of data that can be stored on a linear inch of tape is known by what term?

Last Answer : Recording density.

Description : How do the tape guides on a tape reeling system protect the tape from damage during operation?

Last Answer : They keep the tape straight with respect to both the supply and take-up reels and the magnetic heads.

Description : Which of the following is the best statement of the relationship of intelligence to delinquency? Options: A) Dull children are most likely to be apprehended and appear to be more often delinquent B) ... ad the imbeciles D) Delinquency is not a product of intelligence as much as of other factors

Last Answer : B) Dull children appear more frequently delinquent because they tend to come from slum areas where strict law enforcement prevails

Description : Which of the following is not true for a magnetic disk? A) It is expensive relative to magnetic tape B) It provides only sequential access to stored data C) Users can easily update records by writing over the old data D) All of above

Last Answer : Answer : B

Description : Which of the following is not true for a magnetic disk? a. It is expensive relative to magnetic tape b. It provides only sequential access to stored data c. Users can easily update records by writing over the old data d. All of above

Last Answer : It provides only sequential access to stored data

Description : Which of the following is not true for a magnetic disk? a. It is expensive relative to magnetic tape b. It provides only sequential access to stored data c. Users can easily update records by writing over the old data d. All of above

Last Answer : b. It provides only sequential access to stored data

Description : What equipment should you use to de-magnetize a magnetic tape transport?

Last Answer : A hand-held degausser.

Description : Sometimes it's necessary, but why should you avoid using cotton swabs when cleaning a magnetic tape transport?

Last Answer : Cotton swabs are not lint free.

Description : . How do tape transports with differential velocity capstans maintain a constant tape tension in the area around the magnetic heads?

Last Answer : The supply capstan is slightly larger than the take-up capstan. This causes the take-up capstan to pull the tape slightly faster than the supply capstan feeds the tape.

Description : What are the four basic parts of a magnetic tape recorder's tape transport system?

Last Answer : a. Tape reeling system. b. Tape speed control system. c. Electronic subsystem. d. Basic enclosure.

Description : Why is it important to minimize TBE jitter in magnetic tape recordings where precise timing relationships exist between two or more signals?

Last Answer : The jitter could cause noise and a loss of accuracy.

Description : What number harmonic is the primary harmonic distortion in magnetic tape recorders?

Last Answer : Third-order harmonic.

Description : List four factors that can degrade the frequency response of magnetic tape recorders.

Last Answer : a. A too-high or too-low bias signal level setting for the record head. b. An improper reproduce head gap. c. An improper tape transport speed. d. Poor tape-to-head contact.

Description : What two preventive maintenance actions must you do regularly to increase magnetic head life and to ensure good tape recording and playback?

Last Answer : a. Keep the heads clean. b. Keep the heads demagnetized.

Description : What is the correct way to hold a magnetic tape reel?

Last Answer : Always hold reel by the hub, never by the flanges. Never touch the working tape surface.

Description : What method for erasing magnetic tape is much more effective and reliable than using a recorder’s erase head?

Last Answer : Using a magnetic tape degausser

Description : What are two disadvantages of using a recorder’s erase head to erase data recorded on a magnetic tape?

Last Answer : Using an erase head is slow, and it may not completely erase the tape.

Description : What type of magnetic tape is used to record computer programs and data, and what are the additional thickness and quality standards for this type of tape?

Last Answer : digital magnetic tape is for computer programs and data. Its base material is about 50% thicker. The tape’s surface must not have blemishes or coating flaws because losing even one digital data bit could ruin the recorded computer program or data.

Description : Why is plastic magnetic tape used more than metal tape?

Last Answer : Plastic tape is used more than metal because it’s more flexible, resists mildew and fungus, and is very stable at high temperatures and humidity.

Description : What are the major differences between magnetic tape units?

Last Answer : The speed at which the tape is moved past the read/write head and the density of the recorded information.

Description : What are the major differences between magnetic tape units?

Last Answer : The speed at which the tape is moved past the read/write head and the density of the recorded information.

Description : What is the purpose of any magnetic tape unit?

Last Answer : To write data on or read data from a magnetic tape.

Description : Which digital data tape encoding method presets the magnetic tape to all zeros and then records digital ones onto the tape?

Last Answer : Return-to-bias (RB) encoding.

Description : Which of the eight methods for encoding digital data onto magnetic tape is most widely used because it’s accurate, simple, and reliable?

Last Answer : Non-return-to-zero (NRZ) encoding.

Description : Punched cards, paper tape, and magnetic tape use what storage access method?

Last Answer : Sequential-access.

Description : Weather satellites transmit cloud cover and temperature-humidity profiles back to Earth using images of which combination of the electromagnetic radiation types? w) infra-red and visible light x) ultraviolet and nuclear magnetic y) ultraviolet and infra-red z) ultraviolet and visible light

Last Answer : ANSWER: W -- INFRA-RED AND VISIBLE LIGHT

Description : When does most printed circuit board damage occur?

Last Answer : During disassembly or repair.

Description : When the magnetic field of the inductor is completely collapsed, where is the energy of the tank circuit stored?

Last Answer : . Capacitor.

Description : Consider a system with twelve magnetic tape drives and three processes P1, P2 and P3. Process P1 requires maximum ten tape drives, process P2 may need as many as four tape drives and P3 may need upto nine ... , system is in: (A) safe state (B) unsafe state (C) deadlocked state (D) starvation state

Last Answer : Answer: B

Description : Do you guys have temperature extremes like this (see details) where you live?

Last Answer : answer:Same here. Went from 73 degrees a week ago Sunday to snow and 25 degrees mid-week. I'm in the Sierra Nevada foothills of Ca. About one hour from Lake Tahoe. I think California is in ... 80 something degrees compared to Truckee Ca. which is one of the coldest places on earth in the winter.

Description : Contact dermatitis, which of the following are common irritants? A. Water (Missed. B. temperature extremes (Missed. C. Frictional abrasives (Missed. D. Nickel Ans: D 123. Atopic eczema induces lichenification A. True B. False

Last Answer : Ans: A

Description : Water availability, temperature extremes, and __________ should be considered when selecting trees for the landscape. a. Slope b. Topography c. Soil type d. Buildings present

Last Answer : Soil typ

Description : At steam point, the temperature of water and its vapor at standard pressure are:  a. Extremes or maximum  b. unity  c. in equilibrium  d. undefined

Last Answer : in equilibrium