Description : Pick out the wrong statement. (A) For a pressure vessel to be classified as 'thin vessel', the ratio of wall thickness to mean radius is less than 0.1 (B) For calculating forces and ... Maximum diameter of the opening provided in a pressure vessel, which does not require any compensation is 200 mm
Last Answer : Option B
Description : List three items of information normally included in the general description section of a specification sheet for a transistor.
Last Answer : The kind of transistor, the transistor's common applications, and mechanical data
Description : What type of equipment normally uses 26-volt 400-hertz synchros?
Last Answer : . Aircraft.
Description : In applications where electronic waveforms are displayed on a CRT screen, the input signal is normally applied to what CRT element?
Last Answer : The vertical-deflection plate.
Description : What IF frequencies are normally used in radar receivers
Last Answer : Thirty or sixty megahertz.
Description : A surface-search radar normally scans how many degrees of azimuth?
Last Answer : 360 degrees.
Description : Solder used in electronic repair is normally an alloy of what two elements?
Last Answer : Tin and lead.
Description : Stereoscopic-zoom microscopes and precision drill presses are normally associated with what type of repair station?
Last Answer : Microminiature repair station.
Description : When magnetic tapes are ruined, what three factors are normally the cause?
Last Answer : Poor handling, improper storage, or shipping damage.
Description : For AM transmissions, the carrier is normally modulated within what range?
Last Answer : 60% to 95%.
Description : What areas of the earth are not normally covered by satellites?
Last Answer : The extreme polar regions
Description : When using frequencies above 30 megahertz, you are normally limited to using what range?
Last Answer : Line of sight.
Description : Give the type of fault (reflective or nonreflective) normally produced by: (a) fiber breaks, (b) fiber cracks, and (c) fiber microbends.
Last Answer : (a) Reflective, (b) nonreflective, and (c) nonreflective
Description : What format of digital tape recording is normally used to record instrumentation or telemetry data?
Last Answer : Serial digital magnetic tape recording.
Description : What format of digital tape recording is normally used to store computer data?
Last Answer : Parallel digital magnetic tape recording.
Description : Normally, how are high-power rf tubes tested?
Last Answer : In their circuit.
Description : The LED lamps of a typical logic probe are normally in what state?
Last Answer : DIM.
Description : Power for the electronic digital multimeter is normally supplied by what internal power source?
Last Answer : Rechargeable batteries.
Description : What does the term battery normally refer to?
Last Answer : A voltage source in a single container made from one or more cells.
Last Answer : voltage source in a single container made from one or more cells.
Description : What causes a "fractured solder" joint?
Last Answer : Movement of the parts being soldered while the solder is cooling.
Description : What is the most common type of waveguide joint?
Last Answer : Choke joint.
Description : What is the appearance of a properly soldered joint?
Last Answer : Bright and shiny with no cracks or pits.
Description : in multimode fibers, how do fiber joints increase fiber attenuation following the joint?
Last Answer : By disturbing the fiber's mode power distribution (MPD).