Description : A modulation which does not follow the sine wave pattern, it produces undesirable harmonics such as spurious emission A. 0% modulated B. Over-modulated C. Unmodulated D. 100% modulated
Last Answer : B. Over-modulated
Description : At 100% modulation, the sum fo the effective voltages in both sidebands is equal to ______% of the unmodulated carrier voltage. A. 50 B. 71 C. 100 D. 25
Last Answer : B. 71
Description : Three audio waves with 100,200 and 300 volts amplitude respectively, simultaneously modulate a 450 volts carrier. What is the total percent of modulation of the AM wave? A. 69 % B. 115.5 % C. 50% D. 83%
Last Answer : D. 83%
Description : This is referred to a product of simultaneous frequency and amplitude modulation or a carrier frequency variation which produces unwanted distortion. A. Absorption modulation B. Simultaneous modulation C. Dynamic instability D. Series modulation
Last Answer : C. Dynamic instability
Description : What is the first symbol of a radio signal transmission having an amplitude modulated signal carrier, double side band? A. C B. B C. H D. A
Last Answer : D. A
Description : In modulation technique, which of the following is referred to audible pitch? A. Width B. Frequency C. Harmonic D. Amplitude
Last Answer : B. Frequency
Description : What is meant by the term modulation index? A. The processor index. B. The ratio between the deviation of a frequency modulated signal and the modulating frequency. C. The FM signal-to-noise ratio. D. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Last Answer : B. The ratio between the deviation of a frequency modulated signal and the modulating frequency.
Description : Modulation in which the modulated wave is always present. A. Carrier modulation B. Front-end C. Continuous modulation D. Log-periodic modulation
Last Answer : C. Continuous modulation
Description : The audio signals of TV are – (1) Amplitude modulated (2) Frequency modulated (3) Unmodulated (4) Velocity modulated
Last Answer : (2) Frequency modulated Explanation: In analogue television, the sound portion of a broadcast is invariably modulated separately from the video. Most commonly, the audio and video are combined at ... visual antennas can be used. In almost all cases, standard wideband frequency modulation is used.
Description : The audio signals of TV are : (1) Amplitude modulated (2) Frequency modulated (3) Unmodulated (4) Velocity modulated
Last Answer : (2) Frequency modulated Explanation: In telecommunications and signal processing, frequency modulation (FM) conveys information over a carrier wave by varying its instantaneous frequency. This contrasts with ... , the sound portion of a broadcast is invariably modulated separately from the video.
Description : The audio signals of TV are (1) Amplitude modulated (2) Frequency modulated (3) Unmodulated (4) Velocity modulated
Last Answer : Frequency modulated
Description : A 1000W carrier is amplitude modulated to a depth of 85%. Calculate the total power of the modulated wave? A. 1361.25 W B. 680.62 W C. 1425 W D. 712.5 W
Last Answer : A. 1361.25 W
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : Refers to the first symbol in an emission designation with an amplitude modulated main carrier represented by letter H. A. Single sideband suppressed carrier B. Double sideband full carrier C. Independent sideband D. Double sideband
Last Answer : B. Double sideband full carrier
Description : A transmitter supplies 8 kW to the antenna when it is unmodulated, determine the total radiated power when modulated at 90%. A. 5 kW B. 20 kW C. 15 kW D. 8.36 kW
Last Answer : D. 8.36 kW
Description : For 100% modulation, total power is? a) same as the power of unmodulated signal b) twice as the power of unmodulated signal c) four times as the power of unmodulated signal d) one and half times as the power of unmodulated signal
Last Answer : Ans: D
Description : An AM transmitter is rated 100W at 100% modulation. How much power required for the carrier? A. 33.33 W B. 66.66 W C. 83.33 W D. 100 W
Last Answer : B. 66.66 W
Description : 100% modulation in AM means a corresponding increase in total power by: A. 25% B. 75% C. 100% D. 50%
Last Answer : D. 50%
Description : Modulation means A. Varying of information B. Utilization of a single transmission channel to carry multiple signals C. Varying of some parameters of a carrier such as its amplitude to transmit information D. Transmit pulses in DC form on a copper wire
Last Answer : C. Varying of some parameters of a carrier such as its amplitude to transmit information
Description : If the percentage modulation of an AM amplifier is 88% and the modulating signal is 1 volt, the carrier has an amplitude of _______________. A. 1.14 volts B. 0.88 volt C. 1.88 volts D. 0.12 volt
Last Answer : A. 1.14 volts
Description : For 100% modulation, power in each sideband is ________ of that of carrier? a) 50% b) 70% c) 60% d) 25%
Description : Referred to as an average power from the radio transmitter supplied to the antenna transmission line taken during one radio frequency cycle under no modulation. A. Carrier power B. Rated power C. Peak envelop power D. Mean power
Last Answer : A. Carrier power
Description : In radio regulation, the first symbol in the designation of radio emission is ______. A. Bandwidth B. Nature of signal(s) modulation the main carrier C. Type of modulation of the main carrier D. Type of information to be transmitted
Last Answer : C. Type of modulation of the main carrier
Description : What is the effect in over modulated amplitude modulated radio broadcasting transmission? A. Interference to adjacent channel B. Higher fidelity C. Increase noise D. Higher audio signal
Last Answer : A. Interference to adjacent channel
Description : A carrier signal has ______. A. Constant peak amplitude B. The information C. Frequency range 20-20000 Hz D. A varying amplitude
Last Answer : A. Constant peak amplitude
Description : In frequency modulation, amplitude of modulated wave is A. positive B. negative C. constant D. zero
Last Answer : constant
Description : The ratio of the level of the modulated output of a transmitter under conditions of standard test modulation to the level of the demodulated output with no modulation applied both measured with the ... . Reference audio output B. None of these C. Audio frequency response D. Residual noise level
Last Answer : D. Residual noise level
Description : If the carrier of a 100 percent modulation modulated AM wave is suppressed, the percentage power saving will be (A) 50.55 (B) 15.55 (C) 10.66 (D) 66.66
Last Answer : If the carrier of a 100 percent modulation modulated AM wave is suppressed, the percentage power saving will be 66.66
Description : What is the relative humidity for a saturated air? A. 0% B. 50% C. 100% D. cannot say
Last Answer : ANSWER : C
Description : When the rate of evaporation of water is zero, the relative humidity of the air is A. 0% B. 100% C. 50% D. unpredictable
Last Answer : ANSWER : B
Description : When the dew point temperature is equal to the air temperature then the relative humidity is A. 0% B. 50% C. 100% D. unpredictable
Description : 4. A haemophilic man marries a normal homozygous woman. What is the probability that their son will be haemophilic a) 100% b) 75 % c) 50% d) 0%
Last Answer : d) 0%
Description : What type of transmission is radiated from an aircraft’s radio altimeter antenna? A. An amplitude modulated continuous wave B. A pulse position modulated UHF signal C. A differential phase shift keyed UHF signal D. A frequency modulated continuous wave
Last Answer : D. A frequency modulated continuous wave
Description : The series of periodically recurrent pulses is modulated in amplitude by the corresponding instantaneous samples. A. PFM B. PWM C. PDM D. PAM
Last Answer : D. PAM
Description : In_____ transmission, thephaseof the carrier signal is modulated to follow the changingvoltage level (amplitude) of the modulating signal. A) AM B) PM C) FM D) none of the above
Last Answer : PM
Description : In_____ transmission, the frequency of the carrier signal is modulated to follow the changing voltage level (amplitude)of the modulating signal. The peak amplitude and phase of the carrier signal remainconstant,but as ... of thecarrier changes correspondingly. A) AM B) PM C) FM D) none of the above
Last Answer : FM
Description : A 400 W carrier is amplitude modulated to a depth of 75%.Calculate the total power in AM wave. (i) Explain the types of noise in a communication system. (ii) Compare simplex and duplex mode of communication.
Last Answer : (i) Noise: Noise is any spurious or undesired disturbances that mask the received signal in a communication system. a) Atmospheric Noise: Atmospheric Noise is also known as static noise which is the ... remote control ExamplesWalkytalky,telephone,mobile,Radar, FAX,Pager 4
Description : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly
Last Answer : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly 4 Ghz
Description : Inan HFC network, the upstream data are modulated using the _______ modulation technique. A) QAM B) QPSK C) PCM D) ASK
Last Answer : QPSK
Description : Inan HFC network, the downstream data are modulated using the _______ modulation technique. A) PSK B) QAM C) PCM D) ASK
Last Answer : QAM
Description : The _______ technique uses M different carrier frequencies that are modulated by the source signal. At one moment, the sign modulates one carrier frequency; at the next moment, thesignal modulates another carrier frequency. A) FDM B) DSSS C) FHSS D) TDM
Last Answer : FHSS
Description : In amplitude modulation AM, if modulation index is more than 100% then: (1) Power of the wave increases. (2) Efficiency of transmission increases. (3) The wave gets distorted. (4) Bandwidth increases
Last Answer : In amplitude modulation AM, if modulation index is more than 100% then: The wave gets distorted.
Description : Which of the following systems is not used in radio detection and ranging? A. Frequency shift B. Frequency modulation C. Pulse radar D. Amplitude modulation
Last Answer : D. Amplitude modulation
Description : Used for time division multiplexing. A. Frequency modulation B. Pulsed modulation C. SSB D. Amplitude modulation
Last Answer : B. Pulsed modulation
Description : ECE Board Exam March 1996 One type of pulse communications system uses pulse that appear as a group, and which vary in number according to the loudness of the voice. This type of ... A. pulse duration modulation B. pulse amplitude modulation C. pulse code modulation D. pulse position modulation
Last Answer : A. pulse duration modulation
Description : Variation in amplitude or frequency of carrier wave is called A. amplitude modulation B. frequency modulation C. modulation D. bandwidth
Last Answer : modulation
Description : What is the term used to describe a spread spectrum communications system where the center frequency if a conventional carrier is altered many time per second in accordance with a pseudo ... hopping B. Direct sequence C. Time-domain frequency modulation D. Frequency compandored spread spectrum
Last Answer : A. Frequency hopping
Description : What is meant by the term deviation ratio? A. The ratio of the carrier center frequency to the audio modulating frequency B. The ratio of the highest audio modulating frequency to the ... audio modulation frequency D. The ratio of the audio modulating frequency to the center carrier frequency
Last Answer : C. The ratio of the maximum carrier frequency deviation to the highest audio modulation frequency
Description : It is an average power of a radio transmitter supplied to the antenna transmission line taken during a long sufficient interval of time and compared with the lowest frequency encountered in the modulation ... operating conditions. A. Carrier power B. Rated power C. Mean power D. Peak envelop power
Last Answer : C. Mean power
Description : Average power of a radio transmitter supplied to the antenna transmission line by a transmitter during one radio frequency cycle taken under the condition of no modulation. A. Peak envelop power B. Rated power C. Carrier power D. Mean power
Last Answer : C. Carrier power