Description : A sewer pipe contains 1 mm sand particles of specific gravity 2.65 and 5 mm organic particles of specific gravity 1.2, the minimum velocity required for removing the sewerage, is A. 0.30 m/sec B. 0.35 m/sec C. 0.40 m/sec D. 0.45 m/sec
Last Answer : ANS: D
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above
Description : Maximum permissible velocity 1.5 m/sec, is adopted in drains A. With beds of rocks and gravels B. Lined with stones C. Both A. and B. D. Neither A. nor B.
Last Answer : ANS: C
Description : If is the rugosity coefficient, is the bed slope of sewer, the velocity of flow in m/sec may be obtained by the formula V = (1/n) r2/3 s1/2 evolved by A. Chezy B. Manning C. Bazin D. Kutter
Last Answer : ANS: B
Description : To prevent settling down of sewage both at the bottom and on the sides of a large sewer, self-cleaning velocity recommended for Indian conditions, is A. 0.50 m/sec B. 0.60 m/sec C. 0.70 m/sec D. 0.75 m/sec
Description : Assertion A.: The minimum self cleansing velocity in the sewer, at least once a day, must be generated. Reason (R): If certain deposition takes place and is not removed, it obstructs free flow and causes further ... correct explanation of A C. A is true but R is false D. A is false but R is true
Last Answer : ANS: A
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : Sewer pipes need be checked for A. Minimum flow B. Maximum flow C. Both A. and B. D. None of these
Description : The width of a rectangular sewer is twice its depth while discharging 1.5 m/sec. The width of the sewer is A. 0.68 m B. 0.88 m C. 1.36 m D. 1.76 m
Description : You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at A. Full depth B. Half full C. Two third full D. Three fourth full
Description : For sewer mains of 0.5 to 1 m diameter, the ratio of maximum daily sewage flow to the average daily sewage flow is assumed A. 1.5 B. 2.0 C. 2.5 D. 3.0
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Description : The flow velocity in detritus tanks is A. 0.05 m/sec B. 0.09 m/sec C. 1.25 m/sec D. None of these
Description : In detritus tanks, A. Flow velocity is kept 0.09 m/sec B. Detention period is kept 3 to 4 minutes C. Organic and inorganic materials are separated D. All the above
Description : In a grit chamber of a sewage treatment plant, A. Flow velocity 0.15 m to 0.3 m/sec is kept B. Depth of 0.9 m to 1.20 m is kept C. One minute of detention period is kept D. All the above
Description : For a grit chamber, if the recommended velocity of flow is 0.2 m/sec and detention period is 2 minutes, the length of the tank, is A. 16 m B. 20 m C. 24 m D. 30 m
Description : In sewers the velocity of flow should not be A. More than the self-cleansing velocity B. Less than the self-cleansing velocity C. Less than 10 m/sec D. More than 20 m/sec
Description : The gradient of sewers depends upon A. Velocity of flow B. Diameter of the sewer C. Discharge D. All the above
Description : In Chezy’s formula V = C rs for calculating the velocity of flow in circular sewer of diameter running full, the value of hydraulic mean radius is A. D B. D /2 C. D/3 D. D/4
Description : Pick up the correct statement from the following: A. The water supply pipes carry pure water free from solid particles B. The water supply pipes get clogged if flow velocity is less than self ... carried up and down the hills and valleys D. The sewer pipes are generally laid along level hills
Description : With self cleansing velocity in sewers A. Silting occurs at bottom B. Scouring occurs at bottom C. Both silting and scouring occur at bottom D. Neither silting nor scouring occurs at bottom
Description : In sewers designed with self cleansing velocity, A. The bottom is silted B. The bottom is scoured C. Both silting and scouring occur at the bottom D. Neither silting nor scouring occurs at the bottom
Description : If the depth of partial flow in a sewer of diameter 2 m, is 50 cm, its wetted perimeter is A. B. /2 C. /3 D. 2 /3
Description : Cement concrete sewers are only suitable if non-scouring velocity is between A. 2.5 to 3.0 m/sec B. 3.0 to 4.0 m/sec C. 3.5 to 4.5 m/sec D. 4.5 to 5.5 m/sec
Description : The settling velocity of the particles larger than 0.06 mm in a settling tank of depth 2.4 is 0.33 m per sec. The detention period recommended for the tank, is A. 30 minutes B. 1 hour C. 1 hour and 30 minutes D. 2 hours
Description : For a continuous flow type of sedimentation tanks A. Width of the tank is normally kept about 6 m B. Length of the tank is normally kept 4 to 5 times the width C. Maximum horizontal flow velocity is limited to 0.3 m/minute D. All the above
Description : Pick up the correct statement from the following: A. Maximum daily flow = 2 times the average daily flow B. Maximum daily flow = average daily flow C. Sewers are designed for minimum permissible velocity at minimum flow D. All the above
Description : 221 For non-scouring velocity 5 m/sec, the type of sewers generally preferred to, is A. Cast iron sewers B. Cement concrete sewers C. Glazed bricks sewers D. Stone ware sewers
Description : Pick up the correct statement from the following: A. The boning rod is used for checking the levels of the sewer inverts B. Manhole covers are made circular for the convenience of the cleaning staff C. A manhole is classified as shallow manhole if its depth is less than 0.9 m D. All the above
Description : If the diameter of a sewer is 100 mm, the gradient required for generating self cleansing velocity is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : If the diameter of sewer is 225 mm, the gradient required for generating self cleansing velocity, is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : Pick up the correct statement from the following: A. The larger the sewer in size, more will be velocity B. The smaller the sewer in size, less will be velocity C. The larger the sewer in size, no deposition will take place D. The larger the sewer in size, deposition will take place
Description : If the diameter of a sewer is 150 mm, the gradient required for generating self cleansing velocity, is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : The spacing of man holes along a straight portion of a sewer is 300 m, the diameter of the sewer may be A. 0.9 cm B. 1.2 m C. 1.5 m D. > 1.5 m
Description : If the discharge of a sewer running half is 628 1.p.s., i = 0.001, and n = 0.010, the diameter of the sewer, is A. 1.39 m B. 1.49 m C. 1.59 m D. 1.69 m
Description : The minimum diameter of sewer to be adopted is A. 10 cm B. 12.5 cm C. 15 cm D. 25 cm
Description : The minimum diameter of a sewer is kept A. 10 cm B. 15 cm C. 20 cm D. 25 cm
Description : If the depth of flow in a circular sewer is 1/4th of its diameter D, the wetted perimeter is A. /2 B. /4 C. /3 D. D
Description : The angle subtended by the surface of sewer water with partial flow, at sewer centre is 120°, the depth of sewerage is A. 20 cm B. 25 cm C. 40 cm D. 50 cm
Description : Dry water flow in a combined sewer, is A. Industrial sewage B. Domestic sewage C. Storm water D. Inclusive of domestic and industrial sewage but excludes storm water
Description : Pick up the incorrect statement from the following for allowing workers to enter sewers A. The particular manhole and one manhole on upstream and one manhole on downstream should remain open for 30 ... entering the manhole should be advised to smoke in the sewer D. Warning signals should be erected
Description : Pick up the correct statement from the following: A. Hydrogen sulphide gas in excess, may cause corrosion of concrete sewers B. 4 ppm of Dissolved Oxygen (D.O.) is ensured before discharging the treated ... river C. Solubility of oxygen in sewage is 95% of that of distilled water D. All the above
Description : The settlement velocity of a solid (diameter 0.5 mm, specific gravity 1.75) in water having temperature 10°C, is A. 213.5 cm/sec B. 313.5 cm/sec C. 413.5 cm/sec D. 500 cm/sec
Description : The self-cleansing velocity of water flowing through pipe lines, is A. 2 metres/sec B. 1 metre/sec C. 0.5 metre/sec D. 0.25 metre/sec
Description : Facultative bacteria survive in A. The presence of oxygen B. The absence of oxygen C. Both cases A. and B. D. Neither A. nor B.
Description : The use of coarse screens for the disposal of sewage, may be dispensed with by A. Comminutor B. Shredder C. Both A. and B. D. Neither A. nor B.
Description : In a trickling filter A. Filtration process is used B. Biological action is used C. Neither A. nor B. D. Both A. and B.
Description : The grit and silt of the grit chambers, may not be used for A. Raising low lying areas by dumping B. Concreting C. Both A. and B. D. Neither A. nor B.
Description : For laying a sewer line in a trench of 2 m width, an offset line is marked on the ground parallel to the given centre line at a distance of A. 100 cm B. 120 cm C. 140 cm D. 160 cm
Description : Ventilating shafts are provided to a sewer line at every A. 100 m B. 150 m C. 200 m D. 300 m