Description : The dimensions of a rectangular settling tank are: length 24 m, width 6 m and depth 3 m. If 2 hour detention period for tanks is recommended, the rate of flow of sewage per hour, is A. 204 cu.m B. 208 cu.m C. 212 cu.m D. 216 cu.m
Last Answer : ANS: D
Description : For a grit chamber, if the recommended velocity of flow is 0.2 m/sec and detention period is 2 minutes, the length of the tank, is A. 16 m B. 20 m C. 24 m D. 30 m
Last Answer : ANS: C
Description : The width of a settling tank with 2 hour detention period for treating sewage 378 cu m per hour, is A. 5 m B. 5.5 m C. 6.5 m D. 7 m
Description : In a grit chamber of a sewage treatment plant, A. Flow velocity 0.15 m to 0.3 m/sec is kept B. Depth of 0.9 m to 1.20 m is kept C. One minute of detention period is kept D. All the above
Description : In detritus tanks, A. Flow velocity is kept 0.09 m/sec B. Detention period is kept 3 to 4 minutes C. Organic and inorganic materials are separated D. All the above
Description : To prevent settling down of sewage both at the bottom and on the sides of a large sewer, self-cleaning velocity recommended for Indian conditions, is A. 0.50 m/sec B. 0.60 m/sec C. 0.70 m/sec D. 0.75 m/sec
Description : The detention time of a circular tank of diameter d and water depth H, for receiving the sewage Q per hour, is A. d² (0.011d + 0.785H)/Q B. d (0.022d + 0.085H)/Q C. d (0.785d + 0.011H)/Q D. d (0.285d + 0.011H)/Q
Last Answer : ANS: A
Description : In case of Imhoff tanks, A. The shape is rectangular B. Detention period is 2 hours C. The velocity of flow is restricted to 0.30 m/minute D. All the above
Description : A sewer pipe contains 1 mm sand particles of specific gravity 2.65 and 5 mm organic particles of specific gravity 1.2, the minimum velocity required for removing the sewerage, is A. 0.30 m/sec B. 0.35 m/sec C. 0.40 m/sec D. 0.45 m/sec
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Description : The detention time (t) of a settling tank, may be defined as the time required for A. A particle to travel along its length B. A particle to travel from top surface to bottom sludge zone C. The flow of sewage to fill the tank D. None of these
Description : The recommended detention period for grit chambers is A. 1 minute B. 2 minutes C. 3 minutes D. 5 minutes
Description : In a sedimentation tank (length L, width B, depth D) the settling velocity of a particle for a discharge Q, is A. Q/(B × D) B. Q/(L × D) C. Q/L D. Q/(B × L)
Description : The settling velocity of a spherical particle of diameter less than 0.1 mm as per Stock’s law, is A. Vs = 418 (Gs – Gw) d [(3T + 70)/100] B. Vs = 418 (Gs – Gw)d² [(3T + 70)/100] C. Vs = 218 (Gs – Gw)d² [(3T + 70)/100] D. Vs = 218 (Gs – Gw)d [(3T + 70)/100]
Last Answer : ANS: B
Description : Pick up the incorrect statement from the following: A. Septic tanks are horizontal continuous flow type of sedimentation tanks B. Septic tanks are generally provided a detention period of 12 to 36 hours C ... covered and high vent shafts are provided for the escape of foul gases D. None of these
Description : The detention period for plain sedimentation water tanks, is usually A. 4 to 8 hours B. 8 to 16 hours C. 16 to 24 hours D. 24 to 36 hours
Description : The settlement velocity of a solid (diameter 0.5 mm, specific gravity 1.75) in water having temperature 10°C, is A. 213.5 cm/sec B. 313.5 cm/sec C. 413.5 cm/sec D. 500 cm/sec
Description : Hazen’s formula VS = 418 (GS – Gw)d [(3T + 70)/100] is used for the settlement velocity of the particles of diameter A. Less than 0.01 mm B. Less than 0.05 mm C. Less than 0.1 mm D. Greater than 0.1 mm
Description : The width of a rectangular sewer is twice its depth while discharging 1.5 m/sec. The width of the sewer is A. 0.68 m B. 0.88 m C. 1.36 m D. 1.76 m
Description : Detention period of a settling tank is (A) Average theoretical time required for water to flow through the tank (B) Time required for flow of water to fill the tank fully (C) Average time for which water is retained in tank (D) All the above
Last Answer : (D) All the above
Description : The efficiency of sedimentation tank does not depend upon (A) Depth of tank (B) Length of tank (C) Detention period (D) Velocity of water
Last Answer : (D) Velocity of water
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : The flow velocity in detritus tanks is A. 0.05 m/sec B. 0.09 m/sec C. 1.25 m/sec D. None of these
Description : Cement concrete sewers are only suitable if non-scouring velocity is between A. 2.5 to 3.0 m/sec B. 3.0 to 4.0 m/sec C. 3.5 to 4.5 m/sec D. 4.5 to 5.5 m/sec
Description : For efficient working of a sewer, it must be ensured that A. Minimum velocity of 0.45 m/sec, is maintained at its minimum flow B. A maximum velocity of 0.90 m/sec, is maintained at its maximum flow C. Both A. and B. D. Neither A. nor B.
Description : The detention period in a septic tank is assumed (A) 20 minutes (B) 25 minutes (C) 30 minutes (D) 40 minute
Last Answer : (C) 30 minutes
Description : In sewers the velocity of flow should not be A. More than the self-cleansing velocity B. Less than the self-cleansing velocity C. Less than 10 m/sec D. More than 20 m/sec
Description : For a continuous flow type of sedimentation tanks A. Width of the tank is normally kept about 6 m B. Length of the tank is normally kept 4 to 5 times the width C. Maximum horizontal flow velocity is limited to 0.3 m/minute D. All the above
Description : If is the rugosity coefficient, is the bed slope of sewer, the velocity of flow in m/sec may be obtained by the formula V = (1/n) r2/3 s1/2 evolved by A. Chezy B. Manning C. Bazin D. Kutter
Description : 221 For non-scouring velocity 5 m/sec, the type of sewers generally preferred to, is A. Cast iron sewers B. Cement concrete sewers C. Glazed bricks sewers D. Stone ware sewers
Description : Maximum permissible velocity 1.5 m/sec, is adopted in drains A. With beds of rocks and gravels B. Lined with stones C. Both A. and B. D. Neither A. nor B.
Description : Pick up the correct statement from the following: (A) Detention period for plain sedimentation tanks ranges between 4 to 8 hours (B) Detention period for sedimentation tanks, using coagulants usually ... in sedimentation tanks, is generally limited to 0.3 m/minute (D) All the above
Description : The discharge per unit plan area of a sedimentation tank, is generally called A. Over flow rate B. Surface loading C. Over flow velocity D. All the above
Description : A cylindrical ejector having its height 2 m fills after every 10 minutes with a peak sewage discharge of 0.0157 cumec. The diameter of the ejector chamber, is A. 2.30 m B. 2.40 m C. 2.45 m D. 2.50 m
Description : The self-cleansing velocity of water flowing through pipe lines, is A. 2 metres/sec B. 1 metre/sec C. 0.5 metre/sec D. 0.25 metre/sec
Description : A stone is dropped into a deep shaft without any initial velocity. The sound of the stone hitting the bottom is heard after 4 seconds. If the velocity of sound is 330 m/sec the depth of the shaft will be a.33.1 m b.660 m c.165 m d.66.2 m e.330 m
Last Answer : d. 66.2 m
Description : If L, B and D length, breadth and depth of water in a rectangular sedimentation tank of total discharge Q, the settling velocity, is (A) Q/H (B) Q/D (C) Q/(D × B) (D) Q/(L × B)
Last Answer : (D) Q/(L × B)
Description : Which one of the following statements regarding septic tanks is wrong? A. A gap of 7.5 cm between the bottom of the covering slab and the top level of scum is provided B. The outlet invert level is kept ... . The minimum width of septic level is 90 cm D. The depth of tank is kept equal to its width
Description : In a sedimentation tank, the detention period for water ranges from __________ hours. (A) 2 to 4 (B) 8 to 12 (C) 16 to 20 (D) 24 to 32
Last Answer : (A) 2 to 4
Description : Pick up the correct statement from the following: A. The larger the sewer in size, more will be velocity B. The smaller the sewer in size, less will be velocity C. The larger the sewer in size, no deposition will take place D. The larger the sewer in size, deposition will take place
Description : Pick up the correct statement from the following: A. The water supply pipes carry pure water free from solid particles B. The water supply pipes get clogged if flow velocity is less than self ... carried up and down the hills and valleys D. The sewer pipes are generally laid along level hills
Description : The ratio of design discharge to the surface area of a sedimentation tank is called A. Surface loading B. Overflow rate C. Overflow velocity D. All of these
Description : The settlement of a particle in sedimentation tank, is affected by A. Velocity of flow B. Viscosity of water C. Size and shape of solid D. All the above
Description : Pick up the correct statement from the following: A. The boning rod is used for checking the levels of the sewer inverts B. Manhole covers are made circular for the convenience of the cleaning staff C. A manhole is classified as shallow manhole if its depth is less than 0.9 m D. All the above
Description : Assertion A.: A free board of 0.3 m is provided above the top sewage line in septic tanks. Reason (R): It helps to accommodate the scum in the septic tank. A. Both A and R is true and R is the correct ... is not a correct explanation of A C. A is true but R is false D. A is false but R is true
Description : The drainage area of a town is 12 hectares. Its 40% area is hard pavement ( K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration ... 60) the maximum run off is A. 0.10 cumec B. 0.12 cumec C. 0.15 cumec D. 0.20 cumec
Description : If the diameter of a sewer is 100 mm, the gradient required for generating self cleansing velocity is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : If the diameter of sewer is 225 mm, the gradient required for generating self cleansing velocity, is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : If the diameter of a sewer is 150 mm, the gradient required for generating self cleansing velocity, is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these