Description : For efficient working of a sewer, it must be ensured that A. Minimum velocity of 0.45 m/sec, is maintained at its minimum flow B. A maximum velocity of 0.90 m/sec, is maintained at its maximum flow C. Both A. and B. D. Neither A. nor B.
Last Answer : ANS: C
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above
Last Answer : ANS: D
Description : With self cleansing velocity in sewers A. Silting occurs at bottom B. Scouring occurs at bottom C. Both silting and scouring occur at bottom D. Neither silting nor scouring occurs at bottom
Description : In sewers designed with self cleansing velocity, A. The bottom is silted B. The bottom is scoured C. Both silting and scouring occur at the bottom D. Neither silting nor scouring occurs at the bottom
Description : To prevent settling down of sewage both at the bottom and on the sides of a large sewer, self-cleaning velocity recommended for Indian conditions, is A. 0.50 m/sec B. 0.60 m/sec C. 0.70 m/sec D. 0.75 m/sec
Description : Self-cleansing velocity is A. Velocity at dry weather flow B. Velocity of water at flushing C. Velocity at which no accumulation remains in the drains D. Velocity of water in a pressure filter
Description : Pick up the correct statement from the following: A. Maximum daily flow = 2 times the average daily flow B. Maximum daily flow = average daily flow C. Sewers are designed for minimum permissible velocity at minimum flow D. All the above
Description : 221 For non-scouring velocity 5 m/sec, the type of sewers generally preferred to, is A. Cast iron sewers B. Cement concrete sewers C. Glazed bricks sewers D. Stone ware sewers
Description : A sewer pipe contains 1 mm sand particles of specific gravity 2.65 and 5 mm organic particles of specific gravity 1.2, the minimum velocity required for removing the sewerage, is A. 0.30 m/sec B. 0.35 m/sec C. 0.40 m/sec D. 0.45 m/sec
Description : Cement concrete sewers are only suitable if non-scouring velocity is between A. 2.5 to 3.0 m/sec B. 3.0 to 4.0 m/sec C. 3.5 to 4.5 m/sec D. 4.5 to 5.5 m/sec
Last Answer : ANS: A
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Description : If is the rugosity coefficient, is the bed slope of sewer, the velocity of flow in m/sec may be obtained by the formula V = (1/n) r2/3 s1/2 evolved by A. Chezy B. Manning C. Bazin D. Kutter
Last Answer : ANS: B
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : The flow velocity in detritus tanks is A. 0.05 m/sec B. 0.09 m/sec C. 1.25 m/sec D. None of these
Description : In detritus tanks, A. Flow velocity is kept 0.09 m/sec B. Detention period is kept 3 to 4 minutes C. Organic and inorganic materials are separated D. All the above
Description : In a grit chamber of a sewage treatment plant, A. Flow velocity 0.15 m to 0.3 m/sec is kept B. Depth of 0.9 m to 1.20 m is kept C. One minute of detention period is kept D. All the above
Description : In sewers the velocity of flow should not be A. More than the self-cleansing velocity B. Less than the self-cleansing velocity C. Less than 10 m/sec D. More than 20 m/sec
Description : For a grit chamber, if the recommended velocity of flow is 0.2 m/sec and detention period is 2 minutes, the length of the tank, is A. 16 m B. 20 m C. 24 m D. 30 m
Description : The settling velocity of the particles larger than 0.06 mm in a settling tank of depth 2.4 is 0.33 m per sec. The detention period recommended for the tank, is A. 30 minutes B. 1 hour C. 1 hour and 30 minutes D. 2 hours
Description : Drop manholes are the manholes A. Without entry ladders B. Without manhole covers C. With depths more than 3.5 m D. Having drains at different levels
Description : The maximum diameter of sewers adopted in the designs is A. 1.0 m B. 2.0 m C. 3.0 m D. 4.0 m
Description : Facultative bacteria survive in A. The presence of oxygen B. The absence of oxygen C. Both cases A. and B. D. Neither A. nor B.
Description : The use of coarse screens for the disposal of sewage, may be dispensed with by A. Comminutor B. Shredder C. Both A. and B. D. Neither A. nor B.
Description : In a trickling filter A. Filtration process is used B. Biological action is used C. Neither A. nor B. D. Both A. and B.
Description : The grit and silt of the grit chambers, may not be used for A. Raising low lying areas by dumping B. Concreting C. Both A. and B. D. Neither A. nor B.
Description : The settlement velocity of a solid (diameter 0.5 mm, specific gravity 1.75) in water having temperature 10°C, is A. 213.5 cm/sec B. 313.5 cm/sec C. 413.5 cm/sec D. 500 cm/sec
Description : The self-cleansing velocity of water flowing through pipe lines, is A. 2 metres/sec B. 1 metre/sec C. 0.5 metre/sec D. 0.25 metre/sec
Description : 15 cumecs, the depth d and width are related by For drains up to A. d = 0.2 B B. d = 0.5 B C. B = 0.2 d D. B = 0.5 d
Description : For a continuous flow type of sedimentation tanks A. Width of the tank is normally kept about 6 m B. Length of the tank is normally kept 4 to 5 times the width C. Maximum horizontal flow velocity is limited to 0.3 m/minute D. All the above
Description : The width of a rectangular sewer is twice its depth while discharging 1.5 m/sec. The width of the sewer is A. 0.68 m B. 0.88 m C. 1.36 m D. 1.76 m
Description : A stone is thrown up from the foot of tower 50 m high with a velocity of 25 m/sec and at the same time another stone is dropped from the top of tower, the two stones will cross each other after a.3 sec b.5 sec c.4 sec d.4.5 sec e.2 sec
Last Answer : e. 2 sec
Description : The minimum diameter of sewer to be adopted is A. 10 cm B. 12.5 cm C. 15 cm D. 25 cm
Description : In case of Imhoff tanks, A. The shape is rectangular B. Detention period is 2 hours C. The velocity of flow is restricted to 0.30 m/minute D. All the above
Description : In olden days the type of section adopted in trunk and out fall sewers was A. Parabolic shaped B. Horse shoe shaped C. Egg shaped D. Circular shaped
Description : Q No: 191 Design period of 40 to 50 years is adopted for A. Branch sewers B. Main sewers C. Trunk sewers D. All the above
Description : In areas where light rains are uniformly distributed throughout the year, the type of sewerage system to be adopted is A. Separate system B. Combined system C. Partially combined system D. None of these
Description : For sewer mains of 0.5 to 1 m diameter, the ratio of maximum daily sewage flow to the average daily sewage flow is assumed A. 1.5 B. 2.0 C. 2.5 D. 3.0
Description : The ratio of maximum sewage flow to average sewage flow for trunk mains having diameters more than 1.25 m, is A. 1.5 B. 2.0 C. 3.0 D. 4.0
Description : For trunk sewers more than 1.25 m in diameter, the ratio of the maximum daily sewage flow to the average daily sewage flow is assumed A. 1.5 B. 2.0 C. 2.5 D. 3.0
Description : The maximum depth of sedimentation tanks, is kept A. 3 m B. 3.5 m C. 4 m D. 4.5 m
Description : The ratio of maximum sewage flow to average sewage flow for mains up to 1 m in diameter, is A. 1.5 B. 2.0 C. 3.0 D. 4.0
Description : You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at A. Full depth B. Half full C. Two third full D. Three fourth full
Description : The maximum spacing of manholes specified by Indian standard in sewers upto 0.3 m diameter is A. 20 m B. 30 m C. 45 m D. 75 m
Description : For large sewers, maximum distance between manholes may be A. 50 m B. 100 m C. 200 m D. 300 m
Description : Assertion A.: The minimum self cleansing velocity in the sewer, at least once a day, must be generated. Reason (R): If certain deposition takes place and is not removed, it obstructs free flow and causes further ... correct explanation of A C. A is true but R is false D. A is false but R is true
Description : Hydraulic mean depth (Dm) for a circular pipe of diameter 'D' flowing full is 0.25 D. For a circular channel, at Dm = 0.3 D, gives the condition for the maximum (A) Flow rate (B) Mean velocity (C) Both 'a' & 'b' (D) Neither 'a' nor 'b
Last Answer : (B) Mean velocity
Description : Consider the following statements: 1. A flute of smaller length produces waves of lower frequency. 2. Sound travels in rocks in the form of longitudinal elastic waves only. Which of the statements given above is/are correct? (a) 1 only (b) 2 only (c) Both 1 and 2 (d) Neither 1 nor 2
Last Answer : Ans:(d)
Description : If the diameter of a sewer is 100 mm, the gradient required for generating self cleansing velocity is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : The gradient of sewers depends upon A. Velocity of flow B. Diameter of the sewer C. Discharge D. All the above
Description : The ratio of design discharge to the surface area of a sedimentation tank is called A. Surface loading B. Overflow rate C. Overflow velocity D. All of these