Why is it useful to write a ratio of a fraction as a unit rate?

1 Answer

Answer :

For people who are not familiar with fractions it is easier tocompare them in the form of unit rates.

Related questions

Description : How do I write 23 over 138 as a unit fraction?

Last Answer : 23/138 is equivalent to 1/6 in its simplest form

Description : How do I write 13 over 43 as a unit fraction?

Last Answer : 13/43 is in its simplest form as a fraction

Description : How do you write the ratio as a fraction in simplest form?

Last Answer : Divide the numerator and denominator of the fraction by theirgreatest common factor.

Description : Pick out the wrong statement pertaining to the roll crushers. (A) Maximum feed size determines the required roll diameter (B) For hard material's crushing, the reduction ratio should not ... ratio and differential roll speed affect production rate & energy consumed per unit of surface produced

Last Answer : (C) Both the rolls run necessarily at the same speed

Description : A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co￾efficient for air will vary in the ratio of (A) 2 (B) 2 0.8 (C) 2 0.2 (D) 2 0.5

Last Answer : (B) 2 0.8

Description : What is indicated by gradual blackening at the ends of component 'C' shown in the illustration? EL-0081 A. The unit is in danger of exploding. B. The tube is nearing the end of its useful life. C. The circuit voltage is too high. D. The circuit current is too high.

Last Answer : Answer: B

Description : It is useful to refer to an isotropic radiator. A. when comparing the gains of directional antennas B. when testing a transmission line for standing wave ratio C. when (in the northern hemisphere) directing the transmission D. when using a dummy load to tune a transmitter

Last Answer : A. when comparing the gains of directional antennas

Description : When is it useful to refer to an isotropic radiator? A. When comparing the gains of directional antennas B. When testing a transmission line for standing wave ratio C. When (in the northern ... ) directing the transmission in a southerly direction D. When using a dummy load to tune a transmitter

Last Answer : A. When comparing the gains of directional antennas

Description : Rod mills employed for grinding (A) Employ a steel shell having L/D ratio of 1.5 to 3.0 (B) Is useful for handling sticky materials (C) Employ steel rods of 2-12 cms diameter extending over full length of the mill (D) All 'a', 'b' & 'c'

Last Answer : (D) All 'a', 'b' & 'c'

Description : Trade between two countries can be useful if cost ratio of goods are A. Equal B. Different C. Undetermined D. Zero

Last Answer : Different

Description : The co-efficient of performance (COP) of a refrigerating system, which is its index of performance, is defined as the ratio of useful refrigeration to the net work. The units of __________ and COP are the same. (A) Kinematic viscosity (B) Work (C) Temperature (D) None of these

Last Answer : (D) None of these

Description : What is the ratio of the useful heat extracted to heating value?  A. Combustion efficiency  B. Phase efficiency  C. Heat efficiency  D. Work efficiency

Last Answer : Combustion efficiency

Description : Many sophisticated techniques or tolls are useful in decision-making. Which of the following is a tool that helps managers figure out how much to produce and points out the relationship between revenues, ... Marginal analysis ; (b) Breakeven analysis ; (c) Ratio analysis ; (d) Financial analysis

Last Answer : (b) Breakeven analysis ;