The resistance of a bulb filmanet is `100Omega` at a temperature of `100^@C`. If its temperature coefficient of resistance be 0.005 per `.^@C`, its re

1 Answer

Answer :

The resistance of a bulb filmanet is `100Omega` at a temperature of `100^@C`. If its temperature coefficient of ... . `200^(@)C` D. `400^(@)C`

Related questions

Description : An `L-C-R` series circuit with `100Omega` resistance is connected to an `AC` source of `200V` and angular frequency `300rad//s`. When only the capacit

Last Answer : An `L-C-R` series circuit with `100Omega` resistance is connected to an `AC` source of `200V` and ... and the power dissipated in the `L-C-R` circuit

Description : Pick up the incorrect statement from the following: (A) While measuring a distance with a tape of length 100.005 m, the distance to be increasing by 0.005 m for each tape length (B) An increase in ... ) A 100 m tape of cross section 10 mm 0.25 mm stretches about 10 mm under 5 kg pull

Last Answer : (B) An increase in temperature causes a tape to increase in length and the measured distance is too large

Description : The temperature coefficient of copper is `0.004^(@)C^(-1)`. Find the resistance of a 5 m long copper wire of diameter 0.2 mm at `100^(@)C`, if the res

Last Answer : The temperature coefficient of copper is `0.004^(@)C^(-1)`. Find the resistance of a 5 m long copper wire of ... `0^(@)C` is `1.7xx10^(-8) Omega` m.

Description : As shown in the illustration if the applied voltage is 12 VDC, the resistance of R1 is 24 kohms, and R2 is 3610 ohms what is the current flowing through R1? EL-0036 A. .434 milliamps B. .005 amp C. 6.00 amps D. 2.4 milliamps

Last Answer : Answer: A

Description : The fractional change in resistance per kelvin is known as, a. temperature coefficient of resistance b. coefficient of Voltage of charge c. thermal expansion d. all of above

Last Answer : a. temperature coefficient of resistance

Description : A simply supported beam deflects by 5 mm when it is subjected to a concentrated load of 10 kN at its centre. What will be deflection in a 1/10 model of the beam if the model is subjected to a 1 kN load at its centre? (A) 5 mm (B) 0.5 mm (C) 0.05 mm (D) 0.005 mm

Last Answer : (A) 5 mm

Description : Convert each of the following decimals into a percentage: (i) 0.6 (ii) 0.42 (iii) 0.07 (iv) 0.005 -Maths

Last Answer : answer:

Description : Gold numbers of some colloids are : Gelatin : 0.005 - 0.01 , Gum Arabic : 0.15 - 0.25, Oleate : 0.04 - 1.0, Starch : 15 - 25. Which among these is a b

Last Answer : Gold numbers of some colloids are : Gelatin : 0.005 - 0.01 , Gum Arabic : 0.15 - 0.25, Oleate ... ? A. Gelatin B. Starch C. Gum Arabic D. Oleate

Description : Gold numbers of protective colloids A, B, C and D are `0.50, 0.01, 0.10` and `0.005` respectively. The correct order of their protective powers is

Last Answer : Gold numbers of protective colloids A, B, C and D are `0.50, 0.01, 0.10` and `0.005` respectively. The correct ... lt A lt C` D. `D lt A lt C lt B`

Description : A string of linear mass density 0.005 kg/m is stretched by a force F=2t^2 N

Last Answer : A string of linear mass density 0.005 kg/m is stretched by a force F=2t^2 N ( t is in sec) as shown in figure. ... 24.5 m/s C) 32 m/s D) 40 m/s

Description : How are the values of the 5s in each number related 5.005 0.355?

Last Answer : In the first expression the value is 91 times as large as it isin the second.

Description : What is 0.005 as a lowest term fraction?

Last Answer : 0.005 = 5/1,000 = 1/200

Description : What numbers are from Least to greatest 8.200 ML 0.005 KL 8.1 L?

Last Answer : 0.005KL, 8.1 L, 8.200 ML (ML = megalitres).

Description : What numbers are from Least to greatest 8.200 ML 0.005 KL 8.1 L?

Last Answer : 0.005KL, 8.1 L, 8.200 ML (ML = megalitres).

Description : Least audible sound for most of the human ear is – (1) 10.0 μ bar (2) 0.0002 μ bar (3) 0.005 μ bar (4) 5.0 μ bar

Last Answer : (2) 0.0002 μ bar Explanation: Least audible sound for most of the human ear is 2 x 10-5 pascal. The generally accepted standard range of audible frequencies is 20 to 20,000 Hz.

Description : In measuring critical speed of shaft experiment, it was found that the frequency ratio is 0.707 when the eccentricity is 0.05 m. what will be the displacement of the system. A. 0.05 m B. 0.005 m C. 0.5 m D. Infinite

Last Answer : A. 0.05 m

Description : A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so  that the maximum bending stress is 75 N/mm². If the slope at the ends is 0.005 radian and the  value of E = 0.2 ... joist, is  (A) 200 mm  (B) 250 mm  (C) 300 mm  (D) 400 mm 

Last Answer : (D) 400 mm 

Description : The ultimate failure is assumed to be reached when the section reaches a uniform compression strain of [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.005

Last Answer : [ A ] 0.002

Description : The pH of a 0.005 molar solution of calcium hydroxide is:

Last Answer : ANSWER: 12

Description : Least audible sound for most of the human ear is : (1) 10.0 µ bar (2) 0.0002 µ bar (3) 0.005 µ bar (4) 5.0 µ bar

Last Answer : 0.0002 µ bar

Description : The temperature coefficient of a resistance wire is `0.00 12.5^(@)C^(-1)`. At 300 K, its resistance is `1 Omega`. At what temperature the resistance o

Last Answer : The temperature coefficient of a resistance wire is `0.00 12.5^(@)C^(-1)`. At 300 K, its ... the resistance of the wire will be `2 Omega` ?

Description : The temperature coefficient of resistance of the material of a wire is `0.00125^(@)C^(-1)`. Its resistance at `27^(@)C` is `1 Omega`. At what temperat

Last Answer : The temperature coefficient of resistance of the material of a wire is `0.00125^(@)C^(-1)`. Its resistance at ... K B. 1100 K C. 1400 K D. 1127 K

Description : A filament bulb `(500 W, 100 V)` is to be used in a `230 V` main supply. When a resistance `R` is connected in series, it works perfectly and the bulb

Last Answer : A filament bulb `(500 W, 100 V)` is to be used in a `230 V` main supply. When a resistance `R` is ... Omega` B. `46 Omega` C. `26Omega` D. `13 Omega`

Description : Is the filament resistance lower or higher in a 500 watt light bulb than in a 100 watt light? Assume that both bulbs have been designed to operate at 110 volts. 

Last Answer : ANSWER: LOWER

Description : The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity. (A) 0 (B) 100 (C) 50 (D) None of these

Last Answer : Option B

Description : An electric bulb of 100 W is used for 8 h per day. Calculate the 'units' of energy consumed in one day by the bulb? -Physics 9th

Last Answer : Given : t=6 hrs P=0.06 kW Thus energy consumed per day is: E=Pt=0.06×6=0.36 kWh=0.36 units

Description : A 100-watt light bulb is left on for 10 hours. Electricity is 10 cents per kilowatt-hour. How much did it cost to operate the light bulb?

Last Answer : ANSWER: 10 CENTS

Description : What is 1.005 as a mixed number?

Last Answer : 1 and 1 over 200.

Description : Which is greater .050 or .005?

Last Answer : The 1st decimal number is the greater

Description : For a helical torsion sprig, the stress concentration factor at inner fibre is? Give spring index=5. a) 1.005 b) 1.175 c) 1.223 d) 1.545

Last Answer : b) 1.175

Description : The existing resistance of a conductor is dependent upon its length, cross-sectional area, _____________. A. temperature and insulation B. material and insulation C. resistive coefficient and material D. material and temperature

Last Answer : Answer: D

Description : Calculate Re-order level from the following: Consumption per week: 100-200 units Delivery period: 14-28 days (a) 5600 units (b) 800 units (c) 1400 units (d) 200 units

Last Answer : (b) 800 units

Description : Will the filament resistance of a bulb be higher at normal temperature or in incandescent condition ?

Last Answer : As the resistance increases with increasing temperature, the resistance of the filament of the bulb will be higher than the normal temperature.

Description : The temperature coefficient of resistance of an alloy used for making resistor is

Last Answer : The temperature coefficient of resistance of an alloy used for making resistor is A. small and ... C. large and positive D. large and negative

Description : When temperature rises, resistance of negative temperature coefficient thermistor A. increases B. decreases C. zero D. infinity

Last Answer : decreases

Description : Which temperature coefficient indicates a material whose resistance increases as temperature increases?

Last Answer : Positive.

Description : Define the temperature coefficient of resistance.

Last Answer : The amount of increase in the resistance of a 1-ohm sample of the conductor per degree of temperature rise above 0º C

Description : Semi-conductors have ________ temperature coefficient of resistance. (A) Negative (B) Positive (C) Both positive and negative (D) None of the above

Last Answer : (A) Negative

Description : Problem on temperature coefficient of resistance 3

Last Answer : Problem on temperature coefficient of resistance 3

Description : Problem on temperature coefficient of resistance 2

Last Answer : Problem on temperature coefficient of resistance 2

Description : Problem on temperature coefficient of resistance 1

Last Answer : Problem on temperature coefficient of resistance 1

Description : A semiconductor device made out of a material having very high temperature coefficient of resistance is

Last Answer : A semiconductor device made out of a material having very high temperature coefficient of resistance is Thermistor

Description : Which amongst the following has a negative coefficient of temperature for resistance?  a) Copper b) Lead c) Carbon d) Aluminium

Last Answer : Which amongst the following has a negative coefficient of temperature for resistance? Carbon 

Last Answer : The resistance temperature coefficient is defined as the ratio of increase in resistance per degree centigrade to the resistance at 0oC.

Last Answer : A metal resistor has resistance of 10 ohm at 0°C and 11 ohms at 160°C, the temperature coefficient is 0.000625 /°C.

Last Answer : A semiconductor has Negative temperature coefficient of resistance.

Description :  The metal having the lowest temperature coefficient of resistance is

Last Answer : The metal having the lowest temperature coefficient of resistance is gold.

Description : what is the temperature coefficient of Resistance of conductor ?

Last Answer : conductors have positive coefficient. means as the temperature increases resistance also increases.

Description : what is the temperature coefficient of Resistance of semiconductor ?

Last Answer : semiconductors have negative temperature coefficient of resistance. means as the temperature increases resistance decreases.

Description : Which one of the following is true to estimate the range of cooling tower? a) Range = cooling water inlet temperature - wet bulb temperature b) Range = cooling water outlet temperature - wet bulb temperature ... = heat load in kcal per hour / water circulation in lines per hour d) None of the above

Last Answer : Range = heat load in kcal per hour / water circulation in lines per hour