# In a series parallel circuit, any two resistances in the same current path must be in?

In a series parallel circuit, any two resistances in the same current path must be in?

In a series parallel circuit, any two resistances in the same current path must be in series with each other.

## Related questions

Description : The internal resistances of an ideal current source, and an ideal voltage source are, respectively, (A) 0, ∞ (B) ∞, ∞ (C) ∞, 0 (D) 0,0

Last Answer : The internal resistances of an ideal current source, and an ideal voltage source are, respectively, ∞, 0

Description : Which of the following statements concerning a simple parallel resistance circuit is correct? A. The voltage drop across each resistor is the same. B. The total current flow equals the reciprocal ... resistances. D. The total voltage equals the sum of the individual voltages across each resistance.

Description : Which is NOT a characteristic of a series circuit? w) The current is the same throughout. x) The total resistance is the sum of the individual resistance. y) The voltage of the source ... individual voltage drops. z) The total resistance is the sum of the reciprocals of the individual resistances.

Last Answer : ANSWER: Z -- THE TOTAL RESISTANCE IS THE SUM OF THE RECIPROCALS OF THE RECIPROCAL OF THE INDIVIDUAL RESISTANCES.

Description : Heat flux through several resistances in series in analogous to the current flowing through several (A) Resistances in parallel (B) Capacitors in series (C) Resistances in series (D) None of these

Last Answer : (C) Resistances in series

Description : In a series RLC circuit operating below the resonant frequency the current  (a) I leads Vs (b) I lags Vs (c) I is in Phase with Vs (d) None of these

Last Answer : In a series RLC circuit operating below the resonant frequency the current  I leads Vs

Description : In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

Last Answer : In a series RLC high Q circuit, the current peaks at a frequency equal to the resonant frequency

Description : You are given two resistances `R_(1)` and `R_(2)`. By using them singly, in series and in parallel, you can obtain four resistances of `1.5Omega, 2Ome

Last Answer : You are given two resistances `R_(1)` and `R_(2)`. By using them singly, in series and in parallel ... .5Omega` C. `3Omega,5Omega` D. `2Omega, 6Omega`

Description : If electric resistance is to be decreased, then the number of resistances should be connected in – (1) Series (2) Parallel (3) Mixed arrangement (4) None of these

Last Answer : (2) Parallel Explanation: Resistors are in parallel when each resistor is connected directly to the voltage source by connecting wires having riegligible resistance. Each resistor thus has the full voltage ... same full voltage of the source applied to it, but divide the total current amongst them

Description : If electric resistance is to be decreased, then the number of resistances should be connected in _______ (1) Series (2) Parallel (3) Mixed arrangement (4) None of these

Description : Series parallel resistances problem solution

Last Answer : Series parallel resistances problem solution

Description : If a circuit has resistances of 5, 10, and 20 ohms connected in parallel, what is the combined resistance of the circuit? A. 1.5 ohms B. 2.9 ohms C. 17.5 ohms D. 35.0 ohms

Description : The total resistance of a parallel circuit is always ____________. A. larger than that of the branch with the greatest resistance B. smaller than that of the branch with the lowest resistance C ... resistances D. equal to the sum of the individual branch resistances divided by the number of branches

Description : The total resistance of a parallel circuit is always ____________. A. larger than the greatest branch resistance B. smaller than the lowest branch resistance C. equal to the sum of the individual branch resistances D. one-half the sum of the individual branch resistances

Description : Current measuring instruments must always be connected in _____________. A. series with a circuit B. parallel with a circuit C. series-parallel with a circuit D. delta with the shunt

Description : In a series circuit with unequal resistances?

Last Answer : In a series circuit with unequal resistances the highest resistance has the highest voltage drop.

Description : In a series RLC circuit at resonance, the magnitude of the voltage developed across the capacitor  A) Is always zero B) Can never be greater than the input voltage C) Can be greater than the input ... input voltage D) Can be greater than the input voltage, and is in phase with the input voltage

Last Answer : In a series RLC circuit at resonance, the magnitude of the voltage developed across the capacitor Can be greater than the input voltage, however, it is 90° out of phase with the input voltage

Description : A unit step voltage is applied at t = 0 to a series RL circuit with zero initial conditions  A) It is possible for the current to be oscillatory B) The voltage across the resistor at t ... The energy stored in the inductor in the steady state is zero D) Theresistor current eventually falls to zero

Description : In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

Last Answer : In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C? 7 V

Description : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Last Answer : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the C only

Description : When a current of 0.5 A is passed through two resistances in series, the potential difference between the ends of the series arrangement is 12.5 V. On

Last Answer : When a current of 0.5 A is passed through two resistances in series, the potential difference between ... ends is 6 V. Calculate the two resistances.

Description : "Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual source currents and source resistance is the parallel combination of individual source resistances". The above statement is associated with?

Last Answer : "Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual source currents and source ... parallel combination of individual source resistances". The above statement is associated with Millman's theorem.

Description : When an operating motor is connected to the controller shown in the illustration, the a path of current flow through the circuit is ____________. EL-0010 A. 'L1', stop button, start button, coil 'CR', 'L2' B. 'L1' ... L2' D. 'L1', stop button, start button, 'CR' contact, 'M' contact, 'CR' coil, 'L2'

Description : In the given circuit, the resistances are given in ohm. The current through the `10Omega` resistance is 3 A while that through the resistance X is 1 A

Last Answer : In the given circuit, the resistances are given in ohm. The current through the `10Omega` resistance is 3 A while ... and 6 C. 6 and 12 D. 6 and 6

Description : What is the current through R2 of the circuit illustrated if the resistances of R1 is 2 ohms, R2 is 4 ohms, and R3 is 4 ohms with a 6 volt battery? EL-0021 A. 0.5 amp B. 1.5 amps C. 3.0 amps D. 6 amps

Description : How much current will flow in the illustrated circuit if the supply is 24 volts and the resistances of R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms? EL-0020 A. 2 amps B. 6 amps C. 8 amps D. 10 amps

Description : A closed path made by several branches of the network is known as?

Last Answer : A closed path made by several branches of the network is known as loop.

Description : In the circuit shown below, the current through the inductor is,

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the current through the 1 micro farad capacitor is A) 0A B) 1A C) 1.25A D) 5A

Last Answer : The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the current through the 1 micro farad capacitor is 1A

Description : Two cells of emf of 1.5 V and 2.0 V having internal resistances of `1 Omega` and `2 Omega`, respectively are connected in parallel so as to send curre

Last Answer : Two cells of emf of 1.5 V and 2.0 V having internal resistances of `1 Omega` and `2 Omega` ... of `5 Omega`. Find the current in the external circuit.

Description : Two resistors of resistances `2Omega` and `6Omega` are connected in parallel. This combination is then connected to a battery of emf 2 V and internal

Last Answer : Two resistors of resistances `2Omega` and `6Omega` are connected in parallel. This combination is then connected to a ... . `(4)/(17)A` D. `1 A`

Description : Two resistances are joined in parallel whose resultant is `6//8 ohm`. One of the resistance wire is broken and the effective resistance becomes `2 Ome

Last Answer : Two resistances are joined in parallel whose resultant is `6//8 ohm`. One of the resistance wire is broken and the ... /5` B. 2 C. `6//5` D. 3

Last Answer : If two resistances of 10 Ω and 10 Ω are connected in parallel the equivalent resistance is 5 Ω.

Description : The circuit whose properties are same in either direction is known as?

Last Answer : The circuit whose properties are same in either direction is known as bilateral circuit.

Description : Three resistances `2 Omega, 3 Omega` and `4 Omega` are connected in parallel. The ratio of currents passing through them when a potential difference i

Last Answer : Three resistances `2 Omega, 3 Omega` and `4 Omega` are connected in parallel. The ratio of currents passing through them ... ` C. `4:3:2` D. `6:4:3`

Description : Three resistances 20 Ω, 30 Ω and 60 Ω are connected in parallel, their combined resistance is given by A. 110 Ω B. 50 Ω C. 20 Ω D. 10 Ω

Description : When four resistances of 2W 1W; 5W 2W; 10W 5W and 15W 10 W are connected in parallel, the greatest power is absorbed by • 2 W, 1 W • 5 W, 2 W • 10 W, 5W • 15 W, 10 W

Last Answer : When four resistances of 2W 1W; 5W 2W; 10W 5W and 15W 10 W are connected in parallel, the greatest power is absorbed by 2 W, 1 W

Description : When n resistances each of value r are connected in parallel, then resultant resistance is x. When these n resistances are connected in series, total resistance is

Last Answer : When n resistances each of value r are connected in parallel, then resultant resistance is x. When these n resistances are connected in series, total resistance is n2 x.

Description :  With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals?

Last Answer : Power is the only thing which is additive in both connection whether it is parallel or series connection so total power consumed will addition of all individual power =20+20+20 = 60 watt

Description : When measuring AC current flow, you must always connect the meter _____________. A. in series with the power source and load B. in parallel with the power source and load C. insuring correct polarity D. using the lowest range possible to prevent instrument damage

Description : How does the current and potenial difference behave in a series and parallel circuit?

Description : To limit the current flow through a DC voltmeter to as low a value as possible, the moving coil circuit is provided with a/an _____________. A. high series resistance B. high parallel resistance C. series inductor D. external shunt

Description : What is the effect on total resistance and total current in a circuit if a short occurs in (a) a parallel branch, and (b) in a series portion?

Last Answer : (a) Total resistance decreases, total current increases (b) Total resistance decreases, total current increases

Description : What is the effect on total resistance and total current in a circuit if an open occurs in (a) a parallel branch, and (b) in a series portion?

Last Answer : (a) Total resistance increases, total current decreases (b) Total resistance becomes infinite, total current is equal to zero

Description : There is a relationship between total current and current through the individual components in a circuit. What is this relationship in a series circuit and a parallel circuit?

Last Answer : The source voltage would have to be increased to 640 volts

Last Answer : Req= (1/1200 +1/560 + 1/2.1)^-1        = 2.1 ohms RT= 2.1 + 7.8      = 9.9 ohms IT = V/R = 24/9.9                = 2.4 A Veq= R I =  2.1 2 ... 7.8         = 12.096 w                 = 44.928 w _________________________________________ By: Ellis-Junior Kamatjipose [email protected]

Description :  Compare series and parallel circuit in terms of voltage and current.

Last Answer : Series circuits Parallel circuits Only ONE path for current to flow in a closed circuit Number of path for current to flow in a closed circuit Current remains the SAME ... Voltage is DIFFERENT across each component Voltage remains the same across each component of the circuit

Description : Two cells connected in series have electromotive force of 1.5 V each. Their internal resistances are `0.5 Omega` and `0.25 Omega` respectively. This c

Last Answer : Two cells connected in series have electromotive force of 1.5 V each. Their internal ... potential differnce across the terminals of each cell.

Description : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

Last Answer : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across Rl.

Description : Overall thermal resistance for conductive heat transfer through a series of flat resistances is equal to the (A) Maximum resistance in the series (B) Sum of all resistances (C) Average of all resistances (D) Minimum resistance presents in the series

Last Answer : (B) Sum of all resistances