To a conventional narrowband receiver, a spread spectrum signal appears to be

To a conventional narrowband receiver, a  spread spectrum signal appears to be
by

1 Answer

Answer :

Noise
by

Related questions

The most critical and difficult part of receiving a direct – sequence spread spectrum signal is :

Description : The most critical and difficult part of receiving a direct – sequence spread spectrum signal is :

Last Answer : Synchronism

Which circuit is most common to both frequency-hopping and direct-sequence spread spectrum transmitters?

Description : Which circuit is most common to both frequency-hopping and direct-sequence spread spectrum transmitters?

Last Answer : PSN code generator

Not a benefit of spread spectrum?

Description : Not a benefit of spread spectrum?

Last Answer : Noise proof

It is used to encode the minimum amount of speech information necessary to reproduce a perceptible message with a fewer bits that those needed by a conventional encoder/decoder

Description : It is used to encode the minimum amount of speech information necessary to reproduce a perceptible message with a fewer bits that those needed by a conventional encoder/decoder

Last Answer : vocoders

What distinguishes digital radio systems from conventional analog communications system?

Description : What distinguishes digital radio systems from conventional analog communications system?

Last Answer : the nature of the modulating signal

What circuit in the TV receiver is used to develop the high voltage needed to operate the picture tube?

Description : What circuit in the TV receiver is used to develop the high voltage needed to operate the picture tube?

Last Answer : Horizontal output

The sound IF in a TV receiver is

Description : The sound IF in a TV receiver is

Last Answer : 41.25 MHz

It is the ratio of the largest possible magnitude to the smallest possible magnitude that can be decoded by the digital-to-analog converter in the receiver.

Description : It is the ratio of the largest possible magnitude to the smallest possible magnitude that can be decoded by the digital-to-analog converter in the receiver.

Last Answer : Dynamic range

Involves compression in the transmitter after the input sample has been converted to a linear PCM code and then expansion in the receiver prior to PCM coding:

Description : Involves compression in the transmitter after the input sample has been converted to a linear PCM code and then expansion in the receiver prior to PCM coding:

Last Answer : Digital companding

The sound IF in a TV receiver is

Description : The sound IF in a TV receiver is

Last Answer : 41.25 MHz

In PAM demultiplexing, the receiver clock is derived from

Description : In PAM demultiplexing, the receiver clock is derived from

Last Answer : the PAM signal itself

In a radio receiver with simple AGC:

Description : In a radio receiver with simple AGC:

Last Answer : an increase in signal strength produces more AGC

In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is

Description : In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is

Last Answer : AGC, video IF amplifier, RF amplifier

Message _______ means that the receiver is ensured that the message is coming from the intended sender, not an imposter

Description : Message _______ means that the receiver is ensured that the message is coming from the intended sender, not an imposter

Last Answer : authentication

What is the term used to describe a spread spectrum communications system where the center frequency if a conventional carrier is altered many time per second in accordance with a pseudo-random list of channels? A. Frequency hopping B. Direct sequence C. Time-domain frequency modulation D. Frequency compandored spread spectrum

Description : What is the term used to describe a spread spectrum communications system where the center frequency if a conventional carrier is altered many time per second in accordance with a pseudo ... hopping B. Direct sequence C. Time-domain frequency modulation D. Frequency compandored spread spectrum

Last Answer : A. Frequency hopping

The modulated picture carrier wave includes the composite video signal as the:

Description : The modulated picture carrier wave includes the composite video signal as the:

Last Answer : Symmetric envelope of amplitude variations

A 4.5-MHz signal which is equal to the difference between the picture and sound RF carrier frequencies in a 6-MHz TV channel.

Description : A 4.5-MHz signal which is equal to the difference between the picture and sound RF carrier frequencies in a 6-MHz TV channel.

Last Answer : Intercarrier frequencY

The service are in standard AM broadcast is described as ______ if there is no fading of signal.

Description : The service are in standard AM broadcast is described as ______ if there is no fading of signal.

Last Answer : Primary

The total bandwidth of an NTSC TV signal is:

Description : The total bandwidth of an NTSC TV signal is:

Last Answer : . 6 MHz

The service are in standard AM broadcast is described as ______ if there is no fading of signal.

Description : The service are in standard AM broadcast is described as ______ if there is no fading of signal.

Last Answer : Primary

The total bandwidth of an NTSC TV signal is:

Description : The total bandwidth of an NTSC TV signal is:

Last Answer : 6 MHz

The minimum optical power a light detector can receive and still produce a usable electrical output signal.

Description : The minimum optical power a light detector can receive and still produce a usable electrical output signal.

Last Answer : light sensitivity

The phase relationship between signaling elements for BPSK is the optimum signaling format and occurs only when two binary signal levels are allowed and when one signal is the exact negative of the other

Description : The phase relationship between signaling elements for BPSK is the optimum signaling format and occurs only when two binary signal levels are allowed and when one signal is the exact negative of the other

Last Answer : Antipodal signaling

A pulse modulation technique as the width of a constant amplitude pulse is varied proportional to the amplitude of the analog signal at the time the signal is sampled.

Description : A pulse modulation technique as the width of a constant amplitude pulse is varied proportional to the amplitude of the analog signal at the time the signal is sampled.

Last Answer : PWM, PLM, PDM

The slope of the analog signal is greater than the delta modulator can maintain

Description : The slope of the analog signal is greater than the delta modulator can maintain

Last Answer : Slope overload

Rate of change of a signal on a transmission medium after encoding and modulation have occurred

Description : Rate of change of a signal on a transmission medium after encoding and modulation have occurred

Last Answer : baud rate

Used for transmission of PCM encoded time – division multiplexed digital signal.

Description : Used for transmission of PCM encoded time – division multiplexed digital signal.

Last Answer : T carriers

The signal from a satellite is normally aimed at a specific area called the ________

Description : The signal from a satellite is normally aimed at a specific area called the ________

Last Answer : footprint

What is Narrowband ?

Description : What is Narrowband ?

Last Answer : Narrowband : Narrowband is usually 45 to 300 bps . This band is used for slow data transmission. The use of this band is more noticeable in the case of telephony in general. In the case of telephony, the narrowband typically provides a frequency of 300 to 3400 Hz .

Most data communications involving telegraph lines use: a. simplex lines b. wideband channel c. narrowband channel d. dialed service

Description : Most data communications involving telegraph lines use: a. simplex lines b. wideband channel c. narrowband channel d. dialed service

Last Answer : narrowband channel

What are the datatransmission channels availablefor carrying datafrom one location to another? A. Narrowband B. Voice band C. Broadband D. All of theabove E. None of the above

Description : What are the datatransmission channels availablefor carrying datafrom one location to another? A. Narrowband B. Voice band C. Broadband D. All of theabove E. None of the above

Last Answer : All of theabove

Which of the following types of channels moves data relatively slowly? A. widebandchannel B. voice band channel C. narrowband channel D. broadbandchannel E. None of the above

Description : Which of the following types of channels moves data relatively slowly? A. widebandchannel B. voice band channel C. narrowband channel D. broadbandchannel E. None of the above

Last Answer : narrowband channel

What kind of receiver is used in conventional telephone handset? A. Capacitor B. Electromagnetic C. Carbon D. Ceramic

Description : What kind of receiver is used in conventional telephone handset? A. Capacitor B. Electromagnetic C. Carbon D. Ceramic

Last Answer : B. Electromagnetic

The magnetic field of an antenna is perpendicular to the earth. The antenna’s polarization ___

Description : The magnetic field of an antenna is perpendicular to the earth. The antenna’s polarization ___

Last Answer : is horizontal

It is the ratio of the power density radiated in a particular direction to the power density radiated to the same point by a reference antenna, assuming both antennas are radiating the same amount of power

Description : It is the ratio of the power density radiated in a particular direction to the power density radiated to the same point by a reference antenna, assuming both antennas are radiating the same amount of power

Last Answer : directive gain

The property of interchangeability for the transmitting and receiving operations is known as ____

Description : The property of interchangeability for the transmitting and receiving operations is known as ____

Last Answer : reciprocity

The fields surrounding the antenna do not collapse their energy back into the antenna but rather radiate it out in space

Description : The fields surrounding the antenna do not collapse their energy back into the antenna but rather radiate it out in space

Last Answer : radiation field

It is the ratio of the radiated to the reflected energy:

Description : It is the ratio of the radiated to the reflected energy:

Last Answer : Radiation efficiency

It is the resistance that, if it replaced the antenna, would dissipate exactly the same amount of power that the antenna radiates

Description : It is the resistance that, if it replaced the antenna, would dissipate exactly the same amount of power that the antenna radiates

Last Answer : . Radiation resistance

Plots of field strength or power density with respect to the value at a reference point.

Description : Plots of field strength or power density with respect to the value at a reference point.

Last Answer : relative radiation pattern

The radiation pattern plotted in terms of electric field strength or power density

Description : The radiation pattern plotted in terms of electric field strength or power density

Last Answer : absolute radiation pattern

The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____

Description : The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____

Last Answer : line of shoot

A special type of transmission line that consist of conducting metallic tube through which high frequency electromagnetic energy is propagated

Description : A special type of transmission line that consist of conducting metallic tube through which high frequency electromagnetic energy is propagated

Last Answer : waveguide

If energy is applied at the geometrical center of antenna, the antenna is said to be ___

Description : If energy is applied at the geometrical center of antenna, the antenna is said to be ___

Last Answer : center-fed

The radiation pattern of collinear and a broadside antenna is __

Description : The radiation pattern of collinear and a broadside antenna is __

Last Answer : bidirectional

Hertz antenna are predominantly used with frequencies above

Description : Hertz antenna are predominantly used with frequencies above

Last Answer : 2MHz

The point on the antenna where the transmission line is connected is called _____

Description : The point on the antenna where the transmission line is connected is called _____

Last Answer : feedpoint

The discone antenna is

Description : The discone antenna is

Last Answer : useful as a UHF receiving antenna

It is the same with directive gain except that the total power fed to the antenna is used and the antenna efficiency is taken into account.

Description : It is the same with directive gain except that the total power fed to the antenna is used and the antenna efficiency is taken into account.

Last Answer : power gain

____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.

Description : ____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.

Last Answer : UDP