Description : A system where the modulated RF picture and sound carrier signals are distributed in a cable network, instead of wireless system.
Last Answer : CATV
Description : If the carrier of a 100 percent modulated AM wave is suppressed, the percentage power saving will be
Last Answer : 50
Description : A 4.5-MHz signal which is equal to the difference between the picture and sound RF carrier frequencies in a 6-MHz TV channel.
Last Answer : Intercarrier frequencY
Description : The bandwidth required for a modulated carrier depends on:
Last Answer : the baseband frequency range
Description : If frequency of modulated wave is less than frequency of carrier wave, then input signal is A. negative B. positive C. zero D. infinite
Last Answer : negative
Description : In an amplitude modulated waveform, the amplitude of the sideband is
Last Answer : 1/2 carrier amplitude x modulation index
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : What is meant by the term modulation index? A. The processor index. B. The ratio between the deviation of a frequency modulated signal and the modulating frequency. C. The FM signal-to-noise ratio. D. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Last Answer : B. The ratio between the deviation of a frequency modulated signal and the modulating frequency.
Description : What is the first symbol of a radio signal transmission having an amplitude modulated signal carrier, double side band? A. C B. B C. H D. A
Last Answer : D. A
Description : The _______ technique uses M different carrier frequencies that are modulated by the source signal. At one moment, the sign modulates one carrier frequency; at the next moment, thesignal modulates another carrier frequency. A) FDM B) DSSS C) FHSS D) TDM
Last Answer : FHSS
Description : In_____ transmission, thephaseof the carrier signal is modulated to follow the changingvoltage level (amplitude) of the modulating signal. A) AM B) PM C) FM D) none of the above
Last Answer : PM
Description : In_____ transmission, the frequency of the carrier signal is modulated to follow the changing voltage level (amplitude)of the modulating signal. The peak amplitude and phase of the carrier signal remainconstant,but as ... of thecarrier changes correspondingly. A) AM B) PM C) FM D) none of the above
Last Answer : FM
Description : Carrier is A. One or more conductors that serve as a common connection for a related group of devices B. a continuous frequency capableof being modulated or impressed witha second signal C. ... that provides a data communications service among stations attached tothe network E. None of the above
Last Answer : a continuous frequency capableof being modulated or impressed witha second signa
Description : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly
Last Answer : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly 4 Ghz
Description : A 1000W carrier is amplitude modulated to a depth of 85%. Calculate the total power of the modulated wave? A. 1361.25 W B. 680.62 W C. 1425 W D. 712.5 W
Last Answer : A. 1361.25 W
Description : Modulation in which the modulated wave is always present. A. Carrier modulation B. Front-end C. Continuous modulation D. Log-periodic modulation
Last Answer : C. Continuous modulation
Description : A 400 W carrier is amplitude modulated to a depth of 75%.Calculate the total power in AM wave. (i) Explain the types of noise in a communication system. (ii) Compare simplex and duplex mode of communication.
Last Answer : (i) Noise: Noise is any spurious or undesired disturbances that mask the received signal in a communication system. a) Atmospheric Noise: Atmospheric Noise is also known as static noise which is the ... remote control ExamplesWalkytalky,telephone,mobile,Radar, FAX,Pager 4
Description : If the carrier of a 100 percent modulation modulated AM wave is suppressed, the percentage power saving will be (A) 50.55 (B) 15.55 (C) 10.66 (D) 66.66
Last Answer : If the carrier of a 100 percent modulation modulated AM wave is suppressed, the percentage power saving will be 66.66
Description : The time it takes a light induced carrier travel across the depletion region of the semiconductor.
Last Answer : . transit time
Description : A carrier recovery is needed with:
Last Answer : DPSK
Description : What circuit in the TV receiver is used to develop the high voltage needed to operate the picture tube?
Last Answer : Horizontal output
Description : How long does it take to scan 2 picture elements when 400 are scanned in 50 microseconds?
Last Answer : 0.25 microsec
Description : Picture frames are repeated at the rate of ___ per second
Last Answer : . 30
Last Answer : 30
Description : An image uses 512 x 512 picture elements. Each element can take any of eight distinguishable levels. The maximum entropy in the above image will be:
Last Answer : 786432 bits
Description : In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
Last Answer : AGC, video IF amplifier, RF amplifier
Description : What type of transmission is radiated from an aircraft’s radio altimeter antenna? A. An amplitude modulated continuous wave B. A pulse position modulated UHF signal C. A differential phase shift keyed UHF signal D. A frequency modulated continuous wave
Last Answer : D. A frequency modulated continuous wave
Description : Amplitude of modulated wave is in phase with A. output B. system C. frequency D. signal
Last Answer : signal
Description : The service are in standard AM broadcast is described as ______ if there is no fading of signal.
Last Answer : Primary
Description : The total bandwidth of an NTSC TV signal is:
Last Answer : . 6 MHz
Description : The most critical and difficult part of receiving a direct – sequence spread spectrum signal is :
Last Answer : Synchronism
Last Answer : 6 MHz
Description : To a conventional narrowband receiver, a spread spectrum signal appears to be
Last Answer : Noise
Description : The minimum optical power a light detector can receive and still produce a usable electrical output signal.
Last Answer : light sensitivity
Description : The phase relationship between signaling elements for BPSK is the optimum signaling format and occurs only when two binary signal levels are allowed and when one signal is the exact negative of the other
Last Answer : Antipodal signaling
Description : A pulse modulation technique as the width of a constant amplitude pulse is varied proportional to the amplitude of the analog signal at the time the signal is sampled.
Last Answer : PWM, PLM, PDM
Description : The slope of the analog signal is greater than the delta modulator can maintain
Last Answer : Slope overload
Description : Rate of change of a signal on a transmission medium after encoding and modulation have occurred
Last Answer : baud rate
Description : Used for transmission of PCM encoded time – division multiplexed digital signal.
Last Answer : T carriers
Description : The signal from a satellite is normally aimed at a specific area called the ________
Last Answer : footprint
Description : It is proposed network designed by major telephone companies in conjunction with the ITU-T with the intent of providing worldwide telecommunications support for voice, data, video and facsimile information within the same networ
Last Answer : ISDN
Description : Variation of biphase that is used for encoding SMPTE time code data and for recording on video tapes
Last Answer : Biphase – M
Description : Refers to the first symbol in an emission designation with an amplitude modulated main carrier represented by letter H. A. Single sideband suppressed carrier B. Double sideband full carrier C. Independent sideband D. Double sideband
Last Answer : B. Double sideband full carrier
Description : In amplitude modulation technique the unmodulated carrier is referred to as having ______. A. 100% modulation B. 0% modulation C. 50% modulated D. Over modulated
Last Answer : B. 0% modulation
Description : Geodimeter is based on: (A) Propagation of modulated light waves (B) Propagation of infrared radiation (C) The visible light as carrier with frequency of the order of 5 × 1014 Hz (D) High frequency radio waves
Last Answer : Answer: Option A
Description : For AM transmissions, the carrier is normally modulated within what range?
Last Answer : 60% to 95%.
Description : If a carrier wave of 1000 kHz is used to carry the signal, the length of transmitting antenna will be equal to _______. (1) 300 m (2) 30 m (3) 3 m (4) 0.3 m
Last Answer : (1) 300 m Explanation: h = 3 × 108/106 = 300 m
Description : Referred to an oscillator signal “leak through” from a properly neutralized amplifier such as a master oscillator power amplifier. A. Carrier B. Stray signal C. Back wave D. Loss wave
Last Answer : C. Back wave