The radiation pattern plotted in terms of  electric field strength or power density

1 Answer

Answer :

absolute radiation pattern

Related questions

Description : Plots of field strength or power density with respect to the value at a reference point.

Last Answer : relative radiation pattern

Description : The radiation pattern of collinear and a broadside antenna is __

Last Answer : bidirectional

Description : ________ defines how a particular pattern to be interpreted, and what action is to be taken based on that interpretation.

Last Answer : syntax

Description : What travels down a waveguide by reflecting from the side walls in a zigzag pattern?

Last Answer : wavefronts

Description : Classification of protocol that interprets a frame of data as a group of successive bit combined into predetermined pattern of fixed length, usually 8 bits each.

Last Answer : Character and Byte-oriented protocols

Description : It is the ratio of the power density radiated in a particular direction to the power density radiated to the same point by a reference antenna, assuming both antennas are radiating the same amount of power

Last Answer : directive gain

Description : The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____

Last Answer : line of shoot

Description : “When visible light of high frequency electromagnetic radiation illuminates a metallic surface, electrons are emitted”

Last Answer : Plank’s law

Description : Stacking elements in a transmitting antenna system A. increases the field strength at the receiving antenna B. increases the directivity of the transmitter antenna C. decrease the size of the lobe in the radiation pattern D. both A and B

Last Answer : D. both A and B

Description : The magnetic field of an antenna is perpendicular to the earth. The antenna’s polarization ___

Last Answer : is horizontal

Description : A mode where the entire magnetic field is in the transverse plane and has no portion parallel to the length axis.

Last Answer : TM mode

Description : When microwave energy is passed through a piece of ferrite in a magnetic field, another effect occurs. If the frequency of the microwave energy is much greater than the electron wobble frequency, the plane of polarization of the wavefront is rotated. This is known as

Last Answer : Faraday Rotation Effect

Description : The vertical field-scanning frequency is ______ Hz

Last Answer : 60

Description : In IPv6, when a datagram needs to be discarded in a congested network, the decision is based on the _______ field in the base header.

Last Answer : priority

Description : In IPv4, what is the value of the total length field in bytes if the header is 28 bytes and the data field is 400 bytes?

Last Answer : 428

Description : Have you ever plotted your life on a timeline to look for a pattern in your life?

Last Answer : Yes I attempt to improve my situation, and then fail ;then move in with another parent, and then attempt to improve my life , and fail, and then move back with another parent, Then go to a group home or university, or homeless shelter. ect. and repeat.

Description : In a plane-table survey, the process of determining the plotted position of a station occupied by the plane-table by means of sights taken towards known points, the locations of which have already been plotted, is known as (a) Radiation (b) Resection (c) Intersection (d) Traversing

Last Answer : (b) Resection

Description : It is the resistance that, if it replaced the antenna, would dissipate exactly the same amount of power that the antenna radiates

Last Answer : . Radiation resistance

Description : It is the same with directive gain except that the total power fed to the antenna is used and the antenna efficiency is taken into account.

Last Answer : power gain

Description : It is analogous to power dissipation to copper cables, impurities in the fiber absorb the light and covert it to heaT

Last Answer : absorption loss

Description : Optical power is sometimes called ____

Last Answer : Radiant flux

Description : The final power amplifier in an FM transmitter usually operates class ___

Last Answer : C

Description : The final power amplifier in an FM transmitter usually operates class ______.

Last Answer : C

Description : The minimum optical power a light detector can receive and still produce a usable electrical output signal.

Last Answer : light sensitivity

Description : As light is coupled in a multiport deflective device, the power is reduced by:

Last Answer : 0.5 dB

Description : It is the thermal noise power normalized to 1- Hz bandwidth:

Last Answer : noise power density

Description : If the carrier of a 100 percent modulated AM wave is suppressed, the percentage power saving will be

Last Answer : 50

Description : In S-N diagram, the graph plotted between fatigue strength and number of stress cycles becomes horizontal for which type of materials? a. Ferrous materials b. Non-ferrous materials c. Both a. and b. d. None of the above

Last Answer : a. Ferrous materials

Description : The operating line for an absorber is curved, when plotted in terms of (A) Mole fractions (B) Mole ratios (C) Partial pressure (D) Mass fractions

Last Answer : (C) Partial pressure

Description : The slope of the operating line for a single component co-current absorber when plotted in terms of mole ratio units is (A) 0 (B) ∞ (C) -ve (D) +ve

Last Answer : (C) -ve

Description : While surveying a plot of land by plane tabling, the field observations (A) And plotting proceed simultaneously (B) And plotting do not proceed simultaneously (C) And recorded in field books to be plotted later (D) All the above

Last Answer : (A) And plotting proceed simultaneously

Description : The property of interchangeability for the transmitting and receiving operations is known as ____

Last Answer : reciprocity

Description : The fields surrounding the antenna do not collapse their energy back into the antenna but rather radiate it out in space

Last Answer : radiation field

Description : It is the ratio of the radiated to the reflected energy:

Last Answer : Radiation efficiency

Description : A special type of transmission line that consist of conducting metallic tube through which high frequency electromagnetic energy is propagated

Last Answer : waveguide

Description : If energy is applied at the geometrical center of antenna, the antenna is said to be ___

Last Answer : center-fed

Description : Hertz antenna are predominantly used with frequencies above

Last Answer : 2MHz

Description : The point on the antenna where the transmission line is connected is called _____

Last Answer : feedpoint

Description : The discone antenna is

Last Answer : useful as a UHF receiving antenna

Description : ____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.

Last Answer : UDP

Description : ______ are special-interest groups that quickly test, evaluate, and standardize new technologies

Last Answer : Forums

Description : _______ refers to the structure or format of the data, meaning the order in which they are presented.

Last Answer : Semantics

Description : The effect of a large magnitude of the numerical aperture.

Last Answer : The amount of external light the fiber will accept is greater

Description : It is the figure of merit used to measure the magnitude of the acceptance angle.

Last Answer : numerical aperture

Description : It is a result of photons of light that are absorbed by the atoms of the glass core molecule

Last Answer : infrared absorption

Description : It is caused by valence electrons in the silica material from which the fiber are manufactured.

Last Answer : ultraviolet absorption

Description : The maximum angle in which external light rays may strike the air/glass interface and still propagate down the fiber.

Last Answer : Acceptance cone half-angle

Description : Laser light is very bright because it is:

Last Answer : coherent

Description : The process of moving from one energy level to another is called __

Last Answer : Absorption

Description : The process of decaying from one energy level to another energy level is called _______

Last Answer : Spontaneous emission