Description : How long does it take to scan 2 picture elements when 400 are scanned in 50 microseconds?
Last Answer : 0.25 microsec
Description : An image uses 512 x 512 picture elements. Each element can take any of eight distinguishable levels. The maximum entropy in the above image will be:
Last Answer : 786432 bits
Description : In IPv4, what is the value of the total length field in bytes if the header is 28 bytes and the data field is 400 bytes?
Last Answer : 428
Description : The modulated picture carrier wave includes the composite video signal as the:
Last Answer : Symmetric envelope of amplitude variations
Description : What circuit in the TV receiver is used to develop the high voltage needed to operate the picture tube?
Last Answer : Horizontal output
Description : A system where the modulated RF picture and sound carrier signals are distributed in a cable network, instead of wireless system.
Last Answer : CATV
Description : A 4.5-MHz signal which is equal to the difference between the picture and sound RF carrier frequencies in a 6-MHz TV channel.
Last Answer : Intercarrier frequencY
Description : Picture frames are repeated at the rate of ___ per second
Last Answer : . 30
Last Answer : 30
Description : In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
Last Answer : AGC, video IF amplifier, RF amplifier
Description : What was the name of the program that allows me to take out yellow, add blue, etc. to a scanned picture?
Last Answer : answer:IrfanView does that. It is free. @CWOTUS told me about it a few years ago and I’ve been using it ever since.
Description : The phase relationship between signaling elements for BPSK is the optimum signaling format and occurs only when two binary signal levels are allowed and when one signal is the exact negative of the other
Last Answer : Antipodal signaling
Description : Type of PCM which is designed to take advantage of the sample-to-sample redundancies in the typical speech waveform
Last Answer : Differential PCM
Description : What phenomenon will result if the glass fiber is exposed to long periods of high humidity?
Last Answer : stress corrosion
Description : The magnetic field of an antenna is perpendicular to the earth. The antenna’s polarization ___
Last Answer : is horizontal
Description : It is the ratio of the power density radiated in a particular direction to the power density radiated to the same point by a reference antenna, assuming both antennas are radiating the same amount of power
Last Answer : directive gain
Description : The property of interchangeability for the transmitting and receiving operations is known as ____
Last Answer : reciprocity
Description : The fields surrounding the antenna do not collapse their energy back into the antenna but rather radiate it out in space
Last Answer : radiation field
Description : It is the ratio of the radiated to the reflected energy:
Last Answer : Radiation efficiency
Description : It is the resistance that, if it replaced the antenna, would dissipate exactly the same amount of power that the antenna radiates
Last Answer : . Radiation resistance
Description : Plots of field strength or power density with respect to the value at a reference point.
Last Answer : relative radiation pattern
Description : The radiation pattern plotted in terms of electric field strength or power density
Last Answer : absolute radiation pattern
Description : The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____
Last Answer : line of shoot
Description : A special type of transmission line that consist of conducting metallic tube through which high frequency electromagnetic energy is propagated
Last Answer : waveguide
Description : If energy is applied at the geometrical center of antenna, the antenna is said to be ___
Last Answer : center-fed
Description : The radiation pattern of collinear and a broadside antenna is __
Last Answer : bidirectional
Description : Hertz antenna are predominantly used with frequencies above
Last Answer : 2MHz
Description : The point on the antenna where the transmission line is connected is called _____
Last Answer : feedpoint
Description : The discone antenna is
Last Answer : useful as a UHF receiving antenna
Description : It is the same with directive gain except that the total power fed to the antenna is used and the antenna efficiency is taken into account.
Last Answer : power gain
Description : ____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.
Last Answer : UDP
Description : ______ are special-interest groups that quickly test, evaluate, and standardize new technologies
Last Answer : Forums
Description : _______ refers to the structure or format of the data, meaning the order in which they are presented.
Last Answer : Semantics
Description : ________ defines how a particular pattern to be interpreted, and what action is to be taken based on that interpretation.
Last Answer : syntax
Description : The effect of a large magnitude of the numerical aperture.
Last Answer : The amount of external light the fiber will accept is greater
Description : It is the figure of merit used to measure the magnitude of the acceptance angle.
Last Answer : numerical aperture
Description : It is a result of photons of light that are absorbed by the atoms of the glass core molecule
Last Answer : infrared absorption
Description : It is caused by valence electrons in the silica material from which the fiber are manufactured.
Last Answer : ultraviolet absorption
Description : It is analogous to power dissipation to copper cables, impurities in the fiber absorb the light and covert it to heaT
Last Answer : absorption loss
Description : The maximum angle in which external light rays may strike the air/glass interface and still propagate down the fiber.
Last Answer : Acceptance cone half-angle
Description : Laser light is very bright because it is:
Last Answer : coherent
Description : The process of moving from one energy level to another is called __
Last Answer : Absorption
Description : The process of decaying from one energy level to another energy level is called _______
Last Answer : Spontaneous emission
Description : Any energy above the ground state is called ________
Last Answer : excited state
Description : Developed an optical fiber with losses less that 2 dB/km
Last Answer : Kao and Bockham
Description : Optical power is sometimes called ____
Last Answer : Radiant flux
Description : The term single mode and multimode are best described as:
Last Answer : the number of wavelengths each fiber can support
Description : Photodiodes operate properly with:
Last Answer : reverse bias
Description : Range of wavelengths of ultraviolet
Last Answer : 10 nm to 390 nm
Description : Range of wavelength of visible light.
Last Answer : 390 nm to 770 nm