Description : What is a specific path the light takes in an optical fiber corresponding to a certain angle and number of reflection a. Mode b. Grade c. Numerical Aperture d. Dispersion
Last Answer : a. Mode
Description : Chromatic dispersion can be eliminated by __________. ∙ A. using a monochromatic light source ∙ B. using a very small numerical aperture fiber ∙ C. using a graded-index fiber ∙ D. using a very sensitive photo detector
Last Answer : A. using a monochromatic light source
Description : The effect of a large magnitude of the numerical aperture ∙ A. The amount of external light the fiber will accept is greater. ∙ B. The amount of external light the fiber will accept is less. ... The amount of modal dispersion will be less. ∙ D. The amount of chromatic dispersion will be greater.
Last Answer : The amount of external light the fiber will accept is greater.
Description : It is a graphical representation of the magnitude of the refractive index across the fiber. ∙ A. mode ∙ B. index profile ∙ C. numerical aperture ∙ D. refractive index
Last Answer : B. index profile
Description : The numerical aperture of a fiber if the angle of acceptance is 15 degrees, is ∙ a. 017 ∙ b. 0.26 ∙ c. 0.50 ∙ d. 0.75
Last Answer : ∙ b. 0.26
Description : Is the different angle of entry of light into an optical fiber when the diameter of the core is many times the wavelength of the light transmitted. ∙ a. Acceptance angle ∙ b. Modes ∙ c. Sensors ∙ d. Aperture
Last Answer : b. Modes
Description : It is the figure of merit used to measure the magnitude of the acceptance angle. ∙ A. acceptance angle ∙ B. numerical aperture ∙ C. index profile
Last Answer : B. numerical aperture
Description : Light rays that are emitted simultaneously from an LED and propagated down an optical fiber do not arrive at the far end of the fiber at the same time results to ∙ A. intramodal dispersion ∙ B. pulse length dispersion ∙ C. modal dispersion ∙ D. wavelength dispersion
Last Answer : D. wavelength dispersion
Description : How can modal dispersion reduced entirely? ∙ A. Use a graded index fiber ∙ B. Use a single-mode fiber ∙ C. Use a monochromatic light source ∙ D. Use a very sensitive light detector
Last Answer : Use a single-mode fiber
Description : Light traveling in optical fiber follows which of the following principles. ∙ a. Huygen’s principle ∙ b. Reflection theory ∙ c. Light theory ∙ d. Snell’s law
Last Answer : d. Snell’s law
Description : The operation of a fiber-optic cable is based on the principle of ∙ A. refraction ∙ B. reflection ∙ C. dispersion ∙ D. absorption
Last Answer : A. refraction
Description : The operation of the fiber-optic cable is based on the principle of ∙ a. Refraction ∙ b. Reflection ∙ c. Dispersion ∙ d. Absorption
Last Answer : ∙ b. Reflection
Description : Which type of fiber-optic cable has the least modal dispersion? ∙ A. single-mode step-index ∙ B. multimode step-index ∙ C. single-mode graded-index ∙ D. multimode graded-index
Last Answer : A. single-mode step-index
Description : The bandwidth of a fiber is limited by ∙ a. Mode ∙ b. Wavelength ∙ c. Dispersion ∙ d. Frequency
Last Answer : c. Dispersion
Description : Which type of fiber-optic cable has the least modal dispersion? ∙ a. Single mode step-index ∙ b. Multimode step-index ∙ c. Single-mode graded-index ∙ d. Multimode graded-index
Last Answer : ∙ a. Single mode step-index
Description : What type of fiber has the highest modal dispersion? ∙ a. Step-index multimode ∙ b. Graded index multimode ∙ c. Step-index single mode ∙ d. Graded index mode
Last Answer : a. Step-index multimode
Description : More than one path for light rays to take down the fiber ∙ A. Multimode ∙ B. Step-index ∙ C. Single mode
Last Answer : A. Multimode
Description : Only one path for light rays to take down the fiber ∙ A. Multimode ∙ B. Step-index ∙ C. Single mode ∙ D. Graded index
Last Answer : C. Single mode
Description : Total internal reflection takes place if the light ray strikes the interface at an angle with what relationship to the critical angle? ∙ A. less than ∙ B. greater than ∙ C. equal to ∙ D. zero
Last Answer : ∙ B. greater than
Description : Total internal reflection takes place if the light ray strikes the interface at an angle with what relationship to the critical angle? ∙ a. Less than ∙ b. Grater than ∙ c. Equal to ∙ d. Zer
Last Answer : ∙ b. Grater than
Description : Which of the following is not a factor in cable light loss? ∙ A. reflection ∙ B. absorption ∙ C. scattering ∙ D. dispersion
Last Answer : A. reflection
Description : Which of the following is not a factor in cable light loss? ∙ a. Reflection ∙ b. Absorption ∙ c. Scattering ∙ d. Dispersion
Last Answer : ∙ a. Reflection
Description : A type of index of an optical fiber that has no cladding and whose central core has a non-uniform refractive index. ∙ A. graded index ∙ B. multimode ∙ C. single mode ∙ D. step-index
Last Answer : ∙ A. graded index
Description : A type of index profile of an optical fiber that has a central core and outside cladding with a uniform refractive index ∙ A. multimode ∙ B. graded index ∙ C. step-index ∙ D. single mode
Last Answer : ∙ C. step-index
Description : A single mode optical fiber has a core diameter of _____ nm. ∙ a. 0.1 ∙ b. 0.01 ∙ c. 0.2 ∙ d. 0.05
Last Answer : a. 0.1
Description : The numerical aperture is the ____________________ of the angle of
Last Answer : sine
Description : It is caused by the difference in the propagation time of light rays that take different paths down the fiber. ∙ A. modal dispersion ∙ B. microbending ∙ C. Rayleigh scattering ∙ D. chromatic dispersion
Last Answer : A. modal dispersion
Description : ______ dispersion is caused by the difference in the propagation times of light rays that take different paths down a fiber. ∙ a. Material dispersion ∙ b. Wavelength dispersion ∙ c. Modal dispersion
Last Answer : ∙ c. Modal dispersion
Description : The loss in signal power as light travels down a fiber is called ∙ a. Dispersion ∙ b. Scattering ∙ c. Absorption ∙ d. Attenuation
Last Answer : ∙ d. Attenuation
Description : The time it takes a light induced carrier travel across the depletion region of the semiconductor. ∙ A. dispersion ∙ B. response time ∙ C. irradiance ∙ D. transit time
Last Answer : D. transit time
Description : In fiber optics, higher-order mode refers to ∙ a. Cladding boundary at high angle ∙ b. Backscattering electromagnetic signals ∙ c. Diffracting signals ∙ d. All of these
Last Answer : ∙ a. Cladding boundary at high angle
Description : Reflections in many directions ∙ a. Diffuse reflection ∙ b. Diffraction ∙ c. Scattering ∙ d. Dispersion
Last Answer : a. Diffuse reflection
Description : Modal dispersion is caused by the ∙ a. Dependence of wavelength on index of refraction ∙ b. Dependence of propagation constant on index of refraction ∙ c. Dependence of the propagation constant on the wavelength ∙ d. Dependence of the propagation constant on the mode number
Last Answer : d. Dependence of the propagation constant on the mode number
Description : Material dispersion is caused by the ∙ a. Wavelength dependence of the index of refraction ∙ b. Wavelength independence of the index of refraction ∙ c. Dependence of the propagation constant on the mode number ∙ d. Independence of the propagation constant on the mode number
Last Answer : d. Independence of the propagation constant on the mode number
Description : For a single mode optical cable with 0.25 dB/km loss, determine the optical power 100 km from a 0.1-mW light source. ∙ A. -45 dBm ∙ B. -15 dBm ∙ C. -35 dBm
Last Answer : ∙ C. -35 dBm
Description : Optical cable testers are used for ∙ a. Checking refractive index ∙ b. Light power out of a fiber ∙ c. Non-calibrated light into a fiber
Last Answer : b. Light power out of a fiber
Last Answer : ∙ b. Light power out of a fiber
Description : It indicates what signal frequencies can be propagated through a given distance of fiber cable. ∙ A. Bandwidth Distance Product ∙ B. Pulse width dispersion ∙ C. Rise time ∙ D. Cutoff frequency
Last Answer : A. Bandwidth Distance Product
Description : The dominant loss mechanisms in silica fiber are ∙ a. Absorption and radiation losses ∙ b. Absorption and Rayleigh scattering ∙ c. Coupling and radiation losses ∙ d. Radiation and modal dispersion
Last Answer : b. Absorption and Rayleigh scattering
Description : The term critical angle describes ∙ A. the point at which light is refracted ∙ B. the point at which light becomes invisible ∙ C. the point at which light has gone from the refractive mode ... reflective mode ∙ D. the point at which light has crossed the boundary layers from one index to another
Last Answer : C. the point at which light has gone from the refractive mode to the reflective mode ∙
Description : The maximum angle in which external light rays may strike the air/glass interface and still propagate down the fiber. ∙ A. Acceptance cone half-angle ∙ B. Acceptance cone ∙ C. Critical angle ∙ D. Angle of incidence
Last Answer : A. Acceptance cone half-angle
Description : For a 300-m optical fiber cable with a bandwidth distance product of 600 MHz-km, determine the bandwidth. ∙ A. 5 GHz ∙ B. 1 GHz ∙ C. 2 GHz
Last Answer : C. 2 GHz
Description : Developed an optical fiber with losses less that 2 dB/km ∙ A. Kao and Bockham ∙ B. Maiman, Kao and Bockham ∙ C. Maiman and Schawlow ∙ D. Kapron, Keck and Maurer
Last Answer : ∙ A. Kao and Bockham
Description : Approximately what is the frequency limit of the optical fiber? ∙ A. 20 MHz ∙ B. 1 MHz ∙ C. 100 MHz ∙ D. 40 GHz
Last Answer : ∙ D. 40 GHz
Description : Used to test a fiber optics splice ∙ a. Spectrum analyzer ∙ b. Oscilloscope ∙ c. Optical power meter ∙ d. Field strength meter
Last Answer : c. Optical power meter
Description : What is the frequency limit of an optical fiber? ∙ a. 20 GHz ∙ b. 30 GHz ∙ c. 40 GHz ∙ d. 50 GHz
Last Answer : ∙ c. 40 GHz
Description : Which is not a possible cause of optical fiber loss? ∙ a. Impurities ∙ b. Glass attenuation ∙ c. Stepped index operation ∙ d. Microbending
Last Answer : ∙ c. Stepped index operation
Description : The graded-index multimode optical fiber has a core diameter of _____ nm. ∙ a. 0.5 ∙ b. 0.05 ∙ c. 0.0005 ∙ d. 5
Last Answer : ∙ a. 0.5
Description : A step-index multimode optical fiber has a core diameter of _____ nm. ∙ a. 0.02 ∙ b. 0.2 ∙ c. 2 ∙ d. 0.002
Last Answer : b. 0.2
Description : SONET stands for ∙ a. System Optical Network ∙ b. Synchronous Optical Network ∙ c. Silica Optic Network ∙ d. System Optical Fiber Net
Last Answer : ∙ b. Synchronous Optical Network