Description : In multimode fiber, ____________________ index has less dispersion than step index.
Last Answer : graded
Description : Chromatic dispersion is also called ____________________ dispersion.
Last Answer : intramodal
Description : SONET frames have considerably more ____________________ than do DS frames for information about signal routing and setup.
Last Answer : overhead
Description : With optical fiber, ____________________ light is more common than visible light.
Last Answer : infrared
Description : In SONET, SPE stands for synchronous payload ____________________.
Last Answer : envelope
Description : SONET frame rows contain path overhead and ____________________ overhead.
Last Answer : transport
Description : The number of path overhead bytes in a SONET frame row is ____________________.
Last Answer : 1
Description : The total number of overhead bytes in a SONET frame row is ____________________.
Last Answer : 4
Description : The number of rows in a SONET frame is ____________________.
Last Answer : 9
Description : The number of bytes in the payload of a SONET frame is ____________________.
Last Answer : 774
Description : The number of bytes in a SONET frame is ____________________.
Last Answer : 810
Description : The data rate of an FDDI system is ____________________ bps.
Last Answer : 100 M
Description : FDDI uses ____________________ mode cables.
Last Answer : multi
Description : Each ____________________ in an FDDI system acts as a regenerative repeater.
Last Answer : node
Description : The two rings of an FDDI system carry data in ____________________ directions.
Last Answer : opposite
Description : FDDI systems use two ____________________ rings to carry signals.
Last Answer : token
Description : SONET uses a ____________________ to denote the starting position of an information frame.
Last Answer : pointer
Description : SONET does not use bit ____________________ to synchronize two digital signals.
Last Answer : stuffing
Description : The OC-1 line rate is ____________________ Mbps.
Last Answer : v51.84
Description : Dense ____________________ allows many different wavelengths of light to share a cable.
Last Answer : WDM
Description : Optical amplifiers use a ____________________ laser.
Last Answer : pump
Description : Optical amplifiers use ____________________-doped glass.
Last Answer : erbium
Description : FDDI stands for Fiber ____________________ Data Interface.
Last Answer : Distributed
Description : SONET stands for ____________________ Optical Network.
Last Answer : Synchronous
Description : WDM stands for ____________________-division multiplexing.
Last Answer : Wavelength
Description : SDH stands for Synchronous Data ____________________.
Last Answer : Hierarchy
Description : FITL stands for Fiber In The ____________________.
Last Answer : Loop
Description : FTTC stands for Fiber To The ____________________.
Last Answer : Curb
Description : For safety, you should never ____________________ at the end of an optical fiber unless you know it is not connected to a light source.
Last Answer : look
Description : A ____________________ diode is the usual light detector for single-mode
Last Answer : PIN
Description : The quantum of light is called the ____________________.
Last Answer : photon
Description : A ____________________ diode is the usual light source for single-mode cable.
Last Answer : laser
Description : Good connections are more critical with ____________________-mode fiber.
Last Answer : single
Description : A ____________________ is a short length of fiber that carries the light away from the source
Last Answer : pigtail
Description : The optical fiber is not free to move around in a ____________________ cable.
Last Answer : tight-buffer
Last Answer : loose-tube
Description : For laser diodes, the term ____________________ is used instead of bandwidth.
Last Answer : linewidth
Description : Optical fiber relies on total ____________________ reflection.
Last Answer : internal
Description : The numerical aperture is the ____________________ of the angle of
Last Answer : sine
Description : An electron-volt is a measure of ____________________
Last Answer : energy
Description : The ____________________ angle is where refraction changes to reflection.
Last Answer : : critical
Description : The core is surrounded by the ____________________.
Last Answer : cladding
Description : In the core, the angle of incidence equals the angle of ____________________
Last Answer : reflection
Description : The upper pulse rate and information-carrying capacity of a cable is limited by ∙ A. pulse shortening ∙ B. attenuation ∙ C. light leakage ∙ D. modal dispersion
Last Answer : D. modal dispersion
Description : The operation of a fiber-optic cable is based on the principle of ∙ A. refraction ∙ B. reflection ∙ C. dispersion ∙ D. absorption
Last Answer : A. refraction
Description : The time it takes a light induced carrier travel across the depletion region of the semiconductor. ∙ A. dispersion ∙ B. response time ∙ C. irradiance ∙ D. transit time
Last Answer : D. transit time
Description : It indicates what signal frequencies can be propagated through a given distance of fiber cable. ∙ A. Bandwidth Distance Product ∙ B. Pulse width dispersion ∙ C. Rise time ∙ D. Cutoff frequency
Last Answer : A. Bandwidth Distance Product
Description : How can modal dispersion reduced entirely? ∙ A. Use a graded index fiber ∙ B. Use a single-mode fiber ∙ C. Use a monochromatic light source ∙ D. Use a very sensitive light detector
Last Answer : Use a single-mode fiber
Description : It is caused by the difference in the propagation time of light rays that take different paths down the fiber. ∙ A. modal dispersion ∙ B. microbending ∙ C. Rayleigh scattering ∙ D. chromatic dispersion
Last Answer : A. modal dispersion
Description : Chromatic dispersion can be eliminated by __________. ∙ A. using a monochromatic light source ∙ B. using a very small numerical aperture fiber ∙ C. using a graded-index fiber ∙ D. using a very sensitive photo detector
Last Answer : A. using a monochromatic light source