The data rate of an FDDI system is ____________________ bps.

1 Answer

Answer :

100 M

Related questions

Description : The two rings of an FDDI system carry data in ____________________ directions.

Last Answer : opposite

Description : FDDI stands for Fiber ____________________ Data Interface.

Last Answer : Distributed

Description : Each ____________________ in an FDDI system acts as a regenerative repeater.

Last Answer : node

Description : FDDI uses ____________________ mode cables.

Last Answer : multi

Description : FDDI systems use two ____________________ rings to carry signals.

Last Answer : token

Description : FDDI stands for: a. Fiber Digital Data Interface b. Fiber Distributed Data Interface c. Fiber Distribution Delay Interface d. Frequency-Division Data Interface

Last Answer : b. Fiber Distributed Data Interface

Description : The OC-1 line rate is ____________________ Mbps.

Last Answer : v51.84

Description : SDH stands for Synchronous Data ____________________.

Last Answer : Hierarchy

Description : Using fiber-optic cable in a telephone system except for the connection to the subscriber’s phone is called: a. FDDI b. FTTC c. FITL d. SONET

Last Answer : b. FTTC

Description : A commonly used fiber-based system for LANs is: a. FDDI b. high-speed Ethernet c. gigabit Ethernet d. all of the above

Last Answer : d. all of the above

Description : In SONET, SPE stands for synchronous payload ____________________.

Last Answer : envelope

Description : SONET frame rows contain path overhead and ____________________ overhead.

Last Answer : transport

Description : The number of path overhead bytes in a SONET frame row is ____________________.

Last Answer : 1

Description : The total number of overhead bytes in a SONET frame row is ____________________.

Last Answer : 4

Description : The number of rows in a SONET frame is ____________________.

Last Answer : 9

Description : The number of bytes in the payload of a SONET frame is ____________________.

Last Answer : 774

Description : The number of bytes in a SONET frame is ____________________.

Last Answer : 810

Description : SONET frames have considerably more ____________________ than do DS frames for information about signal routing and setup.

Last Answer : overhead

Description : SONET uses a ____________________ to denote the starting position of an information frame.

Last Answer : pointer

Description : SONET does not use bit ____________________ to synchronize two digital signals.

Last Answer : stuffing

Description : Dense ____________________ allows many different wavelengths of light to share a cable.

Last Answer : WDM

Description : Optical amplifiers use a ____________________ laser.

Last Answer : pump

Description : Optical amplifiers use ____________________-doped glass.

Last Answer : erbium

Description : SONET stands for ____________________ Optical Network.

Last Answer : Synchronous

Description : WDM stands for ____________________-division multiplexing.

Last Answer : Wavelength

Description : FITL stands for Fiber In The ____________________.

Last Answer : Loop

Description : FTTC stands for Fiber To The ____________________.

Last Answer : Curb

Description : For safety, you should never ____________________ at the end of an optical fiber unless you know it is not connected to a light source.

Last Answer : look

Description : A ____________________ diode is the usual light detector for single-mode

Last Answer : PIN

Description : The quantum of light is called the ____________________.

Last Answer : photon

Description : A ____________________ diode is the usual light source for single-mode cable.

Last Answer : laser

Description : Good connections are more critical with ____________________-mode fiber.

Last Answer : single

Description : A ____________________ is a short length of fiber that carries the light away from the source

Last Answer : pigtail

Description : The optical fiber is not free to move around in a ____________________ cable.

Last Answer : tight-buffer

Description : Dispersion can be expressed in units of ____________________ rather than

Last Answer : time

Description : For laser diodes, the term ____________________ is used instead of bandwidth.

Last Answer : linewidth

Description : In multimode fiber, ____________________ index has less dispersion than step index.

Last Answer : graded

Description : With optical fiber, ____________________ light is more common than visible light.

Last Answer : infrared

Description : Chromatic dispersion is also called ____________________ dispersion.

Last Answer : intramodal

Description : Optical fiber relies on total ____________________ reflection.

Last Answer : internal

Description : The numerical aperture is the ____________________ of the angle of

Last Answer : sine

Description : An electron-volt is a measure of ____________________

Last Answer : energy

Description : The ____________________ angle is where refraction changes to reflection.

Last Answer : : critical

Description : The core is surrounded by the ____________________.

Last Answer : cladding

Description : In the core, the angle of incidence equals the angle of ____________________

Last Answer : reflection

Description : The three major groups of the optical system are ∙ A. the components, the data rate and the response time ∙ B. the source, the link and the receiver ∙ C. the transmitter, the cable and the receiver ∙ D. the source, the link and the detector

Last Answer : B. the source, the link and the receiver

Description : ECE Board Exam March 1996 What is the transmission rate of a system for transmitting the output of a microcomputer to a line printer operating at a speed of 30 lines/minute? Assume that the line printer has 8 bits ... and prints out 80 characters/line. A. 800 bps B. 400 bps C. 320 bps D. 640 bps

Last Answer : C. 320 bps

Description : . The product of the bit rate and distance of a fiber-optic system is 2 Gbits-km/s. What is the maximum rate at 5 km? ∙ A. 100 Mbits/s ∙ B. 200 Mbits/s ∙ C. 400 Mbits/s ∙ D. 1000 Gbits/s

Last Answer : C. 400 Mbits/s

Description : The product of the bit rate and distance of a fiber-optic system is 2 Gbits km/s. What is the maximum rate at 5 km? ∙ a. 100 Mbits/s ∙ b. 200 Mbits/s ∙ c. 400 Mbits/s ∙ d. 1000 Gbits/s

Last Answer : c. 400 Mbits/s