The total number of overhead bytes in a SONET frame row is ____________________.

1 Answer

Answer :

4

Related questions

Description : The number of path overhead bytes in a SONET frame row is ____________________.

Last Answer : 1

Description : The number of bytes in the payload of a SONET frame is ____________________.

Last Answer : 774

Description : The number of bytes in a SONET frame is ____________________.

Last Answer : 810

Description : SONET frame rows contain path overhead and ____________________ overhead.

Last Answer : transport

Description : The number of rows in a SONET frame is ____________________.

Last Answer : 9

Description : SONET uses a ____________________ to denote the starting position of an information frame.

Last Answer : pointer

Description : In SONET, SPE stands for synchronous payload ____________________.

Last Answer : envelope

Description : SONET frames have considerably more ____________________ than do DS frames for information about signal routing and setup.

Last Answer : overhead

Description : SONET does not use bit ____________________ to synchronize two digital signals.

Last Answer : stuffing

Description : SONET stands for ____________________ Optical Network.

Last Answer : Synchronous

Description : Optical fiber relies on total ____________________ reflection.

Last Answer : internal

Description : In SONET, for each frame, the bytes are transmitted __________. A) from left to the right, top to bottom B) from right to theleft, bottom to top C) from left to the right, bottom to top D) from right to the left, top to bottom

Last Answer : from left to the right, bottom to top

Description : SONET stands for ∙ a. System Optical Network ∙ b. Synchronous Optical Network ∙ c. Silica Optic Network ∙ d. System Optical Fiber Net

Last Answer : ∙ b. Synchronous Optical Network

Description : Using fiber-optic cable in a telephone system except for the connection to the subscriber’s phone is called: a. FDDI b. FTTC c. FITL d. SONET

Last Answer : b. FTTC

Description : In SONET, STS stands for: a. Synchronous Transport Signal b. Synchronous Transport System c. Synchronous Transmission Signal d. Synchronous Transmission System

Last Answer : a. Synchronous Transport Signal

Description : In SONET, OC-1 stands for: a. Optical Carrier level one b. Optical Coupler unidirectional c. Optical Channel one d. Optical Cable type 1

Last Answer : a. Optical Carrier level one

Description : SONET stands for: a. Simple Optical Network b. Standard Optical Network c. Synchronous Optical Network d. none of the above

Last Answer : c. Synchronous Optical Network

Description : The data rate of an FDDI system is ____________________ bps.

Last Answer : 100 M

Description : FDDI uses ____________________ mode cables.

Last Answer : multi

Description : Each ____________________ in an FDDI system acts as a regenerative repeater.

Last Answer : node

Description : The two rings of an FDDI system carry data in ____________________ directions.

Last Answer : opposite

Description : FDDI systems use two ____________________ rings to carry signals.

Last Answer : token

Description : The OC-1 line rate is ____________________ Mbps.

Last Answer : v51.84

Description : Dense ____________________ allows many different wavelengths of light to share a cable.

Last Answer : WDM

Description : Optical amplifiers use a ____________________ laser.

Last Answer : pump

Description : Optical amplifiers use ____________________-doped glass.

Last Answer : erbium

Description : FDDI stands for Fiber ____________________ Data Interface.

Last Answer : Distributed

Description : WDM stands for ____________________-division multiplexing.

Last Answer : Wavelength

Description : SDH stands for Synchronous Data ____________________.

Last Answer : Hierarchy

Description : FITL stands for Fiber In The ____________________.

Last Answer : Loop

Description : FTTC stands for Fiber To The ____________________.

Last Answer : Curb

Description : For safety, you should never ____________________ at the end of an optical fiber unless you know it is not connected to a light source.

Last Answer : look

Description : A ____________________ diode is the usual light detector for single-mode

Last Answer : PIN

Description : The quantum of light is called the ____________________.

Last Answer : photon

Description : A ____________________ diode is the usual light source for single-mode cable.

Last Answer : laser

Description : Good connections are more critical with ____________________-mode fiber.

Last Answer : single

Description : A ____________________ is a short length of fiber that carries the light away from the source

Last Answer : pigtail

Description : The optical fiber is not free to move around in a ____________________ cable.

Last Answer : tight-buffer

Description : Dispersion can be expressed in units of ____________________ rather than

Last Answer : time

Description : For laser diodes, the term ____________________ is used instead of bandwidth.

Last Answer : linewidth

Description : In multimode fiber, ____________________ index has less dispersion than step index.

Last Answer : graded

Description : With optical fiber, ____________________ light is more common than visible light.

Last Answer : infrared

Description : Chromatic dispersion is also called ____________________ dispersion.

Last Answer : intramodal

Description : The numerical aperture is the ____________________ of the angle of

Last Answer : sine

Description : An electron-volt is a measure of ____________________

Last Answer : energy

Description : The ____________________ angle is where refraction changes to reflection.

Last Answer : : critical

Description : The core is surrounded by the ____________________.

Last Answer : cladding

Description : In the core, the angle of incidence equals the angle of ____________________

Last Answer : reflection

Description : For the implementation of a paging scheme, suppose the average process size be x bytes, the page size be y bytes, and each page entry requires z bytes. The optimum page size that minimizes the total overhead due to the page ... fragmentation loss is given by (A) x/2 (B) xz/2 (C) √2xz (D) (√xz)/2

Last Answer : (C) √2xz