A generator uses what method to produce a voltage?

A generator uses what method to produce a voltage?
by

1 Answer

Answer :

Magnetic.
by

Related questions

. A battery uses what method to produce a voltage?

Description : . A battery uses what method to produce a voltage?

Last Answer : Chemical.

What component causes a generator to produce dc voltage rather than ac voltage at its output terminals?

Description : What component causes a generator to produce dc voltage rather than ac voltage at its output terminals?

Last Answer : A commutator

What is added to a sawtooth generator to produce a trapezoidal wave?

Description : What is added to a sawtooth generator to produce a trapezoidal wave?

Last Answer : A resistor.

What minimum/maximum voltage level can be attained in the pulse generator section by adjusting the LEVEL control?

Description : What minimum/maximum voltage level can be attained in the pulse generator section by adjusting the LEVEL control?

Last Answer : 0 to 5 volts.

When a transmitter uses a high-power oscillator to produce the output pulse, what switches the oscillator on and off?

Description : When a transmitter uses a high-power oscillator to produce the output pulse, what switches the oscillator on and off?

Last Answer : High-voltage pulse from the modulator.

Ships’ generators produce 450-volt, three-phase, ac power; however, most equipment uses 117-volt, single-phase power What transformers and connections are used to convert 450- volt, threephase power to 117-volt, single-phase power?

Description : Ships’ generators produce 450-volt, three-phase, ac power; however, most equipment uses 117-volt, single-phase power What transformers and connections are used to convert 450- volt, threephase power to 117-volt, single-phase power?

Last Answer : A method of generating oscillations, a method of turning the oscillations on and off (keying), and an antenna to radiate the energy.

An alternator will fail to produce line voltage as a result of _____________. A. a closed circuit breaker B. oxidized slip rings C. improperly staggered brushes D. exciter generator failure

Description : An alternator will fail to produce line voltage as a result of _____________. A. a closed circuit breaker B. oxidized slip rings C. improperly staggered brushes D. exciter generator failure

Last Answer : Answer: D

What is the filter called in which the low frequencies do not produce a useful voltage?

Description : What is the filter called in which the low frequencies do not produce a useful voltage?

Last Answer : High-pass filter, low-frequency discriminator, or low-frequency attenuator.

What transmission method uses a stable cw reference oscillator, which is locked in phase with the transmitter frequency?

Description : What transmission method uses a stable cw reference oscillator, which is locked in phase with the transmitter frequency?

Last Answer : Pulse-Doppler.

Which of the listed transformer uses a single winding to produce voltage transformation? A. Stepup transformers B. Stepdown transformers C. Autotransformers D. Isolation transformers

Description : Which of the listed transformer uses a single winding to produce voltage transformation? A. Stepup transformers B. Stepdown transformers C. Autotransformers D. Isolation transformers

Last Answer : Answer: C

The standard method of controlling the output voltage of a 440 volt, 60 Hz, AC generator is accomplished by adjusting the ____________. A. prime mover speed droop B. number of poles C. alternator field excitation D. load on the alternator

Description : The standard method of controlling the output voltage of a 440 volt, 60 Hz, AC generator is accomplished by adjusting the ____________. A. prime mover speed droop B. number of poles C. alternator field excitation D. load on the alternator

Last Answer : Answer: C

One method of testing for a reversed shunt field coil in a DC generator or motor is by connecting the field to a direct current source, at reduced field rated voltage, and test for polarity using a/an ____________. A. iron bar across each field B. magnetic compass placed near each field C. test lamp across adjacent fields D. copper jumper across the interpole connections

Description : One method of testing for a reversed shunt field coil in a DC generator or motor is by connecting the field to a direct current source, at reduced field rated voltage, and test for ... placed near each field C. test lamp across adjacent fields D. copper jumper across the interpole connections

Last Answer : Answer: B

The simplest method of controlling the terminal voltage of compound-wound DC generator is with a _____________. A. hand-operated field rheostat connected in series with the shunt field circuit B. separate exciter in a series with the shunt field C. carbon pile regulator in series with the load D. balance coil diverting neutral current through the shunt field

Description : The simplest method of controlling the terminal voltage of compound-wound DC generator is with a _____________. A. hand-operated field rheostat connected in series with the shunt field circuit B. ... in series with the load D. balance coil diverting neutral current through the shunt field

Last Answer : Answer: A

The purpose of the commutator and brushes on a DC generator is to _____________. A. transfer generated direct current voltage from the armature to the line B. convert the alternating voltage generated within the armature to a direct voltage C. provide a sliding contact method to excite the field D. reduce sparking between the armature and the carbon brushes

Description : The purpose of the commutator and brushes on a DC generator is to _____________. A. transfer generated direct current voltage from the armature to the line B. convert the alternating voltage ... contact method to excite the field D. reduce sparking between the armature and the carbon brushes

Last Answer : Answer: B

A thermocouple is a device that produces voltage by what method?

Description : A thermocouple is a device that produces voltage by what method?

Last Answer : Heat.

The piezoelectric effect is an example of a voltage being produced by what method?

Description : The piezoelectric effect is an example of a voltage being produced by what method?

Last Answer : Pressure.

All of the following are common characteristics of experimental research except: a. It relies primarily on the collection of numerical data b. It can produce important knowledge about cause and effect c. It uses the deductive scientific method d. It rarely is conducted in a controlled setting or environment

Description : All of the following are common characteristics of experimental research except: a. It relies primarily on the collection of numerical data b. It can produce important knowledge about cause and ... uses the deductive scientific method d. It rarely is conducted in a controlled setting or environment

Last Answer : d. It rarely is conducted in a controlled setting or environment

In a sawtooth generator, why is the transistor turned on for a longer time than the discharge time of the RC network?

Description : In a sawtooth generator, why is the transistor turned on for a longer time than the discharge time of the RC network?

Last Answer : To allow the capacitor time to discharge.

Increasing gate length in a sawtooth generator does what to linearity?

Description : Increasing gate length in a sawtooth generator does what to linearity?

Last Answer : Decreases linearity.

When measuring receiver sensitivity, what quantities must you add to the dBm reading obtained on the signal generator or test set?

Description : When measuring receiver sensitivity, what quantities must you add to the dBm reading obtained on the signal generator or test set?

Last Answer : Attenuations of the directional coupler and the connecting cable.

The range sweep in a range-gate generator is started at the same time as what other pulse?

Description : The range sweep in a range-gate generator is started at the same time as what other pulse?

Last Answer : Transmitter.

When measuring harmonic distortion, you set the signal generator to input a 15-kHz test signal. To what frequency should you set the wave analyzer?

Description : When measuring harmonic distortion, you set the signal generator to input a 15-kHz test signal. To what frequency should you set the wave analyzer?

Last Answer : 45 kHz.

While measuring frequency response, as the signal generator approaches the lowest and highest frequency the recorder can effectively record, the VTVM reading drops to less than - 3 dB. What does this indicate?

Description : While measuring frequency response, as the signal generator approaches the lowest and highest frequency the recorder can effectively record, the VTVM reading drops to less than - 3 dB. What does this indicate?

Last Answer : The upper and lower limits of the frequency response specification for that tape recorder.

What are the differences between the components of a dc generator and a dc motor?

Description : What are the differences between the components of a dc generator and a dc motor?

Last Answer : There are no differences.

What is the purpose of a dc generator that has been modified to function as an amplidyne?

Description : What is the purpose of a dc generator that has been modified to function as an amplidyne?

Last Answer : It can serve as a power amplifier.

What is the effect of motor reaction in a dc generator?

Description : What is the effect of motor reaction in a dc generator?

Last Answer : A force which causes opposition to applied turning force.

How can field strength be varied in a practical dc generator?

Description : How can field strength be varied in a practical dc generator?

Last Answer : By varying the input voltage to the field coils

How many commutator segments are required in a two-coil generator?

Description : How many commutator segments are required in a two-coil generator?

Last Answer : Four

Name the three main sections of a typical rf signal generator.

Description : Name the three main sections of a typical rf signal generator.

Last Answer : Oscillator circuit, modulator, and output control circuit.

What generator characteristics must be considered when alternators are synchronized for parallel operation?

Description : What generator characteristics must be considered when alternators are synchronized for parallel operation?

Last Answer : Output voltage, frequency, and phase relationships.

What determines the phase relationship between the voltages in a two-phase ac generator?

Description : What determines the phase relationship between the voltages in a two-phase ac generator?

Last Answer : Placement of armature coils.

Most large alternators have a small dc generator built into them. What is its purpose?

Description : Most large alternators have a small dc generator built into them. What is its purpose?

Last Answer : To provide dc current for the rotating field.

Where to get a Perpetual generator to produce 240 volts?

Description : Where to get a Perpetual generator to produce 240 volts?

Last Answer : Need answer

How much energy can a diesel generator produce?

Description : How much energy can a diesel generator produce?

Last Answer : This depends on the kilowattage of the generator. Most standard diesel generators are between 8-30 killowatts.

What type of home standby generator would produce enough power for my house?

Description : What type of home standby generator would produce enough power for my house?

Last Answer : As you mentioned, a generator is a good idea. To start, some other necessities include flashlights, batteries, wind up flash lights and radios, canned goods, medical supplies, books on ... surgery and remedies for illnesses as well as literature on any subject pertaining to emergency preparedness.

What is the minimum wind speed needed for a wind power generator to produce electricity?

Description : What is the minimum wind speed needed for a wind power generator to produce electricity?

Last Answer : You will need at least 10 miles per hour wind speeds to generate power with a turbine. Look for an open spot in your garden that is away from other structures or above the roof line.

How much energy does a wind powered generator produce?

Description : How much energy does a wind powered generator produce?

Last Answer : The Phillipe Starcke wind turbine is currently in design and is expected to generate about 60% of a house's energy. When it goes on the market it will be around $500.

The 'function generator' of the control circuit illustrated _______________. EL-0095 A. can be programmed to produce a non-linear output for a linear input depending on operating conditions B. is used for controlling relay contacts' positions in selection circuits C. automatically selects which or how many engines are needed for a required vessel speed D. all of the above

Description : The 'function generator' of the control circuit illustrated _______________. EL-0095 A. can be programmed to produce a non-linear output for a linear input depending on operating conditions B. is used for ... which or how many engines are needed for a required vessel speed D. all of the above

Last Answer : Answer: A

What device is used to produce a gradual change in impedance at the end of a waveguide?

Description : What device is used to produce a gradual change in impedance at the end of a waveguide?

Last Answer : Horn.

What field configuration is easiest to produce in a given waveguide?

Description : What field configuration is easiest to produce in a given waveguide?

Last Answer : . Dominant mode

In a bistable multivibrator, how many trigger pulses are needed to produce one complete cycle in the output?

Description : In a bistable multivibrator, how many trigger pulses are needed to produce one complete cycle in the output?

Last Answer : Two.

What type circuit is used to produce square or rectangular waves?

Description : What type circuit is used to produce square or rectangular waves?

Last Answer : Multivibrator.

The horizontal-deflection plates are used to produce what function?

Description : The horizontal-deflection plates are used to produce what function?

Last Answer : Time and/or frequency relationships.

The horizontal-deflection plates are used to produce what function?

Description : The horizontal-deflection plates are used to produce what function?

Last Answer : Time and/or frequency relationships.

Scopes that produce two channels on a single CRT with a single beam are referred to as what types of scopes?

Description : Scopes that produce two channels on a single CRT with a single beam are referred to as what types of scopes?

Last Answer : Dual-trace oscilloscopes.

A two-input X-OR gate will produce a HIGH output when the inputs are at what logic levels?

Description : A two-input X-OR gate will produce a HIGH output when the inputs are at what logic levels?

Last Answer : . One or the other of the inputs must be HIGH, but not both at the same time.

What type of bias is required to cause an LED to produce light?

Description : What type of bias is required to cause an LED to produce light?

Last Answer : Forward bias.

Which component of the receiver produces the signal that is mixed with the received signal to produce the IF signal?

Description : Which component of the receiver produces the signal that is mixed with the received signal to produce the IF signal?

Last Answer : Local oscillator.