What is the purpose of the filter section?

1 Answer

Answer :

To change pulsating dc to pure dc.

Related questions

Description : What is the purpose of the regulator section?

Last Answer : To maintain a constant voltage to the load.

Description : What is the purpose of the rectifier section?

Last Answer : To change ac to pulsating dc.

Description : What type filter is used to block the passage of current for a narrow band of frequencies, while allowing current to flow at all frequencies above or below this band?

Last Answer : . Band-reject.

Description : What type filter is used to allow a narrow band of frequencies to pass through a circuit and attenuate all other frequencies above or below the desired band?

Last Answer : Bandpass.

Description : What term is used to describe the frequency at which the filter circuit changes from the point of rejecting the unwanted frequencies to the point of passing the desired frequencies?

Last Answer : Frequency cutoff (fco).

Description : What is the filter called that passes low frequencies but rejects or attenuates high frequencies?

Last Answer : Low-pass filter, high-frequency discriminator or high-frequency attenuator.

Description : What is the filter called in which the low frequencies do not produce a useful voltage?

Last Answer : High-pass filter, low-frequency discriminator, or low-frequency attenuator.

Description : What are the two main disadvantages of an LC capacitor filter?

Last Answer : Cost and size of the inductor.

Description : What is the most commonly used filter today?

Last Answer : LC capacitor-input filter.

Description : When is a second RC filter stage used?

Last Answer : When ripple must be held at an absolute minimum.

Description : Why is the use of large value capacitors in filter circuits discouraged?

Last Answer : Expense

Description : Is a full-wave rectifier output easier to filter than that of a half-wave rectifier?

Last Answer : Yes.

Description : What determines the rate of discharge of the capacitor in a filter circuit?

Last Answer : Value of capacitance and load resistance.

Description : Does a filter circuit increase or decrease the average output voltage?

Last Answer : A filter circuit increases the average output voltage

Description : In a capacitor filter, is the capacitor in series or in parallel with the load?

Last Answer : Parallel.

Description : What is the most basic type of filter?

Last Answer : The capacitor filter.

Description : In an LC choke-input filter, what prevents the rapid charging of the capacitor?

Last Answer : The CEMF of the inductor

Description : . What are the two main disadvantages of an LC capacitor filter?

Last Answer : Cost of the inductor and size of the inductor.

Description : What is the most commonly used filter in use today?

Last Answer : LC capacitor-input filter.

Description : When is a second RC filter stage used?

Last Answer : When ripple must be held at an absolute minimum

Description : Why is the use of large value capacitors in filter circuits discouraged?

Last Answer : Expense

Description : Is an RC filter used when a large current or a small current demand is required?

Last Answer : Small.

Description : If the inductance of a choke-input filter is increased, will the output ripple voltage amplitude (Er) increase or decrease?

Last Answer : Decrease.

Description : What is the value usually chosen for a filter choke?

Last Answer : 1 to 20 henries.

Description : In an LC choke-input filter, what prevents the rapid charging of the capacitor?

Last Answer : Counter electro-motive force of the inductor.

Description : Is a full-wave rectifier output easier to filter than that of a half-wave rectifier?

Last Answer : Yes.

Description : . What determines the rate of discharge of the capacitor in a filter circuit?

Last Answer : Value of capacitance and load resistance

Description : Does a filter circuit increase or decrease the average output voltage?

Last Answer : Increase.

Description : Is better filtering achieved at a high frequency or at a low frequency at the input of the filter?

Last Answer : High

Description : In a capacitor filter, is the capacitor in series or parallel with the load?

Last Answer : Parallel.

Description : What is the most basic type of filter?

Last Answer : Capacitor.

Description : What is the function of a crystal filter in a receiver?

Last Answer : It is used to achieve maximum selectivity.

Description : A mode filter is a device that attenuates specific modes propagating in the core of an optical fiber. What mode propagating along single mode fibers do mode filters eliminate?

Last Answer : Second-order mode.

Description : How does a low-pass filter detect pdm?

Last Answer : By averaging the value of the pulses over the period of the pulse-repetition rate.

Description : which components act as the filter network in the diode detector?

Last Answer : C1 and R1.

Description : Section II of the circuit shown in the illustration is the ____________. EL-0085 A. voltage regulator B. filter C. rectifier D. voltage transformer

Last Answer : Answer: C

Description : Section IV of the circuit shown in the illustration is the _____________. EL-0085 A. voltage regulator B. filter C. rectifier D. voltage transformer

Last Answer : Answer: A

Description : Section III of the circuit shown in the illustration is a _____________. EL-0085 A. voltage regulator B. filter C. rectifier D. voltage transformer

Last Answer : Answer: B

Description : List three items of information normally included in the general description section of a specification sheet for a transistor.

Last Answer : The kind of transistor, the transistor's common applications, and mechanical data

Description : In the NPN transistor, what section is made very thin compared with the other two sections?

Last Answer : The P or base section.

Description : What type of rectifier is constructed by sandwiching a section of semiconductor material between two metal plates?

Last Answer : Metallic rectifier.

Description : What type of PN diode is formed by using a fine metal wire and a section of N-type semiconductor material?

Last Answer : Point-contact.

Description : Which RC network provides better frequency stability, three-section or four-section?

Last Answer : Four-section.

Description : . In the arithmetic/logic section, data is returned to what section after processing?

Last Answer : Internal storage.

Description : What capability allows the arithmetic/logic section to test various conditions encountered during processing and take action based on the result?

Last Answer : Logic.

Description : What are the four major types of instructions in the control section?

Last Answer : Transfer, arithmetic, logic, and control.

Description : The control section can be compared to what?

Last Answer : A telephone exchange.

Description : What minimum/maximum voltage level can be attained in the pulse generator section by adjusting the LEVEL control?

Last Answer : 0 to 5 volts.

Description : What circuit section is required in the output of a multivibrator modulator to eliminate unwanted output frequencies?

Last Answer : An LCR filter.

Description : What is the purpose of the Snapchat Speed Filter/app, and is it destined to be eliminated after being blamed and involved in lawsuits blaming it for car crashes?

Last Answer : answer:No. The girl was using her phone while driving-that was the problem. The purpose, as stated by Snapchat, is in your article: The speed filter has plenty of uses, and that many people ... that isn't enough, the Snapchat filter clearly states please do not snap and drive when activated.