Description : Pick up the correct statement from the following: (A) The unit hydrograph of a specified unit duration obtained from the past data can be used to obtain the hydrograph of future storms of like duration (B) ... hydrograph may be obtained by dividing the run off in mm by 25 mm (D) All the above
Last Answer : Answer: Option D
Description : Pick up the correct statement from the following: (A) The specified duration of unit hydrograph, is called unit duration (B) The rain during specified duration, is called unit storm (C) The number of unit hydrographs for a given basin, is theoretically infinite (D) All the above
Description : The peak of a 4 hour flood hydrograph is 240 m3 /sec. If the rainfall excess is 80 mm and base flow which is constant is 40 m3 /sec, peak of 4hours unit hydrograph will be (A) 20 m3 /sec (B) 25 m3 /sec (C) 30 m3 /sec (D) 35 m3 /sec
Last Answer : Answer: Option B
Description : Hydrograph is a graphical representation of (A) Surface run off (B) Ground water flow (C) Rain fall (D) Discharge flowing in the river
Description : If the area of storm hydrograph is equal to 102 cm, the ordinates of a unit hydrograph may be obtained by dividing the ordinates of the storm hydrograph by (A) 0.5 (B) 1 (C) 2 D) 4
Description : Instantaneous unit hydrograph is a hydrograph of (i) Unit duration (ii) Unit rainfall excess (iii) Infinitely small duration (iv) Infinitely small rainfall excess The correct answer is (A) (i) and (ii) (B) (i) and (iv) C) (ii) and (iii) (D) (iii) and (iv)
Last Answer : Answer: Option C
Description : The shape of recession limb of a hydrograph depends upon (A) Basin characteristics only (B) Storm characteristics only (C) Both (A) and (B) (D) None of the above
Last Answer : Answer: Option A
Description : The maximum average depth due to one day storm over an area of 100 km² is 100 mm. DepthArea-Duration (DAD) curves indicate the same area of 100 km² the maximum average depth for a 3 hour storm will be (A) 100 mm (B) More than 100 mm (C) Less than 100 mm (D) None of the above
Description : Minimum clear cover (in mm) to the main steel bars in slab, beam, column and footing respectively, are (a) 10, 15, 20 and 25 (b) 15, 25, 40 and 75 (c ) 20, 25, 30 and 40 (d) 20, 35, 40 and 75
Last Answer : (b) 15, 25, 40 and 75
Description : Minimum cover for fire resistance for a given simply supported beam, when the fire rating is 1 hour--------- [ A ] 15 mm [ B ] 20 mm [ C ] 25 mm [ D ] 30 mm
Last Answer : [ B ] 20 mm
Description : Time of concentration (A) Is the time taken, for precipitation (B) Duration of rainfall (C) Time taken for all the ran off to reach the drain (D) Time taken for the storm water to travel from the most remote point to the drain
Last Answer : (D) Time taken for the storm water to travel from the most remote point to the drain
Description : It takes 0.4 hrs to drive from the garage to the head of the route, 0.4 hrs to drive between the route head and disposal site and 0.25 hrs to return from the disposal site. It takes 0.2 hrs to offload a truck at the ... loading time as 30 minutes. (a) 4.15 hrs (b) 4.25 hrs (c) 4.75 hrs (d) 4.85 hrs
Last Answer : (a) 4.15 hrs
Description : For predicting floods of a given frequency, the best reliable method is (A) Unit hydrograph method (B) Gumbel's analytical method (C) California method (D) None of these
Description : The best unit period of a unit hydrograph, is equal to basin lag divided by (A) 2 (B) 3 (C) 4 (D) 5
Description : Unit Hydrograph theory was enunciated by (A) Merril Bernard (B) W.W. Horner (C) Le-Roy K. Shermen (D) Robert E. Horten
Description : The duration of contact of chlorine with water before it is served to the first consumer, should be at least (A) 10 to 15 minutes (B) 15 to 20 minutes (C) 20 to 30 minutes (D) 30 to 40 minutes
Last Answer : (C) 20 to 30 minutes
Description : The recurrence interval (R.I.) of 20 cm rain storm at a place is 5 years. (A) The place will definitely have 20 cm rain storm after every five years (B) The place may have 20 cm rain storm after every ... (C) The place may have 20 cm rain storm within a set of 5 years twice (D) None of these
Description : A 6 hours storm had 4 cm of rainfall and the resulting runoff was 2 cm. If
Description : Which of the following ranges identifies the amount of pressure within the endotracheal tube cuff that is believed to prevent both injury and aspiration? a) 20-25 mm Hg water pressure. Usually the ... pressure A measure of 0-5 mm Hg water pressure would indicate that the cuff is underinflated.
Last Answer : a) 20-25 mm Hg water pressure. Usually the pressure is maintained at less than 25 cm water pressure to prevent injury and at more than 20 cm water pressure to prevent aspiration.
Description : For determining the ultimate bearing capacity of soil, the recommended size of a square bearing plate to be used in load plate test should be 30 to 75 cm square with a minimum thickness of (A) 5 mm (B) 10 mm (C) 15 mm (D) 25 mm
Description : For a longitudinal reinforcing bar in a column, the minimum cover shall neither be less than the diameter of bar nor less than (A) 15 mm (B) 25 mm (C) 30 mm (D) 40 mm
Description : In slump test, each layer of concrete is compacted by a steel rod 60 cm long and of 16 mm diameter for (A) 20 times (B) 25 times (C) 30 times (D) 50 time
Description : The difference in the reservoir level and the lowest point of the water mains is 180 m. The expected pressure due to water hammer is 7.5 kg/cm2 in a pressure conduit of diameter 1 m. Assuming the efficiency of the ... , is (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Last Answer : (C) 20 mm
Description : In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net ... load should not exceed (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Description : The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Description : The minimum cover to the ties or spirals should not be less than (A) 15 mm (B) 20 mm (C) 25 mm (D) 50 mm
Description : Duration of lone Hooter is: (a) 20 seconds (b) 25 seconds (c) 30 seconds* (d) 50 seconds
Last Answer : (c) 30 seconds*
Description : The solution of radiator should be drained out when the engine has run for a) 10 to 15 minutes b) 15 to 20 minutes c) 20 to 25 minutes d) 25 to 30 minutes
Last Answer : b) 15 to 20 minutes
Description : The respective storm totals at three surrounding stations A, B and C are 110, 90 and 70 mm. If the normal annual precipitation amounts at stations X, A, B and C are respectively 1000, 1100, 1200 and 1250 mm, the estimated storm precipitation at X is (A) 75 mm (B) 77 mm (C) 79 mm
Description : Pick up the correct statement from the following: (A) A hydrograph is a plot of discharge versus time (B) A mass curve is a plot of accumulated flow versus time (C) The mass curve continuously rises (D) All the above
Last Answer : (D) All the above
Description : Pick up the correct statement from the following: (A) Hydrograph is a plot of discharge and time (B) In hydrographs, time is plotted on X-axis (C) The maximum flow in the river due to rainfall, is called peak flow (D) All the above
Description : The infiltration capacity during rain storm, is considerably reduced due to (A) Surface detention (B) Soil moisture (C) Compaction due to rain (D) All the above
Description : Pick up the correct statement from the following: (A) The intensity of rain is the rate at which it falls (B) The duration of rain is the time for which it falls with a given intensity (C) The frequency of rain is the number of times, if falls (D) All the above
Description : The runoff is affected by (A) Type of precipitation (B) Rain intensity and duration of rainfall (C) Rain distribution and soil moisture deficiency (D) All the above
Description : The time required by rain water to reach the outlet of drainage basin, is generally called (A) Time of concentration (B) Time of overland flow (C) Concentration time of overland flow (D) Duration of the rainfall
Description : The drainage area of a town is 12 hectares. Its 40% area is hard pavement ( K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration ... 60) the maximum run off is A. 0.10 cumec B. 0.12 cumec C. 0.15 cumec D. 0.20 cumec
Last Answer : ANS: C
Description : Maximum heat dissipation occurs from a steel wire (k = 0.5 W/m. k) of 15 mm diameter exposed to air (h = 20W/m2.k), when the insulation thickness is __________ mm. (A) 15 (B) 25 (C) 10 (D) 30
Last Answer : (B) 25
Description : Which one of the following statements is incorrect ? (A) Pareto analysis is a statistical method used for analyzing causes, and is one of the primary tools for quality management. (B) Reliability of ... (D) In white-box testing, the test cases are decided from the specifications or the requirements.
Last Answer : (D) In white-box testing, the test cases are decided from the specifications or the requirements.
Description : For 3.25 × 10-2 cumecs discharging from a well, a pump is installed to lift water against a total head of 30 m. The minimum required horse power, is (A) 10 H.P. (B) 15 H.P. (C) 18 H.P. (D) 20 H.P.
Last Answer : (D) 20 H.P.
Description : If the radius of a simple curve is 600 m, the maximum length of the chord for calculating offsets, is taken (A) 15 m (B) 20 m (C) 25 m (D) 30 m
Last Answer : (D) 30 m
Description : Keeping the instrument height as 1.5 m, length of staff 4 m, the slope of the ground as 1 in 10, the sight on the down-slope, must be less than (A) 30 m (B) 25 m (C) 20 m (D) 15 m
Last Answer : (B) 25 m
Description : Metric chains are generally available in (A) 10 m and 20 m length (B) 15 m and 20 m length (C) 20 m and 30 m length (D) 25 m and 100 m length
Last Answer : (C) 20 m and 30 m length
Description : For a given material Young's modulus is 200 GN/m2 and modulus of rigidity is 80 GN/m2 . The value of Poisson's ratio is (A) 0.15 (B) 0.20 (C) 0.25 (D) 0.30
Last Answer : (C) 0.25
Description : A rectangular beam 20 cm wide is subjected to a maximum shearing force of 10,000 kg, the corresponding maximum shearing stress being 30 kg/cm2 . The depth of the beam is (A) 15 cm (B) 20 cm (C) 25 cm (D) 30 cm
Last Answer : (C) 25 cm
Description : A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is (A) 20 cm (B) 25 cm (C) 30 cm (D) 35 cm
Description : The stresses developed in concrete and steel in reinforced concrete beam 25 cm width and 70 cm effective depth, are 62.5 kg/cm2 and 250 kg/cm2 respectively. If m = 15, the depth of its neutral axis is (A) 20 cm (B) 25 cm (C) 30 cm (D) 35 cm
Description : For maximum strength and durability minimum percentage of cement, by weight is (A) 15 % (B) 20 % (C) 25 % (D) 30 %
Description : The raft slab is projected beyond the outer walls of the structure by (A) 5 to 10 cm (B) 15 to 20 cm (C) 25 to 30 cm (D) 30 to 45 cm
Description : A helical spring is fabricated by wrapping wire 19.05 mm in diameter around a forming cylinder 203.2 mm in diameter. Compute the number of turns required to permit an elongation of 101.6 mm. without exceeding a shearing ... G = 82737 N/mm2. a. 10 turns b. 20 turns c. 25 turns d. 30 turns
Last Answer : a. 10 turns