Description : The ball bearing is subjected to a radial load of 4000 N. Expected life for 90% bearings is 9000 hr and the shaft is rot (a) 42.21 kN (b) 37.29 kN (c) 26.33 kN (d) 35.22 kN
Last Answer : (b) 37.29 kN
Description : A sliding contact bearing is operating under stable condition. The pressure developed in oil film is p when the journal rotates at N rpm. The dynamic viscosity of lubricant is μ and effective coefficient of ... to p and f) (d) f is directly proportional to μ and inversely proportional to N
Last Answer : (b) f is directly proportional to μ and N
Description : The rated life of a bearing varies (a) directly as load (b) inversely as the square of the load (c) inversely as the cube of the load
Last Answer : (c) inversely as the cube of the load
Description : The rated life of a bearing varies A. Directly as load B. Inversely as square of load C. Inversely as cube of load D. Inversely as fourth power of load
Last Answer : C. Inversely as cube of load
Description : The rated life of a bearing varies (A) Directly as load (B) Inversely as square of load (C) Inversely as cube of load (D) Inversely as fourth power of load
Last Answer : (C) Inversely as cube of load
Description : Hooke's law states that A. the extension is proportional to the load when the elastic limit is not exceeded B. the extension is inversely proportional to the load when the elastic limit is not ... is independent of the load when the elastic limit is not exceeded D. load is dependent on extension
Last Answer : the extension is proportional to the load when the elastic limit is not exceeded
Description : The load shared by each spring is inversely proportional to the cross section of wire. a) Yes b) No, it is directly proportional c) It is proportional to its square d) It is proportional to its square root
Last Answer : b) No, it is directly proportional
Description : When two transformers are operating in parallel, they will share the load as under: (A) proportional to their impedances. (B) inversely proportional to their impedances. (C) 50% - 50% (D) 25%-75%
Last Answer : Ans: A High rating transformer has higher impedance. kVA rating α Impedance of transformer
Description : Half-life period for a first order reaction is __________ the initial concentration of the reactant. (A) Directly proportional to (B) Inversely proportional to (C) Independent of (D) None of these
Last Answer : (C) Independent of
Description : If the time required for half change is inversely proportional to the square of initial concentration and the velocity depends on the units in which the concentration term is expressed, then the order of reaction is (A) 0 (B) 1 (C) 2 (D) 3
Last Answer : (D) 3
Description : Power required to drive a ball mill with a particular ball load is proportional to (where, D = diameter of ball mill.) (A) D (B) 1/D (C) D2.5 (D) 1/D2.5
Last Answer : (C) D2.5 (D) 1/D2
Description : The activity of a nucleus is inversely proportional to its half of average life. Thus, shorter the half life of an element, greater is its radioactivi
Last Answer : The activity of a nucleus is inversely proportional to its half of average life. Thus, shorter the half life of an ... 0.001 B. 1 C. 0.999 D. 0.1
Last Answer : The activity of a nucleus is inversely proportional to its half of average life. Thus, shorter the half life of an ... n)` D. `t_(1//2) lambda In 2`
Last Answer : The activity of a nucleus is inversely proportional to its half of average life. Thus, shorter the half life of an ... stable? A. I B. II C. III D. IV
Description : As per Gilliland's equation, the diffusivity is (A) Directly proportional to 'T 1.5 ' (B) Inversely proportional to 'P' (C) Dependent on the molecular volume & molecular weight of components (D) All 'a', 'b' & 'c'
Last Answer : (D) All 'a', 'b' & 'c'
Description : The statement that "maximum wavelength of radiation is inversely proportional to the temperature" is __________ law. (A) Stefan-Boltzmann’s (B) Planck's (C) Wien's displacement (D) None of these
Last Answer : (C) Wien's displacement
Description : Wavelength corresponding to the maximum energy is inversely proportional to the absolute temperature. This is __________ law. (A) Stefan's (B) Dalton's (C) Wien's (D) Kirchoff’s
Last Answer : (C) Wien's
Description : In case of a multipass shell and tube heat exchanger, the temperature drop in the fluid (A) Is inversely proportional to the resistance across which the drop occurs (B) And the wall are proportional to individual resistances (C) And the wall is not related (D) None of these
Last Answer : (B) And the wall are proportional to individual resistances
Description : In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid (A) Varies directly as the area and the LMTD (B) Directly proportional to LMTD and inversely proportional to the area (C) Varies as square of the area (D) None of these
Last Answer : (A) Varies directly as the area and the LMTD
Description : In a shell and tube heat exchanger, (A) The temperature drops in the two fluids and the wall are proportional to individual resistances (B) The temperature drop is inversely proportional to ... ) There is no relationship between temperature drop and resistance (D) The relationship is not generalised
Last Answer : (A) The temperature drops in the two fluids and the wall are proportional to individual resistances
Description : Pick out the wrong statement. (A) Cokes of high reactivity are obtained from weakly coking coals (B) Cokes of high reactivity are obtained from strongly coking coals (C) Reactivity of coke is inversely proportional to its absolute density (D) Abrasion index of the coke is a measure of its hardness
Last Answer : (B) Cokes of high reactivity are obtained from strongly coking coals
Description : The friction factor is (A) Always inversely proportional to the Reynolds number (B) Not dimensionless (C) Not dependent on the roughness of the pipe (D) None of these
Last Answer : (D) None of these
Description : Pick out the correct statement. (A) Fanning friction factor is inversely proportional to Reynolds number always (B) The property of a randomly packed bed (with raschig rings) is given by the ratio of the ... the ratio of the speed of the fluid to that of sound in the fluid under conditions of flow
Last Answer : (D) Mach number is given by the ratio of the speed of the fluid to that of sound in the fluid under conditions of flow
Description : In the Newton's law range, the terminal velocity of a solid spherical particle falling through a stationary fluid mass is __________ the fluid viscosity. (A) Directly proportional to (B) Inversely proportional to (C) Inversely proportional to the square root of (D) Independent of
Last Answer : (B) Inversely proportional to
Description : The energy loss over a length of pipeline according to Darcy-Weisbach equation for pipe flow is ___________ the mean velocity of flow. (A) Directly proportional to (B) Directly proportional to square of (C) Inversely proportional to (D) Inversely proportional to square of
Last Answer : (B) Directly proportional to square of
Description : Fanning friction factor for laminar flow of fluid in a circular pipe is (A) Not a function of the roughness of pipe wall (B) Inversely proportional to Reynolds number (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : Bag filter design is predominantly dependent on gas temperature, as it affects the gas density & viscosity and the selection of filtering material. The pressure drop in a bag filter is (A) Inversely proportional to ... the gas (C) Proportional to the pressure of the gas (D) Both (B) and (C)
Last Answer : (D) Both (B) and (C)
Description : Overall rate of reaction in a heterogeneous catalytic reaction depends upon the mass and energy transfer from the fluid to solid surface and its rate of reaction is usually __________ the concentration of ... to (B) Independent of (C) Inversely proportional to (D) Proportional to the square o
Last Answer : (A) Proportional to
Description : At very high concentration of enzymes, the rate of fermentation chemical reaction is __________ the concentration of reactants. (A) Independent of (B) Directly proportional to (C) Inversely proportional to (D) Proportional to the square of
Last Answer : (A) Independent of
Description : Saponification number of an oil or fat (A) Gives an idea about its molecular weight (B) Is inversely proportional to its molecular weight (C) Detects its adulteration (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : For an ideal gas, the activity co-efficient is (A) Directly proportional to pressure (B) Inversely proportional to pressure (C) Unity at all pressures (D) None of these
Last Answer : (C) Unity at all pressures
Description : For a given substance at a specified temperature, activity is __________ to fugacity. (A) Directly proportional (B) Inversely proportional (C) Equal (D) None of these
Last Answer : (A) Directly proportional
Description : Hooke's law (A) Applies to elastic deformation (B) Applies beyond limit of proportionality in stress-strain curve (C) States that stress is inversely proportional to strain upto elastic limit (D) None of these
Last Answer : (A) Applies to elastic deformation
Description : A fluid is termed as the Newtonian fluid, when the shear stress is __________ the velocity gradient. (A) Independent of (B) Inversely proportional to (C) Directly proportional to (D) None of these
Last Answer : (C) Directly proportional to
Description : Which one of the following bearing is intended for a very heavy radial load? (a) Ball bearing (b) Self-aligning roller bearing (c) Roller bearing (d) Thrust bearing
Last Answer : (b) Self-aligning roller bearing
Description : Which of the following cannot take the radial load? (a) Cylindrical Roller bearing (b) Taper roller bearing (c) Thrust ball bearing (d) Spherical roller bearing
Last Answer : (c) Thrust ball bearing
Description : Which of the bearings given below SHOULD NOT be subjected to a thrust load? (a) Deep groove ball bearing (b) Angular contact ball bearing (c) Cylindrical (straight) roller bearing (d) Single row tapered roller bearing
Last Answer : (c) Cylindrical (straight) roller bearing
Description : Cylindrical roller bearing has a lower load capacity as compared to deep groove ball bearing. (a) True (b) False
Last Answer : (b) False
Description : Match List-I (Type of Anti-friction bearing) with List-II (Specific Use) and select the using the code given below the Lists: [IES-2006] List-I List -II A. Self-aligning ball bearing 1. For pure axial load B. Taper roller bearing 2. For ... C D (a) 2 1 3 4 (b) 3 4 2 1 (c) 2 4 3 1 (d) 3 1 2 4
Last Answer : (c) 2 4 3 1
Description : Match List I with List II and select the : [IES-2002] List I (Bearings) List II (Load type) A. Hydrodynamic Journal bearing 1. High radial and thrust load combined B. Rectangular Hydrostatic bearing 2. Radial load only C. Taper Roller ... (a) 2 3 1 4 (b) 4 1 3 2 (c) 2 1 3 4 (d) 4 3 1 2
Last Answer : (a) 2 3 1 4
Description : Which of the following cannot take radial load? a) Cylindrical Roller bearing b) Taper roller bearing c) Thrust ball bearing d) None of the listed
Last Answer : c) Thrust ball bearing
Description : Cylindrical load bearing has lower load capacity as compared to deep groove ball bearing. a) True b) False
Last Answer : b) False
Description : A bearing designed to resist axial load is known as a) Ball bearing b) bush bearing c) thrust bearing d) journal bearing
Last Answer : c) thrust bearing
Description : The periodic time of a body moving in Simple Harmonic Motion is a.Directly proportional to its angular velocity b.Directly proportional to the weight of the body c.Inversely proportional to ... d.Directly proportional to the momentum of swinging body e.Inversely proportional to the angular velocity
Last Answer : e. Inversely proportional to the angular velocity
Description : Let the only force acting on two bodies be their mutual interactions. If both bodies start from rest, the distances travelled by each will be a a.proportional to the respective masses of the ... masses of the bodies e.inversely proportional to the square of the respective masses of the bodies
Last Answer : c. inversely proportional to the respective masses of the bodies
Description : if pressure P is inversely proportional to volume (V) at constant temperature, then PV is constant (True/False)
Last Answer : if pressure P is inversely proportional to volume (V) at constant temperature, then PV is constant (True/False)
Description : If the substrate concentration is much below the km of the enzyme, the velocity of the reaction is (A) Directly proportional to substrate concentration (B) Not affected by enzyme concentration (C) Nearly equal to Vmax (D) Inversely proportional to substrate concentration
Last Answer : Answer : A
Description : The velocity of sound is ….. the density of the medium. (a) Directly proportional to (b) Inversely proportional to (c) Directly proportional to the square root of (d) Inversely proportional to the square root of
Last Answer : Ans:(d)
Description : The frequency of vibration of a stretched string is _______ its length. (a) Directly proportional to (b) Inversely proportional to (c) Directly proportional to the square of (d) Independent of
Last Answer : Ans:(b)
Description : Average density of the Earth (a) Is directly proportional to g (b) Is inversely proportional to g (c) Does not depend on g (d) Is a complex function of g
Last Answer : Ans:(c)