Define rectifier and list its types.

Define rectifier and list its types. 
by

1 Answer

Answer :

Definition: A rectifier is a circuit that converts AC input voltage into DC output voltage. 


Types : 1) Half wave rectifier  2) Center tap full wave rectifier. 3) Bridge Rectifier 

by

Related questions

Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform.

Description : Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform. 

Last Answer : Circuit diagram of bridge rectifier with π filter : Input and output waveform:

An AC supply of 230 V is applied to half wave rectifier circuit. A transformer turns ratio is 20 : 1. Find i) Output DC voltage (ii) Peak Inverse Voltage (PIV)

Description : An AC supply of 230 V is applied to half wave rectifier circuit. A transformer turns ratio is 20 : 1. Find i) Output DC voltage (ii) Peak Inverse Voltage (PIV)

Last Answer : Solution:

Explain Center-tapped full wave rectifier with the help of circuit diagram and draw input output waveforms.

Description : Explain Center-tapped full wave rectifier with the help of circuit diagram and draw input output waveforms. 

Last Answer : Operation : During positive half cycle of an AC supply, D1 will forward biased and current starts flowing through load. The output voltage is equal to +Vs. During negative half cycle of an AC ... output voltage is equal to +Vs. In this pulsating DC waveform will be obtained at the load. 

Suggest the suitable diode type for rectifier circuit.

Description : Suggest the suitable diode type for rectifier circuit. 

Last Answer : Any general purpose diodes 1N4001 to 1N4007 series  Or Silicon diode & Germanium diode 

List the applications of RC oscillator and crystal oscillator.

Description : List the applications of RC oscillator and crystal oscillator.

Last Answer : Applications of RC oscillator :  1) In AF signal generators 2) In radio transmitter & Receivers 3) Sine wave generator.  Applications of Crystal oscillator : 1) Electronic navigation systems 2) Frequency Synthesizers 3) Timing circuits (Clock) with high stability. 4) RADAR systems. 

List configurations of BJT.

Description : List configurations of BJT. 

Last Answer : Configurations of BJT : 1) Common Base (CB) configuration 2) Common Emitter (CE) configuration 3) Common Collector (CC) configuration

Define the term line regulation.

Description : Define the term line regulation. 

Last Answer : Line regulation is the ability of a power supply to maintain a constant output voltage irrespective of any changes in input voltage. 

Define rectifier. State its types.

Description : Define rectifier. State its types.

Last Answer : A rectifier is defined as an electronic device which converts alternating (AC) voltage or current into unidirectional/ pulsating (D.C) voltage or current. Types of Rectifier: 1. Half wave rectifier 2. Full wave rectifier a. Centre tapped full wave rectifier b. Full wave bridge rectifier

Name the circuit used in rectifier to minimize ripple. List the types of this circuit with simple circuit diagram.

Description : Name the circuit used in rectifier to minimize ripple. List the types of this circuit with simple circuit diagram.

Last Answer : Rectifier filter is an electronic circuit that removes ripple or unwanted AC signal components from the output of a Rectifier. Types - (a) Series Inductor filter (d) Shunt capacitor filter (b) L-C type filter (e) Π - type filter

Draw output characteristics of common emitter [CE] configuration and explain active, saturation and cut-off regions in detail.

Description : Draw output characteristics of common emitter [CE] configuration and explain active, saturation and cut-off regions in detail. 

Last Answer : Characteristics of common emitter [CE] configuration Explanation :  (1) Active Region: In this region collector junction is reverse biased and emitter junction is forward biased. It is ... the transistor collector current is approximately given by VCC / RC and independent of base current. 

Identify type of BJT configuration having following features : (i) BJT configuration having the least current gain. (ii) KIT configuration called as voltage follower. (iii) BJT configuration having current gain less than one. (iv) BJT configuration suitable for impedance matching. (v) BIT configuration suitable for voltage amplification. (vi) BJT configuration having the least output impedance.

Description : Identify type of BJT configuration having following features : (i) BJT configuration having the least current gain. (ii) KIT configuration called as voltage follower. (iii) BJT ... configuration suitable for voltage amplification. (vi) BJT configuration having the least output impedance.  

Last Answer : (i) BJT configuration having the least current gain : Common Base Configuration  (ii) KIT configuration called as voltage follower: Common Collector Configuration  (iii) BJT ... Emitter Configuration  (vi) BJT configuration having the least output impedance: Common Collector Configuration

Describe the working principle of photodiode with proper diagram.

Description : Describe the working principle of photodiode with proper diagram.

Last Answer : Diagram of photo diode : Working principle of photo diode :  When photons of energy greater than 1.1 eV hit the diode, electron-hole pairs are created. The intensity of photon ... , the holes move toward the anode and the electrons move toward the cathode, thereby producing photocurrent. 

Describe transistor as a switch with neat sketch.

Description : Describe transistor as a switch with neat sketch.

Last Answer : In Bipolar Transistor as a Switch the biasing of the transistor, either NPN or PNP is arranged to operate the transistor at both sides of the I-V characteristics curves. The areas ... possible and maximum current flowing through the transistor. Therefore the transistor is switched Fully-ON .

Differentiate between positive and negative feedback on the basis of . (i) overall phase shift (ii) voltage gain (iii) stability (iv) applications

Description : Differentiate between positive and negative feedback on the basis of . (i) overall phase shift (ii) voltage gain (iii) stability (iv) applications 

Last Answer : Compare positive feedback and negative feedback on the basis of: (i) Gain (ii) Bandwidth (iii) Phase shift (iv) Stability

Draw block diagram of IC 723. Write the functions of IC 723.

Description : Draw block diagram of IC 723. Write the functions of IC 723.

Last Answer : Functions of IC 723 : 1. Series, shunt, switching and floating regulators 2. Basic Low-voltage Regulator (Vo = 2 to 37 volts) 3. Low Voltage High Current Regulator.  ... off is obtained by connecting a small capacitor of 100 pF between frequency compensation and inverting input terminals. 

Draw the symbol, logic expression and truth table of NOR gate.

Description : Draw the symbol, logic expression and truth table of NOR gate.

Last Answer : symbol, logic expression and truth table of NOR gate

Draw the symbol of LED & photodiode.

Description : Draw the symbol of LED & photodiode. 

Last Answer : Symbol of LED & photodiode

List three meter movements that can measure either ac or dc without the use of a rectifier.

Description : List three meter movements that can measure either ac or dc without the use of a rectifier.

Last Answer : Electrodynamic, moving vane, and hot-wire or thermocouple.

List the two advantages of Bridge Rectifier.

Description : List the two advantages of Bridge Rectifier. 

Last Answer : The advantages of bridge rectifier: The output is twice that of the center-tap circuit for the same secondary voltage. The PIV is one half that of the center-tap circuit. The ... and hence transformer losses are reduced. It can be used in applications allowing floating output terminals. 

List out advantages and disadvantages of bridge rectifier.

Description : List out advantages and disadvantages of bridge rectifier.

Last Answer : Advantages :  1. Bridge rectifier can be used in applications allowing floating output terminals i.e. not output terminal is grounded.  2. The need of center-tapped transformer is eliminated.  ... The value of the diodes used should be precise , else there will be an error in rectification

Define : (i) Efficiency (ii) TUF of Rectifier

Description : Define : (i) Efficiency (ii) TUF of Rectifier

Last Answer : Rectifier efficiency (ɳ) : it is defined as the ratio of DC power to the applied input AC power. Transformer utilization factor: It is defined as the ratio of the DC power available at the load resistor and the AC rating of the secondary coil of a transformer.

Define given parameters and state their values for bridge rectifier (i) Ripple factor (ii) PIV of diode.

Description : Define given parameters and state their values for bridge rectifier (i) Ripple factor (ii) PIV of diode.

Last Answer : Ripple Factor: Ripple Factor is defined as the ratio of RMS value of the AC component of output to the DC or average value of the output. Mathematically it is expressed as, ( ... which appears across non-conducting reverse biased diode. (ii) PIV of diode for bridge rectifier-Vm

Define following parameter of rectifier: (i) Ripple factor (ii) Efficiency (iii) Peak Inverse Voltage (iv) Transformer utilization factor

Description : Define following parameter of rectifier: (i) Ripple factor (ii) Efficiency (iii) Peak Inverse Voltage (iv) Transformer utilization factor

Last Answer : (i) Ripple Factor - Ripple factor (γ) may be defined as the ratio of the root mean square (rms) value of the ripple voltage to the absolute value of the DC component of the ... the same rectifier. Effective VA Rating of transformer is the average of primary and secondary VA rating of transformer.

Define rectifier. Draw circuit diagram and input-output waveforms of bridge type full wave rectifier

Description : Define rectifier. Draw circuit diagram and input-output waveforms of bridge type full wave rectifier 

Last Answer : Rectifier - This circuit convert AC signal into DC.

Define PIV, TUF, ripple factor, efficiency of rectifier.

Description : Define PIV, TUF, ripple factor, efficiency of rectifier.

Last Answer : PIV: Peak Inverse Voltage (PIV) is defined as the maximum negative voltage which appears across non-conducting reverse biased diode. TUF : Transformer Utilization Factor (TUF) is defined as the ratio of DC output ... Efficiency of rectifier: η = DC output power/ AC input power = PLdc / Pac

Define the term 'Ripple factor' for rectifier.

Description : Define the term 'Ripple factor' for rectifier.

Last Answer : Ripple factor: The ratio of RMS value of ac component present in the waveform to the dc component in the waveform is called as ripple factor.  OR  The unwanted AC components present in output waveform of a rectifier is called as ripple factor.

what is rectifier and its types?

Last Answer : rectifier is a device which converts AC voltage to pulsating DC voltage using one or more diode diode conducts only in unit direction that is forward bias condition practically it does not conduct ... types one is with using two diodes and Centre tap Transformer and another is bridge wave rectifier

Name the types of rectifier.

Description : Name the types of rectifier.

Last Answer : The two types of rectifier are: a) Half wave rectifier b) Full wave rectifier.

What is rectifier? Write few types of rectifiers.

Description : What is rectifier? Write few types of rectifiers.

Last Answer : Rectifier is a device which converts AC supply into DC. Following are the types of rectifiers generally used. a. Copper oxide rectifier. b. Selenium rectifier. c. Electrolytic rectifier. d. Mercury arc rectifier. e. Tungar rectifier.

Draw the circuit diagram and describe the working principle of full wave bridge rectifier. Draw its waveforms.

Description : Draw the circuit diagram and describe the working principle of full wave bridge rectifier. Draw its waveforms. 

Last Answer : During the first half cycle : During the first half cycle of the input voltage, the upper end of the transformer secondary winding is positive with respect to the lower end. Thus during the first ... , terminal D, diode D4, and terminal A back to transformer and output will positive half cycle.

Draw & describe working of bridge rectifier with its input output waveforms

Description : Draw & describe working of bridge rectifier with its input output waveforms

Last Answer : Four diodes are used. a)In positive half cycle Diodes D1 & D3 becomes forward biased they will conduct & current flows at that time D2 and D4 are reverse biased they will not ... at that time D1 and D3 are reverse biased they will not conduct. we get full cycle rectification.

Draw and describe circuit diagram of centre tapped rectifier with LC filter along with its input and output waveforms.

Description : Draw and describe circuit diagram of centre tapped rectifier with LC filter along with its input and output waveforms.

Last Answer : Explanation: A centre- tap full wave rectifier drive produces the rectified voltage and it drives the LC filter. We know that the series inductor filter is preferred for low values of load resistance ( ... load RL. The output voltage waveforms are similar to that as shown in figure above.  

The input frequency of a bridge rectifier is 50 its output frequency will be

Description : The input frequency of a bridge rectifier is 50 its output frequency will be  1. 25 Hz 2.50 Hz 3.75 Hz 4. 100 Hz

Last Answer : The input frequency of a bridge rectifier is 50 its output frequency will be 100 Hz

Define array. List its types.

Description : Define array. List its types. 

Last Answer : An array is a homogeneous data type where it can hold only objects of one data type. Types of Array:  1)One-Dimensional 2)Two-Dimensional 

Define Constructor. List its types.

Description : Define Constructor. List its types. 

Last Answer : Constructor: A constructor is a special member which initializes an object immediately upon creation. It has the same name as class name in which it resides and it is syntactically similar to ... . Types of constructors: 1. Default constructor 2. Parameterized constructor 3. Copy constructor 

Define stream class. List its types.

Description : Define stream class. List its types.

Last Answer : Definition of stream class: An I/O Stream represents an input source or an output destination. A stream can represent many different kinds of sources and destinations, including disk files, devices, other ... , Writer. Types of stream classes: i. Byte stream classes ii. Character stream classes.

Define Normalization, list its types.

Description : Define Normalization, list its types.

Last Answer : Normalization is a systematic approach of decomposing tables to eliminate data redundancy(repetition) and undesirable characteristics like Insertion, Update and Deletion Anomalies. It is a multi-step process that ... data from the relation tables. Types of Normalization are: 1NF,2NF,3NF,4NF,5NF