Description : Thermal efficiency of blast furnace stoves used for heating blast (air) may be about __________ percent. (A) 20 (B) 40 (C) 60 (D) 80
Last Answer : (D) 80
Description : . An example of a periodic furnace is the (A) Blast furnace stoves (B) Blast furnace (C) Coke oven heating chamber (D) Rotary kilns
Last Answer : (A) Blast furnace stoves
Description : Regenerators are used for waste heat recovery in (A) By-product coke ovens (B) Beehive coke oven (C) Blast furnace stoves (D) Soaking pits
Last Answer : (A) By-product coke ovens
Description : Which furnace employs an I.D. fan for the removal of flue gases from the furnace? (A) Coke oven (B) Blast furnace stoves (C) Beehive coke oven (D) High pressure boiler
Last Answer : (D) High pressure boiler
Description : Heat transfer takes place through a liquid medium surrounding the submerged material under heating, in case of a/an (A) Blast furnace (B) Steam boiler (C) Salt bath furnace (D) Annealing furnace
Last Answer : (C) Salt bath furnace
Description : Blast furnace coke is made from coal by (A) Low temperature carbonisation (B) High temperature carbonisation (C) Medium temperature carbonisation (D) Heating the coal in an oven in presence of air
Last Answer : (B) High temperature carbonisation
Description : Coke oven gas after passing through return electrostatic tar precipitator (RETP) is used for the (A) Hot scarfing of steel slabs (B) Mixing with blast furnace gas (C) Coke oven battery heating (D) Steel ladle drying
Last Answer : (C) Coke oven battery heating
Description : A mixture of haematite, coke and limestone on heating in blast furnace gives molten iron metal. This is known as
Last Answer : A mixture of haematite, coke and limestone on heating in blast furnace gives molten iron metal. ... Smelting B. Calcination C. Roasting D. Liquition
Description : Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600°C, the percentage stack loss will be maximum in case ofcomplete combustion of (A) Furnace oil with air (B) Furnace oil with oxygen (C) Blast furnace gas with air (D) Blast furnace gas with oxygen
Last Answer : (C) Blast furnace gas with air
Description : Explosion limit of blast furnace gas is 37 to 71% gas in gas-air mixture. It means that the blast furnace gas will explode when burnt in a confined space, if its concentration in the gas-air mixture is __________ percent. (A) < 37% (B) > 71% (C) In between 37 & 71% (D) None of these
Last Answer : (C) In between 37 & 71%
Description : Which of the following fuel gases is heavier than air? (A) Blast furnace gas (B) Coke oven gas (C) Natural gas (D) Water gas
Last Answer : (A) Blast furnace gas
Description : Which of the following fuel gases will require maximum amount of air for combustion of 1 Nm3 gas? (A) Blast furnace gas (B) Natural gas (C) Producer gas (D) Water gas
Last Answer : (B) Natural gas
Description : Producer gas is obtained by A. partial combustion of coal, coke, anthracite coal or charcoal in a mixed air steam blast B. carbonisation of bituminous coal C. passing steam over incandescent coke D. passing air and a large amount of steam over waste coal at about 650°C
Last Answer : Answer: A
Description : The main charge in blast furnace is usually (A) Iron ore & coke (B) Iron ore, coke & air (C) Limestone, coke & iron ore (D) Limestone, sand & iron ore
Last Answer : Limestone, coke & iron ore
Description : The main reducing agent in iron blast furnace is(A) Carbon dioxide (B) Carbon monoxide (C) Oxygen (D) Air
Last Answer : Option B
Description : The most efficient equipment for the removal of sub-micronic dust particles from blast furnace gas is the (A) Venturi atomiser (B) Gravity settling chamber (C) Electro-static precipitator (D) Cyclone separator
Last Answer : (C) Electro-static precipitator
Description : Coke ovens in steel plant are heated by (A) Electricity (B) Blast furnace gas/mixed gas (C) Coke oven gas (D) Both (B) and (C)
Last Answer : (D) Both (B) and (C)
Description : Fuel used in B.F. stove is (A) Pulverised coal (B) Furnace oil (C) Blast furnace gas/mixed gas (D) Coke oven gas
Last Answer : (C) Blast furnace gas/mixed gas
Description : Which of the following is not a by-product fuel? (A) Producer gas (B) Blast furnace gas (C) Coke oven gas (D) Refinery gas
Last Answer : (A) Producer gas
Description : Which of the following has the least calorific value (kcal/Nm3 )? (A) Blast furnace gas (B) Coke oven gas (C) Sewage gas (D) Natural gas
Description : Which of the following gaseous fuels has the lowest calorific value? (A) Gobar gas (B) Refinery gas (C) Converter gas (D) Blast furnace gas
Last Answer : (D) Blast furnace gas
Description : Blast furnace gas burns with a bluish flame, because of the presence of (A) CO (B) CH4 (C) CO2 (D) S
Last Answer : (A) CO
Description : Gross & net calorific value is the same for (A) Blast furnace gas (B) Coke oven gas (C) L.D. converter gas (D) None of these
Last Answer : (C) L.D. converter gas
Description : Mixed gas' used in steel plants is a mixture of (A) B.F. gas and coke oven gas (B) Coke oven gas and converter gas (C) Coke oven gas and L.P.G (D) Blast furnace gas and naphtha vapor
Last Answer : (A) B.F. gas and coke oven gas
Description : Dust content in raw blast furnace gas is about __________ gm/Nm3 ; hence it is cleaned to the dust level of about < 10 mg /Nm3 before use. (A) 15-30 (B) 1-2 (C) 70-100 (D) 150-200
Last Answer : (A) 15-30
Description : Which of the following is the most poisonous gas? (A) Coke oven gas (B) Producer gas (C) Blast furnace gas (D) L.D. converter gas
Last Answer : (D) L.D. converter gas
Description : Coke oven gas compared to blast furnace gas is (A) More explosive and inflammable (B) Less poisonous (C) Lighter (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : Which of the following is not a by-product fuel? (A) Pitch (B) Blast furnace gas (C) Petrol (D) Refinery gas
Last Answer : (C) Petrol
Description : Which of the following has the highest theoretical flame temperature? (A) Blast furnace gas (B) Hydrogen (C) Acetylene (D) Coke oven gas
Last Answer : (C) Acetylene
Description : Coke oven gas is a better fuel than blast furnace gas, because of its higher (A) Calorific value, cleanliness and relatively low distribution cost (due to its low specific gravity) (B) Adiabatic flame temperature ... release rate (thus requiring smaller combustion chamber) (D) All (A), (B) and (C)
Description : Which of the following will generate maximum volume of product of complete combustion (Nm3 /Nm3 of fuel)? (A) Carburetted water gas (B) Blast furnace gas (C) Natural gas (D) Producers' gas
Last Answer : (C) Natural gas
Description : Out of the following fuels, the difference between gross and net calorific value will be minimum in case of (A) Coke oven gas (B) Water gas (C) Natural gas (D) Blast furnace gas
Description : Which of the following has the highest gross calorific value? (A) Blast furnace gas (B) Coke oven gas (C) Carburetted water gas (D) Oil refinery gas
Last Answer : (D) Oil refinery gas
Description : Yield of blast furnace gas is about __________ Nm3 /ton of pig iron. (A) 300 (B) 2000 (C) 5000 (D) 10000
Last Answer : (B) 2000
Description : Which is the heaviest fuel gas out of the following? (A) Blast furnace gas (B) Coke oven gas (C) Water gas (D) Carburetted water gas
Description : Which of the following combustibles is absent in blast furnace gas? (A) H2 (B) CH4 (C) CO (D) None of these
Last Answer : (B) CH4
Description : High ash containing coke (A) Produces more slag when used in the blast furnace (B) Has poor strength and abrasion resistance (C) Is desirable in producer gas manufacture (D) None of these
Last Answer : (A) Produces more slag when used in the blast furnace
Description : Percentage of nitrogen in blast furnace gas may be around (A) 5 (B) 25 (C) 55 (D) 80
Last Answer : (C) 55
Description : The calorific value is the highest out of the following for (A) Producer gas (B) Water gas (C) Coke oven gas (D) Blast furnace gas
Last Answer : (C) Coke oven gas
Description : Which of the following is a poisonous fuel gas? (A) Coke oven gas (B) Blast furnace gas (C) Natural gas (D) None of these
Last Answer : (B) Blast furnace gas
Description : Blast furnace gas compared to coke oven gas has (A) Lower ignition temperature (B) Narrower limit of inflammability (C) Higher calorific value (D) Lower theoretical flame temperature
Last Answer : (D) Lower theoretical flame temperature
Description : Which of the following is a primary fuel? (A) Blast furnace coke (B) Gasoline (C) Natural gas (D) Wood charcoal
Description : Largest constituent of blast furnace gas is (A) N2 (B) CO (C) CO2 (D) H2
Last Answer : (A) N2
Description : Blast furnace gas is a very poisonous gas because of its predominantly high __________ content. (A) H2O (B) CO2 (C) CO (D) CH4
Last Answer : (C) CO
Description : Percentage of carbon monoxide in blast furnace gas may be around (A) 8 (B) 14 (C) 22 (D) 52
Last Answer : (C) 22
Description : Out of the following fuels, the difference between the net and gross calorific value is maximum in case of (A) Pitch (B) Fuel oil (C) Blast furnace gas (D) Bituminous coal
Last Answer : (B) Fuel oil
Description : Blast furnace gas constitutes mainly of (A) N2 & CH4 (B) N2 & H2 (C) N2 & CO (D) CH4 & CO2
Last Answer : (C) N2 & CO
Description : Calorific value of blast furnace gas is around __________ KCal/Nm3 . (A) 850 (B) 1800 (C) 4200 (D) 6500
Last Answer : (A) 850
Description : Suspended solid present in the waste water generated in blast furnace gas cooling and cleaning plant is removed by (A) Biological oxygen pond (B) Radial settling tank (thickener) using coagulant (lime & ferrous sulphate) (C) Lagoons (D) Filtration
Last Answer : (B) Radial settling tank (thickener) using coagulant (lime & ferrous sulphate)