i) Spirit Level:-
* It is used to check the level.
* It is a common instrument to test or adjust horizontal surface.
ii) Growler:-
* It is a equipment used for finding shorted turns of armature coil or stator/rotor winding.
It is essentially a single winding transformer.
iii) Bearing Puller:-
* Bearing puller is used for holding and removing the item.
iv) Megger:-
* Megger is used to find out insulation resistance of electrical machine/equipment
* Megger (mega ohm meter) are available for DC voltage of 500V to 5000V.
v) Earth Tester :-
* A earth tester works on the same principle as a megger.
* It is used to measure earth resistance.
vi) Bench Vice :-
* It is used to Clamp the material in its vice for cutting or threading operations.
* For electrical work generally bench vice is used.
* The machine vice is used holding the item while they are being drilled.
vii) Dial Indicator :-
* Dial type indicator are used to check the run-out (Unbalance) of rotating parts (commutators, rotor, shafts) and indicators can also used to check the alignment of shaft in electrical machines.
viii) Filler Gauge :-
* It is used to check the air gap.
x) Multimeter:-
* Measurement of voltage of various ranges.
* Measurements of current of various ranges.
* Measurement of DC resistance
* To check the Continuity
ix) Combination plier :
* It is used for cutting of wires, gripping operation by hand, twisting wires and other different operations required in electrical work
(xi) Tester :
To verify the live main or supply verification
(xii) Wire Stripper: To cut the wire & remove the insulation of the wire.