fundamental mode
Description : If we wrap a second wire around a guitar string to increase its mass what effect does this have on the frequency and wavelength of the fundamental standing wave formed on that string?
Last Answer : What is the answer ?
Description : An organ pipe which is open at both ends resonates at its fundamental frequency. Neglecting any end effects, what wavelength is formed by this pipe in this mode of vibration if the pipe is 2 meters long? w) 2 meters x) 4 meters y) 6 meters z) 8 meters.
Last Answer : ANSWER: X -- 4 METERS
Description : Highest point on AC graph is known as A. peak value B. amplitude C. frequency D. wave front
Last Answer : peak value
Description : Quality of a musical note depends on – (1) Fundamental frequency (2) Amplitude of the wave (3) Harmonics present (4) Velocity of sound in the medium
Last Answer : (3) Harmonics present Explanation: Sound "quality" or "timbre" describes those characteristics of sound which allow the ear to distinguish sounds which have the same pitch and loudness. Timbre is mainly ... and the attack-decay envelope of the sound. Harmonic content is the most important of these.
Description : Quality of a musical note depends on (1) Fundamental frequency (2) Amplitude of the wave (3) Harmonics present (4) Velocity of sound in the medium
Last Answer : Harmonics present
Description : The Nyquist theorem specifies the minimum samplingrate to be_______. A) equal to the lowest frequency of asignal B) equal to the highest frequency ofa signal C) twice thebandwidth of a signal D) twice thehighest frequencyof a signal
Last Answer : twice thehighest frequencyof a signal
Description : It is an average power of a radio transmitter supplied to the antenna transmission line taken during a long sufficient interval of time and compared with the lowest frequency encountered in the modulation ... operating conditions. A. Carrier power B. Rated power C. Mean power D. Peak envelop power
Last Answer : C. Mean power
Description : The base peak in mass spectrum is? A. The lowest mass peak B. The peak corresponding to the parent ion C. The highest mass peak D. The peak set to 100% relative intensity
Last Answer : The peak set to 100% relative intensity
Description : Which of the following characterizes a properly terminated transmission line? A. The line loss is minimum. B. The standing wave ratio is minimum. C. The input impedance is twice the load impedance. D. The standing wave ratio is one.
Last Answer : D. The standing wave ratio is one.
Description : An RG-11/U foam coaxial cable has a maximum voltage standing wave of 52 V and a minimum voltage of 17 V. Find the value of the resistive load. A. 24.59Ω B. Either A or C C. 228.75Ω D. Neither A nor C
Last Answer : B. Either A or C
Description : The lowest frequency produced by an instrument. A. Harmonic B. Fundamental C. Midrange D. 0 Hz
Last Answer : B. Fundamental
Description : Lowest frequency produced by a musical instrument. A. Fundamental B. Midrange C. Period D. Harmonic
Last Answer : A. Fundamental
Description : The value of the normalized frequency parameter (V) relates the core size with mode propagation. When single mode fibers propagate only the fundamental mode, what is the value of V?
Last Answer : V≤2.405.
Description : Which wave has the highest frequency? w) microwaves x) infrared waves y) ultraviolet waves z) radio waves
Last Answer : ANSWER: Y -- ULTRAVIOLET WAVES
Description : A string of length L is fixed between two points. If a standing wave of 5 nodes is produced, what is the relationship between the string's length, L, and its wavelength?
Last Answer : ANSWER: WAVELENGTH = 1/2 L
Description : A wave and its reflection produce a standing wave with the distance from NODE to nearest ANTINODE of 4 meters. The wavelength of this wave is: w) 4 meters x) 8 meters y) 12 meters z) 16 meters
Last Answer : ANSWER: Z -- 16 METERS
Description : What is the amplitude of a standing wave at its node?
Last Answer : ANSWER: 0
Description : A standing wave is formed on a tightly stretched string. The distance between a node and an antinode is: w) 1/8 wavelength x) 1/4 wavelength y) 1/2 wavelength z) 1 wavelength
Last Answer : ANSWER: X -- 1/4 WAVELENGTH
Description : The minimum frequency required to eject electrons from a metallic surface is called a) Critical frequency b) Peak value of frequency c) Threshold frequency d)Photo frequency
Last Answer : c) Threshold frequency
Description : The absolute value of a signal's highest intensity is called………. A. Peak Amplitude B. Frequency C. Phase D. Both a and c
Last Answer : A. Peak Amplitude
Description : To obtain the most reliable sky wave propagation the ____ should be used. A. Lowest useable frequency (LUF). B. Maximum useable frequency (MUF). C. Optimum useable frequency (OUF). D. Critical frequency
Last Answer : C. Optimum useable frequency (OUF).
Description : The number of cycles per second occurring in AC voltage is known as the _____________. A. phase angle B. frequency C. wave form D. half mode
Last Answer : Answer: B
Description : Standing waves are formed when two sets of waves of equal amplitude and frequency w) are in phase x) are in opposite phase y) move through each other in opposite directions z) are reflected from the same surface
Last Answer : ANSWER: Y -- MOVE THROUGH EACH OTHER IN OPPOSITE DIRECTIONS
Description : Ratio of the velocity of propagation of a light ray in free space to the velocity of propagation of a light ray in free space in a given material. ∙ A. refractive index ∙ B. standing wave ratio ∙ C. velocity factor ∙ D. propagation velocity
Last Answer : ∙ A. refractive index
Description : At what time of day is the relative humidity normally at a minimum -------- ? A. When the air temperature is highest (Answer) B. Just before sunrise C. About midnight D. When the air temperature is lowest
Last Answer : A. When the air temperature is highest (Answer)
Description : The product of the power supplied to the antenna and its gain relative to a half-wave dipole in a given direction. A. Peak envelope power B. ERP C. Rated power D. Carrier power’
Last Answer : B. ERP
Description : How to maximize the skip distance? A. Using the smallest possible radiation angle and highest possible frequency B. Using the smallest possible radiation angle and lowest possible frequency ... highest possible frequency D. Using the biggest possible radiation angle and lowest possible frequency
Last Answer : A. Using the smallest possible radiation angle and highest possible frequency
Description : Skip distance can be maximized by using the ____ radiation angle possible and the ____ frequency that will be refracted at that angle. A. lowest, lowest B. lowest, highest C. highest, lowest D. highest, highest
Last Answer : B. lowest, highest
Description : The _____of a composite signal is the difference between the highest and the lowest frequencies contained in that signal. A) frequency B) period C) bandwidth D) amplitude
Last Answer : frequency
Description : While measuring frequency response, as the signal generator approaches the lowest and highest frequency the recorder can effectively record, the VTVM reading drops to less than - 3 dB. What does this indicate?
Last Answer : The upper and lower limits of the frequency response specification for that tape recorder.
Description : A node having twice the frequency of the fundamental is called A. half harmonic B. harmonic C. double harmonic D. triple harmonic
Last Answer : harmonic
Description : Which of the following has the lowest frequency? (1) Visible light (2) Gamma rays (3) Xrays (4) Ultra violet rays
Last Answer : (1) Visible light Explanation: The common material used as fuse wire is an alloy of tin and lead (63% tin and 37% lead). Fuse wires provide over current protection of an electrical circuit ... or strip that melts when too much current flows through it, thereby interrupting the flow of current.
Last Answer : Visible light
Description : Bit on left hand side has A. lowest value B. zero value C. highest value D. infinite value
Last Answer : highest value
Description : As a pendulum swings from its highest to its lowest point, it has the SMALLEST acceleration when it is: w) at its lowest point x) at its highest point y) at a point 1/3 the distance from the top of its swing z) at a point 1/2 the distance from the top of its swing.
Last Answer : ANSWER: W -- AT ITS LOWEST POINT
Description : What does the Voltmeter in AC mode show? Is it RMS value or peak value?
Last Answer : Multimeter in AC mode shows RMS value of the voltage or current. Also when it is DC mode it will show the RMS value only.
Description : Amplitude of modulated wave is in phase with A. output B. system C. frequency D. signal
Last Answer : signal
Description : A man standing at the top of a tower has two spheres A and B. He drops sphere A downwards and throws sphere B horizontally at the same time. Which of the following is correct? (1) Both the ... reach the ground first. (4) The question is incomplete because the masses of the spheres are not given.
Last Answer : (1) Both the spheres will reach the ground simultaneously. Explanation: If no air resistance is present, the rate of descent depends only on how far the object has fallen, no matter how heavy ... objects will reach the ground at the same time if they are dropped simultaneously from the same height.
Description : A man standing on a edge of a cliff throws a stone vertically upwards with a certain speed. He then throws another stone downwards with the same speed. Find the ratio of the speeds of the two stones when they hit the ground ... : 1 (2) 1 : 2 (3) 1 : 4 (4) Cannot be found from the given information.
Last Answer : (1) 1 : 1 Explanation: The stone which is throws upward will have the same velocity of u at the point of its original position when it is falling down. Another stone is thrown downwards with u. So ... will hit the ground with same velocity. So the ratio between the speeds of two stones will be 1:1
Description : A man standing at the top of a tower has two spheres A and B. He drops sphere A downwards and throws sphere B horizontally at the same time. Which of the following is correct ? (1) Both the ... reach the ground first. (4) The question is incomplete because the masses of the spheres are not given.
Last Answer : Both the spheres will reach the ground simultaneously.
Last Answer : 1 : 1
Description : It is useful to refer to an isotropic radiator. A. when comparing the gains of directional antennas B. when testing a transmission line for standing wave ratio C. when (in the northern hemisphere) directing the transmission D. when using a dummy load to tune a transmitter
Last Answer : A. when comparing the gains of directional antennas
Description : Determine the standing wave ratio of a 300-Ω line whose load is 400+j150 Ω. A. 3.55 B. 1.67 C. 5.53 D. 3.35
Last Answer : B. 1.67
Description : When is it useful to refer to an isotropic radiator? A. When comparing the gains of directional antennas B. When testing a transmission line for standing wave ratio C. When (in the northern ... ) directing the transmission in a southerly direction D. When using a dummy load to tune a transmitter
Last Answer : A. When comparing the gains of directional antennas
Description : What is the term for the ratio of actual velocity at which a signal travels through a line to the speed of light in a vacuum? A. Velocity factor B. Characteristic impedance C. Surge impedance D. Standing wave ratio
Last Answer : A. Velocity factor
Description : Electronic equipment used to measure standing wave ration. A. Reflectometer B. Wavemeter C. Altimeter D. Multimeter
Last Answer : A. Reflectometer
Description : The standing wave ratio is equal to ________ if the load is properly matched with the transmission line. A. 1 B. 50 C. 10 D. 2
Last Answer : A. 1
Description : The standing wave ratio of short circuited and open circuited lines will be a) 0 b) 1 c) -1 d) ∞
Last Answer : d) ∞
Description : For matched line, the standing wave ratio will be a) 0 b) ∞ c) -1 d) 1
Last Answer : d) 1
Description : The range of the standing wave ratio is a) 0 < S < 1 b) -1 < S < 1 c) 1 < S < ∞ d) 0 < S < ∞
Last Answer : c) 1 < S < ∞