What is the electrical wavelength of a 500 MHz signal?
A. 60 centimeters
B. 6 meters
C. 0.06 meter
D. 60 meters

1 Answer

Answer :

A. 60 centimeters

Related questions

Description : What is the wavelength of a signal at 500 MHz? A. 0.062 cm B. 6 meters C. 60 cm D. 60 meters

Last Answer : C. 60 cm

Description : What would be the physical length of a tpical coaxial transmission line that is electrically one-quarter wavelength long at 14.1 MHz? A. 20 meters B. 3.51 meters C. 2.33 meters D. 0.25 meter

Last Answer : B. 3.51 meters

Description : A transmitted signal 5 meters in wavelength is received by an antenna coil having a 50-Ω resistance and a 0.01 H inductance. What is the capacitance of the tuner shunting the antenna coil at this point? A. 0.704 fF B. 0.704 μF C. 0.704 nF D. 0.704 mF

Last Answer : A. 0.704 fF

Description : What is the actual length in feet of a one-quarter wavelength of a coax with a velocity factor of 0.68 to 30 MHz? A. 19.26 B. 5.6 C. 17.82 D. 16.97

Last Answer : B. 5.6

Description : Six (6) MHz crystal oscillator has a stability of 1 part in 106. The largest frequency error expected of this crystals A) 0.06 Hz B) 0.6 Hz C) 6 Hz D) 60 Hz.

Last Answer : C) 6 Hz

Description : What is actual length in feet of a one-half wavelength of a coax with a velocity factor of 0.59 at 26 MHz? A. 11.16 B. 40.29 C. 42.46 D. 46.28

Last Answer : A. 11.16

Description : What is the actual length in feet of a one-half wavelength of a coax with a velocity factor of 0.63 at 28 MHz? A. 44.28 B. 43.46 C. 11.07 D. 46.27

Last Answer : C. 11.07

Description : What is the actual length in feet of a one-quarter wavelength of a coax with a velocity factor of 0.695 at 45 MHz? A. 17.82 B. 19.26 C. 16.28 D. 16.97

Last Answer : C. 16.28

Description : A simple half-wavelength antenna radiates the strongest signal A. at 45 degrees to its axis B. parallel to its axis C. at right angles to its axis D. at 60 degrees to its axis

Last Answer : C. at right angles to its axis

Description : What is the seventh harmonic of a 100 MHz quarter wavelength antenna? A. 14.28 MHz B. 107 MHz C. 149 MHz D. 700 MHz

Last Answer : D. 700 MHz

Description : What is the common up-converter and down-converter IF? A. 36 MHz B. 40 MHz C. 70 MHz D. 500 MHz

Last Answer : C. 70 MHz

Description : What is the typical bandwidth of a satellite band? A. 36 MHz B. 40 MHz C. 70 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : What is the required quality factor for an SSB filter with the following data: center frequency= 1 MHz, the desired attenuation level of the unwanted sideband= 80 dB and the separation between sidebands= 200 Hz? A. 1,250 B. 12,500 C. 125,000 D. 25,000

Last Answer : C. 125,000

Description : How many voice signals (4 kHz max.) would fit into a 5 MHz spectrum? A. 1250 B. 500 C. 1000 D. 1500

Last Answer : A. 1250

Description : What is the typical center frequency spacing between adjacent channels (transponders) in satellites? A. 36 MHz B. 40 MHz C. 500 MHz D. 4 MHz

Last Answer : B. 40 MHz

Description : What is the bandwidth available in the commercial C-band? A. 1000 MHz B. 36 MHz C. 250 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : What is the typical satellite transponder bandwidth? A. 24 MHz B. 500 MHz C. 36 MHz D. 48 MHz

Last Answer : C. 36 MHz

Description : What is 1 meter 8.5 centimeters in meters?

Last Answer : 1.085 m

Description : What is the spectrum of stereophonic FM signal? A. 19 to 38 kHz B. 30 to 53 kHz C. 59.5 to 74.5 kHz D. 88 to 108 MHz

Last Answer : B. 30 to 53 kHz

Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz

Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz

Description : Where is the noise generated that primarily determines the signal-to-noise ratio in a VHF (150 MHz) marine-band receiver? A. In the ionosphere B. In the receiver rear end C. In the receiver front end D. In the atmosphere

Last Answer : C. In the receiver front end

Description : What is the most commonly used intermediate frequency of radar receivers? A. 40 MHz B. 60 MHz C. 70 MHz D. 30 MHz

Last Answer : D. 30 MHz

Description : What is the common up-converter and down-converter IF for microwave communications? A. 60 MHz B. 80 MHz C. 120 MHz D. 70 MHz

Last Answer : D. 70 MHz

Description : This type of transmission permits communication in the frequency range from 30 to 60 MHz and over distances from about 1000 to 2000 km. A. Troposcatter B. Ionospheric scatter C. Ducting D. Microwave

Last Answer : B. Ionospheric scatter

Description : Type of transmission path that permits communication in the frequency range from 30 to 60 MHz and over distances form about 1000 to 2000 km. A. Ducting B. Ionospheric scatter C. Microwave D. Troposcatter

Last Answer : B. Ionospheric scatter

Description : What is the deviation ratio for an FM-phone signal having a maximum frequency swing of plus or minus 5 kHz and accepting a maximum modulation rate of 3kHz? A. 60 B. 0.16 C. 0.6 D. 1.66

Last Answer : D. 1.66

Description : What is the maximum color TV bandwidth? A. 1.6 MHz B. 0.5 MHz C. 1.0 MHz D. 1.3 MHz

Last Answer : D. 1.3 MHz

Description : An eight stage ripple counter uses a flip-flop with propagation delay of 75 nanoseconds. The pulse width of the strobe is 50ns. The frequency of the input signal which can be used for proper operation of the counter is approximately (A) 1 MHz. (B) 500 MHz. (C) 2 MHz. (D) 4 MHz.

Last Answer : Maximum time taken for all flip-flops to stabilize is 75ns x 8 + 50 = 650ns. Frequency of operation must be less than 1/650ns = 1.5 MHz.

Description : What is the usual electrical length of a driven element in an HF beam antenna? A. ¼ wavelength B. ¾ wavelength C. ½ wavelength D. 1 wavelength

Last Answer : C. ½ wavelength

Description : A wave with a wavelength of 40 meters and a height of 2 meters will NOT be refracted in water with a depth of more than: w) 1 meter x) 2 meters y) 10 meters z) 20 meters

Last Answer : ANSWER: Z -- 20 METERS

Description : The noise output of a resistor is amplified by a noiseless amplifier having a gain of 60 and a bandwidth of 20 kHz. A meter connected at the output of the amplifier reads 1mV RMS. If the bandwidth of the amplifier is reduced to ... does the meter read now? A. 0.5 mV B. 0.5 µV C. 5.0 mV D. 5.0 µV

Last Answer : A. 0.5 mV

Description : What is the characteristic impedance of a coaxial line with the following data: inner diameter = 0.2 in., center conductor diameter = 0.06 in., insulation = Teflon. A. 200Ω B. 75Ω C. 50Ω D. 150Ω

Last Answer : C. 50Ω

Description : What is the approximate critical frequency of the E layer? A. 4 MHz B. 5 MHz C. 6 MHz D. 3 MHz

Last Answer : A. 4 MHz

Description : A radio communications link is to be established via the ionosphere. The maximum virtual height of the layer is 100 km at the midpoint of the path and the critical frequency is 2 MHz. The distance between stations is 600 ... optimum working frequency? A. 6.32 MHz B. 2.1 MHz C. 5.4 MHz D. 1.8 MHz

Last Answer : C. 5.4 MHz

Description : At a certain time, the MUF for transmission at an angle of incidence of 75° is 17 MHz. What is the critical frequency? A. 4.4 MHz B. 3.5 MHz C. 6.5 MHz D. 1.5 MHz

Last Answer : A. 4.4 MHz

Description : What is the quardband between transponder channels in the commercial C-band for satellite communications? A. 6 MHz B. 36 MHz C. 4 MHz D. 2 MHz

Last Answer : C. 4 MHz

Description : Which of the following is designated as the international distress, safety and calling frequency for radio telephony for stations of the maritime mobile service when using frequencies in the authorized bands between 156 and 174 MHz? A. 165.8 MHz B. 156.8 MHz C. 158.6 MHz D. 168.5 MHz

Last Answer : B. 156.8 MHz

Description : Determine the gain of a 6 ft. parabolic dish operating at 1800 MHz. A. 30 dB B. 11.2 dB C. 15.5 dB D. 28.17 dB

Last Answer : D. 28.17 dB

Description : What is the hydrostatic pressure at the bottom of a pool 6 meters deep? w) 60,000 Newtons per meter squared x) 6,000 Newtons per meter squared y) 600 Newtons per meter squared z) 60 Newtons per meter squared

Last Answer : ANSWER: W -- 60,000 NEWTONS PER METER SQUARED

Description : What is the propagation delay when a signal is transmitter by an earth station to a geosynchronous satellite about 38,500 km above earth’s equator and then received by the same earth station? A. 256 msec B. 128 msec C. 300 msec D. 400 msec

Last Answer : A. 256 msec

Description : What propagation condition is usually indicated when a VHF signal is received from a station over 500 miles away? A. D-layer absorption B. Faraday rotation C. Tropospheric ducting D. Moonbounce

Last Answer : C. Tropospheric ducting

Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz

Last Answer : C. 15 to 160 MHz

Description : How far is the visual carrier from the lowest frequency in the spectrum of a monochrome TV broadcast channel following the NTSC standard? A. 1.5 MHz B. 1.25 MHz C. 4.5 MHz D. 0.25 MHz

Last Answer : B. 1.25 MHz

Description : What is the phase coefficient in radians per unit length of a transmission line at the frequency of 10 MHz if the velocity of propagation is 2.5x108 m/s? A. 0.25 B. 2.5 C. 0.35 D. 3.5

Last Answer : A. 0.25

Description : What is the refractive index of an ionospheric layer with 100x105 free electrons per m3 ? Assume frequency to be at 20 MHz. A. 0.99 B. 0.15 C. 0.78 D. 0.85

Last Answer : A. 0.99

Description : If the operating frequency is 450 MHz what length of a pair of conductors is considered to be a transmission line? A. 2.19 ft B. 2.19 m C. 0.219 ft D. 0.219 m

Last Answer : C. 0.219 ft

Description : Determine the lower half-power frequency of a class-C amplifier having upper half-power frequency of 10.025 MHz, a resonant frequency 5 MHz and a circuit Q of 10. A. 1.0025 MHz B. 10.525 MHz C. 0.5 MHz D. 10 MHz

Last Answer : A. 1.0025 MHz

Description : A radio frequency in the ultra high frequency band of the radio spectrum band. A. 235.50 MHz B. 450.50 MHz C. 150.50 GHz D. 0.31250 GHz

Last Answer : D. 0.31250 GHz

Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz

Last Answer : B. 15 to 160 Mhz