Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz
Last Answer : C. 15 to 160 MHz
Description : Atmospheric noise becomes less severe at frequencies A. above 30 MHz B. below 30 MHz C. above 3000 kHz D. below 3000kHz
Last Answer : A. above 30 MHz
Description : The band of frequencies least susceptible to atmospheric noise and interference is: A. 30 – 300 kHz B. 300 – 3000 kHz C. 3 – 30 MHz D. 300 – 3000 MHz
Last Answer : D. 300 – 3000 MHz
Description : Tropospheric scatter is a method of sky wave propagation for which of the following frequency bands? A. 300 kHz to 3 MHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 300 MHz to 3 GHz
Last Answer : D. 300 MHz to 3 GHz
Description : Which of the following frequency bands is best suited for sky wave propagation? A. 30 to 300 kHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 3 GHz to 30 GHz
Last Answer : B. 3 MHz to 30 MHz
Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz
Last Answer : B. 30 to 300 GHz
Description : What noise is observable at frequencies in the range from about 8 MHz to somewhat 1.5 GHz? A. Industrial noise B. Atmospheric noise C. Space noise D. Shot noise
Last Answer : C. Space noise
Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz
Last Answer : B. 0 to 4 kHz
Description : Extra-terrestrial noise is observable at frequencies from A. 0 to 20 KHz B. Above 2 GHz C. 8 to 1.43 GHz D. 5 to 8 GHz
Last Answer : C. 8 to 1.43 GHz
Description : Fiber optic cable operates near _______ frequencies. A. 800 THz B. 20 MHz C. 200 MHz D. 2 GHz
Last Answer : A. 800 THz
Description : Atmospheric noise is less at severe frequencies above A. Audio level B. 30 MHz C. 10 GHz D. 1 GHz
Last Answer : B. 30 MHz
Description : An amplifier operating over the frequency range of 455 to 460 kHz has a 200 kΩ input resistor. What is the RMS noise voltage at the input to this amplifier if the ambient temperature is 17˚C ? A. 40 µV B. 4.0 µV C. 400 µV
Last Answer : B. 4.0 µV
Description : What noise type is observable between 8 MHz to somewhat above 1.43 GHz or up to 1.5 GHz? A. Solar noise B. Space noise C. Galactic noise D. Cosmic noise
Last Answer : B. Space noise
Description : A radio frequency in the ultra high frequency band of the radio spectrum band. A. 235.50 MHz B. 450.50 MHz C. 150.50 GHz D. 0.31250 GHz
Last Answer : D. 0.31250 GHz
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : Most satellites operate in which frequency band? A. 30 to 300 MHz B. 300 MHz to 3 GHz C. 3 GHz to 30 GHz D. Above 300 GHz
Last Answer : C. 3 GHz to 30 GHz
Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz
Last Answer : D. 500 MHz
Description : What is the local oscillator (mixer) frequency of the satellite with an uplink frequency in GHz band? A. 3500 MHz B. 4500 MHz C. 2225 MHz D. 2555 MHz
Last Answer : C. 2225 MHz
Description : Which of the following frequency bands is best suited for ground wave propagation? A. 30 to 300 kHz B. 300 kHz to 3 MHz C. 3 MHz to 30 MHz D. 30 MHz to 300 MHz
Last Answer : A. 30 to 300 kHz
Description : What is the frequency of a 2-cm sound wave in sea water at 25˚C? A. 76 kHz B. 76 Hz C. 76 MHz D. 76 mHz
Last Answer : A. 76 kHz
Description : Assuming a UHF frequency range of 405.0125 MHz to 405.0875 MHz at 25 kHz channeling plan, how many channels can you produce? A. 2.5 ch. B. 2 ch. C. 4 ch. D. 3 ch.
Last Answer : D. 3 ch.
Description : Assume a frequency range of 405.0125 MHz to 405.0875 MHz and 25 kHz channeling plan, determine the center frequency of the second channel from the lower limit. A. 405.030 MHz B. 405.025 MHz C. 405.050 MHz D. 405.075 MHz
Last Answer : C. 405.050 MHz
Description : Assume a frequency range of 401.000 MHz to 401.050 MHz, if you apply 25 kHz channeling plan, determine the center frequency of the first channel from the lower limit. A. 401.010 MHz B. 401.0125 MHz C. 401.025 MHz D. 401.00625 MHz
Last Answer : B. 401.0125 MHz
Description : What is the refractive index of an ionospheric layer with 100x105 free electrons per m3 ? Assume frequency to be at 20 MHz. A. 0.99 B. 0.15 C. 0.78 D. 0.85
Last Answer : A. 0.99
Description : What is the approximate bandwidth of an FM system with 10 kHz of modulating frequency and a 150 kHz of frequency deviation? A. 300 kHz B. 320 kHz C. 150 kHz D. 200 kHz
Last Answer : B. 320 kHz
Description : The noise output of a resistor is amplified by a noiseless amplifier having a gain of 60 and a bandwidth of 20 kHz. A meter connected at the output of the amplifier reads 1mV RMS. If the bandwidth of the amplifier is reduced to ... does the meter read now? A. 0.5 mV B. 0.5 µV C. 5.0 mV D. 5.0 µV
Last Answer : A. 0.5 mV
Description : Coaxial lines are used on those systems operating _______. A. Below 2 GHz B. At 300 MHz C. Above 10KHz D. Above 10GHz
Last Answer : A. Below 2 GHz
Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone
Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz
Description : Approximately what is the frequency limit of the optical fiber? ∙ A. 20 MHz ∙ B. 1 MHz ∙ C. 100 MHz ∙ D. 40 GHz
Last Answer : ∙ D. 40 GHz
Description : Frequencies above ______ kHz, are referred to as the radio frequencies. A. 20 B. 2 C. 10 D. 200
Last Answer : A. 20
Description : What is the spectrum of stereophonic FM signal? A. 19 to 38 kHz B. 30 to 53 kHz C. 59.5 to 74.5 kHz D. 88 to 108 MHz
Last Answer : B. 30 to 53 kHz
Description : How many voice signals (4 kHz max.) would fit into a 5 MHz spectrum? A. 1250 B. 500 C. 1000 D. 1500
Last Answer : A. 1250
Description : In acoustics, if the volume of the room is 200 m3 then at what frequency the coefficient of absorption is measured? A. 120 kHz B. 120 Hz C. 100 Hz D. 150 Hz
Last Answer : B. 120 Hz
Description : What is the typical frequency used for communicating to submerged submarines? A. 100 Hz B. 500 Hz C. 4 kHz D. 200 Hz
Last Answer : A. 100 Hz
Description : When the elevation angle of a geostationary satellite is 23˚ and the transmitting frequency is 3840 MHz, what is the free space loss in dB? A. 196 dB B. 200 dB C. 150 dB D. 100 dB
Last Answer : A. 196 dB
Description : What is the required quality factor for an SSB filter with the following data: center frequency= 1 MHz, the desired attenuation level of the unwanted sideband= 80 dB and the separation between sidebands= 200 Hz? A. 1,250 B. 12,500 C. 125,000 D. 25,000
Last Answer : C. 125,000
Description : Atmospheric noise or static is not a great problem A. at frequencies below 20 MHz B. at frequencies below 5 MHz C. at frequencies above 30 MHz D. at frequencies above 1 MHz
Last Answer : C. at frequencies above 30 MHz
Description : A pulse radar has a pulse repetition frequency (PRF) of 3 KHz. If the radar is emitting at 10 GHz, what is the maximum unambiguous range for this radar? A) 5 Km B) 5 m C) 50 Km D) 15 m
Last Answer : A pulse radar has a pulse repetition frequency (PRF) of 3 KHz. If the radar is emitting at 10 GHz, what is the maximum unambiguous range for this radar? A) 5 Km B) 5 m C) 50 Km D) 15 m
Description : For a sample rate of 40 kHz, determine the maximum analog input frequency A. 30 kHz B. 40 kHz C. 20 kHz D. 10 kHz
Last Answer : C. 20 kHz
Description : What is the frequency limit of a copper wire? ∙ A. approximately 0.5 MHz ∙ B. approximately 1.0 MHz ∙ C. approximately 40 GHz ∙ D. none of the above
Last Answer : B. approximately 1.0 MHz
Description : The total space loss of transmission and reception for two ground stations with uplink frequency 8GHz and a downlink of 6 GHz with angle of elevations of 3˚ and 7˚ A respectively is A. 403 dB B. 100 dB C. 20 dB D. 215 dB
Last Answer : A. 403 dB
Description : Part of a microwave link can be approximated by free space conditions. The antenna gain are each 40 dB, the frequency is 10 GHz, and the path length is 80 km. Calculate the receive power for a transmitted power of 10 W? A. 0.871 μW B. 871 μW C. 0.871 mW D. 871 nW
Last Answer : A. 0.871 μW
Description : Indicatewhich ofthe followingfrequencies cannotbe used forreliablebeyond-the-horizon terrestrial communicationswithoutrepeaters: a. 20 kHz b. 15 MHz c. 900 MHz d. 12GHz
Last Answer : d. 12GHz
Description : What is the frequency range of an aircraft’s Very High Frequency (VHF) communications? A. 118.000 MHz to 136.975 MHz (worldwide up to 151.975 MHz) B. 108.000 MHz to 117.95 MHz C. 329.15 MHz to 335.00 MHz D. 2.0000 MHz to 29.999 MHz
Last Answer : A. 118.000 MHz to 136.975 MHz (worldwide up to 151.975 MHz)
Description : What is the frequency range of an aircraft’s radio altimeter? A. 962 MHz to 1213 MHz B. 329.15 MHz to 335.00 MHz C. 4250 MHz to 4350 MHz D. 108.00 MHz to 117.95 MHz
Last Answer : C. 4250 MHz to 4350 MHz
Description : The 2G GSM technology uses a carrier separation of _____________ a) 1.25 MHz b) 200 KHz c) 30 KHz d) 300 KHz
Last Answer : b) 200 KHz
Description : What is the minimum spectrum allocation required by W-CDMA? a) 5 MHz b) 20MHz c) 1.25 MHz d) 200 KHz
Last Answer : a) 5 MHz
Description : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly
Last Answer : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly 4 Ghz
Description : What is the frequency range of C-band? A. 10.95 to 14.5 GHz B. 27.5 to 31 GHz C. 3.4 to 6.424 GHz D. 1.53 to 2.7 GHz
Last Answer : C. 3.4 to 6.424 GHz
Description : What is the phase coefficient in radians per unit length of a transmission line at the frequency of 10 MHz if the velocity of propagation is 2.5x108 m/s? A. 0.25 B. 2.5 C. 0.35 D. 3.5
Last Answer : A. 0.25