Description : Antenna which is not properly terminated A. Isotropic B. Non-resonant C. Whip D. Resonant
Last Answer : D. Resonant
Description : A theoretical reference antenna that provides a comparison for antenna measurements. A. Marconi antenna B. Isotropic radiator C. Yagi-Uda array D. Whip antenna
Last Answer : B. Isotropic radiator
Description : An antenna with unity gain A. Rhombic B. Half-wave dipole C. Isotropic D. Whip
Last Answer : C. Isotropic
Description : Which antenna is a properly terminated? A. Marconi B. Rhombic C. Dipole D. Yagi-Uda
Last Answer : B. Rhombic
Description : Which is properly terminated antenna? A. Rhombic B. Hertz C. Marconi D. Dipole
Last Answer : A. Rhombic
Description : Which is a non-resonant antenna? A. Rhombic antenna B. Folded dipole C. End-fire array D. Yagi-Uda antenna
Last Answer : A. Rhombic antenna
Description : Which is the non-resonant antenna? A. Broadside Antenna B. Folded Dipole C. Rhombic antenna D. End fire array
Last Answer : C. Rhombic antenna
Description : Which of the following characterizes a properly terminated transmission line? A. The line loss is minimum. B. The standing wave ratio is minimum. C. The input impedance is twice the load impedance. D. The standing wave ratio is one.
Last Answer : D. The standing wave ratio is one.
Description : Which antenna is not grounded at one end? A. Hertz B. Marconi C. Dipole D. Whip
Last Answer : C. Dipole
Description : _____ is an antenna made up of a number of full wavelengths A. Elementary doublet B. Log-periodic C. Long wire D. Whip
Last Answer : C. Long wire
Description : Refers to a type of beam antenna which uses two or more straight elements arranged in line with each other. A. Dipole antenna B. Yagi antenna C. Whip antenna D. Rhombic antenna
Last Answer : B. Yagi antenna
Description : This is a flexible vertical rod antenna commonly used on mobiles. A. Marconi B. Hertz C. Whip D. Ground plane
Last Answer : C. Whip
Description : How can intermodulation interference between two transmitters in close proximity reduced or eliminated? A. Through installing a band-pass filter in the antenna feed line B. Through installing terminated circulator ... high driving power D. By installing a low-pass filter in the antenna feed line
Last Answer : A. Through installing a band-pass filter in the antenna feed line
Description : What is the gain of an antenna over a half-wavelength dipole when it has 6 dB gain over an isotropic radiator? A. 6.0 dB B. 8.1 dB C. 3.9 dB D. 10.0 dB
Last Answer : C. 3.9 dB
Description : An isotropic radiator is A. in the northern hemisphere B. an antenna high enough in the air C. an antenna whose directive pattern is substantially incredible D. a hypothetical, omnidirectional antenna
Last Answer : D. a hypothetical, omnidirectional antenna
Description : What antenna radiates equally in all directions? A. Vertical antenna B. isotropic antenna C. Horizontal antenna D. Dipole antenna
Last Answer : B. isotropic antenna
Description : What is the gain of isotropic antenna? A. 10 B. 1 C. 10 D. 100
Last Answer : B. 1
Description : In testing transmitter to prevent interfering with other stations, which type of antenna must be used? A. Void antenna B. Dummy antenna C. Hertzian antenna D. Isotropic antenna
Last Answer : B. Dummy antenna
Description : What is the gain of the Hertzian dipole over isotropic antenna? A. 1.64 dB B. 2.15 dB C. 1.76 dB D. 1.55 dB
Last Answer : C. 1.76 dB
Description : Which of the following antennas require good grounding? A. Yagi antenna B. Hertz antenna C. Marconi antenna D. Isotropic antenna
Last Answer : C. Marconi antenna
Description : The product of antenna input power and the antenna power gain expressed in kW is called __. A. Effective Radiated Power (ERP) B. Effective Isotropic Radiated Power (EIRP) C. Radiated Power D. Transmit Power
Last Answer : A. Effective Radiated Power (ERP)
Description : The product of the radiated RF power of a transmitter and the gain of the antenna system in a given direction relative to an isotropic radiator is called ____. A. Effective Radiated Power (ERP) B. Effective Isotropic Radiated Power (EIRP) C. Radiated Power D. Transmit Power
Last Answer : B. Effective Isotropic Radiated Power (EIRP)
Description : An antenna that can only receive a television signal. A. Isotropic antenna B. TVRO C. Reference antenna D. Yagi antenna
Last Answer : B. TVRO
Description : Unity gain antenna A. Isotropic B. Rhombic C. Half-wave dipole D. Dummy
Last Answer : A. Isotropic
Description : Gain of an isotropic antenna A. -1 dB B. 1 dB C. 0 dB D. 2 dB
Last Answer : C. 0 dB
Description : ECE Board Exam March 1996 A type of an underground antenna is a/an __________ antenna. A. Hertz B. isotropic C. parabolic D. Marconi
Last Answer : A. Hertz
Description : ECE Board Exam March 1996 The standard reference antenna for the directive gain is ___________. A. elementary doublet B. isotropic antenna C. half-wave dipole D. infinitesimal dipole
Description : Increasing the resonant frequency of an end-fed Marconi antenna can be done by A. adding a capacitor in series and reducing the physical length B. adding an inductor in series C. adding an inductor in series D. All of these
Last Answer : A. adding a capacitor in series and reducing the physical length
Description : The effect of adding parasitic elements of a Hertz dipole is to A. make the antenna more omnidirectional B. reduce its resonant frequency C. increase the antenna’s power gain D. All of these
Last Answer : C. increase the antenna’s power gain
Description : When a capacitor is connected in series with a Marconi antenna? A. Antenna open circuit stops transmission B. An inductor of equal value must be added C. No change occurs to antenna D. Antenna resonant frequency increases
Last Answer : D. Antenna resonant frequency increases
Description : What is the effect of adding a capacitor in series with an antenna? A. The antenna’s resonant frequency will increase B. The antenna’s resonant frequency will decrease C. The antenna will be physically 5% longer than its electrical length D. A capacitor is never added in series with an antenna
Last Answer : A. The antenna’s resonant frequency will increase
Description : If the length of an antenna is changed from 2.5 meters to 2.8 meters, its resonant frequency will A. increase B. depend on the velocity factor so the resonant frequency can either be increased or decreased C. will be unchanged D. decrease
Last Answer : D. decrease
Description : If the length of a Hertz dipole is decreased A. its resonant frequency will be lowered its distributed inductance will be increased B. its distributed inductance will be decreased C. its ... frequency will be increased D. its distributed capacitance between the antenna and ground will be increased.
Last Answer : C. its resonant frequency will be increased
Description : How is it possible to lower the resonant frequency of Hertz dipole antenna? A. By reducing the frequency at the transmitter B. By connecting a capacitor in series with the antenna C. By the connecting a resistor in series with the antenna D. By connecting an inductor in series with the antenna
Last Answer : D. By connecting an inductor in series with the antenna
Description : Where do the maximum current and minimum voltage values on a resonant Hertz dipole exist? A. Center of the antenna B. Near the end of the antenna C. Near the center of the antenna D. Ends of the antenna
Last Answer : A. Center of the antenna
Description : Transmission lines when connected to antenna have A. capacitive load B. resistive load whose resistance is less than characteristics impedance C. resistive load at the resonant frequency D. resistive load whose resistance is greater than the characteristic impedance of the line
Last Answer : C. resistive load at the resonant frequency
Description : ECE Board Exam March 1996 An antenna which is not resonant at a particular frequencies and so can be used over a wide band of frequencies and so can be used over a wide band of frequencies is called A. aperiodic B. boresight C. cassegrain D. top-loaded
Last Answer : A. aperiodic
Description : What do you call a transmission line used specifically for the purpose of achieving delay? A. Delay line B. Flat line C. Resonant line D. Non-resonant line
Last Answer : A. Delay line
Description : _________ is measured on a circuit when it is correctly terminated but does not have any traffic. A. White noise B. Galactic noise C. Impulse noise D. Atmospheric noise
Last Answer : A. White noise
Description : A transmission line of unknown impedance is terminated with two different resistances, and an SWR is measured each time. With a 75 Ω termination, the SWR measures 1.5. With a 300 Ω termination, it measures 2.67. What is the impedance of the line? A. 100 Ω B. 212 Ω C. 300 Ω D. 112 Ω
Last Answer : D. 112 Ω
Description : It is useful to refer to an isotropic radiator. A. when comparing the gains of directional antennas B. when testing a transmission line for standing wave ratio C. when (in the northern hemisphere) directing the transmission D. when using a dummy load to tune a transmitter
Last Answer : A. when comparing the gains of directional antennas
Description : The directivity pattern of an isotropic radiator is A. a figure-8 B. a sphere C. a unidirectional cardioid D. a parabola
Last Answer : B. a sphere
Description : Which of the following antennas is used for testing and adjusting a transmitter for proper modulation, amplifier operation and frequency accuracy? A. Elementary B. Real C. Isotropic D. Dummy
Last Answer : D. Dummy
Description : What optical source radiates light uniformly in all directions? A. Isotropic source B. Lambertian source C. Voltage source D. Ideal source
Last Answer : B. Lambertian source
Description : When is it useful to refer to an isotropic radiator? A. When comparing the gains of directional antennas B. When testing a transmission line for standing wave ratio C. When (in the northern ... ) directing the transmission in a southerly direction D. When using a dummy load to tune a transmitter
Last Answer : A. When comparing the gains of directional antennas
Description : ECE Board Exam March 1996 EIRP stands for _______________. A. effective isotropic refracted power B. effective and ideal radiated power C. effective isotropic reflected power D. effective isotropic radiated power
Last Answer : D. effective isotropic radiated power
Description : Determine the lower half-power frequency of a class-C amplifier having upper half-power frequency of 10.025 MHz, a resonant frequency 5 MHz and a circuit Q of 10. A. 1.0025 MHz B. 10.525 MHz C. 0.5 MHz D. 10 MHz
Last Answer : A. 1.0025 MHz
Description : Highest theoretical frequency that can be processed at a sampling rate without aliasing. A. Folding frequency B. Resonant frequency C. Natural frequency D. Critical frequency
Last Answer : A. Folding frequency
Description : The standard reference antenna forthe directive gain isthe a. infinitesimal dipole b. isotropic antenna c. elementary doublet d. half-wave dipole
Last Answer : b. isotropic antenna
Description : Explain half dipole antenna ( Resonant antenna ) with its radiation patteren.
Last Answer : Half wave dipole antenna Explanation: 1. It is a resonant antenna 2. It is exact half wavelength (λ /2) long & open circuited at one end. 3. The dipole antennas have ... pattern is bidirectional. The radiation pattern of half wave dipole antenna is - The radiation pattern