Description : The plates of a NiCad storage battery are made of ________. A. potassium hydroxide with a small amount of sulfuric acid B. lead and lead peroxide C. silver oxide and lead sulfate D. combinations of nickel powder and nickel & cadmium salts
Last Answer : Answer: D
Description : If the illustrated device is fully discharged, what will be the result? EL-0061 A. The battery will be short circuited because the mud space will be filled with lead sulfate B. The electrolyte ... minimum sulfuric acid. D. The plates will be maximum lead oxide and sponge lead minimum lead sulfate.
Last Answer : Answer: C
Description : When a nickel-cadium battery begins gassing while connected to the battery charging circuit, you should _____________. A. do nothing as this is a normal condition when charging B. add distilled water ... to each cell to increase the specific gravity of the electrolyte D. decrease the charging rate
Last Answer : Answer: A
Description : If the illustrated device is fully discharged, what will be the result? EL-0061 A. The plates will be maximum lead sulfate minimum sponge lead and lead oxide, the electrolyte will be ... lead oxide and sponge lead minimum lead sulfate, the electrolyte will be maximum water minimum sulfuric acid
Description : When the electrolyte level of a lead-acid storage battery has decreased due to normal evaporation, the level should be reestablished by adding _____________. A. distilled water only B. sulfuric acid ... of sulfuric acid and distilled water D. a strong solution of sulfuric acid and distilled water
Description : The electrolyte in a lead-acid storage battery consists of distilled water and _____________. A. hydrogen chloride B. calcium chloride C. sulfuric acid D. muriatic acid
Description : When charging a nickel-cadmium battery, ____________. A. the charging rate should be lessened when gassing commences B. overcharging should be avoided C. the specific gravity of the electrolyte will be ... by the state of charge D. add distilled water just prior to charging to insure proper mixing
Description : Which of the problems listed will occur if a lead-acid battery is allowed to remain in a discharged condition for a long period of time? A. The battery may be unable to accept a full charge ... . C. The concentrated sulfuric acid will attack the lead peroxide plates. D. The separators will harden.
Description : Local action in a nickel-cadmium battery is offset by _____________. A. separating the positive and negative plates with plastic spacers B. separating the positive and negative plates with resin impregnated spacers C. adding a small amount of lithium hydroxide to the electrolyte D. trickle charging
Description : When mixing electrolyte for a lead-acid storage battery, you should pour the ___________. A. distilled water into the acid in a zinc-plated container B. distilled water into the acid in a glass ... into the distilled water in a zinc-plated container D. acid into distilled water in a glass container
Description : Local action in a dry-cell, or lead-acid storage battery is the process whereby ________________. A. hydrogen gas is liberated B. the electrolyte compensates for overcharging C. potassium hydroxide ... carbon dioxide from the air D. the battery becomes discharged without being connected to a load
Description : The illustrated lead acid battery is about to be placed in service. The negitive plate, labeled 'E', is made of_______. EL-0031 A. sponge lead (Pb) B. lead peroxide (PbO2) C. lead sulfate (PbSO4) D. zinc oxide (ZnO2)
Description : Which of the following statements concerning nickel-cadmium batteries is true? A. When mixing electrolyte always add acid to the water. B. Nickel-cadmium batteries can be charged and ... The electrolyte of an idle nickel-cadmium battery must be replaced monthly to maintain battery condition.
Description : The storage battery generally used in electric power station is A. Nickel-cadmium battery B. Zinc carbon battery C. Lead-acid battery D. None of the above
Last Answer : C. Lead-acid battery
Description : The storage battery generally used in electric power station is A] nickel-cadmium battery B] zinc-carbon battery C] lead-acid battery D] None of the above
Last Answer : C] lead-acid battery
Description : To determine the state of charge of a nickel-cadmium battery, you should ___________. A. check the electrolyte with a hydrometer B. use the constant specific gravity method C. use a nonbreakable mercury thermometer D. connect a voltmeter to the battery terminals
Description : From the standpoint of safety, you should never allow salt water to enter a leadacid storage battery or come in contact with sulfuric acid because ______________. A. the resulting gas is ... peroxide D. combining salt water with lead-acid creates an invisible gas resulting in severe corrosion
Last Answer : Answer: B
Description : When charging lead-acid batteries, you should reduce the charging rate as the battery nears its full charge capacity to ______________. A. prevent excessive gassing and overheating B. allow equalization of cell voltages C. reduce lead sulfate deposits D. increase lead peroxide formation
Description : When mixing electrolyte for a lead-acid storage battery, ______________. A. stirring should always be avoided B. a lead container should always be used C. always pour the water into the acid D. always pour the acid into the water
Description : A lead-acid battery is considered fully charged when the ______________. A. electrolyte gasses freely B. battery charger ammeter indicates a positive reading C. terminal voltage reaches a constant value at a ... cells reaches the correct value and no longer increases over a period of 1 to 4 hours
Description : The proper way to mix the electrolyte for a battery is to add _____________. A. acid to alkaline water B. acid to distilled water C. alkaline water to acid D. distilled water to acid
Description : Whic of the following pairs of materials serves as electrodes in chargeable batteries commonly used in devices such as torch lights, electric shavers, etc.? (1) Iron and cadmium (2) Nickel and cadmium (3) Lead peroxide and lead (4) Zinc and carbon
Last Answer : (2) Nickel and cadmium Explanation: A rechargeable battery, storage battery, or accumulator is a type of electrical battery. It comprises one or more electrochemical cells, and is a ... sizes, ranging from button cells to megawatt systems connected to stabilize an electrical distribution network.
Description : Which of the following pairs of materials serves as electrodes in chargeable batteries commonly used in devices such as torch lights, electric shavers, etc. ? (1) Iron and cadmium (2) Nickel and cadmium (3) Lead peroxide and lead (4) Zinc and carbon
Last Answer : Nickel and cadmium
Description : At high discharge rates, nickel-cadmium storage batteries are superior to lead-acid batteries because they __________. A. require fewer cells for the same voltage and less mounting space B. are able to ... times without much damage D. have no individual cells to replace at the end of useful life
Description : Nickel-cadmium storage batteries are superior to lead-acid batteries because they __________. A. put out higher voltages and require no maintenance B. can remain idle and keep a full charge for a long time C. need fewer cells in series and use less mounting space D. all of the above
Description : Nickel-cadmium batteries are superior to lead-acid batteries at high discharge rates because they _______________. A. deliver a large amount of power and can be recharged in a shorter time B. need ... less mounting space C. have higher output voltages and require no maintenance D. all of the above
Description : Sulfuric acid is to reactant as lead sulfate is to ?
Last Answer : Lead sulfate is the product.
Description : The positive plants of nickel iron cell is made up of a. Nickel hydroxide b. Lead peroxide c. Ferrous hydroxide d. Potassium hydroxide
Last Answer : a. Nickel hydroxide
Description : The positive plates of nickel iron cell is made up of a. Nickel hydroxide b. Lead peroxide c. Ferrous hydroxide d. Potassium hydroxide
Description : Which of the listed forms of water should be added to a lead-acid battery? A. saltwater B. brackish water C. distilled water D. light water
Description : What is the approximate voltage produced by a nickel-cadmium battery cell? A. 1.25 volts B. 1.50 volts C. 2.20 volts D. 6.05 volts
Description : To determine the state of charge of a nickel-cadmium battery, you would use a/an _____________. A. voltmeter B. hydrometer C. ammeter D. potentiometer
Description : To test the state of charge of a nickel-cadmium battery, you should use a/an ____________. A. ammeter B. voltmeter C. hydrometer D. potentiometer
Description : A nickel-cadmium battery is receiving a normal charge and gases freely. The charging current should _____________. A. be increased B. be decreased C. be cut off and the battery allowed to cool D. remain the same
Description : What are the disadvantages of nickel cadmium battery?
Last Answer : Status of charge not known Number of cells are more Cost very high Environmental protection agency considers cadmium as a hazardous material, difficult to discard at the end of life.
Description : Maintenance of alkaline batteries should include _________. A. checking the electrolyte weekly using a hydrometer B. replacing the electrolyte every 5 years C. top off with sulfuric acid as needed D. making certain connections are tight and clean
Description : What happens when? a) A cleaned iron plate or iron nail is kept in 10g of copper sulphate solution. b) A pinch of mercuric oxide is kept in a test tube. c)A small crystal of silver nitrate is dissolved in distilled water and a drop of ammonium hydroxide & a pinch of glucose powder are added.
Last Answer : a) A cleaned iron plate or iron nail is kept in 10g of copper sulphate solution. After a few hours a coating of copper is seen on iron nail/plate. It is based on displacement reaction. ... on the inner walls of the test tube. Aldehyde group in glucose reduced silver nitrate to metallic silver.
Description : Which of the following battery is used for aircraft? A. Lead acid battery B. Nickel-iron battery C. Dry cell battery D. Silver oxide battery
Last Answer : B. Nickel-iron battery
Description : Which of the processes listed occurs during the charging of a lead-acid storage battery? A. Negative plates change to lead peroxide. B. Positive plates change to lead peroxide. C. Both plates change to lead peroxide. D. Both plates change to lead sulfate.
Description : Which of the following activities occurs during the charging process of a lead-acid storage battery? A. The specific gravity of the acid increases. B. Both plates change chemically to lead sulfate. C. The specific gravity of the acid decreases. D. Hydrogen gas is absorbed.
Description : When charging lead-acid batteries, the charging rate should be reduced as the battery nears its full charge to ____________. A. prevent damaging battery plates B. allow equalization of cell voltages C. reduce lead sulfate deposits D. increase lead peroxide formation
Description : The illustrated lead acid battery is about to be placed in service. The positive plate labeled 'D' is made of_______. EL-0031 A. sponge lead (Pb) B. lead peroxide (PbO2) C. lead sulfate (PbSO4) D. a depolarizing mix
Description : Which of the following conditions indicates that a lead-acid battery is being charged too rapidly? A. Sparks occurring at the positive terminal. B. Unusually high electrolyte specific gravity. C. Low plate potentials being developed. D. Excessively high temperatures and gassing rates.
Description : If violent gassing occurs when a lead-acid storage battery is first placed on charge, the _____________. A. battery must be given an emergency charge B. charging rate is too low C. charging rate is too high D. specific gravity of the electrolyte solution is too low
Description : Which of the listed ranges represents specific gravity corrected for temperature for the electrolyte of a fully charged portable lead-acid battery? A. 1.100 to 1.150 B. 1.180 to 1.200 C. 1.280 to 1.300 D. 1.750 to 2.000
Description : When troubleshooting a lead-acid storage battery, a weak or dead cell is best detected by _________________. A. measuring and comparing all cells' specific gravity B. taking an open circuit ... electrolyte levels of each cell D. taking each cell's temperature with a calibrated mercury thermometer
Description : The specific gravity of the electrolyte solution in a lead acid battery _____________. A. is not effected during charging B. remains the same during discharge C. would read close to 1.830 when discharged D. gives an indication of the state of charge of the battery
Description : The specific gravity of the electrolyte in a lead-acid battery is measured by a _____________. A. gould plate B. titration pipette C. hydrometer D. litmus paper test
Description : Violent gassing from a lead-acid battery while it is being charged, indicates that the _____________. A. plate separators are grounded B. battery compartment ventilation is inadequate C. electrolyte specific gravity is too low D. charging rate is too high
Description : The state of charge of a lead-acid battery is best indicated by the ____________. A. individual cell voltage B. ampere-hour capacity C. electrolyte specific gravity D. total cell voltage