Description : The electrolyte used in a nickel-cadmium battery is distilled water and ______________. A. diluted sulfuric acid B. potassium hydroxide C. lead sulfate D. zinc oxide
Last Answer : Answer: B
Description : Which of the problems listed will occur if a lead-acid battery is allowed to remain in a discharged condition for a long period of time? A. The battery may be unable to accept a full charge ... . C. The concentrated sulfuric acid will attack the lead peroxide plates. D. The separators will harden.
Last Answer : Answer: A
Description : If the illustrated device is fully discharged, what will be the result? EL-0061 A. The battery will be short circuited because the mud space will be filled with lead sulfate B. The electrolyte ... minimum sulfuric acid. D. The plates will be maximum lead oxide and sponge lead minimum lead sulfate.
Last Answer : Answer: C
Description : Local action in a nickel-cadmium battery is offset by _____________. A. separating the positive and negative plates with plastic spacers B. separating the positive and negative plates with resin impregnated spacers C. adding a small amount of lithium hydroxide to the electrolyte D. trickle charging
Last Answer : Answer: D
Description : Which of the processes listed occurs during the charging of a lead-acid storage battery? A. Negative plates change to lead peroxide. B. Positive plates change to lead peroxide. C. Both plates change to lead peroxide. D. Both plates change to lead sulfate.
Description : The positive plates of nickel iron cell is made up of a. Nickel hydroxide b. Lead peroxide c. Ferrous hydroxide d. Potassium hydroxide
Last Answer : a. Nickel hydroxide
Description : If the illustrated device is fully discharged, what will be the result? EL-0061 A. The plates will be maximum lead sulfate minimum sponge lead and lead oxide, the electrolyte will be ... lead oxide and sponge lead minimum lead sulfate, the electrolyte will be maximum water minimum sulfuric acid
Description : The illustrated lead acid battery is about to be placed in service. The negitive plate, labeled 'E', is made of_______. EL-0031 A. sponge lead (Pb) B. lead peroxide (PbO2) C. lead sulfate (PbSO4) D. zinc oxide (ZnO2)
Description : When charging lead-acid batteries, the charging rate should be reduced as the battery nears its full charge to ____________. A. prevent damaging battery plates B. allow equalization of cell voltages C. reduce lead sulfate deposits D. increase lead peroxide formation
Description : Caution must be exercised during the charging of lead-acid storage batteries as _____________. A. the acid will become weaker B. hydrogen gas is being continuously liberated C. both plates are changing chemically to lead sulfate D. lead peroxide in the negative plate is poisonous
Description : From the standpoint of safety, you should never allow salt water to enter a leadacid storage battery or come in contact with sulfuric acid because ______________. A. the resulting gas is ... peroxide D. combining salt water with lead-acid creates an invisible gas resulting in severe corrosion
Description : The positive plants of nickel iron cell is made up of a. Nickel hydroxide b. Lead peroxide c. Ferrous hydroxide d. Potassium hydroxide
Description : Which of the following activities occurs during the charging process of a lead-acid storage battery? A. The specific gravity of the acid increases. B. Both plates change chemically to lead sulfate. C. The specific gravity of the acid decreases. D. Hydrogen gas is absorbed.
Description : The illustrated lead acid battery is about to be placed in service. The positive plate labeled 'D' is made of_______. EL-0031 A. sponge lead (Pb) B. lead peroxide (PbO2) C. lead sulfate (PbSO4) D. a depolarizing mix
Description : Local action in a dry-cell, or lead-acid storage battery is the process whereby ________________. A. hydrogen gas is liberated B. the electrolyte compensates for overcharging C. potassium hydroxide ... carbon dioxide from the air D. the battery becomes discharged without being connected to a load
Description : When charging lead-acid batteries, you should reduce the charging rate as the battery nears its full charge capacity to ______________. A. prevent excessive gassing and overheating B. allow equalization of cell voltages C. reduce lead sulfate deposits D. increase lead peroxide formation
Description : The storage battery generally used in electric power station is A. Nickel-cadmium battery B. Zinc carbon battery C. Lead-acid battery D. None of the above
Last Answer : C. Lead-acid battery
Description : The storage battery generally used in electric power station is A] nickel-cadmium battery B] zinc-carbon battery C] lead-acid battery D] None of the above
Last Answer : C] lead-acid battery
Description : What happens when? a) A cleaned iron plate or iron nail is kept in 10g of copper sulphate solution. b) A pinch of mercuric oxide is kept in a test tube. c)A small crystal of silver nitrate is dissolved in distilled water and a drop of ammonium hydroxide & a pinch of glucose powder are added.
Last Answer : a) A cleaned iron plate or iron nail is kept in 10g of copper sulphate solution. After a few hours a coating of copper is seen on iron nail/plate. It is based on displacement reaction. ... on the inner walls of the test tube. Aldehyde group in glucose reduced silver nitrate to metallic silver.
Description : At high discharge rates, nickel-cadmium storage batteries are superior to lead-acid batteries because they __________. A. require fewer cells for the same voltage and less mounting space B. are able to ... times without much damage D. have no individual cells to replace at the end of useful life
Description : Nickel-cadmium storage batteries are superior to lead-acid batteries because they __________. A. put out higher voltages and require no maintenance B. can remain idle and keep a full charge for a long time C. need fewer cells in series and use less mounting space D. all of the above
Description : Nickel-cadmium batteries are superior to lead-acid batteries at high discharge rates because they _______________. A. deliver a large amount of power and can be recharged in a shorter time B. need ... less mounting space C. have higher output voltages and require no maintenance D. all of the above
Description : Whic of the following pairs of materials serves as electrodes in chargeable batteries commonly used in devices such as torch lights, electric shavers, etc.? (1) Iron and cadmium (2) Nickel and cadmium (3) Lead peroxide and lead (4) Zinc and carbon
Last Answer : (2) Nickel and cadmium Explanation: A rechargeable battery, storage battery, or accumulator is a type of electrical battery. It comprises one or more electrochemical cells, and is a ... sizes, ranging from button cells to megawatt systems connected to stabilize an electrical distribution network.
Description : Which of the following pairs of materials serves as electrodes in chargeable batteries commonly used in devices such as torch lights, electric shavers, etc. ? (1) Iron and cadmium (2) Nickel and cadmium (3) Lead peroxide and lead (4) Zinc and carbon
Last Answer : Nickel and cadmium
Description : Which of the following battery is used for aircraft? A. Lead acid battery B. Nickel-iron battery C. Dry cell battery D. Silver oxide battery
Last Answer : B. Nickel-iron battery
Description : When the electrolyte level of a lead-acid storage battery has decreased due to normal evaporation, the level should be reestablished by adding _____________. A. distilled water only B. sulfuric acid ... of sulfuric acid and distilled water D. a strong solution of sulfuric acid and distilled water
Description : The electrolyte in a lead-acid storage battery consists of distilled water and _____________. A. hydrogen chloride B. calcium chloride C. sulfuric acid D. muriatic acid
Description : When a nickel-cadium battery begins gassing while connected to the battery charging circuit, you should _____________. A. do nothing as this is a normal condition when charging B. add distilled water ... to each cell to increase the specific gravity of the electrolyte D. decrease the charging rate
Description : Which of the following statements concerning nickel-cadmium batteries is true? A. When mixing electrolyte always add acid to the water. B. Nickel-cadmium batteries can be charged and ... The electrolyte of an idle nickel-cadmium battery must be replaced monthly to maintain battery condition.
Description : Common nickel-cadmium and nickel-iron storage batteries utilize _______________. A. acid primary cells B. alkaline primary cells C. acid secondary cells D. alkaline secondary cells
Description : During discharge of a lead-acid storage battery, which of the following actions occurs? A. The acid becomes stronger. B. Both plates change chemically to ammonium chloride. C. The acid becomes weaker. D. Hydrogen gas is liberated.
Description : Sulfuric acid is to reactant as lead sulfate is to ?
Last Answer : Lead sulfate is the product.
Description : What is the approximate voltage produced by a nickel-cadmium battery cell? A. 1.25 volts B. 1.50 volts C. 2.20 volts D. 6.05 volts
Description : To determine the state of charge of a nickel-cadmium battery, you would use a/an _____________. A. voltmeter B. hydrometer C. ammeter D. potentiometer
Description : To determine the state of charge of a nickel-cadmium battery, you should ___________. A. check the electrolyte with a hydrometer B. use the constant specific gravity method C. use a nonbreakable mercury thermometer D. connect a voltmeter to the battery terminals
Description : When charging a nickel-cadmium battery, ____________. A. the charging rate should be lessened when gassing commences B. overcharging should be avoided C. the specific gravity of the electrolyte will be ... by the state of charge D. add distilled water just prior to charging to insure proper mixing
Description : To test the state of charge of a nickel-cadmium battery, you should use a/an ____________. A. ammeter B. voltmeter C. hydrometer D. potentiometer
Description : A nickel-cadmium battery is receiving a normal charge and gases freely. The charging current should _____________. A. be increased B. be decreased C. be cut off and the battery allowed to cool D. remain the same
Description : What are the disadvantages of nickel cadmium battery?
Last Answer : Status of charge not known Number of cells are more Cost very high Environmental protection agency considers cadmium as a hazardous material, difficult to discard at the end of life.
Description : Oxygen has a valence number of -1 in: w) Sodium Peroxide x) Potassium Chlorate y) Water z) Sodium Hydroxide
Last Answer : ANSWER: W -- SODIUM PEROXIDE
Description : Compare between lead acid and nickel-cadmium batteries?
Last Answer : Lead acid : Dilute H2SO4, spongy and PbSO2, low efficiency, 2 volt per cell, less strong, requires more maintenance, less efficient wrt temperature, discharges fast, low cost, problem of sulfation.
Description : Carbide tipped cutting tools are manufactured by powder metallurgy techniques and have a composition of (A) 90% tungsten carbide and 10% cobalt (B) 70% aluminium oxide & 30% silica (C) 30% nickel, 15% chromium & 55% tungsten (D) 65% tungsten & 35% zirconium
Last Answer : Option A
Description : A breakable, mercury-filled thermometer should not be used in a lead-acid battery to measure electrolyte temperature, as an accidental breakage can cause ____________. A. severe sparking and explosions ... battery plates C. violent gassing at the positive plates D. corrosion on the battery terminals
Description : Which of the substances listed should be applied to battery terminals to help prevent corrosion? A. Zinc chromate B. Naval jelly C. Lead peroxide D. Petroleum jelly
Description : Acetylene reacts with water in the presence of sulfuric acid and mercuric sulfate to give (a) Acetone (b) Acetic acid (c) Formaldehyde (d) Acetaldehyde
Last Answer : Acetaldehyde
Description : In the reaction of ethylene with H2O in the presence of sulfuric acid, which one adds across the double bond first? (a) H+ (b) H. (c) HO– (d) sulfate ion
Last Answer : H+
Description : The cathode of a lead storage battery is made up of – (1) Zinc (2) Lead (3) Lead oxide (4) Manganese dioxide
Last Answer : (2) Lead Explanation: Lead-acid batteries, invented in 1859 by French physicist Gaston Plante, are the oldest type of rechargeable battery. Despite having a very low energy-to-weight ratio ... attractive for use in motor vehicles to provide the high current required by automobile starter motors.
Description : The cathode of a lead storage battery is made up of (1) Zinc (2) Lead (3) Lead oxide (4) Manganese dioxide
Last Answer : Lead
Description : Which of the following materials does not form adherent oxide film on surface? (A) Copper (B) Nickel (C) Aluminium (D) Gold & silver
Last Answer : (D) Gold & silver
Description : Write the molecular formulae of: 1. Copper oxide 2. Iron (III) chloride 3. Sodium hydroxide 4. Iron (II) sulphide 5. Lead (II) oxide 6. Hydrogen nitrate (nitric ... Hydrogen sulphate (sulphuric acid) 8. Calcium hydroxide 9. Magnesium carbonate 10.Ammonium carbonate
Last Answer : 1. Copper oxide - CuO 2. Iron (III) chloride - FeCl3 3. Sodium hydroxide - NaOH 4. Iron (II) sulphide - FeS 5. Lead (II) oxide - PbO 6. Hydrogen nitrate (nitric acid) - HNO3 7. ... ) - H2SO4 8. Calcium hydroxide - Ca(OH)2 9. Magnesium carbonate - MgCO3 10.Ammonium carbonate - (NH4)2CO3