Description : What power is consumed by a heating element using a current of 20 amperes at 120 volts? A. 20 watts B. 66.67 watts C. 720 watts D. 2400 watts
Last Answer : Answer: D
Description : An electric heating element supplied with 120 volts draws 15 amps. How much power will be consumed? A. 15 watts B. 45.57 watts C. 180 watts D. 1800 watts
Description : The rate at which electrical energy is used is measured in w) volts x) amperes y) joules z) watts
Last Answer : ANSWER: Z -- WATTS
Description : A three phase induction motor is drawing 16 Ampere at 440 Volts. If the operating power factor of the motor is 0.90 and the motor efficiency is 92%, then the mechanical shaft power output of the motor is a) 12.04 kW b) 10.09 kW c) 10.97 kW d) None of the above
Last Answer : b) 10.09 kW
Description : How many volts are necessary to provide a current of 10 amperes to a motor with an in-line resistance of 11 ohms? A. 21 volts B. 110 volts C. 220 volts D. 240 volts
Last Answer : Answer: B
Description : The distance between a generator and its load is 100 feet. What would be the approximate total voltage drop across a two wire supply cable if the current were 5.5 amperes and the resistance of the wire were 2.525 ohms per 1,000 feet? A. 0.5 volts B. 1.38 volts C. 1.90 volts D. 2.77 volts
Description : Electric current is the flow of electrons through a conductor; the rate of this flow is measured in ___________. A. volts B. amperes C. coulombs D. ohms
Description : Electric current is the flow of electrons through a conductor. The rate of this flow is measured as ___________. A. volts/watt B. amperes/centimetre C. coulombs/second D. ohms/volt
Last Answer : Answer: C
Description : The ratio of the effective value of the counter EMF in volts, to the effective value of the current in amperes is called _____________. A. impedance factor B. capacitive reactance C. inductive reactance D. root mean square
Description : In the illustration what is the minimum wattage needed for a 3 ohm resistor with a 12 VDC power source in circuit 'A'? EL-0041 A. 12 watts B. 48 watts C. 64 watts D. 232 watts
Description : Two 100 watt light bulbs are connected in parallel across a 100 volt power supply. The total power developed in the circuit is _______________. A. 200 watts B. 100 watts C. 50 watts D. equal to the product of the amperes times the voltage in each branch
Last Answer : Answer: A
Description : What would be the power consumed in the combined parallel section of the circuit shown in the illustration if the source were 30 volts and the resistance for R1 is 10 ohms, R2 is 10 ohms, and R3 is 10 ohms? EL-0032 A. 5 watts B. 10 watts C. 20 watts D. 40 watts
Description : What power would be consumed by the series resistor of the circuit shown in the illustration if the source is 30 volts, the resistance of R1 is 10 ohms, R2 is 10 ohms, and R3 is 10 ohms? EL-0032 A. 5 watts B. 10 watts C. 20 watts D. 40 watts
Description : What power would be consumed in EACH of the branch resistors of the circuit shown in the illustration if the source is 30 volts, the resistance for R1 is 10 ohms, R2 is 10 ohms and R3 is 10 ohms? EL-0032 A. 5 watts B. 10 watts C. 20 watts D. 40 watts
Description : What would be the total power consumed in the circuit shown in the illustration if the source is 30 volts the resistance for R1 is 10 ohms, R2 is 10 ohms, and R3 is 10 ohms? EL-0032 A. 10 watts B. 40 watts C. 45 watts D. 60 watts
Description : An electrical component is connected across a 120 volt 60 hertz AC supply. What is the current drawn by the component if the impedance is 200 ohms? A. 0.01 amperes B. 0.60 amperes C. 1.67 amperes D. 100 amperes
Description : What current is required to light two 75 watt lamps and one 40 watt lamp when connected in series to a 120 volt power source? A. 0.161 amperes B. 0.631 amperes C. 1.583 amperes D. 6.199 amperes
Description : A three-phase alternator operates at 450 volts with a power factor of 0.8. If the ammeter indicates 250 amperes, what should be the KW meter reading? A. 90.00 KW B. 127.27 KW C. 155.70 KW D. 194.85 KW
Description : Battery capacities are given in _____________. A. volts B. volt-amperes C. volt-hours D. ampere-hours
Description : The inductance of a coil is measured in _____________. A. ohms B. volts C. henries D. amperes
Description : Power transformers are rated in _____________. A. kilowatts B. ampere-turns C. kilowatt-volts D. kilovolt-amperes
Description : What is the SI unit of electric current? (1) Amperes (2) Coulombs (3) Joules (4) Watts
Last Answer : (1) Amperes Explanation: The SI unit for measuring an electric current is the am pere, which is the flow of electric charge across a surface at the rate of one coulomb per second.
Description : A server crashes on the average once in 30 days, that is, the Mean Time Between Failures (MTBF) is 30 days. When this happens, it takes 12 hours to reboot it, that is, the Mean Time to Repair (MTTR) is 12 ... these reliability data values is approximately: (A) 96.3% (B) 97.3% (C) 98.3% (D) 99.3%
Last Answer : (C) 98.3%
Description : The power absorbed (in watts) in overcoming the viscous resistance of a footstep bearing is (A) 1800 t (B) 1800 t (C) (D) 3600
Last Answer : Answer: Option B
Description : The turns ratio of transformer 'A' shown in the illustration is four to one and all taps are evenly spaced. If 120 volts were applied to terminals 'H1' and 'H3', what would appear at 'X1' and 'X2'? EL-0082 A. 15 volts B. 30 volts C. 480 volts D. 960 volts
Description : In the illustrated circuit the voltage is 12 VDC and the resistance is 3 ohms. If the battery is rated for 120 amp-hours, how long before the voltage will drop to 1.75 volts per cell? EL-0018 A. 12 hours B. 1.75 days C. 30 hours D. 2.5 days
Description : The turns ratio of device 'A' shown in the illustration is four to one and all taps are evenly spaced. If 120 volts were applied to terminals 'H1' and 'H3', what would appear at 'X1' and 'X2'? EL-0082 A. 15 volts B. 30 volts C. 480 volts D. 960 volts
Description : The turns ratio of device 'A' shown in the illustration is four to one and all the taps are equally spaced. If 120 volts were applied between 'X1' and 'X2', what would be indicated across 'H1' and 'H4'? EL-0082 A. 30 volts B. 120 volts C. 480 volts D. 1440 volts
Description : When soldering a printed circuit board component, you should be careful to prevent damage by _________. A. quickly heating the joints, using a high wattage iron B. using the soldering iron tip sparingly C. using only acid cord solder D. applying mechanical pressure to the joints being soldered
Description : In the illustration, 24 volts is applied to the circut where the resistance for R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms. What is the power consumed in R3? EL-0020 A. 12 watts B. 20 watts C. 24 watts D. 48 watts
Description : In the illustration, 24 volts is applied to the circuit where the resistance for R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms. What is the power consumed in R2? EL-0020 A. 16 watts B. 20 watts C. 24 watts D. 28 watts
Description : In the illustration, 24 volts is applied to the circuit where the resistance of R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms. What is the power consumed in R1? EL-0020 A. 2 watts B. 3 watts C. 6 watts D. 12 watts
Description : Electrical power is expressed in _____________. A. ohms B. volts C. amps D. watts
Description : Fuses are usually rated in _____________. A. watts B. amps only C. volts only D. amps and volts
Description : What is the power consumed by 'R3' in the circuit illustrated if the supply is 24 volts and resistance of R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms? EL-0020 A. 12 watts B. 20 watts C. 24 watts D. 48 watts
Description : What is the power consumed by 'R2' in the circuit illustrated, if the supply is 24 volts and the resistance of R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms? EL-0020 A. 16 watts B. 20 watts C. 24 watts D. 28 watts
Description : What is the power consumed by 'R1' in the circuit illustrated if the supply is 24 volts and the resistance of R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms? EL-0020 A. 2 watts B. 3 watts C. 6 watts D. 12 watts
Description : What is the total power consumed by the illustrated circuit if the supply is 24 volts and the resistances of R1 is 3 ohms, R2 is 4 ohms, and R3 is 5 ohms? EL-0020 A. 2 watts B. 12 watts C. 48 watts D. 288 watts
Description : Can I use a higher wattage bulb in a lamp that states 40 watts?
Last Answer : You should not use a higher wattage bulb in a lamp that says 40 watts. The higher wattage could cause the lamp to catch fire due to the excess heat and could cause you serious electrical problems.
Description : Which of the following precautions should be taken when troubleshooting various power circuits using a common solenoid-type mechanical voltage tester (wiggins)? A. Never use this tester on circuits greater ... voltage expected in the circuit in order to prevent damage from an off-scale reading.
Description : If Eeff is 130 volts and Ieff is 3 amperes, what is the total resistance (RT) in the circuit?
Last Answer : 43.3 ohms.
Description : The transformer ratings are usually expressed in terms of A. Volts B. Amperes C. kW D. kVA
Last Answer : D) KVA
Description : What is the load voltage 'Es' as shown in the illustration? EL-0083 A. 292 volts B. 360 volts C. 450 volts D. 810 volts
Description : In the illustration, the voltage applied to the circut is 12 VDC, the resistance for R1 is 10 ohms, and R2 is 10 ohms. What is the power consumed in 'R1' of the circuit shown in the illustration? EL-0036 A. 0.6 watts B. 3.6 watts C. 7.2 watts D. 120 watts
Description : Ajay sold a motorbike at a profit of 20% to Balu. Balu sold it to Dinesh at a loss of 20%. If the profit made by Ajay was Rs.120 less than the loss made by Balu, find the cost price of Ajay(in Rs.) a)3000 b)3600 c)3900 d)4500
Last Answer : a)3000
Description : How many items are there in the Union List? (1) 52 (2) 66 (3) 97 (4) 99
Last Answer : (3) 97 Explanation: The Union List or List-I is a list of 100 items (though last item is numbered 97) given in Part XI of the Constitution of India on which Parliament has exclusive power to legislate. Out of the 100 items on the list, one is no longer in force.
Description : The normal body temperature of human beings is - (1) 96.4 °F (2) 97.4 °F (3) 98.4 °F (4) 99.4 °F
Last Answer : (3) 98.4 °F' Explanation: The normal core body temperature of a healthy, resting adult human being is stated to be at 98.6 degrees fahrenheit or 37.0 degrees celsius. Though the body ... the higher the normal body temperature or the slower the metabolic rate the lower the normal body temperature.
Description : (4) sodium chloride contains hygroscopic impurities like magnesium chloride Explanation: Table salt is refined salt, which contains about 97 to 99 percent sodium chloride. It usually contains substances that ... of salt it become wet in rainy season as the salt absorbs moisture from environment.
Last Answer : Which of the following could be used as fuel in propellant or rockets? (1) Liquid Hydrogen + Liquid Nitrogen (2) Liquid Oxygen + Liquid Argon (3) Liquid Nitrogen + Liquid Oxygen (4) Liquid Hydrogen + Liquid Oxygen
Description : Given the following data pairs (x, y), find the regression equation. (1, 1.24), (2, 5.23), (3, 7.24), (4, 7.60), (5, 9.97), (6, 14.31), (7, 13.99), (8, 14.88), (9, 18.04), (10, 20.70) a. y = 0.490 x - 0.053 b. y = 2.04 x c. y = 1.98 x + 0.436 d. y = 0.49 x
Last Answer : c. y = 1.98 x + 0.436
Description : The normal body temperature of human beings is (1) 96.4 °F (2) 97.4 °F (3) 98.4 °F (4) 99.4 °F
Last Answer : 98.4 °F