How to measure peak flow?

1 Answer

Answer :

Move the marker to the bottom of the numbered scale.Stand up straight.Take a deep breath. Fill your lungs all the way.Hold your breath while you place the mouthpiece in your mouth, between your teeth. Close your lips around it. Do not put your tongue inside the hole.Blow out as hard and fast as you can in a single blow. Your first burst of air is the most important, so blowing for a longer time will not affect your result.Write down the number you get. If you coughed or did not do the steps right, do not write down the number. Do it over again.Move the marker back to the bottom and repeat these steps 2 more times. The highest of the 3 numbers is your peak flow number. Write it down in your results log.Reviewed ByReview Date: 03/10/2009David C. Dugdale, III, MD, Professor of Medicine, Division of General Medicine, Department of Medicine, University of Washington School of Medicine. Also reviewed by David Zieve, MD, MHA, Medical Director, A.D.A.M., Inc.

Related questions

Description : Can I use eurometer calibrated in RMS to measure HWDC in peak?

Last Answer : No

Description : In AC circuits, AC meters measure – (1) mean values (2) rms values (3) peak values (4) mean square values

Last Answer : (2) rms values Explanation: Voltages and currents for AC circuits are generally expressed as rms (root mean square) values. For a sine wave, the relationship between the peak and the rms average is: rms value = 0.707 peak value.

Description : In AC circuits, AC meters measure (1) mean values (2) rms values (3) peak values (4) mean square values

Last Answer : rms values

Description : Does anyone have experience with peak flow meters? I have some questions about what's considered "normal". (read on) questions about?

Last Answer : answer:I hope this helps you out. I know nothing but your issue but I looked around for a hopefully helpful link. Best of luck! Ruth http://www.lungusa.org/lung-disease/asthma/living-with-asthma/take-control-of-your-asthma/measuring-your-peak-flow-rate.html

Description : Peak expiratory flow rate?

Last Answer : DefinitionThe peak expiratory flow rate measures how fast a person can breathe out (exhale) air. It is one of many tests that measures how well the lungs are working.Alternative NamesPeak flowHow ... tests.How the test will feelThere is usually no discomfort. Rarely, repeated efforts may cause some

Description : How to use a peak flow meter?

Last Answer : You may have heard of a peak flow meter if you have Asthma and wonder is it really worth it. How do you use it? What good is it really? Well it turns out that it's often hard to tell how ... Washington School of Medicine. Also reviewed by David Zieve, MD, MHA, Medical Director, A.D.A.M., Inc.

Description : Which of the following tests is used at home to assess therapy and determine if a patient with asthma should seek emergency care? (a) Forced expiratory volume in one second (FEV1) (b) Forced vital capacity ... ) Total lung capacity (TLC) (d) Peak expiratory flow rate (PEFR) (e) Residual volume (RV)

Last Answer : Ans: D

Description : Which of the following tests is used at home to assess therapy and determine if a patient with asthma should seek emergency care? (a) Forced expiratory volume in one second (FEV1) (b) Forced vital capacity ... ) Total lung capacity (TLC) (d) Peak expiratory flow rate (PEFR) (e) Residual volume (RV)

Last Answer : Ans: D

Description : When drainage to sewage ratio is 20, the peak dry weather flow is A. 20% of the design discharge B. Slightly less than 5% of the design discharge C. Slightly more than 5% of the design discharge D. None of these

Last Answer : ANS: B

Description : In the flow of one cycle of single phase AC current past any given point in a circuit, the maximum current peak occurs _____________. A. one time B. two times C. three times D. four times

Last Answer : Answer: B

Description : The peak of a 4 hour flood hydrograph is 240 m3 /sec. If the rainfall excess is 80 mm and base flow which is constant is 40 m3 /sec, peak of 4hours unit hydrograph will be (A) 20 m3 /sec (B) 25 m3 /sec (C) 30 m3 /sec (D) 35 m3 /sec

Last Answer : Answer: Option B

Description : Pick up the correct statement from the following: (A) Hydrograph is a plot of discharge and time (B) In hydrographs, time is plotted on X-axis (C) The maximum flow in the river due to rainfall, is called peak flow (D) All the above

Last Answer : Answer: Option D

Description : The Spirometry finding found during episodes of Bronchial Asthma is Options: 1) Marked reduction in FVC 2) Normal or increased FEV1/FVC ratio 3) Marked reduction in FEV1 4) Increased peak expiratory Flow

Last Answer : Correct Answer: 3) Marked reduction in FEV1

Description : The calibration of an HPLC detector can be evaluated by measurement of? A. Retention time B. Temperature C. Flow rate accuracy D. Intensity of the peak

Last Answer : D. Intensity of the peak

Description : For achieving self-cleaning velocity, a minimum velocity of ---- mps. Is desirable for design peak flow (a) 0.6 mps (b) 0.8 mps* (c) 1.0 mps (d) 2.0 mps

Last Answer : b) 0.8 mps*

Description : In patients with benign prostatic hypertrophy, finasteride exerts the following action/actions: A. Reduces size of the prostate gland B. Increases peak urinary flow rate C. Relaxes vesical sphincter D. Both 'A' and 'B' are correct

Last Answer : D. Both 'A' and 'B' are correct