Description : In a city the ratio of the drainage to sewage is 20, the percentage discharge passing through non-monsoon periods, is A. 5 B. 10 C. 15 D. 20
Last Answer : ANS: D
Description : Pick up the correct statement from the following: A. The maximum rate of storm runoff is called peak drainage discharge B. Rational method of estimating peak run off, may be used precisely for ... entire area starts contributing to the runoff, is called the time of concentration D. All the above
Description : The rational formula for peak drainage discharge, was evolved by A. Fruhling B. Lloyd David C. Kuichling D. All of these
Description : A cylindrical ejector having its height 2 m fills after every 10 minutes with a peak sewage discharge of 0.0157 cumec. The diameter of the ejector chamber, is A. 2.30 m B. 2.40 m C. 2.45 m D. 2.50 m
Last Answer : ANS: C
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Description : For design of sewers, percentage of sewage discharge is assumed A. 65 to 70% B. 70 to 75% C. 75 to 80% D. 85%
Description : The density of population over 40 hectares is 250/hectare. If water supply demand per day is 200 litres and sewage discharge is 80% of water supply, the sewage flow in sewers of separate system, is A. 0.05552 cumec B. 0.05554 cumec C. 0.05556 cumec D. 0.0556 cumec
Description : The stone ware sewers A. Are used for carrying sewage and drainage from houses B. Are manufactured from clays and shale C. After casting are dried and burnt at temperature 150°C, 700°C and 1200°C D. All the above
Description : Pick up the in-correct statement from the following: A. Manholes are provided in sewer pipes at suitable intervals B. Catch basins are generally provided in sewers for carrying drainage discharge C. Inlets are generally provided in all sewers D. None of these
Description : Dry water flow in a combined sewer, is A. Industrial sewage B. Domestic sewage C. Storm water D. Inclusive of domestic and industrial sewage but excludes storm water
Description : The ratio of maximum sewage flow to average sewage flow for trunk mains having diameters more than 1.25 m, is A. 1.5 B. 2.0 C. 3.0 D. 4.0
Last Answer : ANS: A
Description : For trunk sewers more than 1.25 m in diameter, the ratio of the maximum daily sewage flow to the average daily sewage flow is assumed A. 1.5 B. 2.0 C. 2.5 D. 3.0
Description : If the depletion of oxygen is found to be 5 ppm after incubating a 2.5% solution of sewage sample for 5 days at 21°C, B.O.D. of the sewage is A. 50 ppm B. 100 ppm C. 150 ppm D. 200 ppm
Description : The design period of sewage treatment works in normally A. 5 – 10 years B. 15 – 20 years C. 30 – 40 years D. 40 – 50 years
Last Answer : ANS: B
Description : Rate of flow of sewage is generally assumed A. More than the rate of water supply B. Equal to the rate of water supply C. Less than the rate of water supply D. At 150 litres per capita
Description : The sewer pipes A. Carry sewage as gravity conduits B. Are designed for generating self-cleansing velocities at different discharge C. Should resist the wear and tear caused due to abrasion D. All the above
Description : The ratio of minimum hourly flow to the average flow of sewage is A. 1/4 B. 1/3 C. 1/2 D. 3/4
Description : For sewer mains of 0.5 to 1 m diameter, the ratio of maximum daily sewage flow to the average daily sewage flow is assumed A. 1.5 B. 2.0 C. 2.5 D. 3.0
Description : The ratio of maximum sewage flow to average sewage flow for mains up to 1 m in diameter, is A. 1.5 B. 2.0 C. 3.0 D. 4.0
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above
Description : The ratio of design discharge to the surface area of a sedimentation tank is called A. Surface loading B. Overflow rate C. Overflow velocity D. All of these
Description : In a grit chamber of a sewage treatment plant, A. Flow velocity 0.15 m to 0.3 m/sec is kept B. Depth of 0.9 m to 1.20 m is kept C. One minute of detention period is kept D. All the above
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : If the peak discharge of a storm water drain (S.W. Drain) is expected to exceed 150 cumecs, the free board to be provided, is A. 100 cm B. 90 cm C. 80 cm D. 50 cm
Description : Self-cleansing velocity is A. Velocity at dry weather flow B. Velocity of water at flushing C. Velocity at which no accumulation remains in the drains D. Velocity of water in a pressure filter
Description : Dry weather flow is: A. Average daily rate of flow B. Average monthly rate of flow C. Average annual rate of flow D. Water supply allowance per capita
Description : The drainage area of a town is 12 hectares. Its 40% area is hard pavement ( K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration ... 60) the maximum run off is A. 0.10 cumec B. 0.12 cumec C. 0.15 cumec D. 0.20 cumec
Description : The dimensions of a rectangular settling tank are: length 24 m, width 6 m and depth 3 m. If 2 hour detention period for tanks is recommended, the rate of flow of sewage per hour, is A. 204 cu.m B. 208 cu.m C. 212 cu.m D. 216 cu.m
Description : The detention time (t) of a settling tank, may be defined as the time required for A. A particle to travel along its length B. A particle to travel from top surface to bottom sludge zone C. The flow of sewage to fill the tank D. None of these
Description : Dilution method of disposing of sewage, is not preferred to A. When sewage is fresh B. When diluting water has high dissolved oxygen content C. When diluting water is used for water supply near the point of sewage disposed D. When the diluting water is having flow currents
Description : If q is the average sewage flow from a city of population P, the maximum sewage flow A. Q = [(4 + )/(18 + )] q B. Q = [(18 + P)/(4 + )] q C. Q = [(18 + )/(4 + )] q D. Q = [(5 + )/((15 + )] q
Description : Pick up the correct statement from the following: A. pH value indicates acidity and alkalinity of sewage B. In acidic sewage, the pH value is less than 7 C. In alkaline sewage, the pH value is more than 7 D. All the above
Description : WASTE WATER Engineering Objective Questions Pdf :: Q No: 151 The pH value of fresh sewage is usually A. Equal to 7 B. More than 7 C. Less than 7 D. Equal to zero
Description : No treatment of the sewage is given if dilution factor is A. Less than 150 B. Between 150 to 200 C. Between 200 to 300 D. More than 500
Description : 54 Pick up the correct statement from the following: A. The ratio of the quantity of the diluting water to that of the sewage, is known as dilution factor B. The automatic purification of polluted ... phenomenon C. The photosynthesis is carried out in the presence of sun light D. All the above
Description : The spacing of bars for perforations in coarse screens used for the treatment of sewage, is A. 20 mm B. 30 mm C. 40 mm D. 50 mm
Description : The bottom of the sewage inlet chamber of septic tanks, is provided an outward slope A. 1 in 5 B. 1 in 10 C. 1 in 15 D. 1 in 20
Description : The Brake Horse power of the motor (efficiency 60%) required for a pump of capacity 0.075 cumec for a total lift of 12 m, is A. 10 B. 15 C. 20 D. 25 Q No: 44 Aerobic bacterias A. ... presence of free oxygen B. Consume organic matter as their food C. Oxidise organic matter in sewage D. All the above
Description : The gradient of sewers depends upon A. Velocity of flow B. Diameter of the sewer C. Discharge D. All the above
Description : The discharge per unit plan area of a sedimentation tank, is generally called A. Over flow rate B. Surface loading C. Over flow velocity D. All the above
Description : As compared to fresh river water, sea water contains oxygen A. 10% less B. 20% less C. 10% more D. 20% more
Description : In sewers the velocity of flow should not be A. More than the self-cleansing velocity B. Less than the self-cleansing velocity C. Less than 10 m/sec D. More than 20 m/sec
Description : The lag time between precipitation period and peak discharge period of a river: w) is increased by urbanization x) is decreased by urbanization y) is shorter for a large drainage basin than for a small one z) depends upon the hydraulic heads
Last Answer : ANSWER: X -- IS DECREASED BY URBANIZATION
Description : The most effective arrangement for diverting excess storm water into a natural drainage, is A. Leaping weir B. Overflow weir C. Siphon spill way D. None of these
Description : For house drainage minimum gradient is A. 1 in 60 B. 1 in 80 C. 1 in 10 D. 1 in 400
Description : If D.O. concentration falls down to zero in any natural drainage, it indicates the zone of A. Degradation B. Active decomposition C. Recovery D. Cleaner water
Description : For drainage pipes in buildings the test applied before putting them to use, is A. Water test B. Smoke test C. Straightness test D. All the above
Description : Pick up the incorrect statement from the following: A. The mixture of water and waste products, is called sewage B. The treated sewage effluents, are generally used for irrigating the ... is called sewerage D. The old convergence system was definitely better than water carried sewerage system
Description : Q No: 271 Pick up the correct statement from the following: A. Turbidity is more in strong sewage B. The black colour indicates septic sewage C. The sewage omits offensive odours after four hours D. All the above
Description : You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at A. Full depth B. Half full C. Two third full D. Three fourth full