Description : Rittinger number which designates the new surface produced per unit of mechanical energy absorbed by the material being crushed, depends on the (A) State or manner of application of the crushing force (B) Ultimate strength of the material (C) Elastic constant of the material (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : In a charged hollow metal conductor, the charge is w) on the inside surface only x) on both the inside and outside surfaces y) on the outside surface only z) only between the inside and outside surfaces
Last Answer : ANSWER: Y -- ON THE OUTSIDE SURFACE ONLY
Description : When a fast charged particle traverses a dielectric medium at a velocity exceeding the velocity of light in that medium, radiation is emitted. This radiation is known as: w) point radiation x) Cerenkov radiation y) Synchrotron radiation z) Bremsstrahlung
Last Answer : ANSWER: X -- CERENKOV RADIATION
Description : Calculate the energy stored per unit volume in a dielectric medium due to polarisation when P = 9 units and E = 8 units. a) 1.77 b) 2.25 c) 36 d) 144
Last Answer : c) 36
Description : The loss tangent refers to the a) Power due to propagation in conductor to that in dielectric b) Power loss c) Current loss d) Charge loss
Last Answer : a) Power due to propagation in conductor to that in dielectric
Description : Compute the conductivity when the current density is 12 units and the electric field is 20 units. Also identify the nature of the material. a) 1.67, dielectric b) 1.67, conductor c) 0.6, dielectric d) 0.6, conductor
Last Answer : c) 0.6, dielectric
Description : The force that causes free electrons to move in a conductor as electric current flow is called a/an _____________. A. resistant force B. electromotive force C. inductive force D. dielectric force
Last Answer : Answer: B
Description : When a megohmmeter is used to test insulation, the gradual rise of the pointer reading as a result of continued cranking, is caused by _____________. A. good conductor resistance B. the ... insulation C. the inductive reactance of the windings D. the dielectric-absorption effect of the insulation
Last Answer : Answer: D
Description : The minimum dielectric stress in a cable is at (a) armour (b) bedding (c) conductor surface (d) lead sheath
Last Answer : (d) lead sheath
Description : Electromagneticwaves are refractedwhen they a. pass into a medium of different dielectric constant b. are polarized at right angles to the direction of propagation c. encounter a perfectly conducting plane d. pass through a small slot in a conducting plane
Last Answer : a. pass into a medium of different dielectric constant
Description : If a positively charged body is placed inside a spherical hollow conductor, what will be the polarity of charge inside and outside the hollow conductor ? (a) Inside positive, outside negative (b) Inside negative, outside positive (c) Both negative (d) Both positive
Last Answer : The polarity of the charge will positive
Description : The force per unit length across such a line in the surface is called _________. a. force per length b. surface tension c. Pressure d. Density
Last Answer : surface tension
Description : Indian agriculture is undergoing a graduals shift from dependence on human power and animal power to......... a) mechanical power b) solar power c) thermal power d) all of the above
Last Answer : mechanical power
Description : The ratio of conduction to displacement current density is referred to as a) Attenuation constant b) Propagation constant c) Loss tangent d) Dielectric constant
Last Answer : c) Loss tangent
Description : Which one of the following statement is incorrect regarding the electromagnetic radiation? (A) These are produced by the motion of electric charge (B) The oscillation of charged particles sets up ... electric fields induce the changing magnetic fields in the surrounding medium (D) None of these
Last Answer : Answer: Option D
Description : Drag co-efficient for flow past immersed body is the ratio of __________ to the product of velocity head and density. (A) Shear stress (B) Shear force (C) Average drag per unit projected area (D) None of these
Last Answer : (C) Average drag per unit projected area
Description : A disc of radius R rotates with constant angular velocity `omega` about its own axis. Surface charge density of this disc varies as `sigma = alphar^(2
Last Answer : A disc of radius R rotates with constant angular velocity `omega` about its own axis. Surface charge density of ... D. `(mu_(0)alphaomegaR^(3))/(3)`
Description : Electric flux density in electric field is referred to as a) Number of flux lines b) Ratio of flux lines crossing a surface and the surface area c) Direction of flux at a point d) Flux lines per unit area
Last Answer : b) Ratio of flux lines crossing a surface and the surface area
Description : If the back fill is having a uniform surcharge of intensity per unit area, the lateral pressure will be (A) q times the lateral pressure within the surface (B) 1/q times the lateral pressure within the surface ... of height Z equal to q/r, where r is the density of the backfill (D) None of these
Last Answer : Answer: Option C
Description : The amount of mechanical force or torque produced by an electric motor depends on the ________________. A. strength of its magnetic field B. amount of armature current flow C. length of conductor in the field D. all of the above
Description : Where do the electrical charges reside in a charged conductor? (1) at the core (2) throughout the body (3) depended upon the nature of the body (4) outer surface of the body
Last Answer : (4) outer surface of the body Explanation: In all conductors, charges reside on the surface. The reason for this is that conductors have free electrons, that is, the electrons are loosely ... field just, outside the conductor is perpendicular to the surface and that the field inside is zero.
Last Answer : outer surface of the body
Description : Rittinger's number designates the new surface created per unit mechanical energy absorbed by the material being crushed. Larger value of Rittinger's number of a material indicates its (A) Easier grindability (B) Poor grindability (C) High power consumption in grinding (D) None of these
Last Answer : (A) Easier grindability
Description : Find the charged enclosed by a sphere of charge density ρ and radius a. a) ρ (4πa 2 ) b) ρ(4πa 3 /3) c) ρ(2πa 2 ) d) ρ(2πa 3 /3)
Last Answer : b) ρ(4πa 3 /3)
Description : Area under current-time graph represents A. magnitude of charge B. dielectric C. amount of positive charge D. amount of negative charge
Last Answer : magnitude of charge
Description : Ferroelectric materials are characterised by (A) Very high degree of polarisation. (B) A sharp dependence of polarisation on temperature. (C) Non-linear dependence of the charge Q on the applied voltage. (D) All the above.
Last Answer : (D) All the above.
Description : Which of the following correctly states Gauss law? a) Electric flux is equal to charge b) Electric flux per unit volume is equal to charge c) Electric field is equal to charge density d) Electric flux per unit volume is equal to volume charge density
Last Answer : d) Electric flux per unit volume is equal to volume charge density
Description : Energy stored per unit volume inside the solenoid is called: a. Energy density b. Charge Density c. Mass density d. Volume charge density
Last Answer : energy density is correct
Description : 16. Surface tension force is the product of surface tension per unit length and cross-sectional area of flow. A) Correct B) Incorrect
Last Answer : B
Description : Surface energy per unit area of a surface is numerically equal to (A) Atmospheric pressure (B) Surface tension (C) Force of adhesion (D) Force of cohesion
Last Answer : Answer: Option B
Description : Electric field of an infinitely long conductor of charge density λ, is given by E = λ/(2πεh).aN. State True/False. a) True b) False
Last Answer : a) True
Description : The propagation constant of the wave in a conductor with air as medium is a) √(ωμσ) b) ωμσ c) √(ω/μσ) d) ω/μσ
Last Answer : a) √(ωμσ)
Description : Under the influence of electric field, the dielectric materials will get charged instantaneously. State True/False. a) True b) False
Description : The removal of paint from electrical equipment, such as generators, should be cautiously undertaken because ____________. A. the mechanical shock of paint removal lessens the dielectric strength ... phase windings frequently become isolated from each other due to dust interference at the terminals
Description : The insulating material for a cable should have (a) low cost (b) high dielectric strength (c) high mechanical strength (d) all of the above
Last Answer : (d) all of the above
Description : A 'dielectric' is a/an ________________. A. electrical insulator B. current flow C. good conductor D. semiconductor material
Last Answer : Answer: A
Description : The electrical conductivity of a __________ decreases with rise in temperature. (A) Metal/alloy (B) Semi-conductor (C) Dielectric (D) None of these
Last Answer : (A) Metal/alloy
Description : An example for lossless propagation is a) Dielectric waveguide propagation b) Conductor propagation c) Cavity resonator propagation d) It is not possible
Last Answer : d) It is not possible
Description : The Gauss law for magnetic field is valid in a) Air b) Conductor c) Dielectric d) All cases
Last Answer : d) All cases
Description : If the loss tangent is very less, then the material will be a a) Conductor b) Lossless dielectric c) Lossy dielectric d) Insulator
Last Answer : b) Lossless dielectric
Description : A dielectric can be made a conductor by a) Compression b) Heating c) Doping d) Freezing
Last Answer : b) Heating
Description : With increase in temperature, the electrical conductivity of a __________ decreases. (A) Semi-conductor (B) Metal or alloy (C) Dielectric (D) None of these
Last Answer : (A) Semi-conductor
Description : Indicate the three types oftransmissionline energylosses. a. I2R, R , and temperature b. Radiation, I2R, and dielectric heating c. Dielectric separation, insulation breakdown, and radiation d. Conductor heating, dielectric heating, and radiation resistance.
Last Answer : b. Radiation, I2R, and dielectric heating
Description : The electric field intensity is defined as a) Force per unit charge b) Force on a test charge c) Force per unit charge on a test charge d) Product of force and charge
Last Answer : c) Force per unit charge on a test charge
Description : The force per unit charge is called: (a) Electric field (b) Electric field intensity (c) Electric potential energy (d) Electric potential
Last Answer : b) Electric field intensity
Description : The rate of an enzyme catalyzed reaction was measured using several substrate concentrations that were much lower than Km, the dependence of reaction velocity on substrate concentration can best be ... constant fraction of Vmax (C) Equal to Km (D) Proportional to the substrate concentration
Last Answer : Answer : C
Description : In a fully turbulent flow (Re > 10 5 ) in a pipe of diameter 'd', for a constant pressure gradient, the dependence of volumetric flow rate of an incompressible fluid is (A) d (B) d 2 (C) d 2.5 (D) d
Last Answer : (C) d 2.5
Description : Modal dispersion is caused by the ∙ a. Dependence of wavelength on index of refraction ∙ b. Dependence of propagation constant on index of refraction ∙ c. Dependence of the propagation constant on the wavelength ∙ d. Dependence of the propagation constant on the mode number
Last Answer : d. Dependence of the propagation constant on the mode number
Description : Material dispersion is caused by the ∙ a. Wavelength dependence of the index of refraction ∙ b. Wavelength independence of the index of refraction ∙ c. Dependence of the propagation constant on the mode number ∙ d. Independence of the propagation constant on the mode number
Last Answer : d. Independence of the propagation constant on the mode number