Recent questions tagged describe

Description : What is one of the craziest things you've ever tried to describe or explain to someone?

Last Answer : Trump’s election.

Description : Describe with neat sketch working of hysteresis motor.

Last Answer : Working: When stator is energized with single phase ac supply, rotating magnetic field is produced because of starting (auxiliary) and main windings, which remain in circuit permanently. The ... the principle of magnetic locking this motor either rotates at synchronous speed or not at all.

Description : State the various lighting calculations methods and Describe any one of them.

Last Answer : Lighting calculation methods: 1. Lumens or Light flux method 2. Point to point or Inverse Square law method 3. Watts per Square meter method i) Lumens or Light ... is taken according to the illumination desired on an average value considering overall efficiency of the lighting system.

Description : Describe the working principle of Thyristor operated dimmer with the help of circuit diagram.

Last Answer : Thyristor operated dimmer: A popular thyristor operated dimmer circuit employ TRIAC-DIAC phase control for low AC power control. During each half-cycle, the capacitor charges through (R1+VR1). When the ... time constant {C (R1+VR1)}. Thus by reducing VR1 the lamp brightness can be increased.

Description : With the help of N-channel JFET describe the effect of input voltage VGS on output current ID.

Last Answer : Working of N channel FET: * When a voltage is applied between the drain and source with a DC supply (VDD), the electrons flows from source to drain through narrow channel ... where the channel gets completely blocked and the drain current becomes zero is called pinch- off voltage. 

Description : Describe strain gauge with labelled diagram.

Last Answer : A Strain gauge is a sensor whose resistance varies with applied force. It converts force, pressure, tension, weight, etc., into a change in electrical resistance which can then be measured. When external ... to the applied strain. So, the voltmeter can be calibrated in terms of strain or force. 

Description : Describe the concept of virtual ground with reference to op-Amp.

Last Answer : Virtual ground concept:-In circuit point A is virtual ground. Figure shows inverting amplifier using op-amp. In this circuit non-inverting terminal is connected to the actual ground. Due to ... zero potential without actually grounding is known as virtual ground concept. Circuit diagram: 

Description : Describe the difference between an open circuit and a short circuit.

Last Answer : Open circuit means the wire is cut meaning power will not flow and close circuit means wire is not cut and hence power will flow.Short circuit is the same as close circuit

Description : Draw and describe working of electronic energy meter.

Last Answer : working of electronic energy meter:- 1. CT reduces current to reasonable value for current scaling network. 2. Voltage & current scaling networks reduce proportionally the voltage & ... The ADC converts the square wave frequency analog output to display the energy in watthour. 

Description : Describe operation of N-channel JFET

Last Answer : Operation of N-channel JFET  1) When VGS = 0 volt: When a voltage is applied between the drain and source with a DC supply voltage VDD with VGS = 0 V, the electrons flow from source ... to zero. The gate to source voltage at which current reduces to zero is called as pinch-off voltage.

Description : Describe the basic SHA operation with the help of its four mode specifications.

Last Answer : Sample-and-hold amplifier (SHA) is a unity gain amplifier with a mode control switch where the input of the amplifier is connected to a time-varying signal. A trigger pulse at the mode control switch ... but other forms, such as optical and mechanical forms, are possible. Also denoted S/H.

Description : Describe triggering circuit for TRIAC using DIAC.

Last Answer : Triggering circuit for TRIAC using DIAC: DIAC stands for diode alternating current. It's a two terminal four layer bidirectional device. It conducts in both directions. DIAC is used for triggering TRIAC. ... of DIAC to the gate terminal of TRIAC reduces the harmonics.