Description : Indicatewhich one ofthe followingreasonsforthe use of a groundscreenwith antennasisfalse: a. Impossibility of a good ground connection b. Provision of an earth for the antenna c.Protectionofpersonnelworkingunderneath d. Improvement of the radiation pattern of the antenna
Last Answer : c.Protectionofpersonnelworkingunderneath
Description : Indicatewhich ofthe followingreasonsfor usinga counterpoisewith antenna isfalse: a. Impossibility of a good ground connection b.Protectionofpersonnelworkingunderground c. Provision of an earth for the antenna d. Rockiness of the ground
Last Answer : b.Protectionofpersonnelworkingunderground
Description : Indicatewhich one ofthe followingterms appliestotroposcatter propagation: a. SIDs b.Fading c. Atmospheric storms d. Faraday rotation
Last Answer : b.Fading
Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz
Last Answer : B. 15 to 160 Mhz
Description : Which ofthe followingcableswill have the highestlaunch power capability? a. 50/125/0.2 b. 85/125/0.275 c. 62.5/125/0.275 d. 100/140/0.3
Last Answer : d. 100/140/0.3
Description : One ofthe followingis not a reason forthe use of anantenna coupler: a. To make the antenna look resistive b. To provide the output amplifier with the correct load impedance c. To discriminate against harmonics d. To prevent reradiation of the local oscillator
Last Answer : d. To prevent reradiation of the local oscillator
Description : One ofthe followingis veryuseful as amultibandHFreceivingantenna.Thisisthe: a. conical horn b. folded dipole c. log periodic d. square loop
Last Answer : c. log periodic
Description : One ofthe followingconsistsof nonresonant antennas: a.The rhombic antenna b. The folded dipole c. The end-fire array d. The broadside array
Last Answer : a.The rhombic antenna
Description : Themaindisadvantage ofthe two-hole directional coupleris a. low directional coupling b. poor directivity c. high SWR d.narrowbandwidth
Last Answer : d.narrowbandwidth
Description : Extra-terrestrial noise is observable at frequencies from A. 0 to 20 KHz B. Above 2 GHz C. 8 to 1.43 GHz D. 5 to 8 GHz
Last Answer : C. 8 to 1.43 GHz
Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz
Last Answer : C. 15 to 160 MHz
Description : In 3G network, W-CDMA is also known as UMTS. The minimum spectrum allocation required for W-CDMA is .......... (1) 2 MHz (2) 20 KHz (3) 5 KHz (4) 5 MHz
Last Answer : Answer: 4
Description : Which is the most suitable power device for high frequency ( more 100 kHz) switching application? a) Power MOSFET b) BJT c) SCR d) UJT
Last Answer : Ans: Power MOSFET
Description : The magnetic flux φB through a plane element of area A⃗ in a uniform magnetic field B⃗⃗ is minimum at a) θ = 900 b) θ = 00 c) θ = 1800 d) None of these
Last Answer : a) θ = 900
Description : A metallic hallow sphere of 8cm diameter is charged with 4 × 10−8c. The potential on its surface will be: (a) 90 volts (b) 9 volts (c) 9000 volts (d) 900 volts
Last Answer : c) 9000 volts
Description : Whatisthe frequencylimitof copperwire? a. approximately 0.5 MHz b. approximately 1.0 MHz c. approximately 40 GHz d. None of the above
Last Answer : b. approximately 1.0 MHz
Description : In which terrestrial biome would you find precipitation of 300 to 900 mm each year?
Last Answer : Need answer
Description : Atmospheric noise becomes less severe at frequencies A. above 30 MHz B. below 30 MHz C. above 3000 kHz D. below 3000kHz
Last Answer : A. above 30 MHz
Description : What is the spectrum of stereophonic FM signal? A. 19 to 38 kHz B. 30 to 53 kHz C. 59.5 to 74.5 kHz D. 88 to 108 MHz
Last Answer : B. 30 to 53 kHz
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : Tropospheric scatter is a method of sky wave propagation for which of the following frequency bands? A. 300 kHz to 3 MHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 300 MHz to 3 GHz
Last Answer : D. 300 MHz to 3 GHz
Description : Which of the following frequency bands is best suited for sky wave propagation? A. 30 to 300 kHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 3 GHz to 30 GHz
Last Answer : B. 3 MHz to 30 MHz
Description : Which of the following frequency bands is best suited for ground wave propagation? A. 30 to 300 kHz B. 300 kHz to 3 MHz C. 3 MHz to 30 MHz D. 30 MHz to 300 MHz
Last Answer : A. 30 to 300 kHz
Description : The band of frequencies least susceptible to atmospheric noise and interference is: A. 30 – 300 kHz B. 300 – 3000 kHz C. 3 – 30 MHz D. 300 – 3000 MHz
Last Answer : D. 300 – 3000 MHz
Description : How many voice signals (4 kHz max.) would fit into a 5 MHz spectrum? A. 1250 B. 500 C. 1000 D. 1500
Last Answer : A. 1250
Description : What is the frequency of a 2-cm sound wave in sea water at 25˚C? A. 76 kHz B. 76 Hz C. 76 MHz D. 76 mHz
Last Answer : A. 76 kHz
Description : Assuming a UHF frequency range of 405.0125 MHz to 405.0875 MHz at 25 kHz channeling plan, how many channels can you produce? A. 2.5 ch. B. 2 ch. C. 4 ch. D. 3 ch.
Last Answer : D. 3 ch.
Description : Assume a frequency range of 405.0125 MHz to 405.0875 MHz and 25 kHz channeling plan, determine the center frequency of the second channel from the lower limit. A. 405.030 MHz B. 405.025 MHz C. 405.050 MHz D. 405.075 MHz
Last Answer : C. 405.050 MHz
Description : Assume a frequency range of 401.000 MHz to 401.050 MHz, if you apply 25 kHz channeling plan, determine the center frequency of the first channel from the lower limit. A. 401.010 MHz B. 401.0125 MHz C. 401.025 MHz D. 401.00625 MHz
Last Answer : B. 401.0125 MHz
Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz
Last Answer : B. 30 to 300 GHz
Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz
Last Answer : B. 0 to 4 kHz
Description : What is the bandwidth ofa signal that ranges from 1 MHz to4 MHz? A) 4 MHz B) 1 KHz C) 3 MHz D) none of the above
Last Answer : 3 MHz
Description : A periodic signal completes onecycle in 0.001 s. What is thefrequency? A) 1 Hz B) 100 Hz C) 1 KHz D) 1 MHz
Last Answer : 1 KHz
Description : What frequency range is used for FM radio transmission? A. Very Low Frequency : 3 kHz to 30. kHz B. Low Frequency :30 kHz to 300 kHz C. High Frequency :3 MHz to 30 MHz D. Very High Frequency : 30 MHz to 300 MHz E. None of the above
Last Answer : Very High Frequency : 30 MHz to 300 MHz
Description : A typical DME frequency is: a. 1000 MHz b. 1300 MHz c. 1000 kHz d. 1575 MHz
Last Answer : a. 1000 MHz
Description : The 2G GSM technology uses a carrier separation of _____________ a) 1.25 MHz b) 200 KHz c) 30 KHz d) 300 KHz
Last Answer : b) 200 KHz
Description : What is the minimum spectrum allocation required by W-CDMA? a) 5 MHz b) 20MHz c) 1.25 MHz d) 200 KHz
Last Answer : a) 5 MHz
Description : Relativistic velocity is of the order of, a) 15 1 of the velocity of light b) 20 1 of the velocity of light c) 10 1 of the velocity of light d) All the above
Last Answer : d) All the above
Description : ……… is the origin of the coordinate system which is defined by manufacturer they cannotbe changed a.Blocking Point b.machine Zero Point c.Start Point d.Program Zero point
Last Answer : b.machine Zero Point
Description : Mark correct option a) The resetting of the credit meter of the franking machine will be done at the PO b) Cut out labels with frank impression on them for prepayment of postage cannot be used ... articles rest entirely with the office of foreign exchange of the country of posting e) All the above
Last Answer : e) All the above
Description : High quality music only needs frequencies up to A. 10 Hz B. 15 Hz C. 20 kHz D. 15 kHz
Last Answer : D. 15 kHz
Description : Which rate is the greatest 800 miles per 16 hours 1500 miles per 50 hours 600 miles per 15 hours or 900 miles per 20 hours?
Last Answer : Convert them all to the same per x hours and then compare them.You can either convert them all to unit rates (x = 1) or some otherrate (eg lcm of 16, 50, 15 and 20).I'll use unit rates:800 miles ... 800 miles per 16 hours > 900 miles per 20 hours > 600miles per 15 hours > 1500 miles per 50 hours.
Description : The drainage area of a town is 12 hectares. Its 40% area is hard pavement ( K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration ... 60) the maximum run off is A. 0.10 cumec B. 0.12 cumec C. 0.15 cumec D. 0.20 cumec
Last Answer : ANS: C
Description : What is the refractive index of an ionospheric layer with 100x105 free electrons per m3 ? Assume frequency to be at 20 MHz. A. 0.99 B. 0.15 C. 0.78 D. 0.85
Last Answer : A. 0.99
Description : Loss comparisons between fusionsplices andmechanicalsplices are a. 1:10 b. 10:1 c. 20:1 d. 1:20
Last Answer : a. 1:10
Description : In Helium-neon Laser, in meta stable state, helium is located at the energy level: a) 20.66 eV b) 20.77 eV c) 20.61 eV d) 20.71 eV
Last Answer : c) 20.61 eV
Description : Substances of conductivity between 10–10 10–20 (n m )–1 are: a) Insulators b) Semiconductors c)Super conductors d)Good conductors
Last Answer : a) Insulators
Description : A transformer steps down 220V to 40 volts. If the secondary turns are 40 then primary turns will be: a. 20 b. 40 c. 120 d. 220
Last Answer : d. 220V
Description : When the potential difference of 4 volt is applied across resistance, 10J energy is converted. Find the charge flows. a. 0.20 C b. 2.5C c. 5C d. 10C
Last Answer : b. 2.5C
Description : An electric iron is marked 20 volts 500W. The units consumed by it in using if for 24 hours will be a. 12 b. 24 c. 5 d. 1100
Last Answer : a. 12