Description : The size of a plane table is (A) 750 mm × 900 mm (B) 600 mm × 750 mm (C) 450 mm × 600 mm (D) 300 mm × 450 mm
Last Answer : (B) 600 mm × 750 mm
Description : The following is an example of Terrestrial Biome A. Tropical rain forest B. Rivers C. Streams D. All of the above
Last Answer : A. Tropical rain forest
Description : Largest terrestrial ecological unit is called a. Forest b. Desert c. Biome d. Tundra
Last Answer : d. Tundra
Description : Explain how temperature and amount of precipitation can affect the type of plants and animals found in the coniferous biome?
Last Answer : {1}} and τ 2 {\displaystyle \tau _{2}} of the single/double-occupancy system
Description : Indicatewhich ofthe followingfrequencies cannotbe used forreliablebeyond-the-horizon terrestrial communicationswithoutrepeaters: a. 20 kHz b. 15 MHz c. 900 MHz d. 12GHz
Last Answer : d. 12GHz
Description : A bullet is fired vertically upwards with a velocity of 2200 ft/s. Bullet ascends to a height of a.56,900 ft b.107 dynes c.75,000 ft d.48.300 ft e.65,800 ft
Last Answer : c. 75,000 ft
Description : If a body (coated black) at `600 K` surrounded by atmosphere at `300 K` has cooling rate `r_(0)`, the same body at `900 K`, surrounded by the same atm
Last Answer : If a body (coated black) at `600 K` surrounded by atmosphere at `300 K` has cooling rate `r_(0)`, the same body ... (0)//16` C. `16r_(0)` D. `4r_(0)`
Description : The serum estradiol level in women during 11–20 days of menstrual cycle is (A) 5–30 pg/ml (B) 50–300 pg/ml (C) 500–900 pg/ml (D) 1000 pg/ml
Last Answer : Answer : B
Description : During pregnancy, the following should be added to the calculated energy requirement: (A) 300 kcal/day (B) 500 kcal/day (C) 700 kcal/day (D) 900 kcal/day
Last Answer : Answer : A
Description : Which of the following statements about normal salt and water balance are true? A. The products of catabolism may be excreted by as little as 300 ml. of urine per day. B. The lungs represent ... of total body water. E. In normal humans, urine represents the greatest source of daily water loss.
Last Answer : Answer: CE DISCUSSION: The skin is the primary source of insensible water loss. Including losses from the lungs, this averages 600 to 900 ml. per day. Catabolism liberates water of solution. In ... still excrete a minimum of 500 to 800 ml. of urine per day to expel the products of catabolism
Description : Chlorophyll formation takes place within a light wavelength of _________: a. 150-200 b. 200-300 c. 300-675 d. 700-900
Last Answer : 300-675
Description : The smallest plant family ‘Gymnosperm’ has how many species? (a) 640 (b) 300 (c) 1000 (d) 900
Last Answer : (d) 900
Description : Low temperature carbonisation of coal takes place at __________ °C. (A) 300 (B) 1100 (C) 700 (D) 900
Last Answer : (C) 700
Description : If the gross vehicle weight of a truck is 30 tonne and rolling resistance is 30 kg/tonne, then the tractive effort required to keep the truck moving at a uniform speed is (A) 30 kg (B) 300 kg (C) 900 kg (D) 1000 kg
Last Answer : (C) 900 kg
Description : Utilizing the answer to the previous problem, estimate the overall or average increase in temperature ( ΔT) of the concrete roof from the energy absorbed from the sun during a12hour day. Assume that all of the radiation absorbed goes into ... °C b. 8.9°C c. 9.9°C d. 10.9°C formula: ΔQ = m c ΔT
Last Answer : 7.9 °C
Description : The interfacial area per unit volume of dispersion, in a gas-liquid contactor, for fractional hold up of gas = 0.1 and gas bubble diameter = 0.5 mm is given by (in m2 /m3 ) (A) 500 (B) 1200 (C) 900 (D) 800
Last Answer : (A) 500
Description : For a simply supported beam of span 15 m, the minimum effective depth to satisfy the vertical deflection limits should be (A) 600 mm (B) 750 mm (C) 900 mm (D) More than 1 m
Last Answer : Answer: Option B
Description : Torque and bending moment of 100 kN.m and 200 kN.m acts on a shaft which has external diameter twice of internal diameter. What is the external diameter of the shaft which is subjected to a maximum shear stress of 90 N/mm2? a. 116.5 mm b. 233.025 mm c. 587.1 mm d. 900 mm
Last Answer : c. 587.1 mm
Description : The size of a plane table is (a) 750mm x 900 mm (b) 600mm x 750 mm* (c) 450mm x 600 mm
Last Answer : (b) 600mm x 750 mm*
Description : Maximum height above rail level of high passenger Platform a. 860 mm b. 900 mm c. 840 mm&* d. 875 mm
Last Answer : c. 840 mm&*
Description : In 1953, Sir Edmund Hillary and Tenzing Norgay were the first people to reach the summit of Mount Everest from their last previously established camp at an altitude of 27,900 feet (barometric pressure ... degrees Celsius x) boiled at 68 degrees Celsius y) not boiled at any temperature z) sublimed
Last Answer : ANSWER: X -- BOILED AT 68 DEGREES CELSIUS
Description : Uniform precipitation having water droplets size less than 0.5 mm is called as a. Rain b. Drizzle c. Snow d. Hail
Last Answer : b. Drizzle
Description : The respective storm totals at three surrounding stations A, B and C are 110, 90 and 70 mm. If the normal annual precipitation amounts at stations X, A, B and C are respectively 1000, 1100, 1200 and 1250 mm, the estimated storm precipitation at X is (A) 75 mm (B) 77 mm (C) 79 mm
Description : While placing of concrete the thickness of each layer for R.C.C. is [ A ] 150 to 300 mm [ B ] 450 mm [ C ] 500 to 750 mm [ D ] 500 mm
Last Answer : [ A ] 150 to 300 mm
Description : what is flora and fauna from each biome
Last Answer : Need Answer
Description : In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the __________ crushing. (A) Primary (B) Secondary (C) Fine (D) Ultrafine
Last Answer : (B) Secondary
Description : In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the __________ crushing. (A) Secondary (B) Fine (C) Primary (D) Ultrafine
Last Answer : (C) Primary
Description : For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of __________ microns (1 mm = 1000 microns). (A) 1-5 (B) 10-60 (C) 200-300
Last Answer : (B) 10-60
Description : A cantilever shaft having 50 mm diameter and length of 300 mm has a disc of mass 100 kg at its free enD. The Young’s modulus for the shaft material is 200 GN/m 2 . Calculate the natural longitudinal frequency in Hz. A. 575B. 625 C. 525 D. 550
Last Answer : A. 575
Description : A cantilever shaft having 50 mm diameter and a length of 300 mm has a disc of mass 100 kg at its free end. The Young’s modulus for the shaft material is 200 GN/m 3 . Determine the static deflection of the shaft in mm. a) 0.147 b) 0.213 c) 0.132 d) 0.112
Last Answer : a) 0.147
Description : A cantilever shaft having 50 mm diameter and a length of 300 mm has a disc of mass 100 kg at its free end. The Young’s modulus for the shaft material is 200 GN/m 2 . Determine the frequency of transverse vibrations of the shaft. a) 31 b) 35 c) 37 d) 41
Last Answer : d) 41
Description : A cantilever shaft having 50 mm diameter and length of 300 mm has a disc of mass 100 kg at its free end. The Young’s modulus for the shaft material is 200 GN/m 2 . Calculate the natural longitudinal frequency in Hz. a) 575 b) 625 c) 525 d) 550
Last Answer : a) 575
Description : Match List-I (crops) with List-II (water requirement) and select your answer from the code given below- List-I (a) Jowar (b) Soybean (c) Cotton (d) Groundnut List-II 1. 140 mm - 300 mm 2. 350 mm - 450 mm 3. 200 mm - 300 mm 4. 300 mm - ... (b) (c) (d) (A) 3 1 2 4 (B) 4 2 3 1 (C) 1 4 2 3 (D) 3 1 4 2
Last Answer : (C) 1 4 2 3
Description : Maximum root zone depth for Maize (a) 200-300 mm (b) 400-600 mm (c) 500-600 mm (d) 350- 450 mm
Last Answer : (b) 400-600 mm
Description : Flat rate parcel rates Flat Rate Parcel Boxes size Dimension of boxes (in mm) Weight (in Kg.) Tariff (in Rs.) Small - S 250*50*300 0 to 1 125 Medium - M 250*100*300 Above 1 to 2.5 200 Large - L 300*250*200 Above 2.5 to 5 400
Last Answer : Large - L 300*250*200 Above 2.5 to 5 400
Description : Pick up the wrong nominal internal diameter of cast iron (spun) pipes in mm from the following: (A) 300 (B) 400 (C) 550 (D) 650
Last Answer : (C) 550
Description : A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so that the maximum bending stress is 75 N/mm². If the slope at the ends is 0.005 radian and the value of E = 0.2 ... joist, is (A) 200 mm (B) 250 mm (C) 300 mm (D) 400 mm
Last Answer : (D) 400 mm
Description : A 300 mm square bearing plate settles by 15 mm in a plate load test on a cohesive soil when the intensity of loading is 0.2 N/mm². The settlement of a prototype shallow footing 1 m square under the same intensity of loading is (A) 15 mm (B) 30 mm (C) 50 mm (D) 167 mm
Last Answer : (C) 50 mm
Description : In the plate loading test for determining the bearing capacity of soil, the size of square bearing plate should be (A) Less than 300 mm (B) Between 300 mm and 750 mm (C) Between 750 mm and 1 m (D) Greater than 1 m
Last Answer : (B) Between 300 mm and 750 mm
Description : If 20 kg of coarse aggregate is sieved through 80 mm, 40 mm, 20 mm, 10 mm, 4.75 mm, 2.36 mm, 1.18 mm, 600 micron, 300 micron and 150 micron standard sieves and the weights retained are 0 kg, 2 kg, 8 kg, ... , the fineness modulus of the aggregate, is (A) 7.30 (B) 7.35 (C) 7.40 (D) 7.45
Last Answer : Answer: Option C
Description : Which of the following statements is incorrect? (A) Minimum cross sectional area of longitudinal reinforcement in a column is 0.8% (B) Spacing of longitudinal bars measured along the periphery of ... (D) The number of longitudinal bars provided in a circular column should not be less than four
Last Answer : Answer: Option D
Description : Sum of tread and rise must lie between (A) 300 to 350 mm (B) 400 to 450 mm (C) 500 to 550 mm (D) 600 to 650 mm
Description : A sewer has a diameter of 300 mm and slop of 1 in 400. While running full it has a mean velocity of 0.7 m/s. If both the diameter and slope are doubled (to respectively be 600 mm and 1 in 200), what will be the changed mean velocity ... 's formula. (a) 1.59 m/s (b) 2.80 m/s (c) 0.90 m/s (d) 1.00 m/s
Last Answer : (a) 1.59 m/s
Description : The Maximum spacing of the longitudinal bars measured long the periphery of the column should be [ A ] 250 mm [ B ] 300 mm [ C ] 400 mm [ D ] 450 mm
Last Answer : [ B ] 300 mm
Description : The Maximum spacing of Secondary reinforcement in slabs should be [ A ] Less than 450 mm [ B ] Less than 300 mm [ C ] Smaller of three times the effective depth and 450 mm [ D ] Smaller of five times the effective depth and 450 mm
Last Answer : [ D ] Smaller of five times the effective depth and 450 mm
Description : According to IS: 456-2000 Maximum spacing of shear reinforcement in no case shall not exceed [ A ] 250 mm [ B ] 300 mm [ C ] 350 mm [ D ] 450 mm
Description : The maximum spacing of main steel in slabs has been limited to [ A ] 250 mm [ B ] 300 mm [ C ] 450 mm [ D ] 500 mm
Description : According to IS: 456-2000 spacing of vertical stirrups for shear reinforcement has been limited to [ A ] 0.75 d [ B ] 450 mm [ C ] lesser of 0.75 d or 300 mm [ D ] lesser of 0.75d or 450 mm
Last Answer : [ C ] lesser of 0.75 d or 300 mm
Description : The maximum of spacing of side face reinforcement shall not exceed [ A ] 300 mm [ B ] Web thickness [ C ] Lesser of (a) and (b) [ D ] Greater of (a) and (b)
Last Answer : [ C ] Lesser of (a) and (b)