What limits the tuning range around the center frequency  of a reflex klystron in a particular mode of operation?

1 Answer

Answer :

The half-power points of the mode.

Related questions

Description : If the constant-speed electrons in a reflex klystron remain in the repeller field for 1 3/4 cycles, what is the mode of operation?

Last Answer : Mode 2.

Description : In a multicavity klystron, tuning all the cavities to the same frequency has what effect on the bandwidth of the tube?

Last Answer : The bandwidth decreases.

Description : The cavities of a multicavity klystron are tuned to slightly different frequencies in what method of tuning?

Last Answer : Stagger tuning.

Description : Debunching of the electron bunches in the higher modes of a reflex klystron has what effect on output power?

Last Answer : Power is reduced.

Description : The constant-speed electrons of an electron bunch in a reflex klystron must remain in the repeller field for what minimum time?

Last Answer : Three-quarter cycle.

Description : When the repealer potential is constant, what property of the electron determines how long it will remain in the drift space of the reflex klystron?

Last Answer : Velocity.

Description : What element of the reflex klystron replaces the output cavity of a normal klystron?

Last Answer : The reflector or repeller.

Description : What is the basic principle of operation of a klystron?

Last Answer : Velocity modulation

Description : Describe working of Reflex Klystron amplifier with a neat diagram.

Last Answer : Operation: It is assumed that the oscillations are set up in the tube initially due to noise or switching transients and these oscillations are sustained by device operation. ... on the reference electron. These bunch transfer maximum energy to the gap to get sustained oscillations.

Description : Reflex klystron is a:  (1) Low power generator (2) High power oscillator (3) Low gain amplifier (4) Not an oscillator

Last Answer : Reflex klystron is a: Low power generator.

Last Answer : The modes in a reflex Klystron gives the same frequency but different transit time.

Description : In single mode operation, the value of the normalized frequency (V) should remain near the 2.405 level. If the value of V is less than 1, do single mode fibers carry a majority of the power in the core or cladding material?

Last Answer : Cladding material.

Description : What is the typical frequency range about the center frequency of a tunable magnetron?

Last Answer : . ±5 percent.

Description : What is the typical frequency range about the center frequency of a tunable magnetron?

Last Answer : ±5 percent.

Description : What limits the maximum range of a surface-search radar?

Last Answer : Radar horizon.

Description : What type of klystron is used as the final stage of a power- amplifier transmitter?

Last Answer : Multicavity klystron.

Description : What type of klystron is used as the final stage of a power- amplifier transmitter?

Last Answer : Multicavity klystron.

Description : Which cavity of a three-cavity klystron causes most of the velocity modulation?

Last Answer : The middle cavity.

Description : How is the electron beam of a three-cavity klystron accelerated toward the drift tube?

Last Answer : A large negative pulse is applied to the cathode.

Description : What can be added to the basic two-cavity klystron to increase the amount of velocity modulation and the power output?

Last Answer : Intermediate cavities between the input and output cavities.

Description : A two-cavity klystron without a feedback path will operate as what type of circuit?

Last Answer : Amplifier.

Description : The two-cavity klystron uses what cavity as an output cavity?

Last Answer : The catcher cavity.

Description : The electrons in the beam of a klystron are speeded up by a high dc potential applied to what elements?

Last Answer : The accelerator grid and the buncher grids.

Description : What should you do if a klystron becomes gassy?

Last Answer : Restore it to serviceable condition by operating it temporarily at reduced beam voltage.

Description : What is the major factor that limits the high-frequency response of an amplifier circuits?

Last Answer : The capacitance of the circuit.

Description : What are the upper and lower frequency limits of an amplifier?

Last Answer : The half-power points of a frequency-response curve. The upper and lower limits of the band f frequencies for which the amplifier is most effective.

Description : What limits the usefulness of high-gain, tunnel-diode frequency converters?

Last Answer : Stability problems.

Description : Klystron operation is based on the principle of  a) Velocity modulation b) Amplitude modulation c) frequency modulation d) Phase modulation

Last Answer : Klystron operation is based on the principle of  Velocity modulation 

Description : Inductive tuning of a resonant cavity is accomplished by placing a nonmagnetic slug in what area?

Last Answer : The area of maximum H lines.

Description : What is the primary measurement application for tuning forks?

Last Answer : They are used to monitor fixed motor speeds.

Description : Capacitive tuning by inserting a ring into the cavity slot of a magnetron is accomplished by what type of tuning mechanism?

Last Answer : . A cookie-cutter tuner

Description : Magnetron tuning by altering the surface-to-volume ratio of the hole portion of a hole-and-slot cavity is what type of tuning?

Last Answer : Inductive.

Description : What type of tuning does the receiver use?

Last Answer : Digital

Description : What are the tuning modes for the coupler group discussed?

Last Answer : Automatic, semiautomatic, and manual.

Description : Why is the pi mode the most commonly used magnetron mode of operation

Last Answer : Greater power output.

Description : A computer that is designed to perform a specific operation and usually satisfies the needs of a particular type of problem, is said to be what type of computer?

Last Answer : Special-purpose.

Description : What is the impedance of a crystal at its resonant frequency when it is used in the series mode?

Last Answer : Minimum.

Description : What is the impedance of a crystal at its resonant frequency when it is used in the parallel mode?

Last Answer : Maximum

Description : Give two reasons why the value of the normalized frequency (V) is varied in single mode stepindex fibers?

Last Answer : To increase performance and reduce losses caused by bending and splicing.

Description : The value of the normalized frequency parameter (V) relates the core size with mode propagation. When single mode fibers propagate only the fundamental mode, what is the value of V?

Last Answer : V≤2.405.

Description : As the temperature of the air increases from 0 degrees C to 20 degrees C, the wavelength of a sound made by a tuning fork of fixed frequency does which of the following? Does the wavelength w) increase x) decrease y) remain the same z) increase up to a maximum, then remain constant

Last Answer : ANSWER: W -- INCREASE

Description : The reflex center associated with temperature regulation are situated in a. cerebrum b. cerebellum c. hypothalamus d. Pons

Last Answer : hypothalamus

Description : The reflex center associated with locomotion are situated in a. Cerebrum b. cerebellum c. mid brain d. Pons

Last Answer : cerebellum

Description : Reflex center are located a. through out the neurons system b. in cervical region only c. thoracic region only d. In lumber region only

Last Answer : through out the neurons system

Description : Later signs of increased intracranial pressure (ICP) later include which of the following? a) Projectile vomiting Projectile vomiting may occur with increased pressure on the reflex center in the ... , the pulse pressure (the difference between the systolic and the diastolic pressure) widens.

Last Answer : a) Projectile vomiting Projectile vomiting may occur with increased pressure on the reflex center in the medulla.

Description : Draw block diagram of digital frequency meter in time mode and describe its operation.

Last Answer : OR Operation: The input signal is amplified and converted to a square wave by a Schmitt Trigger circuit. In this diagram the square wave is differentiated and clipped to ... thereby closing it. The decimal counter and display unit output correspond to the number of input pulses. 

Description : After 48 hours of a cataract extraction operation, a patient complained of ocular pain and visual loss. On examination, this eye looked red with ciliary injection, corneal oedema and absent red ... a. Secondary glaucoma. b. Anterior uveitis. c. Bacterial endophthalmitis. d. Acute conjunctivitis  

Last Answer : ANSWER: C

Description : Assume a frequency range of 405.0125 MHz to 405.0875 MHz and 25 kHz channeling plan, determine the center frequency of the second channel from the lower limit. A. 405.030 MHz B. 405.025 MHz C. 405.050 MHz D. 405.075 MHz

Last Answer : C. 405.050 MHz