An iris placed along the "b" dimension wall produces what  kind of reactance?

1 Answer

Answer :

Inductive.

Related questions

Description : How will an iris that has portions along both the "a" and "b" dimension walls act at the resonant frequency?

Last Answer : As a shunt resistance.

Description : Which one of the following is correct pairing of a body part and the kind of muscle tissue that moves it? (a) Biceps of upper arm – S m o o t h m u s c l e fibres (b) Abdominal wall – Smooth muscle (c) Iris – Involuntary smooth muscle (d) Heart wall – Involuntary unstriated muscle

Last Answer : (b) Abdominal wall – Smooth muscle

Description : A 5 m ladder of mass 25 kg is placed in a position where its inclination to a vertical wall is at 30?. A 100 kg man is to climb the ladder. If the coefficient of static friction is 0.25 the height along ladder at which the slipping will be induced would be a.2.4 m b.1.6 m c.0.8 m d.1.2 m e.0.5 m

Last Answer : c. 0.8 m

Description : What happens to inductive reactance as frequency increases?

Last Answer : It increases.

Description : What happens to capacitive reactance as frequency increases?

Last Answer : It decreases.

Description : In a series-RLC circuit, what is the condition of the circuit if there is high impedance, low current, and low reactance voltages

Last Answer : Nonresonant (circuit is either above or below resonance)

Description : What is the capacitive reactance across a point-contact diode as compared to a normal junction diode?

Last Answer : Lower.

Description : What is the formula for determining total reactance in a series circuit where the values of XC and XL are known?

Last Answer : X = XL – XC or X = XC - XL

Description : Which is more accurate, the bridge- or reactance-type meter?

Last Answer : Bridge type.

Description : What characteristic of a transistor is varied in a semiconductor-reactance modulator?

Last Answer : Collector-to-emitter capacitance.

Description : How does the reactance-tube modulator impress intelligence onto an rf carrier?

Last Answer : By changing the reactance of an oscillator circuit in consonance with the modulating voltage.

Description : What is TRUE about vertical dimension:  A. Does not change for the whole life   B. Decreases when head is tilted back (is the opposite and if is tilted forward decreases, patient  supine reduced, stress and pain also reduced)  C. Increases when a lower denture is placed in mouth 

Last Answer : C. Increases when a lower denture is placed in mouth 

Description : The number of half-wave patterns in the "b" dimension of rectangular waveguides is indicated by which of the two descriptive subscripts?

Last Answer : Second.

Description : The electric field is perpendicular to the "a" dimension of a waveguide in what mode?

Last Answer : TE.

Description : When the frequency is decreased so that two quarter wavelengths are longer than the "a" (wide) dimension of the waveguide, what will happen?

Last Answer : Energy will no longer pass through the waveguide.

Description : When a megohmmeter is used to test insulation, the gradual rise of the pointer reading as a result of continued cranking, is caused by _____________. A. good conductor resistance B. the ... insulation C. the inductive reactance of the windings D. the dielectric-absorption effect of the insulation

Last Answer : Answer: D

Description : Which of the following initiative tries to provide a way of measuring cloud computing services along dimension like cost? a) CCE b) OCCI c) SMI d) All of the mentioned

Last Answer : SMI

Description : A short column (30 cm 20 cm) carries a load P1 at 4 cm on one side and another load P2at 8 cm on  the other side along a principal section parallel to longer dimension. If the extreme intensity on  either side is same, the ... to P2 will be  (A) 2/3  (B) 3/2  (C) 8/5  (D) 5/8 

Last Answer : (C) 8/5 

Description : Along column is one whose ratio of effective length to its least lateral dimension exceeds (a) 5 (b) 10 (c) 12 (d) 20

Last Answer : (c) 12

Description : What type of indicator is usually placed in the stator circuit of a torque synchro system?

Last Answer : An overload indicator.

Description : What restrictions are placed on the use of the electrical lock method?

Last Answer : It can be used only if the leads of the synchro are accessible and the rotor is free to turn.

Description : Why are synchro capacitors placed physically close to differentials transmitters and CTs?

Last Answer : To keep the connections as short as possible in order to maintain system.

Description : In a typical velocity servo block diagram what device is placed in the feedback loop that is not present in the position servo?

Last Answer : Tachometer.

Description : If the ignition switch is placed in the ON position and all the engine instruments operate properly except the gas gauge, where would the fault probably be?

Last Answer : Between point (3) and the gas gauge tank unit ground.

Description : If a transmitting antenna is placed close to the ground, how should the antenna be polarized to give the greatest signal strength?

Last Answer : Vertically polarized.

Description : A recorder's erase head is always placed in what sequence on the record/reproduce track?

Last Answer : . First, before the record and reproduce heads.

Description : Why are record heads always placed before reproduce heads on recorders?

Last Answer : Allow you to monitor the signals you're recording.

Description : If a free gyro is placed at the equator at 1200 in a vertical position; in what position should it be at 1800?

Last Answer : Horizontal.

Description : Why is a dead-zone fiber placed between the test fiber and OTDR when conducting attenuation measurements?

Last Answer : To reduce the effect of the initial reflection at the OTDR

Description : A circuit has a source voltage of 100 volts and two 50-ohm resistors connected in series. If the reference point for this circuit is placed between the two resistors, what would be the voltage at the reference point?

Last Answer : 50 volts.

Description : How would a compass react when placed close to a conductor carrying alternating current at a low frequency?

Last Answer : The compass needle would swing back and forth as the current changed from positive to negative.

Description : How does a compass react when placed close to a current carrying conductor?

Last Answer : The compass needle swings away from magnetic north and aligns itself with the magnetic field around the conductor

Description : 2. A concave mirror produces three times magnified (enlarged) real image of an object placed at 10 cm in front of it. Where is the image located? -Physics-10

Last Answer : Magnification produced by a spherical mirror: Object distance (u) = – 10 cm v = 3 × (- 10) = – 30 cm Therefore, the negative sign indicates that an inverted image is formed in front of the given concave mirror at a distance of 30 cm.

Description : A thin glass prism placed in air produces minimum deviation of `4^(@)` in a light ray. If the prism is immersed in water, what will be the minimum dev

Last Answer : A thin glass prism placed in air produces minimum deviation of `4^(@)` in a light ray. If the prism is immersed in ... //2` and `.^(a)mu_(w) = 4//3`.

Description : A convex mirror produces a magnification of `1//2` when the object is placed at a position A and a magnification of `1//3` when the object is at a pos

Last Answer : A convex mirror produces a magnification of `1//2` when the object is placed at a position A and a ... cm, what is the focal length of the mirror ?

Description : Find the position of an object which when placed in front of a concave mirror of focal length 20 cm, produces a virtual image which is twice the size

Last Answer : Find the position of an object which when placed in front of a concave mirror of focal length 20 cm ... image which is twice the size of the object.

Description : what kind of sun do iris prefer?

Last Answer : I have a lot of Iris's and some get sun all day long and some get just the morning sun (5 or 6 hours) and they all do wonderfully.

Description : A cavity that vibrates at its natural frequency produces a louder sound than at other frequencies. What term is used to describe this phenomenon?

Last Answer : Resonance.

Description : What semiconductor device produces electrical energy when exposed to light?

Last Answer : Photovoltaic cell.

Description : What receiver circuit actually produces the IF frequency?

Last Answer : Mixer.

Description : Which component of the receiver produces the signal that is mixed with the received signal to produce the IF signal?

Last Answer : Local oscillator.

Description : Which of the basic timing circuits produces sharp trigger pulses directly?

Last Answer : Blocking oscillators.

Description : Which of the basic timing circuits produces sharp trigger pulses directly?

Last Answer : Blocking oscillators.

Description : If a power supply produces 20 volts with no load and 15 volts under full load, what is the percent of regulation?

Last Answer : 33.33%

Description : What is a nonrotating device that produces alternating current?

Last Answer : Oscillator.

Description : A thermocouple is a device that produces voltage by what method?

Last Answer : Heat.

Description : What condition produces the 10-kHz error signal generated by the metering bridge in the HP- 431C power meter?

Last Answer : An unbalance in the metering bridge.

Description : What type of core produces the greatest inductance?

Last Answer : Magnetic-metal core.

Description : Which type of optical fiber (multimode or single mode) tends to have lower loss and produces less signal distortion?

Last Answer : Single mode fiber.

Description : A needle 10 cm long is placed along the axis of a convex lens of focal length 10 cm such that the middle point of the neddle is at a distance of 10 cm

Last Answer : A needle 10 cm long is placed along the axis of a convex lens of focal length 10 cm such that ... lens. Find the length of the image of the neddle.