What precautions should you take when tying bundles  
containing coaxial cables?

1 Answer

Answer :

Do not tie too tightly and use the proper type of tape.

Related questions

Description : What is the typical velocity factor of coaxial cables? A. 0.6 to 0.8 B. 0.3 to 0.5 C. 0.5 to 0.9 D. 0.4 to 0.6

Last Answer : A. 0.6 to 0.8

Description : What material is most often used for the outer covering of coaxial cables? A. PVC B. Teflon C. PE D. Polystyrene

Last Answer : A. PVC

Description : Which of the following is not a transmission medium? a. telephone lines b. coaxial cables c. modem d. microwave systems

Last Answer : microwave systems

Description : ______ cables carry data signals in the form of light. A) Coaxial B) Fiber-optic C) Twisted-pair D) none of the above

Last Answer : Fiber-opti

Description : The types of Unguided transmission channel or media used for LAN are __. A. Twisted Pair Cables B. Coaxial Cables C. Radio Waves D. All the above

Last Answer : C. Radio Waves

Description : ……cables are composed of a glass or plastic inner core surrounded by cladding,all encased in an outside jacket. a. Fiber-optic b. Coaxial c. Shield Twisted Pair d. Unshield Twisted-pair

Last Answer : a. Fiber-optic

Description : Which of the following cables can transmit data at high speeds- 1) Coaxial Cable 2) Optic fibre Cable 3) Twistedpair Cable 4) UTP Cabl

Last Answer : 2) Optic fibre Cable

Description : A large numbers of computers in a wide geographical area can be efficiently connected using (A) twisted pair lines (B) coaxial cables (C) Communication satellites (D) all of the above

Last Answer : (D) all of the above

Description : Which of the following cables can transmit data at high speeds 1 Coaxial Cable 2 Optic fibre Cable 3 Twistedpair Cable 4 UTP Cable

Last Answer : 2 Optic fibre Cable

Description : What are precautions to be taken while doing maintenance or repair work on power cables?  

Last Answer : A research organised by EPRI (electric power research institute) on medium voltage XLPE cables found that DC high potential at 80% of the factory value a. Subsequently reduces the life of ... of cramped conductor strands is achieved otherwise it will add resistance and create over heating. 

Description : State the four methods of laying of cable. State precautions while laying of underground cable in the situation : (i) Minimum clearance between cable and water pipe line when running in parallel. (ii) ... is to be laid in the same trench, what should be minimum spacing between two cables ?  

Last Answer : (i) Minimum clearance between cable and water pipe line when running in parallel:- 0.5 mtr. (ii) Minimum clearance between cable and water pipe line when running in parallel:- 0.5 mtr ... should be minimum spacing between two cables :- Then minimum 30 cm spacing is provided between 2 cables 

Description : When in plant leaves, chloroplast containing bundle sheath cells surrounds vascular bundles in several layers that anatomy is known as

Last Answer : When in plant leaves, chloroplast containing bundle sheath cells surrounds vascular bundles in several layers that anatomy is known as

Description : Express mail bags/express bundles mean a) The mail witch should opened first and taken for sorting immediately b) The mail will be received/ dispatched through express trains c) The bags containing accountable articles d) None of these

Last Answer : a) The mail witch should opened first and taken for sorting immediately

Description : Water containing cavities in vascular bundles are found in (a) sunflower (b) maize (c) Cycas (d) Pinus.

Last Answer : (b) maize

Description : What is used to tie wire bundles in high-temperature areas?

Last Answer : High-temperature, pressure-sensitive tape.

Description : What size wire bundles require double lace?

Last Answer : Bundles that are 1 inch or larger in diameter

Description : Why is flat tape preferred instead of round cord when wire bundles are laced?

Last Answer : Round cord has a tendency to cut into the wire insulation.

Description : List five precautions to take when installing fiber optic systems on board naval ships.

Last Answer : a. Never bend an optical fiber or cable at a radius of curvature less than the minimum bend radius. b. Never pull fiber optic cables tight or fasten them over or through sharp corners or ... the hardware. e. Allow only trained, authorized personnel to install or repair fiber optic systems.

Description : When working on electrical circuits containing large capacitors, in addition to deenergizing the circuit, which of the listed precautions should also be taken? A. Keep all radio equipment ... capacitor insulation resistance. C. Ground the capacitor terminals. D. Check capacitor circuit polarity.

Last Answer : Answer: C

Description : What causes the current-carrying area at the center conductor of a coaxial line to be restricted to a small layer at the surface?

Last Answer : Skin effect.

Description : The large surface area of a waveguide greatly reduces what type of loss that is common in two-wire and coaxial lines?

Last Answer : Copper loss.

Description : . Why are coaxial lines more efficient at microwave frequencies than two-wire transmission lines?

Last Answer : The electromagnetic fields are completely confined

Description : Is the attenuation of a coaxial cable independent of frequency?

Last Answer : No.

Description : What factor has the greatest effect on the physical size of a coaxial cable?

Last Answer : The dielectric constant of the insulating material.

Description : List the three disadvantages of the air coaxial line

Last Answer : Expensive to construct, must be kept dry, and high frequency losses limit the practical length of the line.

Description : What is the chief advantage of the air coaxial line?

Last Answer : The ability to minimize radiation losses.

Description : What are the two types of coaxial lines in use today?

Last Answer : Air coaxial (rigid) and solid coaxial (flexible).

Description : What precautions should be exercised when using mercury-vapor thyratrons?

Last Answer : . The filament’s voltage should be applied to the tube at least 30 seconds before attempting to operate the tube.

Description : What precautions must be taken when sweeping a transmitting antenna?

Last Answer : You must ensure that power induced from any adjacent transmitting antennas does not damage your test equipment.

Description : List the safety precautions to be observed when replacing a fuse.

Last Answer : Be sure the power is off in the circuit and the circuit is discharged before replacing a fuse. Use an identical replacement fuse if possible. Remove any corrosion from the fuseholders before replacing the fuses.

Description : List the safety precautions to be observed when checking fuses.

Last Answer : Turn the power off and discharge the circuit before you remove fuses. Use a fuse puller (an insulated tool) when you remove fuses d. Not acceptable-lower voltage rating e. Direct replacement

Description : List the 11 safety precautions for multimeters

Last Answer : a. Deenergize and discharge the circuit completely before connecting or disconnecting a multimeter. b. Never apply power to the circuit while measuring resistance with a multimeter. c. ... a multimeter. k. Observe the general safety precautions for electrical and electronic devices.

Description : List the four safety precautions observed when using a megger.

Last Answer : a. Use meggers for high-resistance measurement only. b. Never touch the test leads when the handle is being cranked. c. Deenergize and discharge the circuit completely before connecting a megger. d. Disconnect the item being checked from other circuitry, if possible, before using a megger

Description : List the four safety precautions observed when using ohmmeters.

Last Answer : a. Deenergize and discharge the circuit before connecting an ohmmeter. b. Do not apply power to a circuit while measuring resistance. c. Switch ohmmeters to the OFF position, ... d. Adjust the ohmmeter after changing resistance range and before measuring reading indicates the resistance.

Description : List the six safety precautions for the use of voltmeters.

Last Answer : a. Always connect a voltmeter in parallel. b. Always start with the highest range. c. Deenergize and discharge the circuit before connecting or disconnecting the voltmeter. d. ... to measure ac voltage. f. Observe the general safety precautions of electric and electronic devices.

Description : List the six safety precautions for the use of ammeters

Last Answer : a. Always connect a voltmeter in parallel. b. Always start with the highest range. c. Deenergize and discharge the circuit before connecting or disconnecting the voltmeter. d. ... to measure ac voltage. f. Observe the general safety precautions of electric and electronic devices.

Description : When should safety precautions pertaining to batteries be observed?

Last Answer : .At all times.

Description : Why are splices staggered on multiconductor cables?

Last Answer : To prevent the joint from being bulky.

Description : Why must cables and wires be identified?

Last Answer : To provide the technician with a means to trace the wires when troubleshooting and repairing electrical and electronic systems.

Description : OFCC, stranded, and ribbon cables have different fiber worst bend performance?

Last Answer : Ribbon.

Description : When is an optical power meter measurement recommended for conducting field measurements on installed optical fiber cables or cable plants?

Last Answer : When an installed optical fiber cable or cable plant is less than 50 meters in length.

Description : Optical fibers or cables should never be bent at a radius of curvature smaller than a certain value. Identify this radius of curvature

Last Answer : Minimum bend radius.

Description : What are the three types of lead-sheathed cables?

Last Answer : Alloy lead, pure lead, and reinforced lead.

Description : What is the most common type of nonmetallic material used to protect wires and cables?

Last Answer : Fibrous Braid.

Description : What is the main disadvantage of using fiber-optic cables?

Last Answer : High attenuation.

Description : What instrument is used for measuring the insulation resistance of cables?

Last Answer : Megohmmeter (megger).

Description : Which is funnier? That Nike invented self-lacing sneakers managed by your smartphone - or - they released an app software update that broke the shoe-tying feature?

Last Answer : I have trouble tying my shoes and might give it a try after the bugs are worked out.

Description : How do you use the Tie Fast Knot tying tool?

Last Answer : You do KNOT use it. If you can’t tie your own flies, then you don’t deserve to have a fishing license.

Description : Do you think tying babies up or caging them is WRONG under ANY circumstances?

Last Answer : answer:Nope. I had 2 toddlers in the airport many years ago. I put both of them on leashes because if I hadn't, we would never had made our plane. Regardless, I got a few round ... (especially extremely active ones) makes many activities impossible, and actually puts the safety of the child at risk.

Description : Tying up a dog for a short amount of time?

Last Answer : answer:Why is he tying her up outside even when he's home? Why on earth get a dog at all if you're unwilling to spend time with it and just banish it away from your presence? I think tying ... deal breaker for sure. BTW: what you're describing certainly doesn't sound like a short amount of time .