Description : Direct relation between…….. &………of saturated steam, the amount of energy input to process easy to control. a) volume, pressure b) volume, temperature c) temperature, pressure d) None of above
Last Answer : c) temperature, pressure
Description : What type of steam is generated by evaporator tube of Lamont boiler ? a. Saturated steam b. Unsaturated steam c. Superheated steam d. Flash steam
Last Answer : a. Saturated steam
Description : For caring the heat efficiently the steam must be__________ a) dry b) wet c) saturated d) none of above
Last Answer : c) saturated
Description : When vapour is cooled at constant total system volume, the _______ changes. A] Volume. B] Pressure C] Temperature. D] None of the mentioned
Last Answer : B] Pressure
Description : When vapour is compressed isothermally the ____________ changes. A] Volume. B] Pressure C] Temperature D] None of the mentioned
Last Answer : A] Volume.
Description : What is the pressure range between which Lamont boiler operator ? a. 80-120 bar b. 120-160 bar c. 180-360 bar d. 450-560 bar
Last Answer : b. 120-160 bar
Description : High pressure boilers operate at 1. Lower than 15 psig 2. Higher than 15 psig 3. 15 psig 4. None of above
Last Answer : 2. Higher than 15 psig
Description : In a steam condenser, the partial pressure of steam and air are 0.06 bar and 0.007 bar respectively. The condenser pressure is (A) 0.007 bar (B) 0.053 bar (C) 0.06 bar (D) 0.067 bar
Last Answer : (D) 0.067 bar
Description : The pressure of steam in the engine cylinder at the beginning of the stroke is ________ the boiler pressure. (A) Equal to (B) Less than (C) Higher than (D) None of these
Last Answer : (B) Less than
Description : In what is water in high pressure boiler circulated through? • Conduits • Cove • Channel • Tubes
Last Answer : • Tubes
Description : What increase as steam pressure increase inside a boiler • Force • Density • Rate of steam conversion • Viscosity
Last Answer : • Density
Description : What is the function of boiler? • To burn the fuel in a confined closed system With the supply of air • To generate steam in varying pressure • To generate steam at constant pressure • To produce flue gases by burning fuel at a given pressure
Last Answer : • To generate steam at constant pressure
Description : On mollier chart ,free expansion or throttling process from High pressure to atmosphere is represented by • Horizontal straight line • Vertical straight line • Straight inclined line • Curved line
Last Answer : • Horizontal straight line
Description : The back pressure created by lift is approximately ______PSIG for every 2 feet of condensate lift. a. 1 PSIG b. 3PSIG c. 1PSGI d. 3PSGI
Last Answer : a. 1 PSIG
Description : A -________ incorporates a firebox or furnace in order to burn the fuel and _________ heat. a. Boiler, generate b. Heat, boiler c. Steam, pressure d. None
Last Answer : a. Boiler, generate
Description : What is the main component in a boiler a) steam b) heat c) pressure condenser d) combination
Last Answer : a) steam
Description : An economiser in a boiler........ A]Increases steam pressure. B]Increases steam flow C]Decreases fuel consumption D]Decreases steam pressure
Last Answer : C]Decreases fuel consumption
Description : Water tube boilers produces steam at a________ pressure than that of fire tube boilers. a) Higher b) Lower c) Same d) None of the above
Last Answer : a) Higher
Description : Find false statement about effect of sulphur in fuel? (A) It has heating value (B) It helps in electrostatic precipitation of ash in flue gases (C) It leads to corrosion of air heaters, ducting, etc. if flue gas exit temperature is low (D) It erodes furnace walls
Last Answer : (D) It erodes furnace walls
Description : Adiabatic process is (A) Essentially an isentropic process is___________ (B) Non-heat transfer process (C) Reversible process (D) Constant temperature process
Last Answer : (B) Non-heat transfer process
Description : When the bubbles of steam are produced? • Once the water reaches saturation temperature • Once the water starts evaporating • Once the temperature decreases • None of the above
Last Answer : • Once the water reaches saturation temperature
Description : Feed water usually at…… °C temperature. a) 70 b) 120 c) 1000 d) 80
Last Answer : d) 80
Description : The product of efficiency & heat transferred to the working fluid is? a. Net temperature change b. Net work done c. Net enthalpy change d. None of the mentioned
Last Answer : b. Net work done
Description : What is the temperature at which the steam boiler are capable to withstand • 200°C • 280°C • 540°C • 358°C
Last Answer : • 540°C
Description : What is the temperature at which the steam boiler are Capable to withstand a. 200°C b. 280°C c. 540°C d. 358°C
Last Answer : c. 540°C
Description : When gas changes to liquid through the process of condensation, the temperature A] Increases. B] Decreases C] Remains constant. D] None of the mentioned
Last Answer : C] Remains constant.
Description : The economiser is used in boilers to........ A]Increase thermal efficiency of boiler B]Economise on fuel C]Extract heat from the exhaust the gases D]Increase flue gas temperature
Last Answer : A]Increase thermal efficiency of boiler
Description : What happens when air dissolves in condensate? a) non corrosive b) temperature of air increases c) corrosive d) none of above
Last Answer : c) corrosive
Description : Based on the exhaust gas analysis, a controller maintains stoichiometric combustion __ a. by commanding a servo motor to adjust the combustion air damper b. By commanding servo motor to adjust the fuel supply valve. c. Both a. & b. d. None of the above.
Last Answer : c. Both a. & b.
Description : Detecting and monitoring carbon monoxide assures the air/fuel ratio is not too rich as a. The excess air is trimmed b. Excess air is let out c. Both a. & b. d. None of above
Last Answer : a. The excess air is trimmed
Description : It is easy to detect and monitor excess air a. As oxygen not used for combustion is heated and discharged with the exhaust gases. b. Oxygen is discharged without heating c. Both a. & b. d. None of above
Last Answer : a. As oxygen not used for combustion is heated and discharged with the exhaust gases.
Description : For process boilers , combustion air fans must meet the following requirements ___ a. The fan motor shall be driven by a variable speed drive b. The fan motor shall include controls that limit the fan motor demand to no more than 30 %. c. Both a. & b. d. None of the above
Description : A flue damper and a vent damper are two examples of _______ a. Combustion air positive shut off devices b. Combustion air negative shut off devices c. Both a. & b. d. None of the above
Last Answer : a. Combustion air positive shut off devices
Description : Process boilers with capacity of 2.5 MMBtu/h and above are also referred as _ a. Natural draft boilers b. Atmospheric boilers c. Both a. And b. d. None of the above
Last Answer : a. Natural draft boilers
Description : If steam is pressurized _____ • It occupies more space • It occupies less space • Both are correct • None of the above
Last Answer : • It occupies less space
Description : when steam is condensate volume is drastically……. a) reduces b) increase c) both a) & b) d) None of above
Last Answer : a) reduces
Description : If the water level inside the boiler were not carefully control cased… a) explosion b) overheat and fail c) both a) & b) d) None of above
Last Answer : c) both a) & b)
Description : The generated heat is transferred to water to make ______ the process of boiling. • Steam • Boiler • Both • None
Last Answer : • Steam
Description : The heat produced in this system is then rejected into the system as _______ a. Steam b. Boiler c. Both a & b d. None
Last Answer : a. Steam
Description : If a member of the assurance team, or their immediate family member receives, by way of, for example, an inheritance, gift or, as a result of a merger, a direct financial interest or a material indirect ... of the assurance team from the assurance engagement. c. Either a or b d. Neither a nor b
Last Answer : Either a or b
Description : What is the main disadvantage of Lamont boiler ? a. Less flexible in design b. Low heat transfer rate c. Formation of bubbles d. Low steam generation capacity
Last Answer : c. Formation of bubbles
Description : Where is water steam separator drum located in Lamont boiler ? a. Inside of the boiler b. Right above the furnace c. Before the feed water pump d. Outside the boiler
Last Answer : d. Outside the boiler
Description : In which year was Lamont boiler invented? a. 1905 b. 1910 c. 1920 d. 1925
Last Answer : d. 1925
Description : Through which does the even circulation of water is possible in Lamont boiler ? a. Nozzles b. Water trough c. Feed pump d. Hose
Last Answer : a. Nozzles
Description : In what form are the boiler tube arrange in Lamont boiler ? a. Parallel in vertical b. Inclined vertically c. Parallel in horizontal d. Horizontally inclined
Last Answer : c. Parallel in horizontal
Description : Through what is feed water from hot-well is passed through, before entering steam and water drum in Lamont boiler? a. Evaporator tubes b. Economizer c. Distributor header d. Circulating pump
Last Answer : b. Economizer
Description : What is called as the heart of the Lamont boiler? a. Water drum b. Centrifugal pump c. Furnace d. Blower
Last Answer : b. Centrifugal pump
Description : Type of Lamont boiler is_______ a. Forced circulation b. Natural circulation c. Over-through d. Positive forced circulation
Last Answer : a. Forced circulation
Description : Boilers are used in places like 1. Domestic heating 2. Commercial heating 3. Industrial heating application 4. All of above
Last Answer : 4. All of above
Description : Combustion of which fuels from following is source of heat for boiler 1. Wood 2. Coal 3. Oil 4. All of above