Description : On piles, the drop must be at least (A) 80 cm (B) 100 cm (C) 120 cm (D) 140 cm
Last Answer : Answer: Option C
Description : In case of Raymond pile (A) Lengths vary from 6 m to 12 m (B) Diameter of top of piles varies from 40 cm to 60 cm (C) Diameter of pile at bottom varies from 20 cm to 28 cm (D) All the above
Last Answer : Answer: Option D
Description : The minimum depth of building foundations on (A) Sandy soils is 80 cm to 100 cm (B) Clay soils is 90 cm to 160 cm (C) Rocky soils is 5 cm to 50 cm (D) All the above
Description : The usual width of parapet walls along Highways in hilly region, is (A) 50 cm (B) 60 cm (C) 70 cm (D) 80 cm
Last Answer : Answer: Option B
Description : In a single threaded worm and worm wheel the number of teeth on the worm wheel is 80. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be a.60 b.45 c.120 d.107 dynes e.90
Last Answer : c. 120
Description : Standerd disc plough consist of steel dics of… to……. CM diameter. a. 60,90 c) 60,80 b. 70,100. d) 70,90
Last Answer : 60,90
Description : For end bearing piles, the minimum spacing of piles of diameter ‘d’ shall be a) 3d b) 2d c) 2.5d* d) 5d
Last Answer : c) 2.5d*
Description : The conductivity of copper is less than that of silver by (A) 5 – 10 %. (B) 50 – 60 %. (C) 80 – 90 %. (D) 20 – 30 %.
Last Answer : (A) 5 – 10 %.
Description : A software project was estimated at 352 Function Points (FP). A four person team will be assigned to this project consisting of an architect, two programmers, and a tester. The salary of the architect is Rs.80,000 per month, the ... ) Rs.28,16,000 (2) Rs.20,90,000 (3) Rs.26,95,000 (4) Rs.27,50,000
Last Answer : (4) Rs.27,50,000
Description : If the peak discharge of a storm water drain (S.W. Drain) is expected to exceed 150 cumecs, the free board to be provided, is A. 100 cm B. 90 cm C. 80 cm D. 50 cm
Last Answer : ANS: A
Description : Pick up the correct statement from the following: (A) The bearing capacity of a pile is defined as the load which can be sustained by the pile without producing excessive settlement (B) The safe bearing capacity ... of safety (C) The factor of safety for piles is taken as 6 (D) All the above
Description : In plain sedimentation tanks under normal conditions, impurities are removed upto (A) 60 % (B) 70 % (C) 80 % (D) 90 %
Last Answer : (B) 70 %
Description : Area of steel required per metre width of pavement for a length of 20 m for design wheel load 6300 kg and permissible stress in steel 1400 kg/cm2 , is (A) 70 kg/sq cm (B) 80 kg/sq cm (C) 90 kg/sq cm (D) 100 kg/sq cm
Description : The minimum width of a septic tank is taken (A) 70 cm (B) 75 cm (C) 80 cm (D) 90 c
Last Answer : (B) 75 cm
Description : Standard disc plough diameter size is A. 40 to 60 cm C. 70 to 90 cm B. 60 to 90 cm D. 50 to 70 cm
Last Answer : 60 to 90 cm
Description : According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than (A) 20 cm (B) 30 cm (C) 40 cm (D) 75 cm
Description : According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than (A) 5 cm (B) 10 cm (C) 15 cm (D) 20 cm
Description : If the effective plan area of a warehouse is 54 sq. m, and maximum height of piles permitted is 270 cm, the number of cement bags to be stored, is (A) 2000 bags (B) 2200 bags (C) 2400 bags (D) 2700 bags
Description : Pick up the incorrect statement from the following: (A) Space between the exterior walls of a warehouse and bag piles should be 30 cm (B) Cement bags should preferably be piled on wooden planks (C) Width and height of the pile should not exceed 3 m and 2.70 m respectively (D) None of these
Description : Two columns 50 cm 50 cm and 60 cm 60 cm carry 80 tonnes and 120 tonnes of loads respectively. The centre to centre distance between columns is 5.00 metres. The permissible bearing capacity of the soil is 20 t ... the foundation slab = 7.00 m (C) Area of footing slab = 11.00 m2 (D) All the above
Last Answer : Option D
Description : Apiece of sawn timber whose cross-sectional dimensions exceed 5 cm, in one direction and 20 cm in the other direction, is called a (A) Cant (B) Deal (C) Baulk (D) Strip
Description : A piece of timber whose thickness and width are respectively 5 cm and 10 cm is called (A) Slate (B) Plank (C) Board (D) Strip
Description : Maximum allowable spacing of shear reinforcement for inclined stirrups with an inclination of 45° is restricted to [ A ] 0.75 d [ B ] 0.45 d [ C ] 0.90 d [ D ] d
Last Answer : [ D ] d
Description : Maximum allowable spacing of shear reinforcement for vertical stirrups is restricted to [ A ] d [ B ] 0.45 d [ C ] 0.75 d [ D ] 0.90 d
Last Answer : [ C ] 0.75 d
Description : An intense rain is falling at a uniform rate of 7.5 cm/hour for a period of 60 minutes on a basin whose area is 500 hectares. If the average infiltration capacity during the entire rain period is assumed to be 1.5 ... of the basin, is (A) 40 cumecs (B) 60 cumecs (C) 80 cumecs (D) 100 cumecs
Description : The height of the sink of wash basin above floor level is kept (A) 60 cm (B) 70 cm (C) 75 cm to 80 cm (D) 80 cm
Last Answer : (C) 75 cm to 80 cm
Description : Mustard crop planted at a spacing of 50 x 20 cm will have _______ plants/ha.
Last Answer : Ans.1,00,000
Description : The spacing between the discs in the gang bolt ranges cm for lighy duty and cm heavy -duty harrows i. 15-25 and 25-30 c) 40-45 and 45-50 ii. 20-30 and 30-40. d) 15-25 and 32-36
Last Answer : 15-25 and 25-30
Description : If the number of lanes on the carriageway of a road is more than two, the total width of lane ways is equal to 3.0 m (A) + 0.60 m (B) + 0.70 m (C) + 0.90 m (D) + 1.50 m
Description : According to National Building Code, the hydrants in water mains is provided at minimum interval of (A) 50 m (B) 60 m (C) 75 m (D) 90 m
Last Answer : Option C
Description : Rapid gravity filters can remove bacterial impurities up to a maximum of (A) 50 % (B) 60 % (C) 70 % (D) 80 %
Last Answer : (D) 80 %
Description : Degree of saturation of a natural soil deposit having water content 15%, specific gravity 2.50 and void ratio 0.5, is (A) 50 % (B) 60 % (C) 75 % (D) 80 %
Last Answer : (C) 75 %
Description : If the radius of curvature of a hill road is 50 m, the percentage grade compensation should be (A) 60/R (B) 70/R (C) 75/R (D) 80/R
Description : The percentage of alumina in a good brick earth lies between (A) 5 to 10 % (B) 20 to 30 % (C) 50 to 60 % (D) 70 to 80 %
Description : Percentage of silica in a good brick earth lies between (A) 5 to 10 % (B) 20 to 30 % (C) 50 to 60 % (D) 70 to 80
Description : The sum of the percentage of tricalcium silicate and dicalcium silicate for Portland cement varies from. (a) 50 to 60% (b) 60 to 70% (c) 70 to 80% (d) 80 to 90%
Last Answer : (c) 70 to 80%
Description : The width b and depth d of a beam cut from a wooden cylindrical log of 100 cm diameter for maximum strength are: (A) b = 57.73 cm d = 81.65 cm (B) b = 81.65 cm d = 57.73 cm (C) b = 50.00 cm d = 50.00 cm (D) b = 40.00 cm d = 80.00 cm
Last Answer : (A) b = 57.73 cm d = 81.65 cm
Description : For a ribbed slab (A) Clear spacing between ribs shall not be greater than 4.5 cm (B) Width of the rib shall not be less than 7.5 cm (C) Overall depth of the slab shall not exceed four times the breadth of the rib (D) All the above
Description : If the width of a pavement slab is 7.5 m, thickness 20 cm and working stress 1400 kg/cm2 , spacing of 10 mm tie bars for the longitudinal joint, is (A) 10 cm (B) 20 cm (C) 30 cm (D) 40 cm
Description : Pick up the incorrect statement from the following: In a dry dock block made of hard wood, (A) Spacing of the blocks is 1.35 m (B) The lowest block is 1.8 m long 40 cm × 40 cm in cross-section (C) The middle block is 1.6 m long 40 cm × 40 cm in cross-section (D) None of these
Last Answer : (D) None of these
Description : Cast iron piles (A) Are suitable for works under sea water (B) Resist shocks or vibrations (C) Are suitable for use as batter piles (D) Are useful for heavy vertical loads
Description : How many maximum tools can ATC hold? a.60 b.80 c.90 d.100
Last Answer : b.80
Description : The fuel in diesel engine is normally injected at pressure of a. 5-10 kg/cm2 b. 20-25 kg/cm2 c 60-80 kg/cm2 d. 90-130 kg/cm2
Last Answer : ANSWER d. 90-130 kg/cm2
Description : Octane number of petrol normally used in petrol engines is of the order of a. 20-30 b. 40-60 c. 60-70 d. 80-90
Last Answer : ANSWER d. 80-90
Description : Octane number (unleaded) of reformed gasoline may be upto (A) 60 (B) 70 (C) 80 (D) 90
Last Answer : (D) 90
Description : A project with total budget cost of 30 crores is scheduled to be completed in 80 weeks. A periodic review was carried out at end of 60 weeks and results are as given: Budgeted cost of work performed (EV) = 17 ... crores What is the cost performance index? A.0.895 B.0.81 C.0.90 D.1.12
Last Answer : A.0.895
Description : The least number that is divisible by all the numbers from 1 to 5 is: (a) 70 (b) 60 (c) 80 (d) 90
Last Answer : (b) 60
Description : amount of liquid that a man can spray in a day is: A. 60 litres liquid B. 70 litres liquid C. 80 litres liquid D. 90 litres liquid
Last Answer : 90 litres liquid
Description : Out of 5 women and 4 men, a committee of three members is to be formed in such a way that at least one member is woman. In how many different ways can this be done? 1) 60 2) 100 3) 120 4) 90 5) 80
Last Answer : 5) 80