Description : For the open drain (N = 0.025) shown in the below figure, the discharge is A. 26.88 cumecs B. 27.88 cumecs C. 28.88 cumecs D. 29.88 cumecs
Last Answer : ANS: C
Description : Pick up the correct statement from the following: A. The maximum rate of storm runoff is called peak drainage discharge B. Rational method of estimating peak run off, may be used precisely for ... entire area starts contributing to the runoff, is called the time of concentration D. All the above
Last Answer : ANS: D
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Description : An intense rain is falling at a uniform rate of 7.5 cm/hour for a period of 60 minutes on a basin whose area is 500 hectares. If the average infiltration capacity during the entire rain period is assumed to be 1.5 ... of the basin, is (A) 40 cumecs (B) 60 cumecs (C) 80 cumecs (D) 100 cumecs
Last Answer : Answer: Option C
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : A cylindrical ejector having its height 2 m fills after every 10 minutes with a peak sewage discharge of 0.0157 cumec. The diameter of the ejector chamber, is A. 2.30 m B. 2.40 m C. 2.45 m D. 2.50 m
Description : In septic tanks, A. Free board of 0.3 m may be provided B. The baffles or tees are extended up to top level of scum C. The clear space between the baffle top and covering slab is about 7.5 cm D. All the above
Description : If total run off of a basin of 50 hectares is 0.8 cm, the ordinate of Bernard's distribution graph, may be calculated by the formula (where Q is the discharge in cumecs at the given time) (A) y = 50 Q (B) y = 100 Q (C) y = 200 Q (D) y = 250 Q
Last Answer : Answer: Option D
Description : The effluent of a septic tank is A. Fit for discharge into any open drain B. Foul and contains dissolved and suspended solids C. As good as that from a complete treatment D. None of these
Last Answer : ANS: A
Description : ¾th or ¼th extra space is left in sewer pipes at maximum discharge for A. Low estimates of the average and maximum flows B. Large scale infiltration of storm water C. Unexpected increase in population D. All the above
Description : Which one of the following statements regarding septic tanks is wrong? A. A gap of 7.5 cm between the bottom of the covering slab and the top level of scum is provided B. The outlet invert level is kept ... . The minimum width of septic level is 90 cm D. The depth of tank is kept equal to its width
Description : Ventilating shafts are provided to a sewer line at every A. 100 m B. 150 m C. 200 m D. 300 m
Description : When drainage to sewage ratio is 20, the peak dry weather flow is A. 20% of the design discharge B. Slightly less than 5% of the design discharge C. Slightly more than 5% of the design discharge D. None of these
Last Answer : ANS: B
Description : The rational formula for peak drainage discharge, was evolved by A. Fruhling B. Lloyd David C. Kuichling D. All of these
Description : 15 cumecs, the depth d and width are related by For drains up to A. d = 0.2 B B. d = 0.5 B C. B = 0.2 d D. B = 0.5 d
Description : If the depletion of oxygen is found to be 2.5 mg/litre after incubating 2.5 ml of sewage diluted to 250 ml for 5 days at 20°C, B.O.D. of the sewage is A. 50 mg/l B. 100 mg/l C. 150 mg/l D. 250 mg/l
Description : If the depletion of oxygen is found to be 5 ppm after incubating a 2.5% solution of sewage sample for 5 days at 21°C, B.O.D. of the sewage is A. 50 ppm B. 100 ppm C. 150 ppm D. 200 ppm
Description : Inter-distance between ventilation columns in a sewer line is kept A. 25 to 50 m B. 50 m to 100 m C. 100 m to 150 m D. 150 m to 300 m
Description : Bottom openings 15 cm × 15 cm in the standing baffle wall are provided A. 15 cm c/c B. 22.5 cm c/c C. 30 cm c/c D. 50 cm c/c
Description : Assertion A.: A free board of 0.3 m is provided above the top sewage line in septic tanks. Reason (R): It helps to accommodate the scum in the septic tank. A. Both A and R is true and R is the correct ... is not a correct explanation of A C. A is true but R is false D. A is false but R is true
Description : The normal value of over flow rates for plain primary sedimentation tanks, ranges between A. 25,000 to 35,000 litres/sqm/day B. 40,000 to 50,000 litres/sqm/day C. 50,000 to 60,000 litres/sqm/day D. 80,000 to 100,000 litres/sqm/day
Description : The normal values of over flow rates for sedimentation tanks using coagulant, ranges between A. 25,000 to 35,000 litres/sqm/day B. 40,000 to 50,000 litres/sqm/day C. 50,000 to 60,000 litres/sqm/day D. 80,000 to 100,000 litres/sqm/day
Description : Pick up the in-correct statement from the following: A. Manholes are provided in sewer pipes at suitable intervals B. Catch basins are generally provided in sewers for carrying drainage discharge C. Inlets are generally provided in all sewers D. None of these
Description : For providing an Indian type W.C., the R.C.C. slabs in the toilet portion A. Should be sunk by 20 cm B. Should be kept 20 cm above the adjacent portion C. Should be sunk by 50 cm D. Need not be sunk
Description : If discharge of a pump is 0.16 cumecs, the economic diameter of pipe, is (A) 0.488 m (B) 4.88 cm (C) 48.8 cm (D) 4.88 m
Last Answer : (A) 0.488 m
Description : In a residential colony, sewers of diameters 100 mm, 150 mm and 225 mm were laid with a gradient 1 in 120. Which portion of the sewage system does not choke in due course of time? A. 100 mm dia. B. 150 mm dia. C. 225 mm dia. D. All of these
Description : If the diameter of a sewer is 150 mm, the gradient required for generating self cleansing velocity, is A. 1 in 60 B. 1 in 100 C. 1 in 120 D. None of these
Description : Drop manholes at the junctions of sewer lines, are provided if A. Invert level of a branch sewer is more than 60 cm that of the main sewer B. Sewer line runs along a main road C. Ordinary manhole cannot be built D. Two sewer lines intersect
Description : Cross sectional area of catch water drain should not be more than a) 0 .75 square meter* b) 0. 90 square meter c) 0. 80 square meter d). 50 square meter
Last Answer : a) 0 .75 square meter*
Description : The normal values of over flow rates for secondary sedimentation tanks, ranges between A. 25,000 to 35,000 litres/sqm/day B. 40,000 to 50,000 litres/sqm/day C. 50,000 to 60,000 litres/sqm/day D. 80,000 to 10,000 litres/sqm/day
Description : If the discharge of a sewer running half is 628 1.p.s., i = 0.001, and n = 0.010, the diameter of the sewer, is A. 1.39 m B. 1.49 m C. 1.59 m D. 1.69 m
Description : If the over land flow from the critical point to the drain is 8 km and the difference in level is 12.4 m, the inlet time is A. 2 hours B. 3 hours C. 4 hours D. 5 hours
Description : If the length of overland flow from the critical point to the mouth of drain is 13.58 km and difference in level between the critical point and drain mouth is 10 m, the inlet time is A. 2 hours B. 4 hours C. 6 hours D. 8 hours
Description : Dry water flow in a combined sewer, is A. Industrial sewage B. Domestic sewage C. Storm water D. Inclusive of domestic and industrial sewage but excludes storm water
Description : The most effective arrangement for diverting excess storm water into a natural drainage, is A. Leaping weir B. Overflow weir C. Siphon spill way D. None of these
Description : A rain sanitary sewer is constructed to carry A. Sanitary sewage B. Storm sewage C. Surface water D. Ground water
Description : The water carried sewerage system removes A. Domestic sewage B. Industrial sewage C. Storm sewage D. All the above
Description : WASTE WATER ENGINEERING Objective Questions with Answers Q No: 161 The quantity of liquid waste which flows in sewers during the period of rainfall, is known A. Sanitary sewage B. Industrial waste C. Storm sewage D. None of these
Description : The sound level of an agricultural tractor should not exceed : I. 110 dB J. 100 dB K. 90 dB L. 80 dB
Last Answer : K. 90 dB
Description : The angle subtended by the surface of sewer water with partial flow, at sewer centre is 120°, the depth of sewerage is A. 20 cm B. 25 cm C. 40 cm D. 50 cm
Description : If the maximum shear stress at the end of a simply supported R.C.C. beam of 6 m effective span is 10 kg/cm2 , the share stirrups are provided for a distance from either end where, is (A) 50 cm (B) 100 cm (C) 150 cm (D) 200 cm
Description : The minimum depth of building foundations on (A) Sandy soils is 80 cm to 100 cm (B) Clay soils is 90 cm to 160 cm (C) Rocky soils is 5 cm to 50 cm (D) All the above
Description : If the depth of partial flow in a sewer of diameter 2 m, is 50 cm, its wetted perimeter is A. B. /2 C. /3 D. 2 /3
Description : For laying a sewer line in a trench of 2 m width, an offset line is marked on the ground parallel to the given centre line at a distance of A. 100 cm B. 120 cm C. 140 cm D. 160 cm
Description : The density of population over 40 hectares is 250/hectare. If water supply demand per day is 200 litres and sewage discharge is 80% of water supply, the sewage flow in sewers of separate system, is A. 0.05552 cumec B. 0.05554 cumec C. 0.05556 cumec D. 0.0556 cumec
Description : Sewer pipes are designed for maximum discharge with 25% to 33% vacant cross-sectional area for A. Unexpected large scale infiltration of stream water B. Unexpected increase in the population C. Under estimates of maximum and average flows D. All of the above
Description : For estimating the peak run off the rational formula Q = 0.0278 KpA was evolved by A. Kinchling B. Lloyd Davis C. Frubling D. All the above
Description : The maximum permissible chloride content in treated water of public water supplies should not exceed (A) 50 P.P.M. (B) 100 P.P.M. (C) 150 P.P.M. (D) 250 P.P.M.
Last Answer : (D) 250 P.P.M.
Description : The gradient of sewers depends upon A. Velocity of flow B. Diameter of the sewer C. Discharge D. All the above
Description : The ratio of design discharge to the surface area of a sedimentation tank is called A. Surface loading B. Overflow rate C. Overflow velocity D. All of these