Description : In diesel engine the fuel injected would burn instantaneously at about compressed air temperature of A. 1000°C B. 250°C C. 450°C D. 2000°C
Last Answer : ANSWER : A
Description : In diesel engine, the fuel is ignited by a. spark b. injected fuel c. heat resulting from compressing air that is supplied for combustion d. ignitor
Last Answer : ANSWER c. heat resulting from compressing air that is supplied for combustion
Description : Octane number of petrol normally used in petrol engines is of the order of a. 20-30 b. 40-60 c. 60-70 d. 80-90
Last Answer : ANSWER d. 80-90
Description : The specific fuel consumption for diesel engine is approximately A. 0.15 kg/kWh B. 0.2 kg/kWh C. 28 kg/kWh D. 0.36 kg/kWh
Last Answer : ANSWER : B
Description : The specific fuel consumption per BHP hour for diesel engine is approximately a. 0.1 kg b. 0.2 kg c. 0.3 kg d. 0.4 kg
Last Answer : ANSWER b. 0.2 kg
Description : Injection pressure of fuel nozzle in diesel engine is a) 30-45 kg/cm2 b) 50-100 kg/cm2 c) 120-200 kg/cm2 d) 200 kg/cm2
Last Answer : c) 120-200 kg/cm2
Description : Compression pressure in diesel engine cylinder is a) 6-10 kg/cm2 b) 10-20 kg/cm2 c) 20-35 kg/cm2 d) None of the above
Last Answer : c) 20-35 kg/cm2
Description : The specific fuel consumption per BHP hour for petrol engine is approximately a. 0.1 kg b. 0.2 kg c. 0.25 kg d. 0.35 kg
Last Answer : ANSWER c. 0.25 kg
Description : The efficiency of a internal combustion engine normally is of the order of a. 15-20 % b. 20-25% c. 25-30% d. 30-35%
Last Answer : ANSWER d. 30-35%
Description : A 5 BHP engine running at full load would consume diesel of the order of A. 0.3 kg/hr B. 1 kg/hr C. 3 kg/hr D. 5 kg/hr
Last Answer : ANSWER ; B
Description : A diesel engine is usually more efficient than a spark ignition engine because a. Diesel being a heavier hydrocarbon, release more heat per kg than gasoline b. The air standard efficiency of diesel ... an Spark ignition engine d.Self ignition temperature of diesel is higher than that of gasoline.
Last Answer : ANSWER c. The compression ratio of a diesel engine is higher than that of an S.I engine
Description : An engine produces 10 kW brake power while working with a brake thermal efficiency of 30%. If the calorific value of the fuel used is 40000 kJ/kg, then what is the fuel consumption? (a) 1.5 kg/hour (b) 3 kg/hour (c) 0.3 kg/hour (d) 1 kg/hour
Last Answer : Ans :b
Description : The specific fuel consumption of a petrol engine compared to diesel engine of same H.P is A. same B.more C. less D. unpredictable
Description : Which of the following is compressed in a diesel engine cylinder A. air B. fuel C. air and fuel D. air and lub oil
Description : The output of a diesel engine can be increased without increasing the engine speed or size in the following way A. feeding more fuel B. increasing the flywheel size C. heating intake air D. supercharging
Last Answer : ANSWER : D
Description : If one cylinder of a diesel engine receives more fuel than others , then for that cylinder the A. exhaust will be smoky B. scavenging occurs C. exhaust temperature will be high D. engine starts overheating
Description : If the performance of diesel engine of different sizes, cylinder dimensions and power rating are to be compared, which of the following parameters can be used for such comparison? (a) Swept volume (b) Air fuel ratio (c) Specific brake fuel consumption (d) Volumetric efficiency
Last Answer : Ans :c
Description : In a 4 S diesel engine, the term ‘squish’ refers to the (a) Injection of fuel in the precombustion chamber (b) Discharge of gases from the precombustion chamber (c) Entry of air into the combustion chamber (d) Stripping of fuel from the core
Description : Mixing of air and fuel in the diesel engine occurs in a. injection pump b. carburetor c. engine cylinder d. inlet manifold
Last Answer : ANSWER c. engine cylinder
Description : The tendency of a diesel engine to knock increases if a. engine speed is increased b. engine power is increased c. cetane number of the fuel is increased d. compression ratio is increased
Last Answer : ANSWER d. compression ratio is increased
Description : Which of the following medium is compressed in a diesel engine cylinder? a. air b. air and fuel c. air and lubricating oil d. fuel
Last Answer : ANSWER a. air
Description : The output of a diesel engine can be increased without increasing the engine size in following way a. injecting more fuel b. increasing flywheel size c. scavenging d. supercharging
Last Answer : ANSWER d. supercharging
Description : Fuel is injected into the cylinder at the end of ______________ stroke. a) suction b) compression c) expansion d) exhaust
Last Answer : Answer: b Explanation: Fuel is injected into the cylinder at the end of compression stroke and not at suction or expansion stroke.
Description : Area of steel required per metre width of pavement for a length of 20 m for design wheel load 6300 kg and permissible stress in steel 1400 kg/cm2 , is (A) 70 kg/sq cm (B) 80 kg/sq cm (C) 90 kg/sq cm (D) 100 kg/sq cm
Last Answer : Answer: Option C
Description : Air fuel ratio for idling speed of a petrol engine is approximately A. 1:1 B. 5:1 C. 20:1 D. 10:1
Description : The theoretically correct air fuel ratio of a petrol engine is of the order of A. 6:1 B. 10:1 C. 15:1 D. 20:1
Last Answer : ANSWER : C
Description : Air fuel ratio at which a petrol engine cannot work is a. 8:1 b. 10:1 c. 20:1 and less d. 15:1
Last Answer : ANSWER c. 20:1 and less
Description : Keeping other parameters constant brake power of diesel engine can be increased by (a) Decreasing the density of intake air (b) Increasing the temperature of intake air (c) Increasing the pressure of intake air (d) Decreasing the pressure of intake air
Last Answer : Ans : c
Description : Scavenging air in diesel engine means a. air used for combustion under pressure b. forced air for cooling the cylinder c. burnt air containing products of combustion d. air used for forcing burnt gases out of the engines cylinder during the exhaust stroke
Last Answer : ANSWER d. air used for forcing burnt gases out of the engines cylinder during the exhaust stroke
Description : Air fuel ratio at which a petrol engine cannot work is A. 8:1 B. 12:1 C. 15:1 D. 20:1 and less
Description : The injection pressure of ic engine used on tractors is in range of kg/cm2 1. 0-6 2. 60-120 3. 120-200 4. 200-300
Last Answer : ans 3
Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on
Description : The tendency of knocking in CI engine reduces by (a) High self ignition temperature of fuel (b) Decrease in jacket water temperature (c) Injection of fuel just before TDC (d) Decrease in injection pressure
Description : Vapour lock is a. complete or partial stoppage of fuel supply due to vaporization of the fuel b. locking of carburetor due to high vapor pressure c. excess fuel supply to the engine d. supply of liquid fuel to the engine
Last Answer : ANSWER a. complete or partial stoppage of fuel supply due to vaporization of the fuel
Description : Supercharging is the process of a. supplying the engine with air at a density greater than the density of the surrounding atmosphere b. providing forced cooling air c. injecting excess fuel d. raising the exhaust pressure
Last Answer : ANSWER a. supplying the engine with air at a density greater than the density of the surrounding atmosphere
Description : Compression pressure in petrol engine cylinder is a) 6-10 kg/cm2 b) 10-20 kg/cm2 c) 20-35 kg/cm2 d) 35-40 kg/cm2
Last Answer : a) 6-10 kg/cm2
Description : A 4S diesel engine, when running at 2000 rpm has an injection duration of 1.5 ms.What is the corresponding of the crank angle in degrees? (a) 18° (b) 9° (c)36° (d) 15°
Last Answer : Ans :a
Description : Which of the following is the lightest and most volatile liquid fuel A. diesel B. kerosene C. fuel oil D. gasoline
Description : A fuel of cetane number 40 has the same ignition quality as a mixture of a) 40% cetane and 60% alpha methyl naphthalene b) 40% alpha methyl naphthalene and 60% cetane c) 40% petrol and 60% diesel d) 40% diesel and 60% petrol
Last Answer : Answer: a Explanation: A fuel of cetane number 40 has the same ignition quality as a mixture of 40% cetane and 60% alpha methyl naphthalene as cetane number is counted on cetane percentage.
Description : A fuel of an octane number rating of 75 matches in knocking intensity as a mixture of a) 75% iso-octane and 25% normal heptane b) 75% normal heptane and 25% iso-octane c) 75% petrol and 25% diesel d) 75% diesel and 25% petrol
Last Answer : Answer: a Explanation: None.
Description : The self-ignition temperature of diesel oil compared to petrol is a. higher b. lower c. same d. depends on the quality of fuel
Last Answer : ANSWER a. higher
Description : Which of the following is the lightest and most volatile liquid fuel? a. diesel b. kerosene c. gasoline d. fuel oil
Last Answer : ANSWER c. gasoline
Description : An engine working on air standard Otto cycle has a cylinder diameter of 10 cm and stroke length of 15 cm. The ratio of specific heats for air is 1.4. If the clearance volume is 196.3 cc and the heat supplied per kg of air per ... kg of air is a. 879.1 kJ/ b. 890.2 kJ c. 895.3 kJ d. 973.5 kJ
Last Answer : ANSWER d. 973.5 kJ
Description : In a boiler enthalpy of water supplied was 2000 kJ/kg. Enthalpy being added by fuel combustion is 3200 kJ/kg. Using first law of thermodynamics, find amount of heat supplied if steam generation rate is 10 tons per hour.
Last Answer : Heat supplied Q = m (h2-h1) …….(Steady flow energy equation for boiler) ; h2=3200 KJ/kg h1=2000 KJ/kg m = 10 Tons /hour = (10 x 1000)/3600 kg/sec = 2.77 Kg/sec Q = 2.77(3200-2000) = 3324 KJ/sec heat supplied for 10 Tons/hr steam generation
Description : In a naturally aspirated diesel engine, the air is supplied by a A. supercharger B. centrifugal pump C. movement of engine piston D. reciprocating pump
Description : The knock in diesel engine occurs due to A. instantaneous and rapid burning of the first part of the charge B. instantaneous auto ignition of the last part of the charge C. delayed burning of the last part of the charge D. reduction of delay period
Description : Most high speed compression ignition engine operate on A. dual cycle B. otto cycle C. diesel cycle D.Carnot cycle
Description : A diesel engine compared to petrol engine, running at full load is A. less efficient B. equally efficient C. more efficient D. other factors will decide it
Description : In a typical medium speed 4- stroke Diesel engine, the inlet valve A. opens 20°before top dead centre and closes at 35°afterthebottomdead centre. B. opens up at top dead centre and closes at bottomdead centre C. may open orcloseanywhere D. remains open for 200°
Description : In diesel engine, the compression ratio as compared with the expansion ratio is a. same b. less c. more d. variable
Last Answer : ANSWER c. more