# Sampling of Analogue Signals

Sampling of Analogue Signals

Sampling of Analogue Signals

•Sampling means splitting in regular interval to convert it in digital form.

•Sampling converts continuous signal to discrete signal.

•Actually the accuracy of analogue signal is more than digital because digital signal have finite data.

•All the positions in discrete signal is a number.

•So analogue signal have some different advantages and digital signal have some different advantages.

•Sampling is used in measurement system and data converters.

•By using different sampling rate we can sampled the signal.

•Sampling frequency or sampling rate Fs = 1/T is the number of samples obtained in one second.

•If the samples are less then it will cause aliasing which will cause loss in information.

•Using Nyquist theorem (Fs ≥2B) where 2B is Nyquist rate we can avoid aliasing and decide how much sampling frequency should use.

•Using sampling we can store the analogue data in digital form.

## Related questions

Last Answer : Operating torques in analogue instruments are deflecting, control and damping.

Description : Classify Interrupts On The Basis Of Signals. State Their Differences.?

Last Answer : Answer :On the basis of level the signals can be classified into the following types: Single level interrupts Multi level interrupts The differences between them are as follows: For single the ... multi level it is not necessary. Single level interrupts are much slower than multi level interrupts.

Description : How Can Signals Be Classified For The 8085 Microprocessor?

Last Answer : Answer :The signals of the 8085 microprocessor based on their functions can be classified into 7 categories namely: Frequency and power signals Address and data buses The control bus Interrupt Signals Serial Input / Output signals DMA signals Reset Signals

Description : Find the phasors corresponding to the following signals

Last Answer : Find the phasors corresponding to the following signals

Description : For measurement of radio frequency ac signals __________ type meter is used

Last Answer : For measurement of radio frequency ac signals thermo-couple type meter is used

Description : Explain the difference between analogue and digital signals. -Technology

Last Answer : Analogue Signal- An analogue signal is any continuous signal. Varying quality of a signal represents changes in the process. Analogue is usually thought of in an electrical context; however, mechanical ... or icons, or continuous, such as sounds, images, and other measurements of continuous systems.

Description : What do you call an oscilloscope that uses sampling techniques in processing signals having frequencies beyond its normal capabilities?

Description : The most common method used for sampling voice signals in PCM systems.

Last Answer : flat top sampling

Description : The signals which are obtained by encoding each quantized signal into a digital word is called as a) PAM signal b) PCM signal c) FM signal d) Sampling and quantization

Last Answer : b) PCM signal

Description : A unit ramp function when integrated yields: A) unit parabolic function B) unit ramp function C) unit doublet D) unit impulse function

Last Answer : A unit ramp function on integration yields a unit parabolic function

Description : The spectrum of discrete-time Fourier transform will be:  a. Periodic and discrete b. Aperiodic and continuous c. Periodic and continuous d. Aperiodic and discrete

Last Answer : The spectrum of discrete-time Fourier transform will be: Periodic and continuous

Description : On different unit impulse function results in   (A) Unit parabolic function (B) Unit triplet (C) Unit doublet (D) Unit ramp function

Last Answer : On different unit impulse function results in Unit doublet

Description : A system is causal if the output of any time depends only on   (A) Values of input in the past and in the future (B) Values of input at that time and in the past (C) Values of input at that time and in the future (D) none

Last Answer : A system is causal if the output of any time depends only on Values of input at that time and in the past

Description : The Match Filter  (A) is a high-pass filter  (B) is a low-pass filter  (C) is an optimum system for detecting known signal in the presence of Gaussian noise  (D) is a system to detect arbitrary signal in the presence of noise

Last Answer : The Match Filter is an optimum system for detecting known signal in the presence of Gaussian noise

Description : For a discrete time filter to be causal and to have exact linear phase (A) Its impulse response must be of infinite length (B) Its impulse response can be of any length (C) The signal should be left sided (D) Its impulse response must be of finite length

Last Answer : For a discrete time filter to be causal and to have exact linear phase Its impulse response must be of finite length

Description : Integration of step signal gives (A) Impulse signal. (B) Ramp function. (C) Parabola. (D) Square pulse.

Last Answer : Integration of step signal gives Ramp function.

Description : What are the advantages of a digital signal?

Last Answer : It  has   only   two  variable   input  and  output (low   or    high)   (0  or    5).

Description : 7.24 Consider the finite-duration signal x(n) = {1,2,3,1} (a) Compute its four point DFT by solving explicitly the 4-by-4 system of linear equations defined by the inverse DFT formula. (b) Check the answer in part (a) by computing the four-point DFT, using its defination.

Last Answer : Handwritten Solution for Problem Number 7.24 from Digital Signal Processing 4th edition By John G. Proakis

Description : Linear Time Invariant (LTI) System

Last Answer : Linear Time Invariant System Linear system means a system which possesses the property of superposition. Time invariant system means its behavior and characteristics are fixed over time. Before ... from the impulse response. Impulse response is related to frequency response via Fourier transform.

Description : A hybrid computer A) Resembles digital computer B) Resembles analogue computer C) Resembles both a digital and analogue computer D) None of the above

Description : All of the following statements about puromycin are true except (A) It is an alanyl tRNA analogue (B) It causes premature termination of protein synthesis (C) It inhibits protein synthesis in prokaryotes (D) It inhibits protein synthesis in eukaryotes

Description : All of the following statements about allopurinol are true except (A) It is a structural analogue of uric acid (B) It can prevent uric acid stones in the kidneys (C) It increases the urinary excretion of xanthine and hypoxanthine (D) It is a competitive inhibitor of xanthine oxidase

Description : A synthetic nucleotide analogue, used in the chemotherapy of cancer and viral infections is (A) Arabinosyl cytosine (B) 4-Hydroxypyrazolopyrimidine (C) 6-Mercaptopurine (D) 6-Thioguanine

Description : A synthetic nucleotide analogue, 4-hydroxypyrazolopyrimidine is used in the treatment of (A) Acute nephritis (B) Gout (C) Cystic fibrosis of lung (D) Multiple myeloma

Description : Coenzymes are (A) Heat stable, dialyzable, non protein organic molecules (B) Soluble, colloidal, protein molecules (C) Structural analogue of enzymes (D) Different forms of enzymes

Description : A synthetic nucleotide analogue, used in organ transplantation as a suppressor of immunologic rejection of grafts is (A) Theophylline (B) Cytarabine (C) 4-Hydroxypyrazolopyrimidine (D) 6-Mercaptopurine

Description : Which part of the camera is analogue to the retina in the human eye? A. Lens B. Film C. Aperture D. Shutter

Description : In electronic circuits, DC voltages can be positive (+) or negative (-) when measured with respect to the _________. A. printed circuit board 'common' trace B. chassis, console frame or hull 'ground' C. analogue or digital circuitry 'common' bus D. all of the above

Description : Refers to the first generation of local loop system in telecommunication technology. A. GSM B. DECT C. Analogue cellular D. TACS

Last Answer : C. Analogue cellular

Description : What is the channel bandwidth of a standard analogue telephone system? A. 300-500 Hz B. 1200 kHz C. 100-300 Hz D. 300-3400 Hz

Last Answer : D. 300-3400 Hz

Description : ___________ is a device in data transmission to interface data terminal equipment to an analogue transmission line. A. RS 232 B. Connector C. Modem D. RJ-11 plug

Description : In __________ transmission, a unique SYNC character is transmitted at the beginning of each message. A. asynchronous B. synchronous C. digital D. analogue

Description : Which part of the Camera is analogue to the retina in the human eye? A. Lens B. Film (Answer) C. Aperture D. Shutter

Description : Unwanted signal that distorts a transmitted signal is called A. analogue B. noise C. digital D. tuning

Description : Data in compact disc is stored in form of A. analogue signal B. digital signal C. noise D. colors

Description : Voltage signal generated by a microphone is A. digital in nature B. analogue in nature C. consists of bits and bytes D. hybrid in nature

Last Answer : analogue in nature

Description : ........................ model is a map which indicates roads, highways, towns and inter- relationships a. Iconic model b. Analogue model c. Mathematical model d. None of these

Last Answer : b. Analogue model

Description : An organisation chart is an example of ........................... a. Iconic model b. Mathematical model c. Analogue model d. None of these

Last Answer : c. Analogue model

Description : .........................are called mathematical models. a. Iconic models b. Symbolic models c. Analogue models d. None of these

Last Answer : b. Symbolic models

Description : .......................... models are obtained by enlarging or reducing the size of the items. a. Iconic models b. Analogue models c. Symbolic models d. None of these

Last Answer : a. Iconic models

Description : 16.5 Octreotide is a long acting synthetic analogue of: A. Prolactin B. Growth hormone C. Somatostatin D. Gonadotropin releasing hormone

Last Answer : D. All of the above

Description : Choose the correct statement about latanoprost: A. It is a PGF2α derivative used in glaucoma B. It is a selective α1 blocker used in benign hypertrophy of prostate C. It is a 5-α- ... reduce the size of enlarged prostate gland D. It is a PGE2 analogue used intravaginally for cervical priming

Last Answer : A. It is a PGF2α derivative used in glaucoma

Description : Choose the correct statement about latanoprost: A. It is a PGF2α derivative used in glaucoma B. It is a selective α1 blocker used in benign hypertrophy of prostate C. It is a 5-α- ... reduce the size of enlarged prostate gland D. It is a PGE2 analogue used intravaginally for cervical priming

Last Answer : A. It is a PGF2α derivative used in glaucoma

Description : Digital meters are superior over analogue meters because (A) less expensive (B) output reading is binary in nature (C) output impedance is less (D) installation is easy as panel meters

Last Answer : Digital metres are superior over analogue metres because output reading is binary in nature and digital metres have various advantages over analogue metres in digital metres we can see the exact precise ... direction but if analogue meter rotate or move in any direction it may give error value

Description : Which is the fastest type of analogue to digital converter?

Last Answer : Flash converter is the fastest type of analogue to digital converter (ADC).

Description :  Minimum number of bits required to represent maximum value of given analogue signal with 0.1% accuracy is: a. 8 bits b. 9 bits c. 10 bits d. 12 bits

Description : Sociologists: What kind of sampling method is it when you make an open survey that anyone can answer?

Last Answer : Qualitative cross-sectional, maybe?

Description : Who sells those blood-curdlingly festive holiday sweaters that those among us,with any taste,have avoided sampling like hot death?

Last Answer : Try Goodwill. I usually see a ton of them there. Got a hot date, do ya? ;)

Description : Transferring DATS to PC via Optical Out and maintaining 48K sampling. what program allows me to do this?

Last Answer : Your sound card needs to have the sync set to Optical or External so that the word clock syncs to the DAT; the DAT is the master, and the sound card is the slave. Otherwise, both decks will ... well DATs are native 16-bit recorders, whereas newer digital formats (i.e. Digital Video) is 24-bit.

Description : Should I use a higher sampling rate when encoding songs in iTunes?

Last Answer : answer:There's definitely an audible difference between 128 and 256 if you're using good equipment. In my experience, the difference is not noticeable in everyday use for most tracks. But I keep ... that certain headphones make my ears fatigued. Since you have the space, go for the higher quality.