Description : What is the impedance of a balance 4-wire with a diameter of 0.25 cm and spaced 2.5 cm apart using an insulator with a dielectric constant of 2.56? A. 100Ω B. 65Ω C. 75 Ω D. 50 Ω
Last Answer : A. 100Ω
Description : Polyethylene has very poor dielectric and ageing properties. (a) Yes (b) No
Last Answer : (b) No
Description : What is the time delay introduced by a 75-ft coaxial cable with a dielectric constant of 2.3? A. 1.54 ns B. 11.5 ns C. 115.6 ns D. 1156 ns
Last Answer : C. 115.6 ns
Description : The ratio of speed of light in air to the speed of light in another substance is called the a. Speed factor b. Index of reflection c. Index of refraction d. Dielectric constant
Last Answer : c. Index of refraction
Description : Referred to the dielectric constant of a transmission line material. A. Inductance and capacitance B. Velocity factor C. Characteristic impedance D. Propagation velocity
Last Answer : B. Velocity factor
Description : What is the characteristic impedance of a two-wire line with the following data: diameter = 0.023in., spacing =0.5 in., insulation = PE.? A. 300Ω B. 250Ω C. 305Ω D. 301Ω
Last Answer : D. 301Ω
Description : What material is most often used for the outer covering of coaxial cables? A. PVC B. Teflon C. PE D. Polystyrene
Last Answer : A. PVC
Description : A 'dielectric' is a/an ________________. A. electrical insulator B. current flow C. good conductor D. semiconductor material
Last Answer : Answer: A
Description : insulator which is placed between 2 plates of capacitor isA. electric B. dielectric C. inductor D. resistor
Last Answer : dielectric
Description : If the loss tangent is very less, then the material will be a a) Conductor b) Lossless dielectric c) Lossy dielectric d) Insulator
Last Answer : b) Lossless dielectric
Description : A dielectric is always an insulator. But an insulator is not necessarily a dielectric. State True/False. a) True b) False
Last Answer : a) True
Description : How is the dielectric strength of an insulator determined?
Last Answer : By raising the voltage on a test sample until it breaks down.
Description : The bridge used to measure the dielectric loss of an insulator is: A) Anderson bridge B) Wien’s bridge C) Schering bridge D) Any of the above
Last Answer : C)Schering bridge
Description : What is the difference between an insulator and a dielectric?
Last Answer : Dielectric is the another name for insulator.
Description : Polytetrafluoroethylene (PTFE) is also widely used insulator and is known as. A. polystyrene B. teflon C. ceramic D. bakelite
Last Answer : B. teflon
Description : What is the order of energy gap in a conductor, semi conductor, and insulator?.
Last Answer : Conductor - no energy gap Semi Conductor - It is of the order of 1 ev. Insulator - 6 ev (or) more than 6 ev.
Description : A dielectric waveguide for the propagation of electromagnetic energy at light frequencies a. Stripline b. Microstrip c. Laser beam d. Fiber optics
Last Answer : d. Fiber optics
Description : Proposed the use of clad glass fiber as a dielectric waveguide a. Karpon and Keck b. Karpon and Bockham c. Bockham and Kao d. Kao and Keck
Last Answer : c. Bockham and Kao
Description : What is the velocity factor for non-foam dielectric 50 or 75 ohm flexible coaxial cable such as RG 8, 11, 58 and 59? A. 2.70 B. 0.66 C. 0.30 D. 0.10
Last Answer : B. 0.66
Description : When electromagnetic wave are propagated through a waveguide, they A. are reflected from the walls but do not travel along them B. travel along all four walls of the waveguide C. travel along the broader walls of the guide D. travel through the dielectric without touching the walls
Last Answer : A. are reflected from the walls but do not travel along them
Description : Proposed the use of a clad glass fiber as a dielectric waveguide. A. Kao and Keck B. Karpon and Keck C. Karpon and Bockham D. Bockham and Kao
Last Answer : D. Bockham and Kao
Description : What is the velocity factor for non-foam dielectric 50 or 75 ohm flexible coaxial cable such as RG 8, 11, 58 and 59? A. 2.70 B. 0.10 C. 0.66 D. 0.30
Last Answer : C. 0.66
Description : What is the frequency range of C-band? A. 8.5 to 12.5 GHz B. 3.4 to 6.425 GHz C. 12.95 to 14.95 GHz D. 27.5 to 31 GHz
Last Answer : B. 3.4 to 6.425 GHz
Description : If the velocity of propagation in a certain medium is 200x106 m/s, what is its refractive index? A. 1.3 B. 1.5 C. 1.27 D. 0.67
Last Answer : B. 1.5
Description : A properly matched transmission line has a loss of 1.5 dB/100m. if 10 W is supplied to one end of the line, how many watts reach the load, 27 m away? A. 10 W B. 7.2 W C. 9.9 W D. 9.1 W
Last Answer : D. 9.1 W
Description : What is the frequency range of C-band? A. 10.95 to 14.5 GHz B. 27.5 to 31 GHz C. 3.4 to 6.424 GHz D. 1.53 to 2.7 GHz
Last Answer : C. 3.4 to 6.424 GHz
Description : What height must a satellite be placed above the surface of the earth in order for its rotation to be equal to earth’s rotation? A. 26,426.4 miles B. 27,426.4 miles C. 23,426.4 miles D. 22,426.4 miles
Last Answer : D. 22,426.4 miles
Description : Reading a 58 dBrnC on your Western Electric 3A test set at a +7 test point is equal to ______ dBrnc0. A. 58 B. 51 C. 65 D. 27
Last Answer : B. 51
Description : What is the actual length in feet of a one-half wavelength of a coax with a velocity factor of 0.63 at 28 MHz? A. 44.28 B. 43.46 C. 11.07 D. 46.27
Last Answer : C. 11.07
Description : What is the r-value of HDPE (high density polyethylene)?
Last Answer : Great question for Google.
Description : What is the role of polyethylene glycol in somatic hybridization? -Biology
Last Answer : answer:
Description : Is polyethylene terephthalate composite?
Last Answer : Polyethylene terephthalate is not a composite material.
Description : Where can I buy polyethylene pipes?
Last Answer : You can buy polyethylene at any of your local hardware stores such as Home Depot lowes and ace hardware. All of them stores have polyethylene pipes and all the accessory to fix your water pipes.
Description : Myeloma cells and lymphocytes can be fused by using (A) Calcium chloride (B) Ethidium bromide (C) Polyethylene glycol (D) DNA polymerase
Last Answer : Answer : C
Description : Nylon is made up of : (1) Polyamide (2) Polyester (3) Polyethylene (4) Polypropylene
Last Answer : (1) Polyamide Explanation: Nylon is a generic designation for a family of synthetic polymers known generically as aliphatic polyamides. It is one of the most commonly used polymers.
Description : Which one of the following polymers is widely used for making bullet proof material? (1) Polyvinyl chloride (2) Polyamides (3) Polyethylene (4) Polycarbonates
Last Answer : (4) Polycarbonates Explanation: Ballistic nylon was the standard cloth used for bulletproof vests until the 1970s. In 1965, Stephanie Kwolek, a chemist at Du Pont, invented Kevlar, trademark ... terephthalamide, a liquid polymer that can be spun into aramid fiber and woven into cloth.
Description : Which one among the following polymers is used for making bullet-proof material? (1) Polyvinyl chloride (2) Polystyrene (3) Polyethylene (4) Polyamide
Last Answer : (3) Polyethylene Explanation: A bullet-proof material is made of polyethylene. It is a higher grade of the plastic found in Tupperware.
Description : Flexible plastic pipes are made of (A) High density polyethylene (HDPE) (B) Low density polyethylene (LDPE) (C) Polypropylene (D) Unsaturated polyester
Last Answer : (B) Low density polyethylene (LDPE)
Description : Identify the group in which all the polymers mentioned can be used to make fibres. (A) Butadiene copolymers, Polyamides, Urea-formaldehyde (B) Cellulose derivatives, Polyisoprene, Polyethylene (C) Cellulose derivatives, Polyamides, Polyurethane (D) Polypropylene, Poly vinyl chloride, Silicon
Last Answer : (B) Cellulose derivatives, Polyisoprene, Polyethylene
Description : Polyethylene glycol method is used for (a) biodiesel production (b) seedless fruit production (c) energy production from sewage (d) gene transfer without a vector.
Last Answer : (d) gene transfer without a vector.
Description : Which of the following enhances or induces fusion of protoplasts? (a) IAA and kinetin (b) IAA and gibberellins (c) Sodium chloride and potassium chloride (d) Polyethylene glycol and sodium nitrate
Last Answer : (d) Polyethylene glycol and sodium nitrate
Description : Which of the following is a thermosetting polymer? (a) Bakelite (b) Nylon-6,6 (c) Polyethylene (d) Teflon
Last Answer : Bakelite
Description : Zeigler process (A) Produces high density polyethylene (B) Produces low density polyethylene (C) Uses no catalyst (D) Employs very high pressure
Last Answer : (A) Produces high density polyethylene
Description : In fiber optics, PCS stands for ∙ a. Plastic-clad-silica ∙ b. Polyethylene-clad-silica ∙ c. Personal carrier system ∙ d. Personal communication
Last Answer : ∙ a. Plastic-clad-silica
Description : What is the collective term used to describe substances such as Orlon, Nylon, polyethylene, and polyurethane foam?
Last Answer : ANSWER: POLYMER
Last Answer : Polyamide
Description : A megger is being used to test the insulation of an AC generator. The resistance value of a dry, clean winding will _____________. A. continue to rise as test potential is maintained, ... , becoming fairly steady after 5-7 minutes D. stabilize after approximately 2-4 minutes of fluctuation
Description : Find the dielectric constant for a material with electric susceptibility of 4. a) 3 b) 5 c) 8 d) 16
Last Answer : b) 5
Description : Find the susceptibility of a material whose dielectric constant is 2.26. a) 1.26 b) 3.26 c) 5.1 d) 1
Last Answer : a) 1.26
Description : What is the dependence of mechanical force per unit area of charged conductor on the surface charge density and the dielectric constant of the medium
Last Answer : What is the dependence of mechanical force per unit area of charged conductor on the surface charge density and the dielectric constant of the medium